| 压盖落料冲孔成形模设计 |
| |
| 引用本文： | 崔志浩,高喜顺,董本峰. 压盖落料冲孔成形模设计[J]. 装备环境工程, 2000, 0(5): 41-41 |
| |
| 作者姓名： | 崔志浩 高喜顺 董本峰 |
| |
| 作者单位： | 崔志浩（阿城继电器股份有限公司，黑龙江阿城150302）;高喜顺（阿城继电器股份有限公司，黑龙江阿城 150302）;董本峰（阿城继电器股份有限公司，黑龙江阿城 150302） |
| |
| 摘 要： | 介绍了在尺寸公差及形位公差要求较高的落料冲孔成形件的模具设计过程中，不降低劳动效率的情况下，如何使模具简化、降低模具成本，并使冲压件满足其设计要求。
|
| 关 键 词： | 压盖；落料成形；模具 |
| 文章编号： | 1000-8446(2000)05-0040-02 |
| 修稿时间： | 2000-01-21 |
Design of Blanking-piecing-forming Die for Pressure Cap |
| |
| CUI Zh-hao,CAO Xi-shum,DONG Ben-feng. Design of Blanking-piecing-forming Die for Pressure Cap[J]. Equipment Environmental Engineering, 2000, 0(5): 41-41 |
| |
| Authors: | CUI Zh-hao CAO Xi-shum DONG Ben-feng |
| |
| Abstract: | This paper presents the design of blanking-forming die for pressure cap .for which the dimensional tolerance and the geometric tolerance are required highly. The impor- tant point of this paper is on how to simplify the die set .to decrease the cost of the die set and to make the stamped component satisfy the requirements for the design on condition that the work efficiency is not degraded. |
| |
| Keywords: | Pressure cap Blank-forming Die |
| 本文献已被 CNKI 等数据库收录！ |
