Microbial PCB dechlorination in dredged sediments and the effect of moisture

Evidence of reductive dechlorination of polychlorinated biphenyls (PCBs) in sediments was investigated in Hudson River sediments dredged and encapsulated in 1978 at Moreau, NY. The effect of different moisture contents in dredged sediments on dechlorination and dechlorinating microorganisms was also determined using PCB-spiked sediments in which the moisture level was adjusted by simulating a dewatering process. The congener pattern of PCBs indicated that the dechlorination in the dredged sediments was far less advanced than that in the river sediments collected from the general area of the dredged site (Ft. Edward site). Dechlorination in encapsulated sediments at the Moreau site appeared to have stopped soon after dredging. When microorganisms eluted from the encapsulated sediments were inoculated in clean sediments spiked with Aroclor 1242, an extensive dechlorination was observed, indicating that the encapsulated sediments still harbored dechlorinating microorganisms. However, the same inoculum failed to further dechlorinate residual congeners in the dredged sediments. On the other hand, an inoculum obtained in 1990 from the dredged site in the Hudson River dechlorinated the residual congeners further. In simulated dredged sediments, the maximum level of dechlorination was lower at reduced moisture contents. The population size of dechlorinating microorganisms, as determined by the most probable number (MPN) technique, was also smaller at the lower moisture levels. There was a significant correlation between the maximum extent of dechlorination and the specific death rate of dechlorinating populations. These results indicate that the underlying mechanism of the moisture-dependent maximum dechlorination is the moisture-dependence of the death rate of dechlorinating microorganisms.