| 某产品钛合金性能及台阶轴磨削 |
| |
| 引用本文： | 乔奇光,乔正阳,李时威,寇娟利,谢宇航.某产品钛合金性能及台阶轴磨削[J].装备环境工程,2013,10(1):108-109,113. |
| |
| 作者姓名： | 乔奇光 乔正阳 李时威 寇娟利 谢宇航 |
| |
| 作者单位： | 1. 中国兵器工业集团北方光电股份有限公司,西安,710043
2. 中国兵器工业第五九研究所,重庆,400039 |
| |
| 摘 要： | TC4因具有良好的力学性能和较好的工艺性能而成为钛合金结构件中使用最多的材料，但其磨削性极差，特别是台阶轴的磨削更为困难。在吸取总结各种磨削经验的基础上对钛合金台阶轴的磨削做了一些探索和实践。
|
| 关 键 词： | 钛合金 性能 磨削 台阶轴 |
| 收稿时间： | 2012/9/28 0:00:00 |
| 修稿时间： | 1/1/2013 12:00:00 AM |
Performance and Stepped Shaft Grinding of Titanium Alloy of Guided Product |
| |
| QIAO Qi-guang,QIAO Zheng-yang,LI Shi-wei,KOU Juan-li and XIE Yu-hang.Performance and Stepped Shaft Grinding of Titanium Alloy of Guided Product[J].Equipment Environmental Engineering,2013,10(1):108-109,113. |
| |
| Authors: | QIAO Qi-guang QIAO Zheng-yang LI Shi-wei KOU Juan-li and XIE Yu-hang |
| |
| Institution: | 1.North Electro-optic Co.,Ltd.of China Ordnance Industry Group,Xi’an 710043,China; 2.No.59 Institute of China Ordnance Industry,Chongqing 400039,China) |
| |
| Abstract: | TC4 becomes most commonly used material of titanium alloy structural components because of good mechanical properties and better process performance. However, its grinding is very poor, especially stepped shafts. Some exploration and practice of titanium alloy stepped shaft grinding were carried out based on various grinding experience. |
| |
| Keywords: | titanium alloy performance grinding stepped shaft |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
| 点击此处可从《装备环境工程》浏览原始摘要信息 |
| 点击此处可从《装备环境工程》下载免费的PDF全文 |
|
