Potential of acid activated clays in the clarification of menhaden stickwater |
| |
Authors: | Peter F. Castillo Ramu M. Rao Joseph A. Liuzzo |
| |
Affiliation: | 1. Department of Natural Sciences, Hostos Community College , City University of New York , Bronx, New York, 10451;2. Department of Food Science, Louisiana Agricultural Experiment Station , Louisiana State University , Baton Rouge, Louisiana, 70803 |
| |
Abstract: | Abstract The primary objective of this investigation was to determine the feasibility of using acid activated clays to clarify menhaden stickwater effluent. Experiments, such as physical and chemical properties determinations, effect of changes in pH and temperature and coagulation, and coagulation followed by clay treatment were also performed to study the separation of solids in stickwater. Analysis of the stickwater showed that it contained 4.5% crude protein, 1.4% crude fat, 6.5% total solids, 1.13% ash and 93.1% water. At a wavelength of 575 um, the sample absorbed all the light and the percent transmittance was zero. When diluted 1:100 the percent transmittance was 0.39 at the same wavelength. Measured at 25°C the sample had a viscosity of 9.0 centipoises. The results showed that the precipitation of fat increased with increasing temperatures, while the reverse was true for protein. A pH of 4.0 gave the maximum clarification at all temperatures employed. The viscosity decreased at pH values above and below the original pH of the sample. Among the four different acid activated clays used in this study (trade names Supact‐150, Impact‐150, Impact‐12 and Impact‐1OORR), Impact‐150 was the most effective in protein and fat precipitation, and the degree of separation of these components increased by treating stickwater with a coagulant (aluminum sulfate) prior to treatment with acid activated clay. |
| |
Keywords: | Menhaden Stickwater Effluent Acid Activated Clay Clarification |
|
|