首页 | 本学科首页   官方微博 | 高级检索  
     

臭氧-CNT膜改性联用工艺阈通量及膜污染分析
引用本文:王凯伦,刘芳,关羽琪,祝学东,董丹,薛小雷,马燕林,栾桂荣,郭瑾. 臭氧-CNT膜改性联用工艺阈通量及膜污染分析[J]. 环境科学, 2019, 40(2): 738-746
作者姓名:王凯伦  刘芳  关羽琪  祝学东  董丹  薛小雷  马燕林  栾桂荣  郭瑾
作者单位:北京工业大学环境与能源工程学院,北京,100124;北京工业大学环境与能源工程学院,北京,100124;北京工业大学环境与能源工程学院,北京,100124;北京工业大学环境与能源工程学院,北京,100124;北京工业大学环境与能源工程学院,北京,100124;北京工业大学环境与能源工程学院,北京,100124;北京工业大学环境与能源工程学院,北京,100124;北京工业大学环境与能源工程学院,北京,100124;北京工业大学环境与能源工程学院,北京,100124
基金项目:国家自然科学基金项目(51478009,51778014);北京市教育委员会科技计划项目(KM201310005011);北京市优秀人才培养资助青年拔尖团队项目(2014000026833TD02);2015年北京市科技新星计划(B类)项目
摘    要:采用碳纳米管(carbon nanotube,CNT)对聚偏氟乙烯(polyvinylidene fluoride,PVDF)中空纤维超滤膜进行改性,结合臭氧预氧化技术,考察了臭氧-CNT膜改性联用工艺的阈通量及膜表面污染情况.结果表明,原膜阈通量为45 L·(m~2·h)~(-1),联用工艺下阈通量为81 L·(m~2·h)~(-1),联用工艺相对原膜阈通量提高了约80%;且联用工艺的污染速率最低,约为0. 001 37k Pa·min-1·L-1·m~2·h.相同臭氧投量与CNT负载量下,对比联用工艺阈通量与临界通量运行情况,得出阈通量下运行过水量高于临界通量运行,表明阈通量下运行能够缓解膜污染,延长膜组件的运行时间.膜污染碳平衡实验结果表明,采用CNT对膜改性后,膜组件的纳污能力与可恢复性得到明显提高,臭氧氧化能够进一步提高CNT改性膜组件的可恢复性,大幅提高其过水性能和使用时间.

关 键 词:超滤膜  二级出水  碳纳米管  臭氧  膜改性  碳平衡
收稿时间:2018-05-08
修稿时间:2018-09-01

Threshold Flux and Membrane Fouling Analysis of the Hybrid Pre-ozonation and CNTs Membrane Modification Process
WANG Kai-lun,LIU Fang,GUAN Yu-qi,ZHU Xue-dong,DONG Dan,XUE Xiao-lei,MA Yan-lin,LUAN Gui-rong and GUO Jin. Threshold Flux and Membrane Fouling Analysis of the Hybrid Pre-ozonation and CNTs Membrane Modification Process[J]. Chinese Journal of Environmental Science, 2019, 40(2): 738-746
Authors:WANG Kai-lun  LIU Fang  GUAN Yu-qi  ZHU Xue-dong  DONG Dan  XUE Xiao-lei  MA Yan-lin  LUAN Gui-rong  GUO Jin
Affiliation:School of Environmental and Energy Engineering, Beijing University of Technology, Beijing 100124, China,School of Environmental and Energy Engineering, Beijing University of Technology, Beijing 100124, China,School of Environmental and Energy Engineering, Beijing University of Technology, Beijing 100124, China,School of Environmental and Energy Engineering, Beijing University of Technology, Beijing 100124, China,School of Environmental and Energy Engineering, Beijing University of Technology, Beijing 100124, China,School of Environmental and Energy Engineering, Beijing University of Technology, Beijing 100124, China,School of Environmental and Energy Engineering, Beijing University of Technology, Beijing 100124, China,School of Environmental and Energy Engineering, Beijing University of Technology, Beijing 100124, China and School of Environmental and Energy Engineering, Beijing University of Technology, Beijing 100124, China
Abstract:Polyvinylidene fluoride (PVDF) hollow fiber ultrafiltration membranes were modified with carbon nanotubes (CNT). Hybrid pre-ozonation and CNT modification were investigated by experimentally manipulating the ozonation process, threshold flux, and membrane fouling. The results showed that the threshold fluxes of the unmodified membrane and hybrid process were 45 L·(m2·h)-1 and 81 L·(m2·h)-1, respectively. Additionally, the fouling rate of the hybrid process was about 0.00137 kPa·min-1·L-1·m2·h, which was notably lower compared to other process. The results showed that the filtration volume under threshold flux was higher than that under critical flux with the same CNT loading mass and ozone dosage. This comparison indicated that membrane fouling was alleviated under threshold flux and that the corresponding operation period was extended. Through the carbon balance experiment, the fouling capacity and recoverability improved remarkably after CNT modification. Additionally, ozonation could enhance the recoverability of membranes. The hybrid process examined in this study could dramatically improve the permeability and extend the operation time of the ultrafiltration membrane.
Keywords:ultrafiltration membrane  sewage effluent  carbon nanotube  O3  membrane modification  carbon balance
本文献已被 CNKI 万方数据 等数据库收录!
点击此处可从《环境科学》浏览原始摘要信息
点击此处可从《环境科学》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号