| 冷挤压双层组合凹模的最佳设计 |
| |
| 引用本文： | 徐小兵. 冷挤压双层组合凹模的最佳设计[J]. 装备环境工程, 1996, 0(6) |
| |
| 作者姓名： | 徐小兵 |
| |
| 作者单位： | 江汉石油学院机械系!湖北荆沙市434102 |
| |
| 摘 要： | 此文应用厚壁圆筒弹性解,推导了冷挤压双层组合凹模,具有最大弹性极限时所能承受的最大挤压应力的计算公式,以及满足上述条件时双层组合凹模分界面半径和分界面过盈量的计算公式.利用上述各式,可使组合凹模获得最佳设计.
|
| 关 键 词： | 最佳设计 分界面 弹性极限 凹模 冷挤压 |
The Optimum Design on Two-Layer Assemblied Cavity Die of Cold Extrusion |
| |
| Jianghan Petroleum Institute Xu Xiaobing. The Optimum Design on Two-Layer Assemblied Cavity Die of Cold Extrusion[J]. Equipment Environmental Engineering, 1996, 0(6) |
| |
| Authors: | Jianghan Petroleum Institute Xu Xiaobing |
| |
| Affiliation: | Jianghan Petroleum Institute Xu Xiaobing |
| |
| Abstract: | In this paper,the optimum calculation formulas with maximum elastic limit on two-layer asscmblicd cavity die of cold exlrusion are derived from the elastic solution of thick-wall cylinder. Then, the maximum extrusion stress, radius and interference of interface on two-layer assem-blied cavity die of cold extrusion can be calculated by above formulas. |
| |
| Keywords: | Cold Extrusion Cavity Die Optimrm Design Elastic Limit Interface |
| 本文献已被 CNKI 等数据库收录！ |
