| 600g-t土工离心机吊篮力学分析与强度设计 |
| |
| 引用本文： | 杨玉明,刘远东,王沪毅. 600g-t土工离心机吊篮力学分析与强度设计[J]. 装备环境工程, 2015, 12(5): 45-49 |
| |
| 作者姓名： | 杨玉明 刘远东 王沪毅 |
| |
| 作者单位： | 中国工程物理研究院 总体工程研究所，四川 绵阳 621900,中国工程物理研究院 总体工程研究所，四川 绵阳 621900,中国工程物理研究院 总体工程研究所，四川 绵阳 621900 |
| |
| 摘 要： | 目的对600g-t土工离心机的吊篮各部件开展力学分析与强度设计。方法基于土工离心机的吊篮结构初始设计方案,利用Ansys有限元分析软件,采用非线性接触算法开展吊篮优化力学分析。结果通过优化设计,吊篮结构相对于初始结构各部件的最大应力下降39%~59%。结论优化后的吊篮结构满足强度要求。
|
| 关 键 词： | 土工离心机；吊篮；接触非线性；优化设计 |
| 收稿时间： | 2015-07-24 |
| 修稿时间： | 2015-10-10 |
Mechanical Analysis and Strength Design of the Nacelle on the 600g-t Geotechnical Centrifuge |
| |
| YANG Yu-ming,LIU Yuan-dong and WANG Hu-yi. Mechanical Analysis and Strength Design of the Nacelle on the 600g-t Geotechnical Centrifuge[J]. Equipment Environmental Engineering, 2015, 12(5): 45-49 |
| |
| Authors: | YANG Yu-ming LIU Yuan-dong WANG Hu-yi |
| |
| Abstract: | Objective To carry out the mechanical analysis and strength design of the nacelle on the 600g-t geotechnical centrifuge. Methods Referring to the original designs of the nacelle on the centrifuge, non-linear contact analyses were carried out on the nacelle of the 600g-t centrifuge by utilizing the contact algorithm in the software ANSYS, and optimizations of the mechanical behaviors of each part of the nacelle were done accordingly. Results FEM results revealed that the maximum von Mises stress of the each part of the nacelle was reduced by 39%~59% after optimization compared to the initial values. Conclusion Optimized structure of the nacelle satisfied the strength requirements. |
| |
| Keywords: | |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
| 点击此处可从《装备环境工程》浏览原始摘要信息 |
|
点击此处可从《装备环境工程》下载全文 |
|
