首页 | 本学科首页   官方微博 | 高级检索  
     

负载型磷酸氧钒低温脱硝催化剂的制备及其抗硫抗水性能
引用本文:贾勇, 张松, 戴波, 顾明言, 史德明, 夏勇军, 胡笳. 负载型磷酸氧钒低温脱硝催化剂的制备及其抗硫抗水性能[J]. 环境工程学报, 2019, 13(1): 125-133. doi: 10.12030/j.cjee.201805172
作者姓名:贾勇  张松  戴波  顾明言  史德明  夏勇军  胡笳
作者单位:1.安徽工业大学能源与环境学院,马鞍山 243002; 2.冶金减排与资源综合利用教育部重点实验室,马鞍山 243002; 3.安徽欣创节能环保科技股份有限公司,马鞍山 243071
摘    要:针对目前低温脱硝催化剂抗硫抗水性较差的不足,以TiO2为载体负载活性组分V2O5,利用磷酸调控表面酸性,制备了磷酸氧钒催化剂VPO/TiO2,并实验研究了SO2和水蒸气对其脱硝活性的影响。结果表明:控制P与V的摩尔比为1/5,活性组分(VPO)负载量为10%,焙烧温度为400 ℃时,催化剂脱硝性能最好,180~400 ℃温度范围内脱硝率高于98%;反应温度为200 ℃,烟气中SO2体积分数为200×10-6~800×10-6和水蒸气体积分数为4%时,催化剂的活性无明显下降。添加磷酸能够促使催化剂表面生成VOPO4、(VO)2P2O7及V4+/V5+氧化还原电对,提高了催化剂的低温脱硝活性。磷酸可增强催化剂的表面酸性,减少了SO2的表面吸附及其与活性组分的反应。另外,催化剂表面以介孔为主,可提高未被水分子占据的活性位点量,FT-IR图谱显示抗硫抗水测试后的VPO/TiO2表面未发现有硫酸根生成,VPO/TiO2表现出较强的抗SO2和水蒸气毒化的性能。负载型磷酸氧钒催化剂具有较高的脱硝活性和较强的抗硫抗水性能。

关 键 词:低温脱硝催化剂   工业烟气脱硝   磷酸氧钒   抗硫抗水   催化活性

Preparation of low-temperature DeNOx catalyst of supported vanadium phosphate and its resistance to sulfur dioxide and water vapor
JIA Yong, ZHANG Song, DAI Bo, GU Mingyan, SHI Deming, XIA Yongjun, HU Jia. Preparation of low-temperature DeNOx catalyst of supported vanadium phosphate and its resistance to sulfur dioxide and water vapor[J]. Chinese Journal of Environmental Engineering, 2019, 13(1): 125-133. doi: 10.12030/j.cjee.201805172
Authors:JIA Yong  ZHANG Song  DAI Bo  GU Mingyan  SHI Deming  XIA Yongjun  HU Jia
Affiliation:1.School of Energy and Environment, Anhui University of Technology, Maanshan 243002, China; 2.Metallurgical Emission Reduction & Resource Recycling, Ministry of Education, Maanshan 243002, China; 3.Anhui Xinchuang Energy & Environmental Protection Science & Techmology Co.Ltd., Maanshan 243071, China
Abstract:In view of poor resistance to sulfur and water vapor for the low temperature DeNOx catalyst, a type of vanadium phosphate catalyst VPO/TiO2 was prepared through doping active constituent V2O5 on TiO2 and regulating the surface acidity with phosphoric acid in this study, and the effects of SO2 and water vapor on its DeNOx activity were studied. The results showed that the best DeNOx performance of this vanadium phosphate catalyst was obtained at P/V molar ratio of 1/5, 10% active component (VPO) loading and the calcination temperature of 400 ℃, and the corresponding DeNOx efficiency was above 98% at the temperature range of 180~400 ℃. The DeNOx efficiency didn’t decrease at reaction temperature of 200 ℃ when the volume fractions of SO2 and water vapor were 200×10-6~800×10-6 and 4%, respectively. The addition of phosphoric acid could promote the formation of VOPO4, (VO)2P2O7 and redox couples V4+/V5+, which led to the improvement on the low temperature DeNOx activity of the catalyst. Phosphoric acid addition could enhance the surface acidity of vanadium-based catalyst, suppressed SO2 adsorption on the catalyst surface and their reaction to active constituent. In addition, the catalyst surface mainly contained mesoporous structure, which caused the increase of the amount of active sites unoccupied by the water molecules. The FT-IR spectra show that sulfate was not produced on the surface of tested VPO/TiO2 in the presence of SO2 and water vapor. The VPO/TiO2 catalysts show a strong resistance to SO2 and water vapor. Accordingly, the supported vanadium phosphate catalyst in this study had a high catalytic activity and strong sulfur and water resistance.
Keywords:low temperature denitrification catalyst  industrial flue gas denitrification  vanadium phosphate  resistance to sulfur and water  catalytic activity
本文献已被 CNKI 万方数据 等数据库收录!
点击此处可从《环境工程学报》浏览原始摘要信息
点击此处可从《环境工程学报》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号