共查询到20条相似文献,搜索用时 93 毫秒
1.
2.
3.
4.
清江化肥厂采用等标污染负荷的评价方法,找出厂外排水中主要污染物。氨氮是对外环境影响的主要污染物,占总污染负荷的72.9%,年排放量为115.79吨,占厂外排废水中污染物总量的31.36%。合理的减少氨的流失,是控制氨氮污染的主要途径。通过对氨氮废水源的控制与治理,每年少排含氨废水65万吨,年回收合成氨170吨,消除了产品的流失,并减少软水的消耗,仅后两项就可为企业增加16.7万元/年的经济效益。 相似文献
5.
6.
通过提高干气和液态烃的脱硫效果及提高酸性气体的硫回收率来控制大气的硫污染;通过加强废水汽提效果和完善污水处理场生化处理设施,控制外排废水氨氮总量;通过采用清洁工艺和碱渣回用来减少碱渣产生量和处理量;用焦肉炭塔处理“三泥”来解决“三泥出路。 相似文献
7.
云硫化工厂生产过程中产生的污染主要来自废水、废气和废渣。为了保护环境 ,该厂以科技为先导 ,大力加强三废的综合治理 ,取得了显著成效。积极推行清洁生产 ,三废的末端治理转向生产全过程控制 ,在污染的源头削减废物产出量 ,将三废消除在生产过程中。早在 1995年该厂就对 4 0kt/a硫酸生产装置推行清洁生产 ,并取得了喜人的效果。建厂投产初期的废水处理系统 ,由于设计流程长、生产工艺上脱吸率低 ,使得处理后废水的总酸度偏高 ,不但消耗大量石灰 ,而且排出的废水有时达不到排放标准 ,污染事故偶有发生。针对这一情况 ,该厂成立了废水处… 相似文献
8.
用水解酸化池-膜生物反应器处理活性艳红X-3B废水 总被引:1,自引:0,他引:1
采用水解酸化池-膜生物反应器处理含活性艳红X-3B的模拟废水,研究了水力停留时间(HRT)对水解酸化池废水处理效果的影响,考察了水解酸化池-膜生物反应器对废水的处理效果及膜生物反应器中污泥沉降性能对膜污染的影响。实验结果表明:水解酸化池HRT为16h时,废水的可生化性最好,挥发性脂肪酸质量浓度与COD比值为0.5;HRT为17h时,废水脱色率达69%,而COD的去除率受HRT影响较小;膜生物反应器主要起去除废水中COD的作用;水解酸化池-膜生物反应器处理后废水的脱色率和COD去除率分别为83%和97%;膜生物反应器中活性污泥沉降性能的变化直接影响膜污染的速率。 相似文献
9.
硒的环境污染特征及其防控技术 总被引:1,自引:0,他引:1
《再生资源与循环经济》2017,(4)
从硒的化学性质、毒性与人类健康、污染来源和分布4个方面,综述了硒及其对环境的污染和危害,总结了含硒废水的膜处理技术、共沉淀法、吸附法、化学还原法、生物还原法和人工湿地法的机理、影响因素和优缺点,为后续硒污染特征研究及污染控制技术提供新思路。 相似文献
10.
11.
12.
主成分分析法在印染废水混凝试验中的应用 总被引:1,自引:0,他引:1
运用主成分分析法的双重图对印染废水混凝试验数据进行分析,揭示了在用复合絮凝剂处理印染废水混凝试验中多维工艺操作参数之间的相关性和各参数对混凝脱色的重要性,从而根据双重图来对混凝试验操作参数实行优化和控制。 相似文献
13.
UV/Fenton氧化-混凝联合工艺处理含酚废水 总被引:8,自引:0,他引:8
采用UV/Fenton氧化-混凝联合工艺对模拟苯酚废水进行处理,探讨了UV/Fenton预氧化程度和混凝处理条件对模拟苯酚废水处理效果的影响。结果表明,采用混凝处理,COD去除率仅为14.1%;当UV/Fenton预氧化处理过程中H2O2的质量浓度为150~300mg/L时,废水的混凝性能可提高1.5倍以上;当H2O2质量浓度为450mg/L、光反应时间为30min时,采用UV/Fenton氧化一混凝工艺联合处理后COD去除率达82.7%。苯酚废水采用UV/Fenton预氧化处理后,进行混凝处理过程的适宜pH为6.5,混凝剂Fe^3 的适宜质量浓度为500mg/L. 相似文献
14.
粉煤灰吸附—石灰沉淀处理高浓度含氟废水 总被引:1,自引:0,他引:1
采用粉煤灰吸附—石灰沉淀处理高浓度含氟废水.正交实验得到的最佳工艺条件为:反应温度10℃,石灰加入量3.0 g/mL,反应时间60 min,废水pH 6.88.在此最佳工艺条件下处理F质量浓度为150 mg/L的含氟废水,Fˉ去除率为97.53%.Mn2+,Fe3+,Mg2+,A13+,Zn2+单独存在时,随5种阳离子质量浓度增大,Fˉ去除率略有增加;当5种阳离子共同存在且质量浓度均大于500 mg/L时,Fˉ去除率下降.PO43-,SO42-,CO32-,NO3-单独存在时对Fˉ去除率影响不大;当4种阴离子共同存在且质量浓度均大于800 mg/L时,Fˉ去除率低于对照实验. 相似文献
15.
16.
Decolorization and estrogenic activity of colored livestock wastewater after electrolysis treatment 总被引:1,自引:0,他引:1
Hotaka Kai Yasuhiro Ishibashi Taiki Mori Hiroshi Ishibashi Isao Kawaguchi Hiroki Ohwaki Takehiro Takemasa Koji Arizono 《Journal of Material Cycles and Waste Management》2010,12(2):128-135
Livestock wastewater is treated by activated sludge treatment. Untreated livestock wastewater has high estrogen activity because
animal excreta contains estrogen. When activated sludge treatment is applied, the estrogen activity declines or is lost. However,
the color of treated livestock wastewater is deep brownish-red because of the decomposition of organic compounds or the synthesis
of metabolites. Discharging colored wastewater to the environment could cause some problems, so it is necessary to decolorize
colored wastewater before it is discharged. It has been suggested that electrolysis decolorization technology is suitable
for treating colored wastewater; however, the process produces volatile organic compounds (VOCs). In fact, little research
has been conducted with reference to estrogen activity in wastewater that has undergone electrolysis, especially on the contribution
of the electrolysis decolorization process to estrogen activity, i.e., the possibility of resynthesis of some substance with
estrogen activity due to resolved and metabolized colored components. In this study, the concentration of VOC was measured
for various electrolysis conditions, and estrogen activity was examined using a yeast two-hybrid assay. From the results,
decolorization of colored livestock wastewater by electrolysis was possible, and the VOC generation during electrolysis could
be controlled depending on the electrolysis conditions. Estrogen activity in colored livestock wastewater disappeared on electrolysis
decolorization. 相似文献
17.
超细粉煤灰对模拟废水中孔雀石绿的吸附性能 总被引:1,自引:0,他引:1
以球磨制得的超细粉煤灰为吸附材料,采用振荡吸附法研究了其对模拟废水中孔雀石绿的吸附性能.实验结果表明:在超细粉煤灰加入量为10g/L、吸附温度为298K、初始孔雀石绿质量浓度为500mg/L、振荡时间为120min、孔雀石绿废水自然酸碱度条件下,达到吸附平衡时的吸附量为49.97 mg/g,孔雀石绿几乎全部被超细粉煤灰所吸附;该吸附反应很好地符合二级吸附动力学方程,Ea为3.95kJ/mol,吸附反应速率较快,吸附过程由孔雀石绿在超细粉煤灰颗粒内部的扩散控制;该吸附符合Langmuir吸附等温方程,随吸附温度升高,饱和吸附量下降,298K下的饱和吸附量可达526.32mg/g,是自发进行的放热反应过程. 相似文献
18.
采用化学沉淀法,以模拟联碱厂碳化塔洗水为原料,制备磷酸铵镁,并采用SEM和XRD技术对产品的晶形和成分进行分析。通过正交实验和单因素优化实验确定较适宜的反应条件为:反应液pH 9.5,n(Mg)∶n(P)∶n(N)=1.2∶1.1∶1.0,反应温度25 ℃。在此条件下,处理氨氮质量浓度为7 500 mg/L的联碱厂碳化塔洗水,氨氮的利用率为97.4%,制备的磷酸铵镁产物晶形比较规则,呈斜立方正交结构。1 t氨氮质量浓度为7 500 mg/L的联碱厂碳化塔洗水可生产磷酸铵镁0.139 2 t,产品收益约为320.2 元,药剂成本为352.3 元,即废水的处理费用约为32.1 元/t。 相似文献
19.
David Chung Hyo-Hyun Choi Hye-Young Yoo Ji-Young Lee Sun-Kyoung Shin Jung Min Park Junbeum Kim 《Journal of Material Cycles and Waste Management》2017,19(1):46-54
To prepare for the international mercury convention, the characteristics of mercury emissions from a zinc smelting facility in South Korea have been reviewed and a material flow analysis (MFA) has been conducted in this research. As inputs into the mercury MFA study, zinc ores and sulfuric acid were examined, whereas wastewater sludge, effluence water, spent catalyst, and emissions from the casting and roasting processes were examined as outputs. Mercury concentrations extracted from end products like zinc ingots, cadmium ingots, and sulfuric acid were then analyzed. Our results showed that the wastewater sludge discharged from the zinc smelting process had a relatively higher concentration of mercury, indicating that the concentration of mercury was further enriched in the wastewater sludge. The wastes discharged through the zinc smelting process should be thoroughly controlled, as results of the MFA showed that approximately 89 % of the mercury contained in the original input was later found in the waste. According to this study, the higher the concentration of mercury within zinc ores at the input stage, the higher is the mercury concentration found in the wastewater sludge at the output stage. 相似文献
20.
分别采用UV-Fenton试剂氧化法、次氯酸钙氧化法和二氧化氯氧化法处理模拟聚合物驱废水,考察了各工艺条件对废水降黏效果的影响。实验结果表明:在初始废水pH为7、反应温度为50℃、反应时间为20 min的条件下,UV-Fenton试剂氧化法适宜的H2O2加入量为1 mmol/L,n(H2O2)∶n(Fe2+)=10,处理后废水降黏率达65.7%;次氯酸钙氧化法适宜的次氯酸钙加入量为500 mg/L,处理后废水降黏率达81.7%;二氧化氯氧化法适宜的二氧化氯加入量为100 mg/L,处理后废水降黏率为40.9%。3种氧化法对模拟聚合物驱废水的降黏率大小顺序为:次氯酸钙氧化法>UV-Fenton试剂氧化法>二氧化氯氧化法。 相似文献