谏壁发电厂10号炉电除尘器改造

分析了谏壁发电厂10号炉原电除尘器除尘效率低的原因，介绍了该电除尘器的改造方案及依据。除尘器改造后烟尘排放质量浓度仅为41．5mg／m^3，大大削减了电厂烟尘排放量，增强了企业的发展后劲。     

石洞口第二发电厂2号炉电除尘器的现状及其改进措施

本文介绍了华能上海石洞口第二发电厂２号炉电除尘器的现状，分析了其除尘效率低的主要原因，并介绍了改善其除尘性能的措施。     

新型电除尘技术在200MW机组改造上的应用

介绍了国电双鸭山发电有限公司2号炉200MW机组除尘系统改造项目（原水膜除尘器改造为电除尘器）。由于受场地限制,常规结构除尘器难以布置,故采用EEII-G新型电除尘器,该除尘器是在EEII型电除尘器技术基础上进行了优化改进,较好地利用了现场空间,也取得了满意的除尘效果。     

大武口发电厂3号炉电除尘器改造

根据大武口发电厂3号炉飞灰比电阻高的特点，对电除尘器进行了改造，使除尘效率由原来的97．3％提高到99.5％。     

富拉尔基发电总厂200MW机组除尘器改造

对富拉尔基发电总厂5号炉的设计条件进行了分析，针对燃用低硫煤，飞灰比电阻高，场地较小，除尘效率要求高的情况，在电除尘器的设计上采取有效措施，达到了排放要求。     

600 MW机组除尘器升级改造及效益评价

元宝山发电有限责任公司2号600 MW机组配套电除尘器由于设计效率低、燃烧煤种变化、设备老化等多方面原因，除尘效率下降，除尘器出口烟尘排放浓度超标严重。为了满足新的《火电厂大气污染物排放标准》的要求，对元宝山发电有限责任公司2号机组配套电除尘器进行升级改造，将原有的4台四电场静电除尘器增效改造为4台电袋复合式除尘器。通过电除尘器的改造，降低了除尘器出口粉尘排放浓度，提高了除尘效率，保证了2号机组电除尘器的安全稳定运行。     

关断隔离振打技术研究与应用

关断隔离振打技术能有效减少电除尘器的二次扬尘，提高除尘效率。介绍了关断隔离振打技术的基本工作原理，并通过来试验验证了该技术的可靠性，同时介绍了宣城发电厂12号炉电除尘改造采用该技术后，电除尘器出口烟尘排放浓度低于30 mg／m3。该工程实际应用的案例验证了该技术抑制二次扬尘的效果，为相似的电除尘器提效改造提供参考。     

SO3烟气调质试验研究

介绍了SO3烟气调质技术的原理和现场试验方法，并就烟尘调质中的设备腐蚀问题进行了探讨。上海石洞口电厂2号炉烟气调质试验结果表明。该技术在解决电厂由高硫煤改烧低硫煤时，原电除尘器除尘效率下降的问题有显效，可使除尘效率从98．5％提高到99％以上。     

循环流化床锅炉配置电除尘器的设计

循环流化床锅炉的烟气和烟尘性质与常规煤粉炉相比有较大差异。针对循环流化床烟尘特性．分析其对电除尘器除尘效率可能造成的影响，提出电除尘器的设计要求，并对应用工程实例进行了分析。     

浅析电袋除尘器滤袋的设计选型

扬子石化热电厂1～9号炉电除尘器全部改造为电袋除尘器后,出口粉尘浓度均满足排放要求。但运行中发现5、6、9号炉电袋除尘器滤袋破损较多,影响了电袋除尘器的安全稳定运行。分析了这3台炉滤袋破损的原因,提出在电除尘器改造电袋除尘器的工程实践中滤袋选型是个关键。滤袋设计时应以滤料的连续长期使用温度来选型,同时应重视设计煤种和较核煤种的选取,袋区的过滤风速以1.0～1.2m/s为宜。     

石景山电厂1号炉电除尘器技术改造

石号山电厂1号炉配套的电除尘器，虽然一直能达到设计时的保证效率值，但不能满足现今的环保要求。在结构、资金等受到限制的条件下，挖掘现有设备潜力，制定了经济、合理的改造方案，取得了预定的效果，收尘效率达到了99．91％以上，为同类电除尘器的改造积累了经验。     

煤场防风抑尘网抑尘效果研究

随着国家环保要求越来越高,火电厂煤场扬尘问题受到越来越多的关注。防风抑尘网作为治理煤场扬尘的有效技术,日益得到广泛的应用。论述了煤场起尘机理、起尘风速及起尘量估算、煤场扬尘预测模式,综合研究了防风抑尘网起尘机理及抑尘效果,提出了起尘风速及起尘量估算推荐公式、煤场扬尘预测推荐模式,并通过数值模拟计算与实测数据,对防风抑尘网抑尘效果进行了分析。     

Study of Asian Dust Phenomena in 2001–2003 Using A Network of Continuously Operated Polarization Lidars

We have conducted dust observations at a number of locations including Beijing, Hefei, Suwon, Fukue, Nagasaki, Tsukuba, and Sapporo using automated two-wavelength polarization lidars o study Asian dust phenomena, including generation, transport, and change during transport. We developed a method using the depolarization ratio for estimating the contributions of Asian dust and spherical air-pollution aerosols in observed aerosol mixtures. We analyzed the dust profiles statistically to derive climatological characteristics and year-on-year variations. We also studied dust source and transport path for each dust event using the regional chemical transport model CFORS. The statistical analysis clearly demonstrated the year-on-year variation of dust phenomena and the characteristics depending on the locations of the observational sites. Most major dust events in 2001 and 2002 originated in Inner Mongolia and/or Mongolia at the southern edge of a low-pressure area located in Siberia and were transported by strong westerlies. In 2003, the typical meteorological pattern for heavy dust cases accompanying a strong low in Siberia was not seen, except for one case in April. Furthermore, the lidar observation in Beijing suggests that less dust was generated in the source regions in Inner Mongolia and/or Mongolia, probably due to higher precipitation in 2003.     

Long Range Transport of Asian Dust from Dust Storms and its Impact on Japan

We simulated the long range transport of dust emitted from dust storms that occurred in China by using a global three-dimensional chemical transport model. A modified dust emission flux scheme and a nonlocal diffusion scheme for determining the atmospheric eddy diffusivity in the atmospheric boundary layer were implemented to improve the chemical transport model. We examined the dust transport by comparing the model results with TOMS satellite images. The model calculated monthly total deposition of dust masses were used for comparison with the measurements collected at sampling stations in Japan, and good agreement was found. The model generally reproduced the temporal and spatial variations of dust reasonably well.     

烟尘浓度分布对二次扬尘影响的探讨

电除尘器内电场断面烟尘浓度呈非均匀性分布,它是产生振打二次扬尘的重要原因之一,通过改善电场内部气流分布状况和使用出口向上的出气箱,可以减少振打二次扬尘,从而达到电除尘器高效除尘的目的。     

防风抑尘网设计要点及参数的确定

介绍了堆场起尘、防风抑尘网抑尘的机理和国内外防风抑尘网研究结果,结合实际工程设计的经验,分析了防风抑尘网设计要点和主要参数,提出防风抑尘网设计的意见和建议。     

Duststorms and Mesoscale Cloud Systems over The East Asian Deserts in Spring

Meteorological characteristics and morphology of duststorms and other dust weather phenomena in the arid regions of East Asia were described in order to investigate a possible role of mesoscale cloud disturbances that develop in synoptic-scale mid-latitude cyclones in intensifying dust weather. This study is a statistical examination of conventional surface observational data as well as satellite data obtained during April 2000–2003. In the deserts of Mongolia and northern China (e.g., the Gobi Desert) duststorms and other weaker dust weather (i.e., dust whirls, blowing dust) frequently occur under a strong influence of synoptic-scale cyclones; on the other hand in the Taklamakan Desert (northwestern China), dust weather phenomena occur in a less organized fashion and may be driven mainly by local meteorological and geographical effects. A significant signal was identified, revealing of the intensification of dust weather by the presence of convective cloud disturbances. Meteorological changes such as pressure rise and temperature drop, typically found during the passage of cold fronts, were frequently observed in the cases of duststorms occurring in the analysis region. However, no definite tendency was found for moisture change and wind speed in relation to cloud activity, probably because rainfall amount is generally too low to moisten the boundary-layer air.     

What Anthropogenic Radionuclides (90Sr and 137Cs in Atmospheric Deposition, Surface Soils and Aeolian Dusts Suggest for Dust Transport over Japan

Currently, atmospheric anthropogenic radionuclides (particulate) are controlled by suspension of the surface dust containing those radionuclides (resuspension). We have found, therefore, that such radionuclides can be used as tracers of the surface dust suspension, transport and its subsequent deposition in distant areas. The ¹³⁷Cs/⁹⁰Sr activity ratios in the atmospheric deposition, without the direct influence of nuclear tests and accidents, at the Meteorological Research Institute (MRI, Tsukuba, Japan) during the 1990s were fairly low (average: 2.1). This value is not in agreement with the ratios in Japanese surface soils (range of averages: 4–7), which had been considered as the primary source of the deposited dust. This suggests that the current atmospheric dust deposition in Japan is a mixture of local and remote components. The remote component could be an aeolian dust that has been transported long distances from arid areas. The major component is most likely to be Asian dust. It was further hypothesized that other remote source may exist beyond the Asian domain, based on accumulated observations and model results. To obtain more information about the dust transport, Sahara dust deposited in Monaco in 2002 and a suspended dust collected in the Taklamakan area in 2001 were analyzed for ⁹⁰Sr and ¹³⁷Cs. The Taklamakan dust exhibited a ¹³⁷Cs/⁹⁰Sr ratio of about 4, which is within the range of atmospheric deposition observed at the MRI, while the Sahara dust exhibited a higher ¹³⁷Cs/⁹⁰Sr ratio (about 13). Although the present Sahara datum was negative for our hypothesis of ‘hyper-range transport’, the seasonal change of the ¹³⁷Cs/⁹⁰Sr ratio in the atmospheric deposition observed at the MRI requires an aeolian dust source having a low ¹³⁷Cs/⁹⁰Sr ratio, other than Asian dust.     

采用花岗岩水膜除尘器燃煤锅炉脱硫和除尘的工艺改造

为了使现有花岗岩水膜除尘器的燃煤锅炉烟气净化达标排放,在不更换水膜除尘器的前提下,探讨和比较了后继烟气吸收装置喷淋塔和鼓泡塔的脱硫和除尘机理,提出改进措施。该技术具有工艺流程简单,建设和运行成本低,适用于由于历史原因仍有相当大数量使用的花岗岩水膜除尘器的烟气净化工艺路线的改造。