Inhalation Transfer Factors for Air Pollution Health Risk Assessment

ABSTRACT

To facilitate routine health risk assessments, we develop the concept of an inhalation transfer factor (ITF). The ITF is defined as the pollutant mass inhaled by an exposed individual per unit pollutant mass emitted from an air pollution source. A cumulative population inhalation transfer factor (PITF) is also defined to describe the total fraction of an emitted pollutant inhaled by all members of the exposed population. In this paper, ITFs and PITFs are calculated for outdoor releases from area, point, and line sources, indoor releases in single zone and multizone indoor environments, and releases within motor vehicles. Typical PITFs for an urban area from emissions outdoors are ~10^-6–10^-3. PITFs associated with emissions in buildings or in moving vehicles are typically much higher, ~10^-3–10^-1.     

A model of oscillatory transport in granular soils, with application to barometric pumping and earth tides

A simple algebraic model is proposed to estimate the transport of a volatile or soluble chemical caused by oscillatory flow of fluid in a porous medium. The model is applied to the barometric pumping of vapors in the vadose zone, and to the transport of dissolved species by earth tides in an aquifer. In the model, the fluid moves sinusoidally with time in the porosity of the soil. The chemical concentration in the mobile fluid is considered to equilibrate with the concentration in the surrounding matrix according to a characteristic time governed by diffusion, sorption, or other rate processes. The model provides a closed form solution, to which barometric pressure data are applied in an example of pore gas motion in the vadose zone. The model predicts that the additional diffusivity due barometric pumping in an unfractured vadose zone would be comparable to the diffusivity in stagnant pore gas if the equilibration time is 1 day or longer. Water motion due to the M2 lunar tide is examined as an example of oscillatory transport in an aquifer. It is shown that the tidal motion of the water in an aquifer might significantly increase the vertical diffusivity of dissolved species when compared to diffusion in an absolutely stagnant aquifer, but the hydrodynamic dispersivity due to tidal motion or gravitational flow would probably exceed the diffusivity due to oscillatory advection.     

Inhalation transfer factors for air pollution health risk assessment

To facilitate routine health risk assessments, we develop the concept of an inhalation transfer factor (ITF). The ITF is defined as the pollutant mass inhaled by an exposed individual per unit pollutant mass emitted from an air pollution source. A cumulative population inhalation transfer factor (PITF) is also defined to describe the total fraction of an emitted pollutant inhaled by all members of the exposed population. In this paper, ITFs and PITFs are calculated for outdoor releases from area, point, and line sources, indoor releases in single zone and multizone indoor environments, and releases within motor vehicles. Typical PITFs for an urban area from emissions outdoors are approximately 10(-6)-10(-3). PITFs associated with emissions in buildings or in moving vehicles are typically much higher, approximately 10(-3)-10(-1).     

Photodegradation of an azo dye of the textile industry

An advanced oxidation treatment, UV/H2O2, was applied to an azo dye, Hispamin Black CA, widely used in the Peruvian textile industry. Rates of color removal and degradation of the dye have been evaluated. A strongly absorbing solution was completely decolorized after 35 min of treatment, and after 60 min an 82% reduction of the total organic carbon (TOC) was obtained. It has been found that the degradation rate increased until an optimum value, beyond which the reagent exerted an inhibitory effect. The degradation rate was also function of pH.     

Profiling the spatial concentration of allethrin and piperonyl butoxide using passive sorptive sampling and thermal desorption capillary GC-MS

Spatial concentration distribution of a chemical in an indoor environment is an important factor in the evaluation of chemical nuisances. However, straightforward techniques for the determination of this distribution are not very common and usually limited in their application. Sorptive sampling using polydimethylsiloxane-coated stir bars and the combination of active and diffusive sampling were shown to allow uncomplicated spatial concentration profiling of multiple compounds in an indoor environment. The validity of the approach was demonstrated in the analysis of the spatial concentration distribution of a pyrethroid insecticide in a common bedroom. The relative concentrations of allethrin and piperonyl butoxide were profiled throughout the room upon the application of an insecticide vaporizer.     

Demarcating coastal vegetation buffers with multicriteria evaluation and GIS at Saldanha Bay, South Africa

The Saldanha-Langebaan coastal zone forms an integral part of the South African coastal resource base. As elsewhere in the world, an acute need exists to balance development and economic growth and conservation in the coastal zone as an exploitable resource frontier area. Vegetated buffers and greenways are conservation concepts that have been used with great success in such conservation efforts. They are applied in the study area through the use of a Geographic Information System (GIS) as spatial decision-support system to legitimize the demarcation of a vegetated buffer zone. The method of multicriteria evaluation, as applied here, incorporates public decision-making in constructing an objective model for buffer zone demarcation. Representatives from interested and affected parties participated in model construction and calibration, resulting in the spatial delimitation of a multifunctional vegetated buffer. It conforms to a range of functional criteria and can serve as an environmental element in coastal conservation planning frameworks.     

Parameters governing permeate flux in an anaerobic membrane bioreactor treating low-strength municipal wastewaters: a literature review.

The objective of this review was to conduct a comprehensive literature survey to identify the parameters that govern the permeate flux in an anaerobic membrane bioreactor (AnMBR) treating municipal wastewater. Based on the survey, research to date indicates that the optimal membrane system for an AnMBR consists of an organic, hydrophilic, and negatively charged membrane with a pore size of approximately 0.1 microm. The use of both external and submerged membrane configurations shows promise. The operating parameters that affect permeate flux in an external membrane system are transmembrane pressure (TMP) and cross-flow velocity. The operating parameters that affect permeate flux in a submerged membrane system are TMP, sparging intensity, and duration of the relaxation period. Both cross-flow velocity and sparging intensity impart a significant amount of shear force on the biomass in an AnMBR. High shear forces can reduce the microbial activity in an AnMBR. In addition, high shear forces can reduce the size of the biosolids in the mixed liquor and increase the release of soluble microbial products. In this respect, external and submerged membrane systems are expected to perform differently because the magnitude of the shear forces to which the biomass is exposed in an external membrane system is significantly greater than that in a submerged system. The size of the biosolid particles and concentration of soluble microbial products in the mixed liquor affect permeate flux. Higher concentrations of soluble microbial products may be present in the mixed liquor when an AnMBR is operated at relatively low operating temperatures. Aerobic polishing following anaerobic treatment can potentially significantly reduce the concentration of some components of the soluble microbial products in the mixed liquor. It is not possible to remove the foulant layer on an organic membrane with caustic cleaning alone. Acidic cleaning or acidic cleaning followed by caustic cleaning is required to remove the foulant layer. This suggests that both biological/organic and inorganic material contribute to membrane fouling.     

A Comparison of Various Sources of Automotive Emissions

Chlorinated phenolic hydrocarbons are used as intermediate chemicals in the manufacture of 2,4-D (2,4-Dichlorophenoxy-acetic Acid) and related herbicides. These chemicals have an unusual odor with an extremely low threshold level of detection and consequently the manufacture and handling of these compounds poses a difficult odor control problem. Chipman Chemical Company at its Portland, Oregon plant has developed a system of fume collection and caustic soda solution scrubbing capable of removing phenolic compounds in the plant exhaust air to an acceptable level from an odor release standpoint. This article describes the development, present status, and projected future improvements of this odor control system.     

Variation in diet composition: a hazard to the reliability of the LD50-test

The severity of toxic effects on nearly fully-grown birds from an organophosphorus insecticide (isofenphos) was shown to be affected by the tested birds' previous diet as juveniles. Subadult grey partridges (Perdix perdix), with an insect-poor diet as juveniles, were severely affected by the insecticide, whereas birds fed an insect-rich diet as juveniles showed no signs of poisoning after feeding on isofenphos-treated seeds.     

New ternary water-soluble support from self-assembly of β-cyclodextrin-ionic liquid and an anionic polymer for a dialysis device

Environmental Science and Pollution Research - We developed a new hybrid material resulting from an innovative supramolecular tripartite association between an ionic liquid covalently immobilized...     

Urban returns to scale and environmental resources: an estimate of environmental externalities in an urban production function

The paper deals with the measurement of the economic advantages and environmental disadvantages of an urban setting. Based on a large sample of Italian cities, the paper provides results from an estimate of an urban production function which contains, in addition to the traditional labour and capital production factors, a variable representing the environmental resource consumption and the negative environmental externalities associated with urban life. A major result highlighted in the paper is that cities have in themselves mechanisms to favour an efficient consumption of environmental resources; however, the use of these resources has a cost in terms of environmental output, of negative externalities that are generated on the environment and which become worse by increasing the urban size.     

Production and characterization of novel thermo- and organic solvent–stable keratinase and aminopeptidase from Pseudomonas aeruginosa 4–3 for effective poultry feather degradation

Environmental Science and Pollution Research - Feather biodegradation is an important premise for efficient resource development and utilization, in which keratinase plays an important role....     

Engineering risk assessment for emergency disposal projects of sudden water pollution incidents

Without an engineering risk assessment for emergency disposal in response to sudden water pollution incidents, responders are prone to be challenged during emergency decision making. To address this gap, the concept and framework of emergency disposal engineering risks are reported in this paper. The proposed risk index system covers three stages consistent with the progress of an emergency disposal project. Fuzzy fault tree analysis (FFTA), a logical and diagrammatic method, was developed to evaluate the potential failure during the process of emergency disposal. The probability of basic events and their combination, which caused the failure of an emergency disposal project, were calculated based on the case of an emergency disposal project of an aniline pollution incident in the Zhuozhang River, Changzhi, China, in 2014. The critical events that can cause the occurrence of a top event (TE) were identified according to their contribution. Finally, advices on how to take measures using limited resources to prevent the failure of a TE are given according to the quantified results of risk magnitude. The proposed approach could be a potential useful safeguard for the implementation of an emergency disposal project during the process of emergency response.

     

Do herbicide treatments reduce the sensitivity of mosquito larvae to insecticides?

Invasive mosquitoes are economic and sanitary concerns especially in Europe and America. Most work has emphasized the role of resistance [Berrada, S., Fournier, D., Cuany, A., Nguyen, T.X., 1994. Identification of resistance mechanisms in a selected laboratory strain of Cacopsylla pyri (Homoptera: Psyllidae): altered acetylcholinesterases and detoxifying oxidases. Pesticide Biochemistry and Physiology 48, 41-47; Hemingway, J., Hawkes, N.J., McCarroll, L., Ranson, H., 2004. The molecular basis of insecticide resistance in mosquitoes. Insect Biochemistry and Molecular Biology 34, 653-665] to insecticides. Compounds acting on larval sensitivity to insecticides are not well studied and their action remains poorly understood. Among several residual chemicals in ecosystems, particularly in wetlands, we identified a possible interaction of an herbicide on larval resistance to an insecticide. Our work contributes to the global control of mosquito populations by identifying possible pathways of resistance to insecticides of these vectors. Resistance or tolerance to insecticide treatments might contribute to successful invasion by mosquitoes. Here we report an ecotoxicological approach to test the hypothesis of an indirect effect of atrazine on mortality of an invasive vector. A brief contact (48h) between Aedes aegypti mosquito larvae and atrazine led to a modification of larval sensitivity to an insecticide: using atrazine as an inducer led to a decrease in the mortality of larvae treated with Bacillus thuringiensis var. israelensis (Bti).     

Toxic components of motor vehicle emissions for the spruce Picea abies

Six-year-old Norway spruce trees were exposed for 30 min under standardised conditions to the exhaust from an Otto engine running on lead-free petrol. Gas-exchange measurements in an open system using an infrared gas analyser showed a sudden, severe drop in CO(2) assimilation and transpiration rates. By using filters which absorbed different fractions of the exhaust it could be demonstrated that the toxic effects can be attributed to the NO(x) fraction.     

Innovative application of facile single pot green synthesized CuO and CuO@APTES nanoparticles in nanopriming of Vigna radiata seeds

Environmental Science and Pollution Research - Nanopriming is an emerging field of science which uses nanoparticles in solution to improve parameters of seed vigor. This leads to an initial...     

Feasibility of iron scraps for enhancing nitrification of domestic wastewater at low temperatures

Environmental Science and Pollution Research - The development of an effective approach to improve low-temperature nitrification of domestic wastewater remains an important issue that needs to be...     

Application of enzyme-mediated cellulose nanofibers from lemongrass waste for the controlled release of anticancer drugs

Environmental Science and Pollution Research - In the present study, an application of cellulose nanofibers has been established for the controlled release of an anticancer drug, i.e.,...     

杭州市环保信访网络系统的研究与开发

在对市环保局信访处理流程研究的基础上，开发一套自动化、无纸化的环保信访处理信息系统。     

Amelioration of toxicopathological effects of cadmium with silymarin and milk thistle in male Japanese quail (Coturnix japonica)

Environmental Science and Pollution Research - Cadmium is an important widely distributed heavy metal in the environment due to its several industrial uses, while milk thistle is an important herb...