Self-Injection of a Dipteran Parasitoid into a Spider

 A host invasion strategy hitherto unknown from other insect parasitoids was observed in the dipteran Acrocera orbicula (Fabricius) (Diptera: Acroceridae) parasitizing the wolf spider, Pardosa prativaga (L. Koch) (Araneida: Lycosidae). In laboratory experiments the free-living first instar acrocerid larvae attached themselves firmly to the spiders' integument by the mouthparts, cutting a tiny hole through the integument. No first instar larvae invaded the host. A week later the parasitoids molted, and a small, flexible, and glabrous second instar larva left each of the attached first instar exuviae and invaded the host through the attachment hole of the first instar larva. The novel host invasion pattern observed may reduce physical damage to the host in the initial phase of endoparasitism, enhancing parasitoid survival. Received: 14 April 1999 / Accepted in revised form: 2 July 1999     

Attributes of a hopper-predator community in a rice field

A hopper-predator community in an experimental rice field was observed weekly with regard to information content (H′), formation of a geometric series or the grade of orderly distribution of component taxa (R²), and clumping index (I). These community attributes changed with time in close association with one another, and attained the highest values around the heading time of the rice. Significant correlations were found between the density of prey and that of predators when a certain time-lag was assumed for the increase of predators.     

Performance of a novel vertical-flow settler: a comparative study

By increasing particle concentration and G value （root-mean-square velocity gradient） to enhance flocculation, a novel vertical-flow settler was designed to increase sedimentation effectiveness, and to simultaneously improve operational stabilization. Due to the gradual decrease in upward flow-rate of raw water, a floes blanket would form and suspend in the middle section of the settler, not at the bottom as in a conventional clarifier. Enough large floes, resulted from flocculation or fltration, would continuously settle out of the floes blanket, and simultaneously, the floes in raw water or those forming above the blanket would ceaselessly enter the floes blanket. As a result, the floes concentration in the blanket could keep a dynamic balance. The hydrodynamic shear in the blanket was improved by flow separation, which was induced by the abrupt change in flow channel. Due to the floes blanket and improved hydrodynamic shear, flocculation would be enhanced, which was helpful for removing fine particles in raw water. A comparative study showed that the novel vertical-flow settler had a much better performance in the removal of the particles in raw water than a conventional one, when they treated kaolin suspensions of different concentrations （500, 100 and 50 mg/L, respectively） coagulated by polyaluminum chloride（PAC1） at the up-flow rates of 1 and 2 mm/s, respectively.     

Male-biased predation of a cave fish by a giant water bug

Male-biased predation has been described from several epigean species, and in many cases, intrinsic differences between the sexes (such as male ornaments) have been suggested as an explanation. Here we report on male-biased predation of a cave fish (Poecilia mexicana) by an aquatic insect (Belostoma sp.) in a Mexican sulfur cave. P. mexicana use aquatic surface respiration (ASR) to survive in their sulfidic, hypoxic habitat. We found that males typically exhibit more ASR activity than females, which leads to increased exposure to the sit-and-wait predator that catches fish near the water surface. Our finding is novel, because male vulnerability to predation is not directly related to male traits involved in courtship, but rather due to other sexual differences in behavior and ultimately, oxygen demands.     

船运液态二氧化碳储罐爆炸事故的原因分析

在分析船运液态二氧化碳储罐爆炸事故的基础上,近似计算了其物理爆炸的能量,并采用TNT当量计算方法,分别估算了事故的人员死亡区域、重伤区域、轻伤区域的半径和建筑物毁灭性破坏区域的半径;同时根据事故容器设计参数的验算,指出由于对事故容器归属"低温压力容器"和"低温低应力压力容器"的错误划分造成制造材料选用的错误,以及违规使用,从而导致了事故的发生;并针对事故的原因,提出了应引起的反思。     

混凝剂FAS的制备及性能研究

报道利用铜矿渣制取固体混凝剂ＦＡＳ。实验表明,该混凝剂具有优良的除蚀、除色、除ＣＯＤ、除硫性能,尤其对采用常规混凝剂难以除去的亲水性染料,ＦＡＳ有独特的去除效率。对各种模拟废水和实际废水,ＦＡＳ的脱色率为９５％,对ＣＯＤ的去除率则在９０％以上。本文还对ＦＡＳ的混凝脱色机理进行了初步的探讨。     

Characteristics of the pollutant emissions in a tunnel of Shanghai on a weekday

Tunnel displays a typical semi-closed environment, and multitudes of the pollutants tend to accumulate. The samples of gaseous pollutants and particulate matter(PM) were collected from the Xiangyin tunnel at Shanghai to investigate the characteristics of the pollutant emissions. The results indicated that both gaseous pollutants and PM exhibited much higher concentrations during the rush hours in the morning and at night due to vehicle emission. Two peaks of the PM concentration were observed in the scope of 0.7‐1.1 and 3.3–4.7 μm, accounting for 14.6% and 20.3% of the total concentrations, respectively.Organic matter(OM), EC, and many water-soluble ions were markedly higher at the rush hours in the morning than those at night, implicating comprehensive effects of vehicle types and traffic volume. The particle number concentrations exhibited two peaks at Aitken mode(25 nm and 100 nm) and accumulation mode(600 nm), while the particle volume concentration displayed high values at the accumulation mode(100–500 nm) and coarse mode(2.5–4.0 μm). The peak around 100 nm was detected in the morning rush hours, but it diminished with the decrease of the traffic volume. Individual-particle analysis revealed that main particles in the tunnel were Fe-rich particles, K-rich particles, mineral particles,Ca–S rich particles and Al–Si particles. The particles collected at the rush hours displayed marked different morphologies, element concentrations and particle sizes compared to the ones collected at the non-rush period. The data presented herein could shed a light on the feature of vehicle emissions.     

喷射火焰对容器的热辐射计算

液化气体容器在火灾环境下由于内部压力升高和容器本身强度的下降，爆炸的危险性极大。研究容器在喷射火焰作用的响应规律是预防事故发生的关键。本文研究了由于气体泄漏引起的喷射火焰在有风条件下的火焰形状和温度变化规律，以及对于水平圆柱形容器的热辐射影响，并用编制计算程序进行了数值计算。计算结果表明，容器表面的热辐射随风速、容器表面的位置等因素而变化。风速越大，容器表面的热辐射会减少；轴向距离越大，热辐射减少，周向角度增加，热辐射减少。     

Field survey of a sustainable sanitation system in a residential house

Sustainable sanitation is an approach for more ecological and sustainable water resources management. In this paper, we proposed one of the new integrated waste treatment systems： an ＂sustainable sanitation system＂ that includes separation of the black water from water system by a non-flushing toilet （bio-toilet）, and a gray water treatment based on a biological and ecological concept. Sustainable sanitation system also converts the domestic waste to soil conditioners and fertilizers, for farmland use. As one of the case studies, Environmentally Symbiotic Housing in which people actually live using the bio-toilet for the black water treatment and the household wastewater treatment facility for the gray water was introduced. The availability of this system was investigated by analyzing the sawdust used in the bio-toilet and the quality of the effluent in the household wastewater treatment facility. As the result, the water content of the sawdust did not exceed 60% in any of the sampling points and the BOD and COD of the effluent of the household wastewater treatment facility were below 10 and 20 mg/L respectively, due to the low loading. Compared to the pollution load on the water environment created by the conventional system, it was found that the effluent of the house has a lower load than the tertiary treatment and the volume of the water consumption is 75% of the conventional system.     

某石化企业粉体料仓爆燃事故原因分析

本文以某企业HDPE料仓的一次爆燃事故为案例,通过分析事故的成因,提供了调查料仓事故的思路及整改方案的确定方法.     

Ultrasonographic diagnosis of a fetal abdominal mass: A case of a mesenchymal liver hamartoma and a review of the literature

A case of a prenatally recognized hepatic mesenchymal hamartoma is presented and the literature reviewed. These tumors are benign and usually present in early infancy with symptoms that are related to the mass effect on adjacent organs. Radiologic methods used in the past to image this tumor include angiography and ultrasound. However, there is no specific radiologic finding, and, therefore, the diagnosis is usually made during surgery. Once the tumor is removed, the prognosis is generally good. With the increasing use of high resolution ultrasound in prenatal diagnosis, this rare tumor should be considered in the differential diagnosis of any multicystic mass found in the fetal abdomen. The recognition of a mass should then alert the physician to the need for early neonatal intervention.     

Development of a unique topology for a hard-turning micro-scale machine tool

A micro-scale machine tool (mMT) topology is developed for turning hardened steel bearing components. The topology utilizes the principle of leverage to increase accuracy and stiffness and incorporates decoupling to reduce unwanted motion of the tool. Performance specifications required that the static stiffness is at least 10 N/μm and dynamic stiffness is at least 30 N/μm in all directions. The kinematics for the topology are developed to enable control over the position and orientation of the tool tip. The effect of the topology on rake angle is determined and the topology is adjusted so as to minimize the rake angle variation during the cut. Cutting tests are performed to determine cutting parameters for achieving a low surface roughness and to estimate the accuracy of the machine. Tests show that the hard-turning mMT can achieve surface roughness below 25 nm Ra, diametrical accuracy of 1 μm and peak-to-valley roundness deviation (RONt) below 0.35 μm.     

Analysis of a laser process for permanently degrading a photo-activated adhesive joint

A pulsed, laser process has been developed to reduce the permanent strength of photo-activated adhesive joints prior to work-piece de-bonding. The objective of this investigation was to gain insight into the relationships between carbon black content of the adhesive, laser delivery mode, heat transfer, and adhesive degradation. To do so, a variety of experiments were performed to characterize process sensitivity, radiation absorption within the adhesive joint, and thermal decomposition of the adhesive. In addition, heat transfer analysis was conducted to predict adhesive temperatures during the process.The results of this investigation indicate that the strength diminishment of an adhesive joint occurs after it has absorbed a train of high power pulses in rapid succession. The vast majority of strength diminishment occurs over a very narrow time window and is highly correlated to the rapid emission of gray smoke/vapor from the adhesive joint. For this to occur, the adhesive must contain carbon black. It is also highly correlated to a rapid increase in temperatures throughout the adhesive matrix. Laser pulse parameters that do not lead to this rapid increase, will not initiate adhesive degradation.The inclusion of carbon black into the adhesive promotes heat absorption and increased temperatures in the adhesive joint. These temperatures are large enough to enable adhesive decomposition. But the time span over which this happens is too small for significant damage to occur. It is currently hypothesized that high temperatures local to the carbon black particles may be the source of adhesive degradation.     

Spontaneous resolution of a cystic hygroma in a fetus with Turner syndrome

The prenatal detection of a cystic hygroma (CH) in a fetus with a 45,X karyotype is described. The cystic hygroma underwent spontaneous resolution and a healthy baby with Turner syndrome was subsequently born. The implications for genetic counselling are discussed.     

传统给水处理厂氯消毒模型的开发与应用

以建立给水处理过程的风险分析方法为目标,提出了适用于传统给水处理工艺的氯消毒概率机理模型.模型既考虑氯消毒过程中有机物、余氯、氨氮、溴离子之间化学反应,又考虑水厂混凝、沉淀和过滤工艺过程中的物理和生物作用.典型水厂的现场监测数据表明,该模型能够较好地模拟水厂中高锰酸盐指数、氨氮以及4种三卤甲烷的浓度概率分布.Monte Carlo模拟的结果表明,与我国城市供水水质标准相比,该水厂高锰酸盐指数和单种三卤甲烷的超标概率极低,但总三卤甲烷的超标概率略高,约为2.3%.