碘化阶层孔氧化硅纳米球对水中典型有机氯污染物的吸附性能研究

采用共缩聚法,成功地原位合成了碘改性的阶层多孔氧化硅纳米球（SiO₂-I）,研究了其基于卤键作用对典型有机氯污染物六六六的吸附性能,并考察了改性剂I-硅烷含量和pH值对吸附效果的影响.实验结果表明,该纳米材料对六六六表现出优异的吸附富集性能,吸附速率快,60 min内对六六六的去除率为71.6%,240 min内达到吸附平衡,去除率可达98.3%,最大吸附量为178.6 mg·g^-1;吸附动力学符合拟二级动力学模型;碘物种的加入提高了阶层多孔氧化硅的吸附速率和吸附效率.另外,为了便于纳米吸附材料的分离,本研究对SiO₂-I纳米球进行了磁性化.研究发现,磁性化修饰后,SiO₂-I纳米材料仍然保留对六六六优异的吸附富集性能,240 min时的吸附去除率达90.3%.     

酸性紫色水稻土颗粒有机质对镉的吸附特性

采集典型的酸性紫色水稻土（APPS）,从中分离出颗粒有机质（POM）,通过批量试验研究POM及其来源土壤Cd²⁺的吸附动力学、等温吸附和热力学特征,通过扫描电镜-能谱仪、傅里叶红外光谱仪等手段及吸附前后镉的形态变化的测定,研究了POM对Cd²⁺的吸附机制.结果表明：POM对Cd²⁺的亲和力远高于其来源土壤.POM及土壤对Cd²⁺的吸附动力学最优模型均为准二级动力学.Langmuir、Freundlich方程均能较好地描述其等温吸附特征,其中对POM,以Freundlich方程更优,表明POM对Cd²⁺的吸附属于多分子层的非均质吸附.吸附热力学参数△G^θ均小于0、△H^θ和△S^θ均大于0,表明吸附属于自发吸热过程.根据△H^θ值及解吸试验判定POM对Cd²⁺的吸附以化学吸附为主,土壤对Cd²⁺的吸附过程以物理吸附为主.吸附平衡后,土壤中可交换态镉比例提高,而POM中交换态和络合态镉比例增加.综上及吸附前后POM的表征结果说明,POM对Cd²⁺的吸附机制包括含氧官能团的络合、离子交换、阳离子-π键、沉淀作用和静电吸附.     

硅胶表面TEOS疏水化改性及吸附VOCs特性

以正硅酸乙酯（TEOS）为疏水改性剂,通过硅胶表面的羟基接枝反应,得到具备一定疏水性的改性硅胶;利用BET、FT-IR、XRD和TG-DTG等手段对改性硅胶的结构及稳定性进行了表征;在此基础上考察了改性硅胶对各类有机废气的吸附性能.结果表明,TEOS成功接枝在了硅胶表面,改性硅胶不仅具备一定的疏水性,而且机械强度增加到原来的66.85%,稳定性也都得到了提高; 550℃空气下焙烧后的改性硅胶仍具有疏水性且吸附容量是焙烧之前的2倍;在高湿度高浓度的废气治理中,TEOS改性硅胶表现出更高的吸附能力和优良的热再生性能.高浓度下改性硅胶的吸附容量是低浓度下的10倍且不受水汽的影响;改性硅胶循环10次的吸附/脱附几乎不变,且在一定条件下,15~30min就达到90%的脱附率.     

磁性有序介孔碳的制备及其对水中双酚A的吸附

采用水热法成功制备了磁性有序介孔碳（Fe-OMC）,用于吸附水中双酚A （BPA）.采用高倍投射电镜、X射线衍射仪、傅里叶红外光谱仪、比表面积分析仪和振动样品磁强计对Fe-OMC进行表征.结果表明,该吸附剂具备较大的比表面积、独特的有序介孔孔道结构、丰富的含氧官能团以及较强的超顺磁性.Fe-OMC能够高效地吸附去除水中的BPA,平衡吸附量可达72.62mg/g,经过外加磁场分离回收后依旧具备较好的吸附性能.随着BPA浓度从1mg/L提高到20mg/L,其平衡吸附量由8.33mg/g增至91.78mg/g.随着pH值的升高呈现出先降低后升高再降低的趋势,最高吸附量出现在pH=8（75.34mg/g）.Fe-OMC对BPA的吸附过程可用准二级吸附动力学模型和Langmuir吸附等温模型进行描述.计算的热力学参数表明,Fe-OMC对BPA的吸附过程是自发进行的放热过程.     

基于铁锰泥的除砷吸附剂性能比较及吸附机理

为解决反冲洗铁锰泥粉末吸附剂（BSPA）使用后难以泥水分离问题,将除铁锰水厂生物滤池产生的反冲洗泥制成颗粒吸附剂（GA）和磁性粉末吸附剂（MPA）,并对BSPA、GA和MPA的除砷性能进行了比较,通过SEM、TED、XRD、BET、FTIR等技术对3种材料进行了表征,寻找3种吸附剂之间除砷性能差异的根源.结果表明,BSPA、GA和MPA对As （V）的最大吸附容量分别为40.980,5.048,8.694mg/g,改性后的吸附材料GA和MPA对砷的吸附能力下降.BSPA是一种以纤铁矿为主的无定形结构混合物,并混有针铁矿和结晶度差的水铁矿,GA的XRD图谱中出现石英晶体和少量赤铁矿晶体的衍射峰,而MPA的主要成分为结晶程度较高的磁赤铁矿.3种材料中均存在有利于吸附的含羟基官能团.BSPA、MPA和GA的比表面积分别为253.150,238.660,43.803m²/g.物相改变且结晶程度增加、表面羟基减少和比表面积降低是导致GA和MPA的砷吸附容量比BSPA低的主要因素.     

Large-scale mercury variations in Lake Vänern (Sweden) 1974-98

Lake V?nern, the largest lake in Sweden, has been seriously contaminated with mercury during the 20th century. In the 1970's and 80's the direct load, mainly from a chlor-alkali industry in the area, of mercury was drastically reduced as a response to new legislation, from three to five tons down to between five and ten kg yr(-1). Large amounts of the disposed pollutant have accumulated in the sediments. The question posed in this work is now, is the effect of the drastic load reduction after more than two decades visible in the sediments? The question is relevant as large areas still are blacklisted for fishing, but also as a follow-up of a major remedy action. The lake also serves as a freshwater reservoir for even Sweden's second largest city. This work synthesises and compares data of mercury in the sediments from three major field programs, in 1974, 1984 and 1998. The interest is focused on both spatial heterogeneity and temporal trends. In 1974, the surface concentrations are significantly higher than in subsequent surveys. Significant differences are also found between 1984 and 1998. Significant spatial differences within the lake are found for respective year. The most contaminated area is located in the north, close to the major point source (a former chlor-alkali industry). This is also the area with the largest improvement, as a direct response to the reduction in load. Further from the outlet, the recovery is more affected by burial and transport processes out into the deeper basins.     

Exposure Assessment to Mercury Vapor in Chloralkali Industry

The aim of the study was to develop a sampling method aimed at individual sampling of mercury vapor and subsequent individualexposure assessment of the worker. Hopcalite available fromInowrocawskie Zakady Chemiczne (in Poland) was founduseful for mercury vapor sampling in active and passive individual samplers. However the sampling rate determined forpassive sampler in steady-state laboratory chamber cannot be usedunder fluctuating conditions of mercury vapor concentration andair movement typical for field measurement. In order to check comparativeness of passive and active sampling methods, sampleswere taken in the same time and individual samplers fixed toworker's clothes were used. Mercury vapor concentration wasmeasured at two chloralkali industries in Poland and the resultswere presented. Excessive exposure in both industries wasconfirmed by finding elevated mercury concentration in urinesamples from the workers.     

MERCURY EMISSION INVENTORY IN ONTARIO

Mercury is released to the environment from various anthropogenic and natural sources. This work is a compilation of mercury emissions from anthropogenic sources in Ontario, Canada. The goal of our study was to identify all sources of mercury, and develop an emission inventory of anthropogenic mercury in Ontario. The result of our investigation revealed that combustion of fossil fuels and emissions from landfill sites are two primary sources of mercury to the atmosphere. Other sources of significance are emissions from waste incinerators, various industrial activities, and cement production. Total mercury emission in Ontario is estimated as 4100 kg per year.     

中国黄土元素背景值分异规律研究

报道了中国黄土中40个元素的背景值,并以F、Cr、Mn、Co、Ni、V、Cu、Zn、As、Se、Cd、Pb、Hg等13个元素为例,讨论了其在黄土高原的分布与含量。利用趋势面分析等数理统计方法,揭示了黄土中元素的某些环境地球化学特征及元素背景值的分异规律。结果表明,黄土的元素背景值具有三维的分异特征,黄土的质地及沉积的生物气候环境黄土是影响背景值分异的主要因素。为中国黄土的风成学说提供了佐证。     

黄磷尾气中单质磷的测定

研究了测定黄磷尾气中单质磷的分析方法 ,该方法具有灵敏度高 ,线性好 ,操作快速、简便的特点 ,检测限 1μg 5mL ,摩尔吸光系数为 4 5× 10 4L mol·cm ,线性相关系数为 0 9998