Stability of a Coal Waste Artificial Reef

The feasibility of using U.K. coal-fired power station waste materials for artificial reef production is being examined. in June, 1989, an experimental artificial reef was constructed in Poole Bay, off the central south coast of the U.K., using three different mixtures of pulverised fuel ash (PFA), flue gas desulphurisation (FGD) gypsum and slurry, stabilized with cement and formed into blocks. Fifty tonnes of 40 × 20 × 20 cm blocks were formed into eight conical reef units replicating three different PFA/gypsum mixtures and one concrete control. the reef structure is 10m below chart datum on a flat sandy sea-bed.

Combustion of coal concentrates the heavy metal content in the resultant ash. the purpose of stabilization of the ash as blocks is twofold: to immobilize heavy metals (or other components) and to provide hard substratum for the attachment of organisms. to examine the effectiveness of this stabilization and hence the environmental compatibility of the block materials, heavy metal (Cd, Cr, Cu, Pb, Mn, Ni, Zn) content of the blocks has been monitored routinely over two years, to determine leaching rates. Sectional profiles indicate partial replacement of calcium content by magnesium. Associated with this there has also been some redistribution of heavy metals. Only in the case of cadmium has there been a detectable loss from the surface of blocks. Chromium and manganese concentrations appear to have increased. the metal content of the reef epibiota (including ascidians, Ascidia mentula; hydroids, Halecium spp.; bryozoans, Bugula spp. and red algae) growing on the ash blocks has been compared to that of epibiota attached to the concrete controls and surrounding sea-bed. to date no evidence of excess bioaccumulation of metals has been detected.

The physical integrity of the ash reef blocks has been maintained. There is evidence that the blocks are increasing in compressive strength.

An indication of the fishery enhancement potential of the experimental structure is given by the presence of eight commercially fished species (crustaceans and molluscs) including lobsters (Homarus gammarus).     

乙醇汽油与普通汽油非常规污染物排放特性对比研究

在一台满足国Ⅴ排放标准的双喷射(气口喷射+缸内直喷)汽油机上开展了燃用E10乙醇汽油(乙醇体积比为10%)对发动机非常规排放特性影响的试验研究.使用傅里叶变换红外分析仪(FTIR)测量了饱和烃、不饱和烃、芳香烃及醇、醛等非常规污染物排放量,对比分析了双喷射模式时各工况下E0和E10两种燃料的非常规排放水平.结果表明,双喷射模式下,加入乙醇有效降低了乙烯、1,3-丁二烯、苯和甲苯的排放量,但会导致乙醛排放升高.双喷射模式下,随着负荷增加,两种燃料下的1,3-丁二烯和甲苯排放呈现先升高后降低的趋势,乙烯、甲醛和苯排放则先降低后升高.乙醇能抑制1,3-丁二烯、乙烯生成,抑制效果为PFI模式优于双喷射模式,GDI模式抑制量最低.PFI和GDI模式下E10的甲醛排放均显著升高,但双喷射模式有效抑制了甲醛排放的增加.     

基于遥感尾气监测的柴油车气态污染物排放因子计算方法研究

采用遥感尾气测试系统实测了柴油车在实际道路工况下的CO、HC和NO排放特征,修正了排放因子的计算方法,并与车载排放测试系统（PEMS）实测结果进行了验证,获得了实测车辆的CO、HC和NO排放因子.测试结果显示,在各种遥感监测的工况下柴油车尾气中均含有较高浓度的氧气,未考虑氧气影响的燃烧方程反演获得的各污染物体积浓度计算值与PEMS实测值的偏差较大,且氧气浓度越大,偏差越大.经过氧气修正的燃烧方程反演计算的尾气浓度与PEMS实测值吻合度大幅提升,适用于实际工况下遥感检测车辆尾气的反演计算.修正算法得到CO、HC和NO的排放因子离散性较小,精确度较高,可以为量化柴油车尾气排放贡献提供科学依据.     

DOC+CDPF对国III重型柴油货车实际道路排放的影响

利用便携式车载排放测试系统（PEMS）对2辆加装氧化催化转化器（DOC）和催化型柴油颗粒捕集器（CDPF）与否的国III重型柴油货车进行实际道路排放测试.结果表明,2辆改造重型柴油车的CO、THC、固态颗粒物粒数（SPN）和黑碳（BC）实际道路排放因子分别为（1.31±0.37）g/（kW×h）、（0.20±0.03） g/（kW×h）、（7.13×10¹⁰±5.27×10¹⁰）个/（kW×h）和（0.69±0.06）mg/（kW×h）,相对于原始排放（拆除DOC+CDPF）分别降低52.48%、55.69%、99.91%和99.22%.从低速、中速到高速,CO和THC减排比例呈现上升趋势,然而运行工况对SPN和BC减排比例则无显著影响.加装DOC+CDPF会导致NO₂在NO_x中的占比升高,且从低速、中速到高速涨幅依次增大,但对NO_x无明显减排效益,其排放因子为9.53~9.83g/（kW×h）,远高于实验室排放限值.     

Investigation to meet China II emission legislation for marine diesel engine with diesel methanol compound combustion technology

In order to reduce the pollutant emission and alleviate the pressure of petroleum resources shortage and greenhouse gas emission at the same time, the use of clean and renewable alternative fuel for marine engines is a promising option. In this study, a marine diesel engine, which was modified to run in diesel methanol compound combustion (DMCC) mode, was investigated. After the diesel injection parameters were calibrated, and combined with a sample after-treatment device DOC (diesel oxidation catalyst), the engine could meet the requirements of China II legislation. The overall MSP (methanol substitute percent) reached 54.1%. The value of each pollutant emission was much lower than that in China II emission legislation, and there was almost no methanol and formaldehyde emissions. When methanol was injected into the inlet manifold, the intake air temperature decreased a lot, as well as the exhaust gas temperature, which were beneficial to increase engine thermal efficiency and improve engine room environment. Compared with the engine running in pure diesel mode, when the engine ran in diesel/methanol dual fuel mode, the combustion phase was advanced, and the combustion duration became shorter. Therefore, the engine thermal efficiency increased, and fuel consumption decreased significantly.     

珠江口夏季海陆源有机碳的模拟研究——分布特征、贡献比重及其迁移转化过程

基于经过验证的三维水动力-水质模型,对珠江口夏季有机碳进行海陆源区分,并对海陆源有机碳的分布特征、贡献比重及其通量过程进行研究.结果表明,水平方向上,珠江口夏季陆源（海源）有机碳浓度从口门到外海逐渐降低（升高）,在表、底层海水中平均浓度分别为1.45和0.87mg/L（0.97和1.05mg/L）;垂直方向上,在层化水域陆源（海源）有机碳浓度从上到下逐渐递减（升高）,在非层化水域海陆源有机碳浓度垂向分布较为均匀.珠江口夏季海源有机碳贡献率表层海水低于底层海水,平均贡献率为48.26%,沿向海方向海源有机碳贡献率逐渐增加--从内伶仃洋水域的4.43%逐渐提升到外伶仃洋东侧水域的81.20%.珠江口水动力条件复杂,在径流、潮汐、季风等因素的作用下陆源有机碳向海输送且向海输送量逐渐递减;海源有机碳在不同水域动力输送特征不同,西南水域向海输送,向海输送量逐渐递增;东北水域向岸输送,向岸输送量逐渐递减.陆源有机碳生化反应活性较弱,只有小部分被生化过程消耗,其迁移转化主要由沉降过程控制,而海源有机碳的迁移转化,则由口门的动力输送过程主控向外海的生化耗碳过程主控过渡.此外,海源有机碳沉降作用明显低于陆源有机碳,生化作用明显高于陆源有机碳.     

中国沿海省市海洋生态补偿效率评价

本文运用考虑非期望产出的超效率SBM模型、DEA-Malmquist指数模型、Tobit模型和标准差椭圆模型,对2006-2016年中国11个沿海省市的海洋生态补偿效率开展测度和分析,结果显示：2006~2016年中国总体海洋生态补偿效率平均值为0.633,处于中等效率水平,随时间呈“下降-上升-稳定”的趋势;海洋生态技术进步依旧是海洋生态补偿过程中全要素生产率的重要驱动力,但面临一定的技术效率损失;海洋第三产业比重对海洋生态补偿效率值有正向的显著影响,城市化率、进出口总额占比和海洋灾害直接经济损失对海洋生态补偿效率存在显著的负向影响;海洋生态补偿效率的空间聚集性增强,区域不平衡性有所收敛,空间分布格局基本保持稳定.     

Potential of secondary aerosol formation from Chinese gasoline engine exhaust

Light-duty gasoline vehicles have drawn public attention in China due to their significant primary emissions of particulate matter and volatile organic compounds(VOCs). However,little information on secondary aerosol formation from exhaust for Chinese vehicles and fuel conditions is available. In this study, chamber experiments were conducted to quantify the potential of secondary aerosol formation from the exhaust of a port fuel injection gasoline engine. The engine and fuel used are common in the Chinese market, and the fuel satisfies the China V gasoline fuel standard. Substantial secondary aerosol formation was observed during a 4–5 hr simulation, which was estimated to represent more than 10 days of equivalent atmospheric photo-oxidation in Beijing. As a consequence, the extreme case secondary organic aerosol(SOA) production was 426 ± 85 mg/kg-fuel, with high levels of precursors and OH exposure. The low hygroscopicity of the aerosols formed inside the chamber suggests that SOA was the dominant chemical composition. Fourteen percent of SOA measured in the chamber experiments could be explained through the oxidation of speciated single-ring aromatics. Unspeciated precursors, such as intermediate-volatility organic compounds and semi-volatile organic compounds, might be significant for SOA formation from gasoline VOCs. We concluded that reductions of emissions of aerosol precursor gases from vehicles are essential to mediate pollution in China.     

海洋环境低水位加速腐蚀研究进展

以海洋环境中一个非常重要的局部腐蚀形式——低水位加速腐蚀(ALWC)为对象,自其检测、发生原因、防护三个方面就国内外的文献报告进行综述分析。在检测方面,首先介绍了常用的宏观观察这一被动形式,并突出其特征,然后介绍了利用海水中可溶性无机氮含量作为ALWC发生概率预测这一主动形式,分析其优势与不足。在发生原因方面,在对将ALWC认定为一种典型的微生物腐蚀(MIC)形式的认知过程进行介绍之后,重点分析了微生物对ALWC作用机制不清晰的原因,并建议在后续研究中突出动态演变过程,结合高通量测序等分子生物学技术,确定在不同的阶段影响ALWC的关键微生物,且进一步在大气-海水体系下研究典型菌株及其协同作用的影响,提出微生物对ALWC的作用机制。在防护方面,根据新建和已建钢结构设施分别对传统和针对ALWC所具有的MIC与局部腐蚀特性的新型高效防护方法进行了介绍,并分析了防护方法的优缺点。     

柴油机尾气中PAH_s的分析

本文概述了柴油机尾气中ＰＡＨｓ的分析方法，着重论述了采样及预处理方法，特别对预处理方法进行了深入的探讨。另外，通过对柴油机两种不同工况下产生的尾气进行分析后发现，柴油机转速越高，其排放尾气中ＰＡＨｓ的含量就越低。