Effects of leachate accumulation on landfill stability in humid regions of China

Leachate levels are important to landfill stability and safety. High leachate or water levels often lead to landfill instability, which can cause accidents. Here a case study of a landfill located in a humid region of southern China is presented. Leachate distribution and quality were systematically analyzed, and the effect of leachate level on waste-mass stability was assessed. Boreholes were drilled in the field, samples were analyzed in the laboratory, and a simulation was performed. In addition, the safety and stability of the landfill was evaluated. The leachate level in the landfill was 9–19 m, which was higher than the top of the dam crest (8–20 m). Leachate accounted for more than 1/4 of the total landfill storage capacity. The contaminant concentration of the leachate samples collected directly from the waste body was very high, with large variation among the samples. The mean concentrations of NH₃–N, BOD, and COD from the waste body were 5404, 14,136, and 22,691 mg/L, nearly 2.7, 2.4, and 1.8 times the mean concentrations in the leachate pond, respectively. Three series of shear strength parameters were used in a slope stability analysis, and a limit equilibrium method was used to calculate the factor of safety (Fs). The analysis showed that Fs could be affected by potential anisotropy in the shear strength of the waste. The minimum values of Fs corresponding to series I were 1.84 and 1.17 for units ? and II, respectively. The Fs value of unit II was significantly lower than the safe design value (1.25). In addition, Fs decreased with increase in the normalized height of the leachate level, h/H, where h is the height of the leachate mound and H is the maximum thickness of the landfill. If the h/H values of units I and II are kept below 50% and 40%, respectively, a safe design value of 1.25 for Fs can be guaranteed. Therefore, some measures to prevent risk should be considered.     

响应面法优化聚丙烯酸/腐殖酸/累托石吸附剂的制备条件

以累托石、丙烯酸及腐殖酸为原料制备出能同时吸附重金属和多环芳烃的吸附剂聚丙烯酸/腐殖酸/累托石,采用响应面试验设计法优化吸附剂的制备条件。利用Design Expert软件,建立了预测吸附剂对Cd2+、菲吸附量的二次回归模型,对回归模型进行了方差分析,并确定了吸附剂的最佳制备条件。结果表明,二次回归模型能较好地模拟Cd2+、菲的吸附量与影响因子丙烯酸中和度、引发剂量和交联剂量之间的关系。各因子对Cd2+吸附量的影响次序为:交联剂量>引发剂量>丙烯酸中和度;对菲吸附量的影响次序为引发剂量>交联剂量>丙烯酸中和度。吸附剂的最佳制备条件为:累托石、丙烯酸和腐殖酸三者的质量比为65∶30∶5,丙烯酸中和度、引发剂量和交联剂量分别为75.16%、2.57%和0.44%。在此优化条件下制备的吸附剂对Cd2+和菲的吸附量分别为170.19 mg/g和7.36 mg/g。     

垃圾焚烧炉炉膛温度的影响因素

垃圾焚烧过程的不稳定会导致大量有害物质的生成,为确保垃圾的清洁燃烧需要将炉膛温度控制在850℃以上,为此测试了焚烧炉运行的主要可控参数对炉膛温度的影响。结果表明,垃圾堆放位置在垃圾池深3～8 m处,并经过6 d以上发酵脱水后适合焚烧;炉膛温度随给料量、一次风率和一次风温增加而增大,随过量空气系数增加而降低,其中给料量宜控制在95%～110%之间;当过量空气系数为1.6、一次风率为90%、一次风温为260℃、给料量为100%时炉膛温度达901℃。     

Dechlorination of PCBs in the simulative transformer oil by microwave-hydrothermal reaction with zero-valent iron involved

The conventional hydrothermal reaction with iron powder, NaOH and H₂O as reactants was reported to occur at temperature above 423 K, and iron oxides (Fe₃O₄ and NaFeO₂) and hydrogen were produced. In this study, microwave heating was adopted to take the place of conventional heating to induce the hydrothermal reaction. Under microwave irradiation, NaOH and H₂O absorbed microwave energy by space charge polarization and dipolar polarization and instantly converted it into thermal energy, which initiated the hydrothermal reaction that involved with zero-valent iron. X-ray diffraction (XRD) analysis found Fe₃O₄/NaFeO₂ and confirmed the occurrence of microwave-induced hydrothermal reaction. The developed microwave-hydrothermal reaction was employed for the dechlorination of PCBs. Hexadecane containing 100 mg L⁻¹ of Aroclor1254 was used as simulative transformer oil, and the dechlorination of PCBs was evaluated by GC/ECD, GC/MS and ion chromatography. For PCBs in 10 mL simulative transformer oil, almost complete dechlorination was achieved by 750 W microwave irradiation for 10 min, with 0.3 g iron powder, 0.3 g NaOH and 0.6 mL H₂O added. The effects of important factors including microwave power and the amounts of reactants added, on the dechlorination degree were investigated, moreover, the dechlorination mechanism was suggested. Microwave irradiation combined with the common and cheap materials, iron powder, NaOH and H₂O, might provide a fast and cost-effective method for the treatment of PCBs-containing wastes.     

Estimating the variance in before-after studies

Problem

To simplify the computation of the variance in before-after studies, it is generally assumed that the observed crash data for each entity (or observation) are Poisson distributed. Given the characteristics of this distribution, the observed value (x_i) for each entity is implicitly made equal to its variance. However, the variance should be estimated using the conditional properties of this observed value (defined as a random variable), that is, f(x_i|μ_i), since the mean of the observed value is in fact unknown.

Method

Parametric and non-parametric bootstrap methods were investigated to evaluate the conditional assumption using simulated and observed data.

Results

The results of this study show that observed data should not be used as a substitute for the variance, even if the entities are assumed to be Poisson distributed. Consequently, the estimated variance for the parameters under study in traditional before-after studies is likely to be underestimated.

Conclusions

The proposed methods offer more accurate approaches for estimating the variance in before-after studies.     

张店区水泥行业发展策略

调查发现，张店区水泥行业整体经营粗放，资源、能源消耗高，综合利用水平低，生产能力落后，其生产对环境造成了严重的粉尘、废气和噪声污染。基于此基本情况，根据水泥行业产业政策，建议张店区水泥行业进行工艺创新、材料创新，完善水泥产业链，环保部门要加大监察力度。     

高铁酸钾预处理对活性污泥脱水性能的影响

通过投入不同剂量的高铁酸钾于剩余活性污泥中,研究其对污泥絮体性质和脱水性能的影响作用。污泥絮体性质的研究包括絮体粒径的变化以及污泥EPS含量的变化。脱水性能的研究包括过滤脱水性能(以CST表征)以及脱水程度(离心泥饼含固率)。实验结果表明,高铁酸钾的强氧化性可以破坏污泥絮体结构,提高污泥的机械脱水程度;但同时污泥EPS含量增加,对污泥过滤脱水性能有负面影响。高铁酸钾氧化分解生成的Fe(OH)3具有絮凝能力,可以使污泥颗粒重新絮凝;而其混凝作用可以破坏污泥细胞的稳定性,提高污泥的沉降性能。     

膜吸收法净化低浓度甲醛和氨气简

基于膜吸收技术自制双层平板式膜吸收器，搭建净化低浓度甲醛和氨气污染模拟系统，考察不同膜结构参数、进气流量、吸收剂流量等因素对其净化效果的影响。结果表明，聚偏氟乙烯PVDF对低浓度甲醛和氨气的净化效率高于聚四氟乙烯PTFE。对同一材质膜，随着膜孔隙率的增大，甲醛和氨气的净化率呈上升趋势。随着进气流量的增加，甲醛和氨气的净化效率降低；而吸收剂流量对其净化效率影响不大。对于所有实验条件，平均膜孔径为0.22 μm的PVDF 4^#在进气流量u_g=120 L/h时，甲醛和氨气的净化效率最高，分别达94.7%和96.3%。     

用含固定化微生物的曝气生物滤池处理炼油厂高浓度废水

采用含固定化微生物的曝气生物滤池(G-BAF)处理炼油厂高浓度废水。当G-BAF池进水COD为298～11 278 mg/L时,出水COD为33.0～94.3 mg/L,COD平均去除率为97%;当G-BAF池进水ρ(NH_3-N)为12.1～188.0 mg/L时,出水ρ(NH_3-N)为0.9～49.4 mg/L,NH_3-N平均去除率为83%。经G-BAF处理后出水水质完全达到GB8978—1996《污水综合排放标准》第二类污染物的二级排放标准。     

Enantioselectivity in environmental risk assessment of modern chiral pesticides

Chiral pesticides comprise a new and important class of environmental pollutants nowadays. With the development of industry, more and more chiral pesticides will be introduced into the market. But their enantioselective ecotoxicology is not clear. Currently used synthetic pyrethroids, organophosphates, acylanilides, phenoxypropanoic acids and imidazolinones often behave enantioselectively in agriculture use and they always pose unpredictable enantioselective ecological risks on non-target organisms or human. It is necessary to explore the enantioselective toxicology and ecological fate of these chiral pesticides in environmental risk assessment. The enantioselective toxicology and the fate of these currently widely used pesticides have been discussed in this review article.