Metals emitted from heavy-duty diesel vehicles equipped with advanced PM and NOX emission controls

Emission factors for elemental metals were determined from several heavy-duty diesel vehicles (HDDV) of 1998–2007 vintage, operating with advanced PM and/or NO_X emissions control retrofits on a heavy-duty chassis dynamometer, under steady state cruise, transient, and idle conditions. The emission control retrofits included diesel particulate filters (DPF): catalyzed and uncatalyzed, passive and active prototype vanadium- or zeolite-based selective catalytic reduction (SCR) systems, and a catalyzed DPF fitted on a hybrid diesel electric drive vehicle. The prototype SCR systems in combination with DPF retrofits are of particular interest because they represent the expected emissions controls for compliance with PM and NO_X regulations in 2010. PM samples from a full-exhaust dilution tunnel were collected on bulk filters, and on a Personal Cascade Impactor Sampler (PCIS) for total and water-soluble elemental analysis. All the DPFs significantly reduced emissions of total trace elements (>85% and >95% for cruise and for the Urban Dynamometer Driving Schedule (UDDS), respectively). However, we observed differences in the post-retrofit metals emissions due to driving cycle effects (i.e., exhaust temperature) and type of retrofit. In general, the metals emissions over cruise conditions (which leads to higher exhaust temperatures) were substantially different from the emissions over a transient cycle or while idling. For instance, during cruise, we observed higher levels of platinum (1.1 ± 0.6–4.2 ± 3.6 ng km^?1) for most of the retrofit-equipped vehicle tests compared to the baseline configuration (0.3 ± 0.1 ng km^?1). The vanadium-based DPF + SCR vehicle during cruise operation exhibited emissions of vanadium (562 ± 265 ng km^?1) and titanium (5841 ± 3050 ng km^?1), suggesting the possible release of actual SCR wash-coat (V₂O₅/TiO₂) from the catalyst under the higher temperatures characteristic of cruise operation. The vanadium emissions exhibited a bi-modal mass size distribution, with modes at <0.25 μm and 1.0–2.5 μm size ranges for the vanadium-based SCR system. For the DPF + SCR systems, a greater fraction of the metal emissions from the zeolite-based system is water-soluble compared to emissions from the vanadium-based system.     

A study of emissions from a Euro 4 light duty diesel vehicle with the European particulate measurement programme

The California Air Resources Board, CARB, has participated in a program to quantify particulate matter (PM) emissions with a European methodology, which is known as the Particulate Measurement Programme (PMP). The essence of the PMP methodology is that the diesel PM from a Euro 4 vehicle equipped with a Diesel Particulate Filter (DPF) consists primarily of solid particles with a size range greater than 23 nm. The PMP testing and the enhanced testing performed by CARB have enabled an increased understanding of both the progress that has been made in PM reduction, and the future remaining challenges for new and improved DPF-equipped diesel vehicles. A comparison of measured regulated emissions and solid particle number emissions with the results obtained by the PMP participating international laboratories was a success, and CARB’s measurements and standard deviations compared well with the other laboratories. Enhanced measurements of the influence of vehicle conditioning prior to testing on PM mass and solid particle number results were performed, and some significant influences were discovered. For example, the influence of vehicle preconditioning on particle number results was significant for both the European and USA test driving cycles. However, the trends for the cycles were opposite with one cycle showing an increase and the other cycle showing a decrease in particle number emissions. If solid particle size distribution and total particle numbers are to be used as proposed in PMP, then a greater understanding of the quality and errors associated with measurement technologies is advisable.In general, particle counting instruments gave results with similar trends, but cycle-to-cycle testing variation was observed. Continuous measurements of particle number concentrations during test cycles have given detailed insight into PM generation. At the present time there is significant variation in the capabilities of the particle counting instruments in terms of particle size and concentration.Current measurements show the existence of a large number of volatile and semi-volatile particles of yet-to-be-resolved chemical composition in diesel exhaust, especially during DPF regeneration, and these particles are not included in the PMP methodology because they are smaller than 20 nm. It will be very challenging to improve our understanding of this class of diesel particulate matter.     

Morphology,Chemical Characterization and Sources of Microplastics in a Coastal City in the Equatorial Zone with Diverse Anthropogenic Activities (Fortaleza city,Brazil)

Journal of Polymers and the Environment - The aim of the present study was to perform morphological and chemical characterizations of microplastics (MPs) found in seawater samples from the coast of...     

Macroinvertebrate community response to acid mine drainage in rivers of the High Andes (Bolivia)

Several High Andes Rivers are characterized by inorganic water pollution known as acid mine drainage (AMD). The aim of this study was to assess the relationship between metal concentrations in the sediments and the macroinvertebrate communities in two river basins affected by AMD. In general, the taxon diversity of the macroinvertebrate community at the family level was low. The concentrations of Cd, Cu, Zn, Pb and Ni at mining sites were higher than at unpolluted sites. The pH of the water was alkaline (7.0-8.5) in unpolluted sites, whereas it dropped to very low values (<3) at mining sites. Redundancy Analysis (RDA) showed that pH was the best predictor of macroinvertebrate community richness. The number of macroinvertebrate families decreased gradually with increasing acidity, both in pools and riffles, though it is suggested that riffle communities were more affected because they are in closer contact with the acid water.