Effect of composite amendments on physicochemical properties of copper tailings repaired by herbaceous plants

Environmental Science and Pollution Research - Phytoremediation is considered to be the most environmentally friendly green restoration technology for dealing with mine waste. Adding amendments can...     

内窥镜检查在电站锅炉内部检验中的应用

工业内窥镜是电站锅炉内部检验中不可或缺的设备,主要用来对集箱、减温器、受热面管等内部人眼无法观察到的地方进行检验,从而确定承压部件内部是否存在严重影响锅炉安全运行的缺陷.本文通过对锅炉内窥实例进行分析和总结,阐述内窥镜检查在锅炉内检中的重要性并给相关工作人员提供借鉴与参考.     

南海湖非冰封期浮游植物群落生态特征及其与环境因子关系

分别于2017、2018年的非冰封期(5—10月)对南海湖的浮游植物群落和环境因子进行了调查。共发现浮游植物7门80属157种(含变种),其中绿藻门种数最多,其次是硅藻门和蓝藻门,时间上7月最多、10月最少,空间上呈东高西低、南高北低的趋势。浮游植物密度为23.35×10~6～126.00×10~6个/L,平均值为66.78×10~6个/L。主要优势种有微小平裂藻(Merismopedia tenuissima)、水华束丝藻(Aphanizomenon flosaquae)和螺旋弓形藻(Schroederia spiralis)。南海湖水质总体处于中污染状态。冗余分析表明,TN、TP、pH和温度是影响浮游植物分布的主要环境因子,绿藻门与TN关系密切,蓝藻门与TP、温度关系密切,硅藻门与pH关系密切。     

石化行业的VOCs排放控制管理

概述了我国挥发性有机化合物（VOCs）的排放情况。介绍了国内外VOCs的管理现状。分析了国内石化行业VOCs排放控制管理中存在的主要问题以及污染物排放过程的类别。提出了明确定义、制定相关标准、完善分类管理体系、研究最佳的可行性控制技术等加强VOCs排放控制管理的对策和建议。     

渤海排污口邻近海域异养细菌的组成与分布

对渤海4个重点监测排污口（北塘、大蒲河、弥河和虞河）邻近海域异养细菌的组成和分布进行了调查研究。结果表明，分离到的各排污口邻近海域的细菌隶属于变形菌门（Proteobacteria）、厚壁菌门（Firmicutes）、放线菌门（Acti-nobacteria）和拟杆菌门（Bacteroidetes）4个细菌类群，其中变形菌门的细菌最丰富。各排污口的优势菌有所不同，北塘、弥河2个采样点的优势菌分别为Bacillus sp．、Pseudoalteromonas sp．，大蒲河采样点的优势菌为Vibrio sp．和Oceanospirillum sp．，虞河采样点的优势菌为 Shewanella sp．和 Bacillus sp．。多维尺度分析表明，北塘和虞河采样点的细菌种群特征较相近，细菌种群分布特征可能与排污口的海洋环境有一定的相关性。     

An investigation on pollutant emissions from co-firing of RDF and coal

Pollutant emissions from co-firing of refuse derived fuel (RDF) and coal were investigated in a vortexing fluidized bed combustor (VFBC). RDF-5 was made of common municipal solid waste (MSW). CaCO₃ was injected in the combustor to absorb HCl at 850 °C. The results show that NO_x and HCl emissions increase with RDF-5 co-firing ratio. The NO_x concentration in flue gas at the bottom of the combustor is higher than that at the top. However, the trend of HCl released is reverse compared with NO_x emissions. It was found that the HCl concentration decreases with increasing the molar ratio of Ca/Cl. However, the effect of CaCO₃ addition on HCl retention is not significant when the molar ratio of Ca/Cl is higher than 5. The chlorine content in fly ash increases obviously with the molar ratio of Ca/Cl. PCDD/Fs emissions decrease slightly with an addition of CaCO₃. In this study incomplete combustion is regarded as the main cause for polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) formation.     

Chemical compositions and sources of atmospheric PM10 in heating, non-heating and sand periods at a coal-based city in northeastern China

Mass concentrations and chemical components (18 elements, 9 ions, organic carbon [OC] and elemental carbon [EC]) in atmospheric PM(10) were measured at five sites in Fushun during heating, non-heating and sand periods in 2006-2007. PM(10) mass concentrations varied from 62.0 to 226.3 μg m(-3), with 21% of the total samples' mass concentrations exceeding the Chinese national secondary standard value of 150 μg m(-3), mainly concentrated in heating and sand periods. Crustal elements, trace elements, water-soluble ions, OC and EC represented 20-47%, 2-9%, 13-34%, 15-34% and 13-25% of the particulate matter mass concentrations, respectively. OC and crustal elements exhibited the highest mass percentages, at 27-34% and 30-47% during heating and sand period. Local agricultural residuals burning may contribute to EC and ion concentrations, as shown by ion temporal variation and OC and EC correlation analysis. Heavy metals (Cr, Ni, Zn, Cu and Mn) from coal combustion and industrial processes should be paid attention to in heating and sand periods. The anion/cation ratios exhibited their highest values for the background site with the influence of stationary sources on its upper wind direction during the sand period. Secondary organic carbon were 1.6-21.7, 1.5-23.0, 0.4-17.0, 0.2-33.0 and 0.2-21.1 μg m(-3), accounting for 20-77%, 44-88%, 4-77%, 8-69% and 4-73% of OC for the five sampling sites ZQ, DZ, XH, WH and SK, respectively. From the temporal and spatial variation analysis of major species, coal combustion, agricultural residual burning and industrial emission including dust re-suspended from raw material storage piles were important sources for atmospheric PM(10) in Fushun at heating, non-heating and sand periods, respectively. It was confirmed by principal component analysis that coal combustion, vehicle emission, industrial activities, soil dust, cement and construction dust and biomass burning were the main sources for PM(10) in this coal-based city.     

Assessment of heterogeneity of metal composition of fine particulate matter collected from eight U.S. counties using principal component analysis

The main objectives of this study are to (1) characterize chemical constituents of particulate matter (PM) and (2) compare overall differences in PM collected from eight US. counties. This project was undertaken as a part of a larger research program conducted by the Johns Hopkins Particulate Matter Research Center (JHPMRC). The goal of the JHPMRC is to explore the relationship between health effects and exposure to ambient PM of differing composition. The JHPMRC collected weekly filter-based ambient fine particle samples from eight US. counties between January 2008 and January 2010. Each sampling effort consisted of a 5-6-week sampling period. Filters were analyzed for 25 metals using inductively coupled plasma mass spectrometry (ICP-MS). Overall compositional differences were ranked by principal component analysis (PCA). The results showed that weekly concentrations of each element varied 3-40 times between the eight counties. PCA showed that the first five principal components explained 85% of the total variance. The authors found significant overall compositional differences in PM as the average of standardized principal component scores differed between the counties. These findings demonstrate PCA is a useful tool to identify the differences in PM compositional mixtures by county. These differences will be helpful for epidemiological and toxicological studies to help explain why health risks associated with PM exposure are different in locations with similar mass concentrations of PM.     

A comparison study on high-temperature water–gas shift reaction over Fe/Al/Cu and Fe/Al/Ni catalysts using simulated waste-derived synthesis gas

A comparative study on Fe/Al, Fe/Al/Cu, and Fe/Al/Ni catalysts in high-temperature water–gas shift reaction (HT–WGS) using simulated waste-derived synthesis gas has been carried out. The metal oxide (Cu and Ni) and aluminum incorporated Fe catalysts were designed to get highly active HT–WGS catalysts. Despite the high CO concentration in the simulated waste-derived synthesis gas, Fe/Al/Cu catalyst exhibited the highest CO conversion (84 %) and 100 % selectivity to CO₂ at a very high gas hourly space velocity (GHSV) of 40,057 h^?1. The outstanding catalytic performance is mainly due to easier reducibility, the synergy effect of Cu and Al, and the stability of the magnetite.     

3株反硝化聚磷菌的分离与鉴定

通过烛缸法培养富集、分离，结合除磷试验、硝酸盐还原产气试验及异染颗粒和PHB颗粒染色辅助检验相结合的方法筛选，得到3株具有较高脱氮除磷效率的反硝化聚磷菌DNPA8, DNPA9和DNPA10。在富氮富磷培养基中培养48 h，各菌株的脱氮率均大于75%，除磷率均大于78%。采用多相分类的方法确定了3株反硝化聚磷菌的分类地位，DNPA8为嗜麦芽寡养单胞菌，DNPA9为水生丛毛单胞菌属首次发现的反硝化聚磷菌；DNPA10为约翰逊氏不动杆菌。该研究结果为富营养化水体的治理提供了有效的菌种资源。