胶带输送机运输事故树可靠性的计算机模拟

以胶带输送机运输事故树的计算机模拟过程为例 ,介绍了对事故树可靠性进行计算机模拟的原理、算法以及程序运行步骤 ,编制了模拟程序。用笔者提出的理论、方法及模拟程序 ,对平顶山煤业集团一矿胶带输送机运输事故进行了事故树分析与求解 ,同时将模拟程序运行结果与最小割集法求得的理论值进行了对比 ,计算结果误差小 ,所得结论准确可靠 ,为类似事故的模拟分析提供了一种新的方法和途径     

高硬度富锶地下水的软化沉淀-超滤膜联用工艺

针对一种高硬度富锶地下水,分别采用石灰和石灰-碳酸钠两种方法,利用药剂软化/超滤膜工艺对其进行软化处理,同时考察了药剂投量对出水锶含量的影响。结果表明,采用石灰软化/超滤膜法,Ca(OH)2最佳投加量为270 mg/L时,出水总硬度(以CaCO3计)由287.12 mg/L降低到96.44 mg/L,硬度去除率为66.41%,出水锶含量也由原水中的0.37 mg/L下降为0.21 mg/L;而采用石灰-碳酸钠软化/超滤膜法,Ca(OH)2和Na2CO3最佳投加量分别为270 mg/L、160mg/L时,出水总硬度降低到60.34 mg/L,硬度去除率达78.98%,锶含量仅为0.02 mg/L。2种处理方法出水总硬度均达到预期目标,石灰软化/超滤膜法可使出水锶含量满足富锶水的要求,而石灰-碳酸钠软化/超滤膜法则造成了对人体有益微量元素锶的大量损失。     

Using Si depletion in aerosol to identify the sources of crustal dust in two Chinese megacities

Depletion of Si in transported dust has been recognized for many years. It can be used to distinguish between transported and local dust in cities, although it rarely has been. Here we use the variations of the Si/Al ratio in 15 months of continuous PM_2.5 samples at Beijing (northern China) and Chongqing (southwestern China) to reveal the seasonal patterns of their dust sources. For both cities, peaks of concentration for Si and Al in PM_2.5 corresponded with minima of Si/Al, and could often be linked to pulsed air flow from deserts to the northwest. With significant depletion (up to 80%) and homogeneous distribution at urban and rural sites, Si/Al showed a clear seasonal evolution, which decreased from spring to summer, increased from fall to winter, and collapsed during Chinese Spring Festival, indicating the dominance of transported dust, local fugitive dust and firework influence, respectively. The low ratios implied that desert dust is a common source during spring at Chongqing, whereas its presence during cold season at Beijing was also more frequent than expected. Failing to recognize the depletion of Si may lead to an overestimate of desert dust by 15%–65% when using the average abundance of Al in crust (6%–8%), as in previous studies. The difference in Si/Al ratio between local and transported dust implies that >60% of the dust at Beijing came from outside the city during the springs of 2004–2006. This result can help resolve the contradictory findings on this topic that have been presented earlier.     

新型SBBR处理畜禽废水脱氮实验研究

以畜禽废水为处理对象,将序批式运行模式应用到好氧三相内循环生物流化床中,考察在不同模式下的处理效果及氮的转化情况。实验结果表明,在室温条件下,进水COD浓度为2 000 mg/L左右,总氮为140 mg/L左右时,保持溶解氧在2~2.5 mg/L,交替好氧/缺氧运行方式处理效果优于单一的好氧/缺氧方式;模式为3 h(曝气)-1.5 h(停曝)-1.5 h(曝气)-1 h(停曝)时系统对总氮和氨氮处理效果最好,总氮去除率达到90%,系统主要脱氮方式为同步硝化反硝化和短程硝化反硝化。     

强化混凝工艺深度处理给水厂排泥废水

水厂废水的综合处理与回用是我国供水行业的新趋势和节水目标所在,采用强化混凝技术进行水厂排泥废水的深度处理。通过混凝剂筛选实验和有机物表征确定最佳混凝剂为高效聚合铝(HPAC),适宜投加量为650 mg/L。当混凝剂HPAC投加量为650 mg/L时,对COD、TOC、浊度和色度的去除率分别为82.5%、89.8%、95%和92.5%,相应的出水值分别为58 mg/L、8.46 mg/L、2.35 NTU、13度,COD满足《污水综合排放标准》(GB 8978-1996)的要求(COD≤100 mg/L),同时实验结果显示聚合氯化铝(PAC)、HPAC、三氯化铁(FeCl3)主要去除分子量处于>1 300 Da范围的有机物,对分子量处于744～1 300 Da之间的有机物去除有限。     

Source apportionment of polycyclic aromatic hydrocarbons in surface soil in Tianjin, China

Principal component analysis and multiple linear regression were applied to apportion sources of polycyclic aromatic hydrocarbons (PAHs) in surface soils of Tianjin, China based on the measured PAH concentrations of 188 surface soil samples. Four principal components were identified representing coal combustion, petroleum, coke oven plus biomass burning, and chemical industry discharge, respectively. The contributions of major sources were quantified as 41% from coal, 20% from petroleum, and 39% from coking and biomass, which are compatible with PAH emissions estimated based on fuel consumption and emission factors. When the study area was divided into three zones with distinctive differences in soil PAH concentration and profile, different source features were unveiled. For the industrialized Tanggu-Hangu zone, the major contributors were cooking (43%), coal (37%) and vehicle exhaust (20%). In rural area, however, in addition to the three main sources, biomass burning was also important (13%). In urban-suburban zone, incineration accounted for one fourth of the total.     

Seasonal variation on size distribution and concentration of PAHs in Guangzhou city, China

Size distribution aerosol samples were collected at an urban location of Guangzhou in four seasons of 2003-2004 by a MOUDI (Micro-orifice Uniform Deposit Impactor). The particle loading (PM10: 80-397 microg m(-3)) was comparable with some other Asia cities; however, much higher than that of Western Europe and North America. Polycyclic aromatic hydrocarbons (PAHs) were measured by gas chromatography with mass selective detector (GC-MS). Seasonal effects on the size distribution of PAHs are presented. Bimode (accumulation and coarse mode) and unimode (accumulation mode) distributions were observed for low-molecule-weight and high-molecule-weight PAHs. A slight shift to larger particles was found for the accumulation mode in autumn and winter, compared with that of spring and summer. One explanation is that the longer aging process of PAHs in autumn and winter would result in volatilization from finer particles followed by condensation onto coarser particles. Another is there was mixing process of local emission with long-range transported aerosol in autumn and winter. The relative higher value of IcdP/(BghiP+IcdP) and lower value of BghiP/BeP in winter also give evidences to the mixing process. The level of PAHs concentration has been much elevated in recent years. This can be attributed to the fast growth of motor vehicle and energy consumption.     

磁絮凝处理废水工艺条件的响应曲面法优化研究

以聚硅硫酸铁(PFSS)为絮凝剂、磁流体为磁种,采用磁絮凝法处理模拟废水。在正交实验基础上,利用Matlab软件进行响应曲面分析,研究磁絮凝法处理模拟废水的各因素间具有的交互作用关系。回归拟合结果表明最佳工艺条件为:PFSS加入量36.8g/L,模拟废水pH7.4,磁种加入量14.7mg/L,搅拌转速266r/min。在最佳工艺条件下进行实验,TP去除率为97.70%。     

高效聚合氯化铝对超滤膜污染影响的中试研究

针对某水厂以超滤为核心的短流程水处理工艺,在通过聚氯乙烯(PVC)超滤膜之前选择不同投加量(5、10、15和20 mg/L)的高效聚合氯化铝(HPAC)对长江下游原水进行混凝处理。通过跨膜压差(TMP)增长趋势、CODMn的去除率以及混凝后的水质,可知HPAC的最优投加量为15 mg/L。在此投加量下,运用体积排阻色谱法分析原水、膜前水、膜后水中各相对分子质量有机物的变化,可以发现混凝去除有机物的效果要优于超滤截留的。继而将HPAC与另外4种常用混凝剂:硫酸铝(分析纯)、氯化铁(化学纯)、聚合氯化铝(PAC)、聚合硫酸铁进行对比,结果表明,在它们各自最优投加量下,HPAC能够更有效地减缓超滤膜TMP的增长率,从而降低膜污染。因此,认为HPAC是与PVC超滤合金膜契合效果最佳的混凝剂。     

Co3O4/介孔分子筛催化剂对苯催化完全氧化的研究

分别以介孔分子筛MCM-41、MCM-48、SBA-15为载体，采用等体积浸渍法制备了氧化钴/介孔分子筛催化剂，利用N₂吸附、X射线衍射、程序升温还原等技术对催化剂进行了表征，考察了Co₃O₄的负载量及载体的孔结构对催化剂完全催化氧化苯的性能的影响。结果表明，Co₃O₄的负载量为20%时，催化剂的催化活性最好；载体的孔径和催化剂的可还原性能是影响催化活性的主要因素，催化剂活性顺序为Co₃O₄ /SBA-15> Co₃O₄ /MCM41> Co₃O₄ /MCM-48。