纳米零价铁的制备及其去除水中对氯硝基苯的研究

通过FeSO4与KBH4反应,利用液相还原法制备纳米零价铁颗粒(NZVI),用XRD、SEM和BET对其性能进行表征。在常温常压下利用纳米铁还原废水中的对氯硝基苯(p-CNB),探讨了反应条件对还原率的影响。结果表明,制备过程中碱性物质(NaOH)的添加可以明显减小颗粒粒径,增大比表面积,提高纳米铁还原反应的效率。NZVI对于对氯硝基苯有很好的去除效果,NZVI用量、p-CNB初始浓度和pH值均对其去除效率产生影响。在纳米铁投加量为1 g/L,pH=2的条件下,添加NaOH的纳米铁能在120 min内将质量浓度为50 mg/L的对氯硝基苯基本完全降解,降解率为98.8%。此外,还对NZVI还原对氯硝基苯的机理进行了初步探讨。     

基于esp基因和JCV标记的MST方法在五大流域典型水源地中的应用

非点源污染目前已经成为影响水体环境的重要污染。微生物源示踪技术(microbial source tracking,MST)是解决非点源污染的一项新技术,它可以确定污染的宿主来源。肠球菌esp基因和多瘤病毒JCV可以作为检测水体中人源粪便污染的分子标记,其灵敏度和特异性都很高。为分析五大流域水源地是否受到人源粪便的污染,对辽河、海河、淮河、长江和黄河五大流域典型水源地水样进行采集和检测,选取人源粪便特异病原微生物肠球菌的esp基因和多瘤病毒JCV建立了相应的MST分子检测方法。结果表明,五大流域的典型水源地采样点均有可能受到了人源粪便的污染,可为当地相关部门提供技术支持和数据参考。     

植物活性物质对PM_(2.5)致细胞损伤的抗性作用

为研究植物活性物质对PM2.5致细胞损伤的抗性作用,研究了北京城区PM2.5对CHO(Chinese hamster ovary,中国仓鼠卵巢)细胞的损伤作用,并选择植物活性物质绿原酸、阿魏酸和荭草素探讨其对CHO细胞的保护作用.以CCK-8法确定PM2.5的试验剂量和3种活性物质的最佳保护剂量,然后通过彗星试验、微核试验、流式细胞术及Western Blotting分别检测PM2.5的损伤作用及植物活性物质的保护作用.结果表明:1由CHO细胞存活率可知,PM2.5的有效试验剂量为15μg/m L,绿原酸、阿魏酸和荭草素的最佳保护剂量分别为50、20、10μmol/L.2PM2.5可引起CHO细胞明显的DNA损伤、微核形成增加、细胞周期阻滞所致的细胞增殖指数降低,而经阿魏酸、绿原酸和荭草素预处理后,均可减轻PM2.5对细胞的损伤作用,起到了一定的保护作用.3PM2.5能引起CHO细胞中p53和caspase-3蛋白的表达增加,而阿魏酸、绿原酸和荭草素均可使其表达量有所降低.由PM2.5引起的细胞损伤经绿原酸、阿魏酸、荭草素作用后表达量降低.在3种植物活性物质中,以阿魏酸拮抗PM2.5损伤的效果最佳,绿原酸次之,荭草素相对较差.     

某农药厂废弃场地土壤中甲拌磷垂向分布特征

为了解废弃农药厂土壤中甲拌磷的垂向分布特征,在前期表层土壤筛查的基础上,进一步在原甲拌磷生产车间开展了钻孔取样工作,布置了3个钻孔,钻孔深度43.0、41.0和45.0m,根据土壤颜色、岩性、电导率和pH的变化,共采集土壤样品39个,利用高效液相色谱仪对土壤中的甲拌磷进行了定量分析,同时测试了总有机碳、阳离子交换量、土壤粘粒含量、土壤含水率和温度等土壤的理化性质参数。测试结果显示,甲拌磷主要富集在表层土壤中,随着深度的增加,甲拌磷含量逐渐降低。根据相关性分析,土壤中甲拌磷含量和总有机碳含量有着显著的相关性,R分别为0.767、0.893和0.917,这表明土壤总有机碳含量对甲拌磷垂向分布有着非常重要的影响。     

爆炸超压场景下危化品社会风险对允许规划人口密度的影响分析*

为研究危化品重大危险源基于社会风险基准的规划管控影响,采用我国标准规定的定量风险评价方法,TNT当量炸药简化方法,针对最大TNT当量炸药、事故发生总累计频率、人口密度分布控制参数等不同工况条件,对比分析国土开发强度的允许人口密度受社会风险约束影响的变化规律。研究结果表明:人口密度指数分布控制参数Nk与Nb的允许取值随最大TNT当量炸药和事故发生总累计频率降低而提高;确定工况下,允许总人口规模受最大TNT当量炸药影响很小;在最大TNT当量炸药大于100 t或事故发生总累计频率小于1×10-8次/a时可按最大事故场景进行规划控制分析。     

Recovery of Cu and Fe from Printed Circuit Board waste sludge by ultrasound: Evaluation of industrial application

The paper presents a novel cleaner process for metal recovery from the Printed Circuit Board (PCB) waste sludge by assistance of ultrasound. The process can effectively recover heavy metals at low cost with high separation and recovery efficiency, produce high quality products and also achieve zero waste discharge with operation at industrial scale. With the PCB waste sludge containing (wet content) 3.14–4.85% copper and 3.71–4.23% iron, copper recovery efficiency of 95.2–97.5% and iron recovery efficiency of 97.1–98.5% were achieved, while the purity of copper sulfate produced by the process was 98.0% and the produced ferric chloride had a satisfied quality for using as a coagulant material for the plant on-site wastewater treatment. The process had been successfully scaled up to the industrial scaled applications in a heavy metal recovery plant in city of Huizhou, China for more than two years. The novel cleaner heavy metal recovery process has a great prospect on the applications of resources recovery and environmental protection practices.     

Effect of humic acids on physicochemical property and Cd(II) sorption of multiwalled carbon nanotubes

Zinc pyrithione is used as an antifouling agent. However, the environmental impacts of zinc pyrithione have recently been of concern. Zinc induces diverse actions during oxidative stress; therefore, we examined the effect of zinc pyrithione on rat thymocytes suffering from oxidative stress using appropriate fluorescent probes. The cytotoxicity of zinc pyrithione was not observed when the cells were incubated with 3 μM zinc pyrithione for 3 h. However, zinc pyrithione at nanomolar concentrations (10 nM or more) significantly increased the lethality of cells suffering from oxidative stress induced by 3 mM H₂O₂. The application of zinc pyrithione alone at nanomolar concentrations increased intracellular Zn²⁺ level and the cellular content of superoxide anions, and decreased the cellular content of nonprotein thiols. The simultaneous application of nanomolar zinc pyrithione and micromolar H₂O₂ synergistically increased the intracellular Zn²⁺ level. Therefore, zinc pyrithione at nanomolar concentrations may exert severe cytotoxic action on cells simultaneously exposed to chemicals that induce oxidative stress. If so, zinc pyrithione leaked from antifouling materials into surrounding environments would be a risk factor for aquatic ecosystems. Alternatively, zinc pyrithione under conditions of oxidative stress may become more potent antifouling ingredient.     

高碱度水库水混凝过程中残留铝控制

针对高碱度水库水源的某水厂残留铝超标问题,选取碱化度(B)与Alb含量不同的3种铝盐絮凝剂,研究不同投量与pH值下混凝效果与残留铝浓度水平。结果表明,碱化度和Alb含量显著影响混凝效果。DOC和浊度的去除率随着3种絮凝剂AlCl3(B=0)、PACl-1(B=1.2)、PACl-2(B=2.2)投量增大而升高。3种絮凝剂投量在1.5～2.0 mg/L(以铝计)范围内,总铝和溶解铝含量最低。对于该水厂自制的絮凝剂PACl-2,可通过降低絮凝剂碱化度,或将水的pH值降低至7～7.5之间,以此可以提高PACl-2混凝效果,而且可以降低出厂水残留铝浓度。考虑工程应用可行性,可优先考虑调整絮凝剂生产工艺。