Sustainable development conflict over freeway construction

Environmental disputes arise due to opposing views of various groups about their environmental concerns and their economic or developmental interests. Development and protection of the environment constitute two main contradictory objectives within the sustainable development paradigm, which are often in conflict. The decision support system, GMCR II, which implements the graph model for conflict resolution, is employed to model and analyze an environmental dispute arising over the construction of a new freeway between the Iranian capital, Tehran, and the city of Chalous located in the north of the country. This study demonstrates that the graph model for conflict resolution can be used as a methodology to promote a reasonable balance between economic development and environmental protection from a strategic viewpoint. In addition to systematically modelling the conflict by putting the existing information into proper perspective, it is shown how conflict analysis can be used for comparing alternative scenarios and predicting possible future outcomes. Readers should send their comments on this paper to: BhaskarNath@aol.com within 3 months of publication of this issue.     

A Microprocessor-Based Air Quality Monitoring System

Portable air quality monitoring systems may be required to supplement fixed installations or to provide for quick response to a transient situation, possibly at a remote location. A microprocessor-based monitoring unit has been developed for use with existing sensors. The unit is portable and its operational sequence can be programmed to adapt it to any unique requirements existing at the deployment site. Selectable on-site calculations are performed on raw data, and a hard copy or tape record of results can be produced.     

Exporting natural capital: the foreign eco-footprint on Costa Rica and implications for sustainability

As the world economy ‘globalizes’, trade has become a major mechanism by which much of the human population supports its needs. While trade in resource commodities (natural income) can increase the well-being of people in both exporting and importing countries, it can also lead to depletion of natural capital and the loss of ecosystems integrity. In recent years, various researchers have attempted to address this problem using a consumption-based perspective on ecological change. Their work shows that the loss of ecosystem integrity in almost any region of the world can be attributed to both local and international consumer demand. This paper illustrates the utility of modified eco-footprint analysis in assessing export-related ecological change in Costa Rica. We quantify ecological footprint of consumers around the world on the productive ecosystems of Costa Rica, document the changing character of this footprint and highlight some of the linkages between production for export in Costa Rica and ecological degradation. We then discuss the implications of the increasing trade-based entanglement of nations for ecosystems and global sustainability.     

Evaluation of particulate matter abatement strategies for almond harvest

Almond harvest accounts for substantial PM10 (particulate matter [PM] < or =10 microm in nominal aerodynamic diameter) emissions in California each harvest season. This paper evaluates the effects of using reduced-pass sweepers and lower harvester separation fan speeds (930 rpm) on lowering PM emissions from almond harvesting operations. In-canopy measurements of PM concentrations were collected along with PM concentration measurements at the orchard boundary; these were used in conjunction with on-site meteorological data and inverse dispersion modeling to back-calculate emission rates from the measured concentrations. The harvester discharge plume was measured as a function of visible plume opacity during conditioning operations. Reduced-pass sweeping showed the potential for reducing PM emissions, but results were confounded because of differences in orchard maturity and irrigation methods. Fuel consumption and sweeping time per unit area were reduced when comparing a reduced-pass sweeper to a conventional sweeper. Reducing the separation fan speed from 1080 to 930 rpm led to reductions in PM emissions. In general, foreign matter levels within harvested product were nominally affected by separation fan speed in the south (less mature) orchard; however, in samples conditioned using the lower fan speed from the north (more mature) orchard, these levels were unacceptable.     

Valorization of solid waste products from olive oil industry as potential adsorbents for water pollution control—a review

The global olive oil production for 2010 is estimated to be 2,881,500 metric tons. The European Union countries produce 78.5 % of the total olive oil, which stands for an average production of 2,136,000 tons. The worldwide consumption of olive oil increased of 78 % between 1990 and 2010. The increase in olive oil production implies a proportional increase in olive mill wastes. As a consequence of such increasing trend, olive mills are facing severe environmental problems due to lack of feasible and/or cost-effective solutions to olive-mill waste management. Therefore, immediate attention is required to find a proper way of management to deal with olive mill waste materials in order to minimize environmental pollution and associated health risks. One of the interesting uses of solid wastes generated from olive mills is to convert them as inexpensive adsorbents for water pollution control. In this review paper, an extensive list of adsorbents (prepared by utilizing different types of olive mill solid waste materials) from vast literature has been compiled, and their adsorption capacities for various aquatic pollutants removal are presented. Different physicochemical methods that have been used to convert olive mill solid wastes into efficient adsorbents have also been discussed. Characterization of olive-based adsorbents and adsorption mechanisms of various aquatic pollutants on these developed olive-based adsorbents have also been discussed in detail. Conclusions have been drawn from the literature reviewed, and suggestions for future research are proposed.     

Comprehensive Area Surveys in New York State

The proposed By-law changes have been suggested over the last two years. They are basically housekeeping changes which correct the language, eliminate duplications, and clarify the dates for the receipt and acceptance of the ballots for nominees for the Board. The major revision proposed is in Article XV of the Technical Council which was necessitated by the new structure of the Technical Council approved by the Board of Directors in June 1970.     

Effectiveness of Smokeless Ashtrays

Abstract

Most environmental tobacco smoke (ETS) issues from the tips of smoldering cigarettes between puffs. Smokeless ashtrays are designed to reduce ETS exposure by removing particulate and/or gas-phase contaminants from this plume. This paper describes an experimental investigation of the effectiveness of four smokeless ashtrays: two commercial devices and two prototypes constructed by the authors. In the basic experimental protocol, one or more cigarettes was permitted to smolder in a room. Particulate or gas-phase pollutant concentrations were measured in the room air over time. Device effectiveness was determined by comparing pollutant concentrations with the device in use to those obtained with no control device. A lung deposition model was applied to further interpret device effectiveness for particle removal. The commercial ashtrays were found to be substantially ineffective in removing ETS particles because of the use of low-quality filter media and/or the failure to draw the smoke through the filter. A prototype ashtray using HEPA filter material achieved better than 90% particle removal efficiency. Gasphase pollutant removal was tested for only one prototype smokeless ashtray, which employed filters containing activated carbon and activated alumina. Removal efficiencies for the 18 gas-phase compounds measured (above the detection limit) were in the range of 70 to 95%.     

Geographic distribution and environmental characterization of livestock production systems in Eastern Africa

The central role played by livestock in the livelihoods of rural households in the developing world is seldom fully appreciated by policy makers, development agencies and donors. Knowledge gaps in the geographic distribution and environmental determinants of farming systems, especially if viewed through the livestock lens, compound this problem. We have produced a map of pastoral, agro-pastoral and mixed farming systems across Eastern Africa, by analysing datasets collected in the framework of livelihood analysis. Input data were gathered between 2000 and 2007 by various emergency and development agencies for Djibouti, Eritrea, Kenya, Somalia, Uganda and parts of Ethiopia and Sudan. A quantitative definition of the production systems is adopted, based on the ratio of livestock- to crop-derived income. The resulting livelihood-based map of livestock production systems was compared through correspondence analysis to an alternative livestock production systems map, produced independently from environmental data. Convergence between the two mapping approaches was evident. The geographic distribution of the livestock production systems was also modelled using multivariate analysis of remotely sensed and other geospatial datasets. Models show high statistical accuracy, and were thus used to fill the gaps in the observed distribution of livestock production systems. Finally, selected environmental factors underpinning the systems (agro-climatology, human and livestock populations and land cover) were analysed in detail, enabling the livestock production systems to be characterized in terms of them. The regional scope of the map, as well as its direct link with a vast amount of livelihood information, render it a valuable tool for a range of development and research applications, including those related to global change.     

A Simple Technique for Determining The Maximum Ground Level Concentration of An Elevated Gaseous Release

A screening technique has been developed to determine the maximum one-hour ground level concentration of a gaseous emission from a stack located In flat terrain. The method does not require the use of a computer and eliminates the usual trial and error calculations. An infinite mixing height is assumed. It involves a linear or quadratic solution of the gaussian plume diffusion as a function of the effective stack height and a linear approximation of the Briggs plume rise equation. The linear approximation of the former gives results that are within 5 % of the gaussian plume results for stability criteria A, B, and C. For stability criteria D, the difference can be as great as 80%. If a quadratic estimation Is used, the differences are less than 3% for stability criteria A, B, and C, and are within 18% for stability criteria D. A linear approximation is used for the Briggs plume rise equation. This gives results within 4% of the Briggs equation. Overall, this is a simple straightforward approximation which gives results which can be used to determine if more sophisticated procedures are necessary.     

The Inadequacy of PSD Increments to Protect Visibility in Class I Areas

This study includes an application of the first two phases of a new three-phased decision-making structure that was developed to overcome the problems related to ecological safety and social justice in site selection applications. It was conducted on a current site selection problem related to the municipal solid waste disposal facilities in Kocaeli, the most industrialized region of Turkey. In order to assess the deficiencies of the legal site selection procedures related to ecological safety, two different decision tree modes were applied separately. The first mode (“Legislation”) concerns the current buffer zone applications given in the regulations, while the second one (“Proposed”) includes the applications of the new decision-making structure proposed in this study. Since it was assumed that the subjective tendencies of the decision makers on the weightings would have a significant effect on the final decision, these two modes were assessed by employing two different weighting models. The results were obtained from all of the scenarios related to selection of suitable sites with three different area requirements (15, 250, and 500 acres) for the solid wastes generated in the Kocaeli region. The results showed that the possible changes in the decision structure could cause significant differences in the final decision related to selection of the most suitable sites. The most highest and lowest differences were at the “Legislation” mode for 15 acres and 500 acres, respectively. Furthermore, the results obtained in the study showed that the possible differentiations in the criteria weightings could also cause significant differences in the suitability ranking. Therefore, to get a reliable final decision, a statistical assessment of these differentiations should be made.

Implications: The results showed that the possible changes in the decision structure could cause significant differences in the final decision related to selection of the most suitable sites. Furthermore, the results obtained in the study showed that the possible differentiations in the criteria weightings could also cause significant differences in the suitability ranking. Therefore, to get a reliable final decision, a statistical assessment of these differentiations should be made.