Enhanced mercuric chloride adsorption onto sulfur-modified activated carbons derived from waste tires

A number of activated carbons derived from waste tires were further impregnated by gaseous elemental sulfur at temperatures of 400 and 650 degrees C, with a carbon and sulfur mass ratio of 1:3. The capabilities of sulfur diffusing into the micropores of the activated carbons were significantly different between 400 and 650 degrees C, resulting in obvious dissimilarities in the sulfur content of the activated carbons. The sulfur-impregnated activated carbons were examined for the adsorptive capacity of gas-phase mercuric chloride (HgC1) by thermogravimetric analysis (TGA). The analytical precision of TGA was up to 10(-6) g at the inlet HgCl2 concentrations of 100, 300, and 500 microg/m3, for an adsorption time of 3 hr and an adsorption temperature of 150 degrees C, simulating the flue gas emitted from municipal solid waste (MSW) incinerators. Experimental results showed that sulfur modification can slightly reduce the specific surface area of activated carbons. High-surface-area activated carbons after sulfur modification had abundant mesopores and micropores, whereas low-surface-area activated carbons had abundant macropores and mesopores. Sulfur molecules were evenly distributed on the surface of the inner pores after sulfur modification, and the sulfur content of the activated carbons increased from 2-2.5% to 5-11%. After sulfur modification, the adsorptive capacity of HgCl2 for high-surface-area sulfurized activated carbons reached 1.557 mg/g (22 times higher than the virgin activated carbons). The injection of activated carbons was followed by fabric filtration, which is commonly used to remove HgCl2 from MSW incinerators. The residence time of activated carbons collected in the fabric filter is commonly about 1 hr, but the time required to achieve equilibrium is less than 10 min. Consequently, it is worthwhile to compare the adsorption rates of HgCl2 in the time intervals of < 10 and 10-60 min.     

Impacts of climate change in rapidly urbanizing region-a case study in Hangzhou(China)

Climate change is expected to be a major driving force of landscape in the coming decades.It will have a multitude of potential impacts that vary in intensity and effect according to region and sector.In the context of global warming,the climate of China has changed significantly in the recent 100 years.The reason for climate change in China is mainly due to irrational land use caused by human activities,which chiefly results in the rapid industrialization and urbanization process.Based on an assessment model,this research represents a picture of the impacts of climate change in six districts of Hangzhou region.The aim of this paper is to conclude,on the one hand,some of Hangzhou sensitivities in relation to the primary effects of climate change.On the other hand,a reflection is made on a methodology to formulate preconditions on a scientific basis for further research by design of integrated adaptation options for the future spatial developments in function to upgrade Hangzhou resilience in relation to climate change challenges.     

硫化法制备废水处理用光催化剂La3NbS2O5

采用高温硫化法制备了具有可见光活性的La3 NbS2 O5光催化剂,运用X射线衍射谱图、扫描电子显微镜照片、比表面积和紫外-可见漫反射光谱对La3 NbS2 O5的结构、物理性质和光吸收性能进行了表征.以亚甲基蓝为目标降解物,考察了硫化温度、催化剂加入量和制备方法对亚甲基蓝降解率的影响.实验结果表明,当硫化温度为800...     

Preformed Amide-containing biopolymer for Improving the Environmental Performance of Synthesized Urea–formaldehyde in Agro-fiber Composites

Investigations have continued for production high performance agro-based composites using environmentally acceptable approaches. This study examines the role of adding amide-containing biopolymers during synthesis of urea–formaldehyde (UF) on properties of adhesive produced, especially its adhesion potential. The environmental performance of UF-resin synthesized in the presence of modified amide-containing biopolymer was evaluated by evaluating the free-HCHO of both adhesive (during processing) and of the eventual engineered composite product. Also, the benefits of this synthesis-modified adhesive in enhancing the bondability of sugar-cane fibers used in engineered composite panels was evaluated and compared to using UF-resin. The results obtained show that, static bending of the produced composites varied from 27.7 to 33.13 N/mm² of modulus of rupture (MOR) and from 2860 to 3374 N/mm² of Modulus of Elasticity (MOE); while for internal bond (IB) it’s varied from 0.64 to 0.866 N/mm². Based on the ANSI and EN Standards modified UF-based agro composites produced meet the performance requirements for high grade particleboards with respect to static bending strength. These agro-based composite also tested out as having free-HCHO values of ~13 mg/100 g board.     

Analytical survey of arsenic in geothermal waters from sites in Kyushu,Japan, and a method for removing arsenic using magnetite

The objective of this study was to survey the cation and anion contents of geothermal waters to gather fundamental information on geographical variations. Sixteen sites in hot spring areas on the island of Kyushu in Japan were studied. The study focused on the arsenic content of the samples. Very high arsenic concentrations (more than 0.1 mg/l) were detected in most of the geothermal waters sampled. High contents of boron and fluoride (more than 1.0 mg/l) were also detected in some samples. Arsenic removal was performed on a laboratory scale using columns packed with a magnetite-type adsorbent. The reduction of arsenic contamination to a concentration of less than 0.01 mg/l could be achieved in the early stages of adsorption (bed volume = 200).     

An assessment of ecosystem services of Corbett Tiger Reserve,India

This paper examines the economic value of selected ecosystem services of Corbett Tiger Reserve, India. The direct cost was derived from secondary sources, and indirect and opportunity costs through socioeconomic surveys. For recreational value the individual approach to travel cost method was used, and to assess carbon sequestration the replacement cost method was used. The maintenance cost of the reserve was estimated as US $2,153,174.3 year⁻¹. The indirect costs in terms of crop and livestock depredation by wild animals ranged from US $2,153,174.3 year⁻¹. The indirect costs in terms of crop and livestock depredation by wild animals ranged from US 2,408 to US $37,958 village⁻¹ over a period of 5 years. The dependence of local communities was for fuel wood (US $37,958 village⁻¹ over a period of 5 years. The dependence of local communities was for fuel wood (US 7,346 day⁻¹), fodder (US $5,290 day⁻¹), small timber, and other nontimber forest products. The recreational value of the reserve was estimated as US $5,290 day⁻¹), small timber, and other nontimber forest products. The recreational value of the reserve was estimated as US 167,619 year⁻¹. With the cost per visitor being US $2.5, the consumers’ surplus was large, showing the willingness of visitors to pay for wildlife recreation. The forests of the reserve mitigate carbon worth US $2.5, the consumers’ surplus was large, showing the willingness of visitors to pay for wildlife recreation. The forests of the reserve mitigate carbon worth US 63.6 million, with an annual flow of US $65.0 ha⁻¹ year⁻¹. The other benefits of the reserve include US $65.0 ha⁻¹ year⁻¹. The other benefits of the reserve include US 41 million through generation of electricity since 1972. The analysis reveals that, though the benefits outweigh costs, they need to be accrued to local communities so as to balance the distribution of benefits and costs.     

层燃螺旋炉排焚烧技术处理含油污泥研究

通过对几种含油污泥无害化处理技术的比选,分析不同处理技术物耗、能耗情况,优选出经济有效的含油污泥焚烧技术,结合新疆油田含油污泥的特点,采用层燃螺旋炉排焚烧技术,利用其燃烧热能生产蒸汽用于原油生产,采用余热吸收急冷与碱液半干法除酸技术,有效控制了二次污染;采用布袋除尘与烟尘固化技术确保了烟气达标排放。年节省成本支出3095.88万元。     

多孔性Mn3O4的制备及其对水中镉的吸附

采用硫酸锰水解-氧化两步法制备了多孔性四氧化三锰,以X射线衍射、扫描电镜和氮吸附比表面仪对其进行了表征,研究了该多孔性Mn3O4在不同的溶液pH值、吸附时间、投加量和温度下对水中Cd(Ⅱ)的吸附行为,并测定了吸附过程的动力学和热力学参数。实验结果表明,该法合成的四氧化三锰属四方体心结构,一次晶粒尺寸为45.8 nm,颗粒间存在大量的孔洞,BET法比表面积为40.27 m2/g。在293 K,pH 5.5,吸附12 h时达到平衡,饱和吸附量为12.8 mg/g。该吸附过程符合准二级反应动力学模型,其反应的吸附活化能为2.743 kJ/mol,吸附等温线较好地符合Langmuir等温方程,吸附焓变和熵变均为正值,自由能变为负值,说明该吸附过程为自发的吸热过程。     

不同因素对人工湿地基质脱氮除磷效果的影响

在人工配制的污水中投入一定量的基质,不同条件下振荡培养,评价沸石、炉渣和陶瓷滤料3种基质在不同因素影响下对氨氮(NH4+-N)和总磷(TP)的吸附能力。结果表明,不同吸附时间时,沸石对NH4+-N的吸附效果最好,陶瓷滤料对TP的吸附效果最好;进水浓度对沸石吸附NH4+-N的影响较大,其吸附量随进水浓度的增大而增大,进水浓度对炉渣和陶瓷滤料吸附NH4+-N及炉渣吸附TP影响不大;3种基质对NH4+-N和TP的吸附量均是随吸附剂量的增加而降低,要达到较好的去污效果,应根据实验结果考虑基质投入量;pH值对沸石吸附NH4+-N影响显著,pH值6～7范围内吸附效果最好,pH值8～12的碱性条件有利于基质对TP的吸附。