Investigations into the transport and pathways of scallop larvae--the use of numerical models for managing fish stocks

The scallop fisheries off the southeast coast of Ireland have historically been considered a valuable resource for coastal communities, and hence their management is important. The scallop fishing grounds consist of a number of scallop beds dispersed throughout the St George's Channel and the southern Irish Sea. The boundaries between stocks and the interconnection in populations of adult scallops, through larval transport, is generally unknown. Until the time of this research, the stocks of scallop in this region had not been assessed. A research project was undertaken to develop novel, spatially explicit and multi-disciplinary approaches to the assessment of the scallop fisheries in the region. The project supported research in three related areas under the broad objective of developing stock assessment protocols and methods in order to promote sustainable management of these fisheries. One of these areas was the development and application of numerical models. The objectives of this modelling research were: (a) to reconstruct the physical environment of the study area; (b) investigate how this environment affects the demographics and nature of scallop; and (c) determine migration-transport pathways of the scallop larvae. From these investigations, light is shed on how the spatial variability in certain parameters of the natural environment determine habitats and the scallop populations. Also, the investigations now enable determinations to be made on the interconnectivities of 'disparate' scallop beds and where larvae are, in general, likely to be found. Thus, through the use of complex computer models, important clues are deduced that enable us to now understand key behavioural components of scallop larvae and their transport pathways. The analysis of these clues is assisting the development of protocols for managing the fish stock in a sustainable manner.     

Comparison of 24 h averaged VOC monitoring results for residential indoor and outdoor air using Carbopack X-filled diffusive samplers and active sampling--a pilot study

Analytical results obtained by thermal desorption GC/MS for 24 h diffusive sampling of 11 volatile organic compounds (VOCs) are compared with results of time-averaged active sampling at a known constant flow rate. Air samples were collected with co-located duplicate diffusive sampling tubes and one passivated canister. A total of eight multiple-component sampling events took place at fixed positions inside and outside three private homes. Subsequently, a known amount of sample air was transferred from the canister to an adsorbent tube for analysis by thermal desorption GC/MS. Results for the 11 most prevalent compounds--Freon 11, 1,3-butadiene, benzene, toluene, tetrachloroethene, ethylbenzene, m,p-xylene, o-xylene, 4-ethyltoluene, 1,3,5-trimethylbenzene, and p-dichlorobenzene--show that the ratio of average study values (diffusive sampling to active sampling) is 0.92 with 0.70 and 1.14 extreme ratios. Absolute percent difference for duplicate samples using diffusive sampling was <10% for the four most prevalent compounds. Agreement between the two sampling approaches indicates that the prediction of approximately constant diffusive sampling rates based on previous laboratory studies is valid under the field conditions.     

Spatial and temporal variability of water repellency in a sandy soil contaminated with tar oil and heavy metals

Water repellency can induce preferential flow and thus affect water flow and contaminant transport at hazardous waste sites. Since the spatial patterns of water repellency are mostly unknown, it is problematic to use numerical transport models to predict leachate composition. In this study, the spatial variability of soil water repellency was studied at an industrial site contaminated with tar oil, chromium, copper and arsenic. The persistence of water repellency was assessed by the water drop penetration time (WDPT), and the degree of water repellency was quantified by the ethanol percentage (EP) test. Measurements were made at the soil surface along 3.5-12.1 m long transects at different times between March and October 2002. The spatial variability of WDPT, EP, water content, and organic matter content was quantified by variogram analyses. Both the persistence and the degree of water repellency varied seasonally, with the highest water repellency during the summer months. The correlation lengths of WDPT values ranged between 16 and 406 cm, whereas EP values showed no spatial correlation. For field-moist samples, a critical soil water threshold, below which water repellency prevails, was estimated to be 2.5-4%. For oven dry samples, the WDPT values were dependent on the water content prior to drying. The wide range of correlation lengths and the temporal dynamics of spatial repellency patterns suggest that simulations of solute leaching must consider the spatial and temporal variability of soil hydrophobic properties.     

Titration Curves: A Useful Instrument for Assessing the Buffer Systems of Acidic Mining Waters (10 pp)

Background, Aims and Scope The acidification of mine waters is generally caused by metal sulfide oxidation, related to mining activities. These waters are characterized by low pH and high acidity due to strong buffering systems. The standard acidity parameter, the Base Neutralization Capacity (BNC) is determined by endpoint titration, and reflects a cumulative parameter of both hydrogen ions and all buffering systems, but does not give information on the individual buffer systems. We demonstrate that a detailed interpretation of titration curves can provide information about the strength of the buffering systems. The buffering systems are of importance for environmental studies and treatment of acidic mining waters. Methods Titrations were carried out by means of an automatic titrator using acidic mining waters from Germany and Canada. The curves were interpreted, compared with each other, to endpoint titration results and to elemental concentrations contained therein. Results and Discussion The titration curves were highly reproducible, and contained information about the strength of the buffer systems present. Interpretations are given, and the classification and comparison of acidic mining waters, by the nature and strength of their buffering systems derived from titration curves are discussed. The BNC-values calculated from the curves were more precise than the ones determined by the standard endpoint titration method. Due to the complex buffer mechanisms in acidic mining waters, the calculation of major metal concentrations from the shape of the titration curve resulted in estimates, which should not be confused with precise elemental analysis results. Conclusion Titration curves provide an inexpensive, valuable and versatile tool, by which to obtain sophisticated information of the acidity in acidic water. The information about the strength of the present buffer systems can help to understand and document the complex nature of acidic mining water buffer systems. Finally, the interpretation of titration curves could help to improve treatment measurements and the ecological understanding of these acidic waters.     

New York State urban and rural measurements of continuous PM2.5 mass by FDMS, TEOM, and BAM

Field evaluations and comparisons of continuous fine particulate matter (PM2,5) mass measurement technologies at an urban and a rural site in New York state are performed. The continuous measurement technologies include the filter dynamics measurement system (FDMS) tapered element oscillating microbalance (TEOM) monitor, the stand-alone TEOM monitor (without the FDMS), and the beta attenuation monitor (BAM). These continuous measurement methods are also compared with 24-hr integrated filters collected and analyzed under the Federal Reference Method (FRM) protocol. The measurement sites are New York City (the borough of Queens) and Addison, a rural area of southwestern New York state. New York City data comparisons between the FDMS TEOM, BAM, and FRM are examined for bias and seasonality during a 2-yr period. Data comparisons for the FDMS TEOM and FRM from the Addison location are examined for the same 2-yr period. The BAM and FDMS measurements at Queens are highly correlated with each other and the FRM. The BAM and FDMS are very similar to each other in magnitude, and both are approximately 25% higher than the FRM filter measurements at this site. The FDMS at Addison measures approximately 9% more mass than the FRM. Mass reconstructions using the speciation trends network filter data are examined to provide insight as to the contribution of volatile species of PM2.5 in the FDMS mass measurement and the fraction that is likely lost in the FRM mass measurement. The reconstructed mass at Queens is systematically lower than the FDMS by approximately 10%.     

A multivariate examination of ‘artificial mussels’ in conjunction with spot water tests in freshwater ecosystems

Metal pollution in aquatic systems is considered a serious environmental issue globally due to their ability to accumulate in aquatic environments. Wetlands are vulnerable to this pollution as they are known to trap toxins, removing them from the water. Artificial mussel technology, originally developed for marine environments, was applied to this freshwater system and spot water samples were collected. The Nyl River floodplain (Ramsar classified) is one of the largest and most ecologically significant wetlands in South Africa. The aims of this study were to determine metal contamination along the Nyl River system by means of artificial mussels (AM) and water ICP-MS analysis and to determine whether the use of AMs in conjunction with spot water testing could give more insight into the pollution in freshwater wetlands. The concentrations of Al, Cd, Cr, Co, Cu, Fe, Mn, Ni, Pb and Zn were determined at seven sites. It was determined that the levels accumulated by the AMs differed in spatial and temporal trends when compared to spot water samples. It was determined that there were high levels of some metals found in the spot water tests that were not corroborated by the AMs results, which could indicate isolated pollution events. The use of AMs in conjunction with spot water testing was determined to be beneficial in gaining deeper insight into water metal conditions in dynamic freshwater systems.     

Are naked and common mole-rats eusocial and if so, why?

Eusociality in mammals is defined in the present paper by the following criteria: reproductive altruism (which involves reproductive division of labor and cooperative alloparental brood care), overlap of adult generations, and permanent (lifelong) philopatry. We argue that additional criteria such as the existence of castes, colony size, reproductive skew, and social cohesion are not pertinent to the definition of eusociality in mammals. According to our definition of mammalian eusociality, several rodent species of the African family Bathyergidae can be considered eusocial, including the naked mole-rat (Heterocephalus glaber), Damaraland mole-rat (Cryptomys damarensis), and several additional, if not all, species in the genus Cryptomys. Furthermore, some species of social voles (like Microtus ochrogaster) may also fulfill criteria of mammalian eusociality. Understanding the evolution of eusociality in mole-rats requires answers to two primary questions: (1) What are the preconditions for the development of their eusocial systems? (2) Why do offspring remain in the natal group rather than dispersing and reproducing? Eusociality in mammals is by definition a special case of monogamy (more specifically: monogyny one female breeding), involving prolonged pair bonding for more than one breeding period. We argue that eusociality in mole-rats evolved from a monogamous mating system where cooperative brood care was already established. A tendency for group living is considered to be an ancestral (plesiomorph) trait among African bathyergid mole-rats, linking them to other hystricognath rodents. A solitary lifestyle seen in some genera, such as Bathyergus, Georychus, and Heliophobius, is assumed to be a derived trait that arose independently in different lineages of bathyergids, possibly as a consequence of selective constraints associated with the subterranean environment. In proximate terms, in eusocial mole-rats either puberty is assumed to be developmentally delayed so that under natural conditions most animals die before dispersal is triggered (e.g., in the case of Heterocephalus) or dispersal is induced only by an incidental encounter with an unfamiliar, yet adequate sexual partner (e.g., in the case of Cryptomys). Ultimately, a combination of strategies involving either dispersal and/or philopatry can be beneficial, especially in a highly unpredictable environment. If genetic relatedness among siblings is high (e.g., a coefficient of relatedness of 0.5 or more), then philopatry would not invoke an appreciable loss of fitness, especially if the cost of dispersing is higher than staying within the natal group. High genetic relatedness is more likely in a monogamous mating system or a highly inbred population. In this paper, we argue that the preconditions for eusociality in bathyergid mole-rats were a monogamous mating system and high genetic relatedness among individuals. We argue against the aridity food-distribution hypothesis (AFDH) that suggests a causal relationship between cooperative foraging for patchily distributed resources and the origin of eusociality. The AFDH may explain group size dynamics of social mole-rats as a function of the distribution and availability of resources but it is inadequate to explain the formation of eusocial societies of mole-rats, especially with respect to providing preconditions conducive for the emergence of eusociality.     

Coral-spawn slicks in the Great Barrier Reef: preliminary observations

Aerial surveys and surface samples in the spring of 1985, showed that slicks of coral eggs and embryos (coral spawn) formed in large numbers within and between reefs in the Central Great Barrier Reef Region. Coral-spawn slicks appeared on the days immediately following the annual mass multispecific spawning of reef corals. They were white or pink in colour, and were often highly elongate in form extending up to 5 km in length, and 10 m in width. Over 99% of each slick sampled during the surveys consisted of dead eggs, embryos and their breakdown products, which formed dense, highly viscous patches readily recognizable during aerial surveys. Despite the low proportion of live material, the slicks contained high concentrations of live embryos (15 to 230 per litre) which were over two orders of magnitude greater than concentrations in adjacent water masses. The distinctive colour, shape and texture of the coral-spawn slicks generally distinguished them from slicks formed by blooms of the blue-green alga Oscillatoria erythraea, which also occur commonly in the region. Many of the slicks were closely associated with surface oceanographic features, such as fronts between water parcels, and wakes and eddies behind reefs. Although more detailed sampling and surveys are required, these results suggest that it may be possible to track the movements of coral embryos and larvae directly for the first one or two days following mass spawning, and indirectly thereafter by monitoring other surface features.