Decarbonization of Vietnam’s economy: decomposing the drivers for a low-carbon growth

Environmental Science and Pollution Research - Vietnam has witnessed a rapid increase in national-level CO2 emissions due to rising urbanization, economic expansion, export growth, and industrial...     

Regional disparities in Preventive measures of COVID-19 pandemic in China. A study from international students’ prior knowledge,perception and vulnerabilities

Environmental Science and Pollution Research - The COVID-19 pandemic needs immediate solution before inflicting more devastation. So far, China has successfully controlled transmission of COVID-19...     

Ultrasensitive and selective 4-aminophenol chemical sensor development based on nickel oxide nanoparticles decorated carbon nanotube nanocomposites for green environment

Nickel oxide nanoparticles decorated carbon nanotube nanocomposites(Ni O·CNT NCs)were prepared in a basic medium by using facile wet-chemical routes. The optical,morphological, and structural properties of Ni O·CNT NCs were characterized using Fourier transformed infra-red(FT-IR), Ultra-violet visible(UV/Vis) spectroscopy, field-emission scanning electron microscopy(FESEM), X-ray energy dispersed spectroscopy(XEDS), X-ray photoelectron spectroscopy(XPS), and powder X-ray diffraction(XRD) methods. Selective4-aminophenol(4-AP) chemical sensor was developed by a flat glassy carbon electrode(GCE, surface area: 0.0316 cm~2) fabricated with a thin-layer of NCs. Electrochemical responses including higher sensitivity, large dynamic range(LDR), limit of detection(LOD), and long-term stability towards 4-AP were obtained using the fabricated chemical sensors. The calibration curve was found linear(R~2= 0.914) over a wide range of 4-AP concentration(0.1 nmol/L–0.1 mol/L). In perspective of slope(2 × 10~(-5)μA/μM), LOD and sensitivity were calculated as 15.0 ± 0.1 pM and ~ 6.33 × 10~(-4)μA/(μM·cm) respectively. The synthesized Ni O·CNT NCs using a wet-chemical method is a significant route for the development of ultrasensitive and selective phenolic sensor based on nano-materials for environmental toxic substances. It is suggested that a pioneer and selective development of 4-AP sensitive sensor using Ni O·CNT NCs by a facile and reliable current vs voltage(I–V)method for the major application of toxic agents in biological, green environmental, and health-care fields in near future.     

Application of fire suppression materials on suppression of LNG pool fires

An LNG pool fire is considered one of the main hazards of LNG, together with LNG vapor dispersion. Suppression methods are designed to reduce the hazard exclusion zones, distance to reach radiant heat of 5 kW/m², when an LNG pool fire is considered. For LNG vapor dispersion, the hazard exclusion zone is the distance travelled by the LNG vapor to reach a concentration of 2.5% v/v (half of the LNG lower flammability limit).Warming the LNG vapor to reach positive buoyancy faster is one way to suppress LNG vapor dispersion and reduce evaporation rate (thus fire size and its associated radiant heat) and that is the main objective in LNG pool fire suppression. Based on previous research, the use of high expansion foam has been regarded as the primary method in suppressing LNG pool fires. However, in 1980, another method was introduced as an alternative pool fire suppression system, Foamglas^®. The research concluded that 90% of the radiant heat was successfully reduced. Currently-called Foamglas^® pool fire suppression (Foamglas^® PFS) is a passive mitigation system and is deployed after the leak occurs. Foamglas^® PFS is non-flammable, and has a density one-third of the density of LNG, thus floats when an LNG pool is formed.This paper describes the study and confirmation of Foamglas^®PFS effectiveness in suppressing LNG pool fires. In addition, while Foamglas^® PFS is not expected to suppress LNG vapor dispersion, further investigation was conducted to study the effect of Foamglas^®PFS on LNG vapor dispersion. An LNG field experiment was conducted at Brayton Fire Field. The experimental development, procedures, results and findings are detailed in this paper.     

Feasibility of bioleaching integrated with a chemical oxidation process for improved leaching of valuable metals from refinery spent hydroprocessing catalyst

Bioleaching is considered an eco-friendly technique for leaching metals from spent hydroprocessing catalysts; however, the low bioleaching yield of some valuable metals (Mo and V) is a severe bottleneck to its successful implementation. The present study reported the potential of an integrated bioleaching-chemical oxidation process in improved leaching of valuable metals (Mo and V) from refinery spent hydroprocessing catalysts. The first stage bioleaching of a spent catalyst (coked/decoked) was conducted using sulfur-oxidizing microbes. The results suggested that after 72 h of bioleaching, 85.7% Ni, 86.9% V, and 72.1% Mo were leached out from the coked spent catalyst. Bioleaching yield in decoked spent catalyst was relatively lower (86.8% Ni, 79.8% V, and 59.8% Mo). The low bioleaching yield in the decoked spent catalyst was attributed to metals’ presence in stable fractions (residual + oxidizable). After first stage bioleaching, the integration of a second stage chemical oxidation process (1 M H₂O₂) drastically improved the leaching of Ni, Mo, and V (94.2–100%) from the coked spent catalyst. The improvement was attributed to the high redox potential (1.77 V) of the H₂O₂, which led to the transformation of low-valence metal sulfides into high-valence metallic ions more conducive to acidic bioleaching. In the decoked spent catalyst, the increment in the leaching yield after second stage chemical oxidation was marginal (<5%). The results suggested that the integrated bioleaching-chemical oxidation process is an effective method for the complete leaching of valuable metals from the coked spent catalyst.

     

Fluoride contamination in groundwater of central Rajasthan,India and its toxicity in rural habitants

This study was carried out to assess fluoride (Fl) concentration in groundwater in some villages of central Rajasthan, India, where groundwater is the main source of drinking water. Water samples collected from deep aquifer-based hand pumps were analyzed for Fl content. Fluoride in groundwater of 121 habitations of Bhilwara tehsil of Bhilwara district of Rajasthan was determined to examine the potential Fl-induced toxicity in rural locations. Fluoride concentrations in the tehsil ranged from 0.5 to 5.8 mg/l. In the tehsil, 69 villages (57%) were found to have Fl concentration beyond the maximum desirable limit recommended in Bureau of Indian Standards (BIS), 10500, 1991. Fifty-eight percent population of these villages was under the threat of fluorosis. One percent population of tehsil living in two villages ingested more than 5 mg/l Fl in each liter of drinking water and at maximal risk for dental and skeletal fluorosis. 142 individuals of these villages were examined for fluorosis. Data indicated that only four individuals (2.82%) did not exhibit dental fluorosis. Most individuals were found to suffer from mild (34.51% or 49 individuals) and moderate (31.69% or 45 individuals) fluorosis. Severe dental fluorosis was recorded in only 16 individuals (11.27%). In 104 individuals above 21 years of age examined for the prevalence of skeletal fluorosis, 66 were positive for skeletal fluorosis with a maximum 36.5% with grade I skeletal fluorosis. Grade II skeletal fluorosis was recorded in 28 individuals (26.9%). Data in this study demonstrate that there is a need to take ameliorative steps in this region to prevent fluorosis.     

Characterizing dietary variability and trophic positions of coastal calanoid copepods: insight from stable isotopes and fatty acids

The spring zooplankton community in the Strait of Georgia (British Columbia, Canada) is characterized by the presence of several calanoid copepod species which collectively make up ~90% of the mezozooplankton biomass. Here, we investigate interspecific, interannual, and geographic variability in the diets and trophic positions of these copepods using a combination of fatty acids and stable isotopes. To characterize geographic variability in diet, we compare our findings from the Strait of Georgia with similar data from Ocean Station P in the subarctic northeast Pacific. Both fatty acid and stable isotope signatures indicate the existence of three trophic levels, even within the limited size range of these copepods: Neocalanus plumchrus and Calanus marshallae are primarily omnivorous, while Euchaeta elongata is carnivorous and Eucalanus bungii is herbivorous. Fatty acid markers of trophic position (e.g., DHA/EPA, 18:1n-9/18:1n-7) correlate significantly with δ¹⁵N, while markers indicating the proportion of diatoms to flagellates in the diet (e.g., 16PUFA/18PUFA and DHA/EPA) correlate significantly with δ¹³C, after the effect of lipid concentration on δ¹³C is accounted for. Despite the general correlation between stable isotopes and fatty acids, the former are not sensitive enough to capture the range of interannual variability observed in the latter, and can only capture substantial shifts in the diet over geographic scales. However, regardless of variability in food quality, the relative trophic positions of these copepods do not change significantly either spatially or temporally.     

Removal of Novacron Golden Yellow dye from aqueous solutions by low-cost agricultural waste: Batch and fixed bed study

The present work describes the removal of Novacron Golden Yellow (NGY) dye from aqueous solutions using peanut hulls. The experiments were performed with native, pretreated and immobilised forms of peanut hulls. The effect of various operational parameters (pH, biosorbent dose, initial dye concentration and temperature etc.) was explored during batch study. NGY showed maximum removal at low pH and low biosorbent dose. High initial dye concentration facilitated the biosorption process. Maximum dye removal with native, pretreated and immobilised biomass was found to be 35.7, 36.4 and 15.02 mg/g respectively. The experimental data were subjected to different kinetic and equilibrium models. The kinetic data confirmed the fitness of pseudo-second-order rate law for NGY biosorption. The equilibrium modelling was carried out by Freundlich, Langmuir and Temkin models. The isothermal data of NGY removal were best described by Freundlich adsorption isotherm. Negative values of Free energy change (Δ G⁰) for NGY with native and pretreated biomass depicted the spontaneous nature of biosorption process. In column mode, the effects of bed height, flow rate and initial dye concentrations were optimised. Maximum NGY biosorption (7.28 mg/g) was observed with high bed height, low flow rate and high initial concentration in continuous mode. Bohart–Adams model best fitted to the data obtained from column studies. The results indicated that the peanut hulls could be used effectively for the removal of dyes containing wastewater.     

Recent developments on gas–solid heterogeneous oxidation removal of elemental mercury from flue gas

Environmental Chemistry Letters - Mercury is a toxic and persistent environmental pollutant which has been recognized as a global threat to human health and our ecosystem because&nbsp;mercury...     

Carbon nitride,metal nitrides,phosphides, chalcogenides,perovskites and carbides nanophotocatalysts for environmental applications

Environmental Chemistry Letters - Effective technologies and materials are needed for environmental detoxification and clean energy production. The actual photocatalytic technology is largely...