Modeling analyses of the effects of changes in nitrogen oxides emissions from the electric power sector on ozone levels in the eastern United States

In this paper, we examine the changes in ambient ozone concentrations simulated by the Community Multiscale Air Quality (CMAQ) model for summer 2002 under three different nitrogen oxides (NOx) emission scenarios. Two emission scenarios represent best estimates of 2002 and 2004 emissions; they allow assessment of the impact of the NOx emissions reductions imposed on the utility sector by the NOx State Implementation Plan (SIP) Call. The third scenario represents a hypothetical rendering of what NOx emissions would have been in 2002 if no emission controls had been imposed on the utility sector. Examination of the modeled median and 95th percentile daily maximum 8-hr average ozone concentrations reveals that median ozone levels estimated for the 2004 emission scenario were less than those modeled for 2002 in the region most affected by the NOx SIP Call. Comparison of the "no-control" with the "2002" scenario revealed that ozone concentrations would have been much higher in much of the eastern United States if the utility sector had not implemented NOx emission controls; exceptions occurred in the immediate vicinity of major point sources where increased NO titration tends to lower ozone levels.     

Plume persistence caused by back diffusion from thin clay layers in a sand aquifer following TCE source-zone hydraulic isolation

This paper concludes that back diffusion from one or a few thin clayey beds in a sand aquifer can cause contaminant persistence above MCLs in a sand aquifer long after the source zone initially causing the plume is isolated or removed. This conclusion is based on an intensive case study of a TCE contaminated site in Florida, with the processes evaluated using numerical modeling. At this site, the TCE DNAPL zone formed decades ago, and was hydraulically isolated by means of an innovative system performing groundwater extraction, treatment and re-injection. Treated water is re-injected in a row of injection wells situated a short distance downgradient of the extraction wells, creating a clean-water displacement front to efficiently flush the downgradient plume. This scheme avoids the creation of stagnation zones typical of most groundwater pump-and-treat systems, thereby minimizing the time for aquifer flushing and therefore downgradient cleanup. The system began operation in August 2002 and although the performance monitoring shows substantial declines in concentrations, detectable levels of TCE and degradation products persist downgradient of the re-injection wells, long after the TCE should have disappeared based on calculations assuming a nearly homogenous sand aquifer. Three hypotheses were assessed for this plume persistence: 1) incomplete source-zone capture, 2) DNAPL occurrence downgradient of the re-injection wells, and 3) back diffusion from one or more thin clay beds in the aquifer. After careful consideration, the first two hypotheses were eliminated, leaving back diffusion as the only plausible hypothesis, supported by detailed measurements of VOC concentrations within and near the clay beds and also by numerical model simulations that closely represent the field site hydrogeologic conditions. The model was also used to simulate a more generalized, hypothetical situation where more thin clayey beds occur in a sand aquifer with an underlying aquitard. While there is no doubt that DNAPL source mass reduction can eventually improve downgradient groundwater quality, the magnitude and time scale over which the improvement occurs is the major uncertainty given current characterization approaches. This study shows that even one thin clay bed, less than 0.2 m thick, can cause plume persistence due to back diffusion for several years or even decades after the flux from the source is completely isolated. Thin clay beds, which have a large storage capacity for dissolved and sorbed contaminant mass, are common in many types of sandy aquifers. However, without careful inspection of continuous cores and sampling, such thin clay beds, and their potential for causing long-term back-diffusion effects, can easily go unnoticed during site characterization.     

Thermally induced filter bias in TEOM mass measurement

Researchers at the National Institute for Occupational Safety and Health (NIOSH) have long used stationary tapered element oscillating microbalances (TEOMs) in laboratory settings. They have served to assess the mass concentration of laboratory-generated particulates in experimental dust chambers and they provide a reference method for comparison with other particulate-measuring instruments. Current NIOSH research is focused on further adapting TEOM technology as a wearable personal dust monitor (PDM) for coal mining occupations. This investigation's goal is to help identify, quantify, and provide means for resolving certain TEOM-related error. The present research investigated bias caused by thermal effects on filter assemblies. New filters used in the PDM for 8 h tests show an average positive bias of 25.5 microg, while similar tests of equivalent filters used in two 1400A model TEOMs show an average positive bias of 34.3 microg. The derived bias values allow correction of previously collected biased data. Also, pre-heating the filters for 24 h at 46 degrees C shows significant bias reduction, with PDM pre-heated filters subsequently averaging -3.3 microg and 1400A TEOM filters averaging 5.9 microg. On a single-point comparison to gravimetric sampling, a 25.5 microg bias is only significant at low mass loadings. At 2.5 mg, this bias represents a negligible 1% of the mass measurement. If ordinary linear regression is used, the bias is still insignificant. However, if the more valid weighted linear regression is used, it gives more weight to the smaller dependent variable values, which are more impacted by the bias. Consequently, what is 1% bias on a single high-mass value can translate into a larger bias percentage at high-mass values when performing a weighted regression on data that include a large number of low-mass values.     

Genetic Diversity and Tests of the Hybrid Origin of the Endangered Yellow Larkspur

Abstract: Delphinium luteum ( Ranunculaceae), an endangered larkspur, is restricted to two wild populations near Bodega Bay, California. The total number of individuals in these two populations is estimated to be <100. We used allozyme and random amplified polymorphic DNA ( RAPD) markers to (1) assess levels and patterns of genetic diversity in one wild population and two cultivated populations and (2) test the hypothesis that D. luteum is of hybrid origin between D. decorum and D. nudicaule . These data will be used to aid in developing a management plan to conserve the species. The wild population maintains high levels of genetic diversity. Genetic data indicate that both cultivated populations, especially the north Sonoma population, have several allozymes and RAPD markers not found in the wild population and could be used to establish new populations of D. luteum or to enhance the diversity and size of the wild population. The allozyme data did not reveal any fixed differences between D. decorum and D. nudicaule , although allele frequencies of the putative parental populations differed. At these loci, D. luteum resembled D. nudicaule more than D. decorum  . Many unique RAPD markers distinguish each of the three species. The diagnostic markers from populations of D. nudicaule and D. decorum were not additive in the putative hybrid, and these data indicate that D. luteum is not of recent hybrid origin. Conservation of the yellow larkspur should include strategies that use the cultivated populations of D. luteum , but hybridizing D. decorum and D. nudicaule to "recreate" D. luteum is not recommended.     

海上注聚井渗氮油管腐蚀失效原因

渤海S油田A2井渗氮防腐油管在注聚过程中发现多处腐蚀穿孔,为避免换管柱后再次发生腐蚀失效,通过腐蚀形貌观察、腐蚀产物分析、腐蚀介质分析对A2井油管腐蚀失效原因进行了研究。认为A2井油管部分渗氮层脱落,形成了电化学腐蚀的阳极,这是造成局部腐蚀的根本原因。注入水中存在较高含量的氯离子和硫酸盐还原菌,加剧了腐蚀进程,造成油管腐蚀穿孔,形成了以FeCO_3为主的腐蚀产物。建议加强渗氮油管质量管控,防止入井前渗氮层脱落,同时在注入水中加入杀菌剂减少细菌对腐蚀的影响,并在井下安装牺牲阳极短节预防腐蚀。     

Effect of pH on Anti-Rotavirus Activity by Comestible Juices and Proanthocyanidins in a Cell-Free Assay System

Cranberry (Vaccinium macrocarpon) and grape (Vitis labrusca) juices, and these species?? secondary plant metabolites [i.e., proanthocyanidins (PACs)] possess antiviral activity. An understanding of the mechanism(s) responsible for these juices and their polyphenolic constituents?? direct effect on enteric virus integrity, however, remains poorly defined. Using the rotavirus (RTV) as a model enteric virus system, the direct effect of manufacturer-supplied and commercially purchased juices [Ocean Spray Pure Cranberry 100?% Unsweetened Juice (CJ), Welch??s 100?% Grape Juice (GJ), 100?% Concord (PG) and 100?% Niagara juices (NG)] and these species?? cranberry (C-PACs) and grape PACs (G-PACs) was investigated. Loss of viral capsid integrity in cell-free suspension by juices and their PACs, and as a factor of pH, was identified by an antigen (RTV) capture enzyme-linked immunosorbent assay. At native and an artificially increased suspension at or near pH 7, loss of viral infectivity occurred after 5?min, in the order CJ?>?NG?=?GJ?>?PG, and PG?>?GJ?=?NG?=?CJ, respectively. Antiviral activity of CJ was inversely related to pH. Grape, but not cranberry PACs, displayed a comparatively greater anti-RTV activity at a suspension pH of 6.7. Anti-RTV activity of C-PACs was regained upon reduction of RTV-cranberry PAC suspensions to pH 4. An alteration or modification of Type A PAC (of V. macrocarpon) structural integrity at or near physiologic pH is suggested to have impacted on this molecule??s antivirus activity. Type B PACs (of V. labrusca) were refractive to alternations of pH. Significantly, findings from pure system RTV?CPAC testing paralleled and in turn, supported those RTV-juice antiviral studies. Electron microscopy showed an enshroudment by PACs of RTV particles, suggesting a blockage of viral antigenic binding determinants. The implications of our work are significant, especially in the interpretation of PAC (and PAC-containing food)?CRTV interactions in the differing [pH] conditions of the gastrointestinal tract.     

Spray deposition from ground-based applications of carbaryl to protect individual trees from bark beetle attack

Bark beetles (Coleoptera: Curculionidae, Scolytinae) are recognized as the most important tree mortality agent in western coniferous forests. A common method of protecting trees from bark beetle attack is to saturate the tree bole with carbaryl (1-naphthyl methylcarbamate) using a hydraulic sprayer. In this study, we evaluate the amount of carbaryl drift (ground deposition) occurring at four distances from the tree bole (7.6, 15.2, 22.9, and 38.1 m) during conventional spray applications for protecting individual lodgepole pine (Pinus contorta Dougl. ex Loud.) from mountain pine beetle (Dendroctonus ponderosae Hopkins) attack and Engelmann spruce (Picea engelmannii Parry ex Engelm.) from spruce beetle (D. rufipennis [Kirby]) attack. Mean deposition (carbaryl + alpha-naphthol) did not differ significantly among treatments (nozzle orifices) at any distance from the tree bole. Values ranged from 0.04 +/- 0.02 mg carbaryl m(-2) at 38.1 m to 13.30 +/- 2.54 mg carbaryl m(-2) at 7.6 m. Overall, distance from the tree bole significantly affected the amount of deposition. Deposition was greatest 7.6 m from the tree bole and quickly declined as distance from the tree bole increased. Approximately 97% of total spray deposition occurred within 15.2 m of the tree bole. Application efficiency (i.e., percentage of insecticide applied that is retained on trees) ranged from 80.9 to 87.2%. Based on review of the literature, this amount of drift poses little threat to adjacent aquatic environments. No-spray buffers of 7.6 m should be sufficient to protect freshwater fish, amphibians, crustaceans, bivalves, and most aquatic insects. Buffers >22.9 m appear sufficient to protect the most sensitive aquatic insects (Plecoptera).     

An evaluation of the performance of multiple passive diffusion devices for indoor air sampling of VOCs

The United States Environmental Protection Agency is considering recommending longer‐term sampling to achieve more accurate time‐weighted‐average detections for indoor air monitoring of volatile organic chemicals. The purpose of the research presented herein was to compare longer sampling times using passive diffusion samplers to the results from shorter‐term testing periods using sorbent tubes and low‐flow pumps (US EPA Method TO‐17) at great frequency for trichloroethene (TCE) in indoor air. A controlled release of TCE in a large room allowed for over two‐orders‐of‐magnitude daily concentration variability over the course of the two‐week monitoring event. The daily concentration measurements by US EPA Method TO‐17 and the passive diffusion samplers were performed in triplicate and had excellent reproducibility. The results of daily tests were averaged and compared with four passive diffusion devices exposed to indoor air for three, seven, ten, and fourteen days in accordance with ASTM D6196‐02. A specific uptake rate for each of the passive devices at the four different time intervals and the statistical significance of the time‐varying uptake rates were evaluated. The performance of each passive diffusion device was determined using a statistical performance criterion. The average concentration for all of the exposure periods could be reliably predicted using the established uptake rates for two of the four passive devices. © 2009 Wiley Periodicals, Inc.