Development and validation of a method for analysis of "dioxin-like" PCBs in environmental samples from the steel industry

A method, previously used for determination of 2,3,7,8-substituted polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs), has been modified for quantitative analysis of "dioxin-like" polychlorobiphenyls (PCBs) in environmental samples from the steel industry. The existing sample clean-up procedure, involving liquid chromatography on multi-layered silica and Florisil columns, has been extended to include a third chromatography stage on a basic alumina stationary phase. The additional clean-up stage is required for PCB analysis in order to eliminate interferences from relatively large concentrations of saturated cyclic and aliphatic hydrocarbons. Samples were analysed for WHO-12 congeners using high resolution gas chromatography/high resolution mass spectrometry (HRGC/HRMS) and standard solutions of the method US EPA 1668A. Replicate analysis of method blanks revealed background contamination for PCBs 118, 105 and 77, which are generally abundant in ambient air. These contaminants were taken into account using a subtraction method. The entire procedure was validated by replicate analysis (N = 3) of a certified reference sediment. The RSD for each WHO-12 congener was below 15%, 13C12-labelled PCB internal standard recoveries were in the range 70-95%. A waste dust sample collected in the electrostatic precipitator of a UK sinter plant was analysed for determination of PCDD/Fs and WHO-12 PCBs and exhibited a PCDD/F I-TEQ of 148.5 +/- 21.2 ngkg(-1) and a WHO-TEQ of 7.2 +/- 1.5 ngkg(-1). WHO-12 congeners contributed only 4.6% to the overall TEQ and PCB 126 was the major congener contributing to the WHO-TEQ (96%). The contribution to the overall TEQ of the waste dust sample was mainly attributed to PCDF followed by PCDD, which accounted for 86.6% and 8.7% to the overall TEQ, respectively.     

Field testing of particulate matter continuous emission monitors at the DOE Oak Ridge TSCA incinerator. Toxic Substances Control Act

A field study to evaluate the performance of three commercially available particulate matter (PM) continuous emission monitors (CEMs) was conducted in 1999-2000 at the US Department of Energy (DOE) Toxic Substances Control Act (TSCA) Incinerator. This study offers unique features that are believed to enhance the collective US experience with PM CEMs. The TSCA Incinerator is permitted to treat PCB-contaminated RCRA hazardous low-level radioactive wastes. The air pollution control system utilizes MACT control technology and is comprised of a rapid quench, venturi scrubber, packed bed scrubber, and two ionizing wet scrubbers in series, which create a saturated flue gas that must be conditioned by the CEMs prior to measurement. The incinerator routinely treats a wide variety of wastes including high and low BTU organic liquids, aqueous, and solid wastes. The various possible combinations for treating liquid and solid wastes may present a challenge in establishing a single, acceptable correlation relationship for individual CEMs. The effect of low-level radioactive material present in the waste is a unique site-specific factor not evaluated in previous tests. The three systems chosen for evaluation were two beta gauge devices and a light scattering device. The performance of the CEMs was evaluated using the requirements in draft Environmental Protection Agency (EPA) Performance Specification 11 (PS11) and Procedure 2. The results of Reference Method 5i stack tests for establishing statistical correlations between the reference method data and the CEMs responses are discussed.     

Radon Risk Communication Research: Practical Lessons

Those responsible for state and local radon programs often express frustration about the small share of homes that have been tested for radon, and the small share of those with high readings that have been mitigated. There are now a number of completed studies that have examined how well alternative ways of communicating about radon risk have accomplished the goals of motivating appropriate testing and mitigation. This paper summarizes the research results that are most crucial for planning and implementing effective radon risk communication programs. We identify six reasons why people do not respond to radon as a serious threat and provide some remedies suggested by radon studies.     

Real-time measurement of outdoor tobacco smoke particles

The current lack of empirical data on outdoor tobacco smoke (OTS) levels impedes OTS exposure and risk assessments. We sought to measure peak and time-averaged OTS concentrations in common outdoor settings near smokers and to explore the determinants of time-varying OTS levels, including the effects of source proximity and wind. Using five types of real-time airborne particle monitoring devices, we obtained more than 8000 min worth of continuous monitoring data, during which there were measurable OTS levels. Measurement intervals ranged from 2 sec to 1 min for the different instruments. We monitored OTS levels during 15 on-site visits to 10 outdoor public places where active cigar and cigarette smokers were present, including parks, sidewalk cafés, and restaurant and pub patios. For three of the visits and during 4 additional days of monitoring outdoors and indoors at a private residence, we controlled smoking activity at precise distances from monitored positions. The overall average OTS respirable particle concentration for the surveys of public places during smoking was approximately 30 microg m(-3). OTS exhibited sharp spikes in particle mass concentration during smoking that sometimes exceeded 1000 microg m(-3) at distances within 0.5 m of the source. Some average concentrations over the duration of a cigarette and within 0.5 m exceeded 200 microg m(-3), with some average downwind levels exceeding 500 microg m(-3). OTS levels in a constant upwind direction from an active cigarette source were nearly zero. OTS levels also approached zero at distances greater than approximately 2 m from a single cigarette. During periods of active smoking, peak and average OTS levels near smokers rivaled indoor tobacco smoke concentrations. However, OTS levels dropped almost instantly after smoking activity ceased. Based on our results, it is possible for OTS to present a nuisance or hazard under certain conditions of wind and smoker proximity.     

Effect of Macroalgal Expansion and Marine Protected Areas on Coral Recovery Following a Climatic Disturbance

Disturbance plays an important role in structuring marine ecosystems, and there is a need to understand how conservation practices, such as the designation of Marine Protected Areas (MPAs), facilitate postdisturbance recovery. We evaluated the association of MPAs, herbivorous fish biomass, substrate type, postdisturbance coral cover, and change in macroalgal cover with coral recovery on the fringing reefs of the inner Seychelle islands, where coral mortality after a 1998 bleaching event was extensive. We visually estimated benthic cover and fish biomass at 9 sites in MPAs where fishing is banned and at 12 sites where fishing is permitted in 1994, 2005, 2008, and 2011. We used analysis of variance to examine spatial and temporal variations in coral cover and generalized additive models to identify relations between coral recovery and the aforementioned factors that may promote recovery. Coral recovery occurred on all substrate types, but it was highly variable among sites and times. Between 2005 and 2011 the increase in coral cover averaged 1%/year across 21 sites, and the maximum increase was 4%/year. However, mean coral cover across the study area (14%) remained at half of 1994 levels (28%). Sites within MPAs had faster rates of coral recovery than sites in fished areas only where cover of macroalgae was low and had not increased over time. In MPAs where macroalgae cover expanded since 1998 there was no recovery. Where coral was recovering on granite reefs there was a shift in relative prevalence of colony life‐form from branching to encrusting species. This simplification of reef structure may affect associated reef fauna even if predisturbance levels of coral cover are attained. Efecto de la Expansión de Macroalgas y Áreas Marinas Protegidas sobre la Recuperación de Coral Después de una Perturbación Climática     

Wood bison population recovery and forage availability in northwestern Canada

Forage availability was assessed to determine sustainable stocking rates for eight broadly defined vegetation types (Treed Uplands, Treed Lowlands, Mixed Tall Shrub/Sedge, Closed-canopied Willow, and Open-canopied Willow, Meadow, Wetland Grass, Wetland Sedge) for use by wood bison (Bison bison athabascae), a threatened subspecies, in the Canadian boreal forest of northern Alberta. Clip plots (n=108) were used to sample peak availability of herbs and current annual growth of Salix spp. in late summer. Graminoid wetlands dominated by Carex atherodes, Carex aquatilis, Carex utriculata, Scolochloa festucacea, or Calamagrostis stricta produced 1975-4575 kg ha(-1) of fair to good quality forage, whereas treed stands produced < 250 kg ha(-1) of forb-dominated forage (>85% content), which was below a published 25% foraging efficiency threshold of 263 kg ha(-1) for bison. Upland forests that dominate the region produced < or = 1 animal unit day (AUD) of forage per hectare in summer. Most forest understory plants were of poor forage value, suggesting the potential sustainable stocking rate of such areas was actually < or = 0.3 AUD ha(-1), with even lower rates during winter due to snow cover. Herbaceous wetlands contained approximately 78 AUD ha(-1) of forage, but were considered largely unavailable in summer because of flooding and soft organic soils that make access difficult. Conversion of prime foraging habitat to agricultural land, forest expansion due to fire control, and a warmer and wetter climatic regime after the mid-1900s likely contributed to a regional reduction in carrying capacity. It is hypothesized that substantial recovery of the wood bison population toward historical levels will be constrained in northern Alberta by the availability of summer forage, and the limited extent of graminoid wetlands that provide winter foraging habitat.     

A Combined Ca(OH)2/NH3 Flue Gas Desulfurization Process for High Sulfur Coal: Results of a Pilot Plant Study

The removal of SO₂ with atomization of a slaked lime slurry and supplemental injection of gaseous NH₃ were tested in a conventional spray dryer/baghouse system for SO₂ concentrations of 2000 ppm and 3000 ppm and a 30° F approach to saturation. Results at 3000 ppm of SO₂ showed an average SO₂ removal efficiency of 90.3 percent at a combined stoichiometric ratio of 0.95-1.10 and an average overall sorbent utilization of 91.6 percent. The overall molal ratio of NH₃/SO₂ reaction was found to be 2:1 under the test conditions Particle size analyses, and EP toxicity tests were conducted on the products of the reactions.