Remediation procedure used for contaminated soil and underground water: A case study from the chemical industry

This is a case study of contamination by a non-aqueous phase liquid (NAPL) that leaked from a chemical plant. The remediation procedure adopted for the initial phase of the plume migration was a plastic diaphragm wall coupled with a series of water extraction wells designed to avoid environmental impact on the surrounding ecosystems. Monitoring has shown that the containment is successful, and additional measures that contribute to accelerating remediation have been adopted. The authors wished to investigate how remediation might be further enhanced. The use of in situ aeration coupled with a system of soil vapor extraction (AS/SVE) has been chosen, since the remediation of sites with characteristics similar to those in this study, if based exclusively on dissolved-phase control, would take several decades to be completed. The transport of contaminant plumes has been simulated by using an analytical model to evaluate the effectiveness of the natural attenuation of the contaminant. The results of the simulation have confirmed the limited effectiveness of the natural attenuation of the contaminant, as well as the effective increase of remediation that would occur if the AS/SVE system is applied. A sensitivity analysis that included several combinations of increments of parameters that correspond to the decay rate of the source and the dissolved plume has simulated what might happen if the AS/SVE system is implemented.     

Assessing spatial variability of SO2 field as detected by an air quality network using Self-Organizing Maps,cluster, and Principal Component Analysis

In Bilbao (Spain), an air quality network measures sulphur dioxide levels at 4 locations. The objective of this paper is to develop a practical methodology to identify redundant sensors and evaluate a network's capability to correctly follow and represent SO₂ fields in Bilbao, in the frame of a continuous network optimization process.The methodology is developed and tested at this particular location, but it is general enough to be useable at other places as well, since it is not tied neither to the particular geographical characteristics of the place nor to the phenomenology of the air quality over the area.To assess the spatial variability of SO₂ measured at 4 locations in the area, three different techniques have been used: Self-Organizing Maps (SOMs), cluster analysis (CA) and Principal Component Analysis (PCA). The results show that the three techniques yield the same results, but the information obtained via PCA can be helpful not only for that purpose but also to throw light on the major mechanisms involved. This might be used in future network optimization stages. The main advantage of cluster analysis and SOMs is that they provide readily interpretable results. All the calculations have been carried out using the freely available software R.     

Operation and maintenance of water projects and services in Latin America

This paper concentrates on two aspects of the vast subject of '… water projects and services'. Even though the questions tackled may affect different water uses, this analysis is focused on operation and maintenance of water supply systems and the institutions that service them. The paper seeks to analyse some of the obstacles which impede the attainment of better performance in the operation and maintenance of water projects. It tackles the institutional problems and restrictions which must be overcome to speed up the adoption of operational patterns which will lead to a better use of available capacities.     

Characterization of humic-rich hydrocolloids and their metal species by means of competing ligand and metal exchange--an on-site approach

An improved on-site characterization of humic-rich hydrocolloids and their metal species in aquatic environments was the goal of the present approach. Both ligand exchange with extreme chelators (diethylenetetraaminepentaacetic acid (DTPA), ethylendiaminetetraacetic acid (EDTA)) and metal exchange with strongly competitive cations (Cu(II) were used on-site to characterize the conditional stability and availability of colloidal metal species in a humic-rich German bogwater lake (Venner Moor, Münsterland). A mobile time-controlled tangential-flow ultrafiltration technique (cut-off: 1 kDa) was applied to differentiate operationally between colloidal metal species and free metal ions, respectively. DOC (dissolved organic carbon) and metal determinations were carried out off-site using a home-built carbon analyzer and conventional ICP-OES (inductively-coupled plasma-optical emission spectrometry), respectively. From the metal exchange equilibria obtained on-site the kinetic and thermodynamic stability of the original metal species (Fe, Mn, Zn) could be characterized. Conditional exchange constants Kex obtained from aquatic metal species and competitive Cu(II) ions follow the order Mn > Zn > > Fe. Obviously, Mn and Zn bound to humic-rich hydrocolloids are very strongly competed by Cu(II) ions, in contrast to Fe which is scarcely exchangeable. The exchange of aquatic metal species (e.g. Fe) by DTPA/EDTA exhibited relatively slow kinetics but rather high metal availabilities, in contrast to their Cu(II) exchange.     

Distribution in Portugal of some pollutants in the lichen Parmelia sulcata

During the months of July and August 1993 a lichen (Parmelia sulcata Taylor) collection campaign was held in Portugal where samples were obtained from olive tree bark at 228 sites, following a grid of 10 x 10 km along the Atlantic coast and 50 x 50 km in the interior of the country. The samples were analysed by instrumental neutron activation analysis and proton induced X-ray emission techniques. Concentration data patterns for the pollutants As, Cr, Hg, Ni, Pb, S, Sb, Se, and V were obtained for the whole country surface by making use of an extinction rule of 1/r(3), preventing any cut-off distance from being artificially introduced. Some pollution sources were identified: (1) oil-powered plants on the Lisbon-Setúbal axis (V, Ni), (2) coal-power plants in Porto and Sines (S, Se), (3) traffic in the northern area and the Lisbon-Setúbal axis (Pb), (4) a chemical industry south of Porto (Hg, As), and (5) soil influence (Cr, Sb). Arsenic and chromium results largely exceed, in a few areas, the concentrations acceptable to plants, and in a few spots also Hg, Ni, and Pb data.     

Influence of organic loading on an anaerobic sequencing biofilm batch reactor (ASBBR) as a function of cycle period and wastewater concentration

The effect of organic loading on the performance of a mechanically stirred anaerobic sequencing biofilm batch reactor (ASBBR) has been investigated, by varying influent concentration and cycle period. For microbial immobilization 1-cm polyurethane foam cubes were used. An agitation rate of 500 rpm and temperature of 30+/-2 degrees C were employed. Organic loading rates (OLR) of 1.5-6.0gCODl(-1)d(-1) were applied to the 6.3-l reactor treating 2.0 l synthetic wastewater in 8 and 12-h batches and at concentrations of 500-2000mgCODl(-1), making it possible to analyze the effect of these two operation variables for the same organic loading range. Microbial immobilization on inert support maintained approximately 60 gTVS in the reactor. Filtered sample organic COD removal efficiencies ranged from 73 to 88% for organic loading up to 5.4gCODl(-1)d(-1). For higher organic loading (influent concentration of 2000mgCODl(-1) and 8-h cycle) the system presented total volatile acids accumulation, which reduced organics removal efficiency down to 55%. In this way, ASBBR with immobilized biomass was shown to be efficient for organic removal at organic loading rates of up to 5.4gCODl(-1)d(-1) and to be more stable to organic loading variations for 12-h cycles. This reactor might be an alternative to intermittent systems as it possesses greater operational flexibility. It might also be an alternative to batch systems suspended with microorganisms since it eliminates both the uncertainties regarding granulation and the time necessary for biomass sedimentation, hence reducing the total cycle period.     

An Ecological Integrity Index for Littoral Wetlands in Agricultural Catchments of Semiarid Mediterranean Regions

The main goal of the present study was to develop an ecological integrity index for littoral wetland management and conservation in semiarid Mediterranean areas that have been highly impacted by agriculture, including the selection of pressure and state indicators at landscape and wetlands scales that reflect the status, condition, and trends of wetlands ecosystems. We used a causality framework based on the relationship between pressure of anthropogenic activities and the ecological state of wetlands and their catchments, integrating environmental, biologic, economic, and social issues. From the application of 51 indicators in 7 littoral wetlands in the southeastern Iberian Peninsula, we selected 12 indicators (5 at catchment scale and 7 at wetland scale) to constitute the ecological integrity index proposed. The potential nitrogen export per area at catchment scale and the potential relative nitrogen export from the area surrounding the wetlands were the best pressure single predictors of state indicators with a causal relationship with environmental meaning. Wetlands in catchments with more agriculture had less ecological integrity than those in less impacted areas. A wide riparian zone in some wetlands acts as a buffer area, diminishing the effects of intensive agriculture. The index of ecological integrity developed here has a number of essential characteristics that make it a useful tool for ecosystem managers and decision-makers. The index can be used to (1) assess and control ecological integrity, (2) diagnose probable causes of ecological impairment, (3) establish criteria for protecting and restoring wetland ecosystems, and (4) integrate catchment management. Published online     

Fed-batch and batch operating mode analysis of a stirred anaerobic sequencing reactor with self-immobilized biomass treating low-strength wastewater

This work presents an analysis of a stirred anaerobic sequencing discontinuous reactor with different substrate feeding strategies resulting in batch, fed-batch/batch and fed-batch operating modes. The reactor, containing granulated biomass, was fed with approximately 2.0L of synthetic domestic wastewater with Chemical Oxygen Demand of nearly 500 mg/L per cycle and operated at 30 degrees C and 50 rpm. Three feeding strategies with a total cycle time of 6 h, including 30-min settling, were adopted: batch mode with a fill cycle of 6 min, a fed-batch/batch mode with fill cycles of 60, 120 and 240 min and fed-batch mode with a fill cycle of 320 min. The system attained average non-filtered and filtered substrate removal efficiency of 78 and 84%, respectively, for all operating conditions, presenting good stability, solid retention and no granule break-up. A first order kinetic model with a residual organic matter concentration was proposed to analyze the influence of the feeding strategy on the performance during a cycle and bicarbonate alkalinity and total volatile acids concentration profiles were also quantified in order to verify the transient stability behavior.     

Landform Classification for Land Use Planning in Developed Areas: An Example in Segovia Province (Central Spain)

Landform-based physiographic maps, also called land systems inventories, have been widely and successfully used in undeveloped/rural areas in several locations, such as Australia, the western United States, Canada, and the British ex-colonies. This paper presents a case study of their application in a developed semi-urban/suburban area (Segovia, Spain) for land use planning purposes. The paper focuses in the information transfer process, showing how land use decision-makers, such as governments, planners, town managers, etc., can use the information developed from these maps to assist them. The paper also addresses several issues important to the development and use of this information, such as the goals of modern physiography, the types of landform-based mapping products, the problem of data management in developed areas, and the distinctions among data, interpretations, and decisions.