山东半岛城市群人居环境质量综合评价

随着中国城市化的高速发展,"城市病"问题日益突出,城市群作为统筹区域协调发展、建设宜居人居环境的重点地区,其人居环境发展状况备受关注。基于此,本文以山东半岛城市群为例,从人文环境、经济环境、社会环境和生态环境4个方面构建人居环境质量综合评价指标体系,利用人居环境质量计算模型和系统协调度模型,对其人居环境质量进行静态定量化评价和动态综合性评价。研究表明:(1)山东半岛城市群人居环境质量与社会环境的关联性最大,经济实力、基础设施水平时空发展不均衡、地域差异大,是制约山东半岛城市群人居环境发展的突出问题。(2)2000—2014年山东半岛城市群人居环境综合水平呈现良好的上升趋势,且增速较稳,增幅较小;各要素间的协调性均达到了中级协调等级;系统层的评价值除人文环境外,均呈现不同程度的波动式上升态势;领域层的评价值差异明显,发展不均衡。(3)城市群内部各城市人居环境综合质量水平逐步提高,且排名相对稳定;各要素间的协调度等级差异较小,但起伏变化较大;人居环境质量时空分异特征明显,呈现东西高、中间低的格局,内部级别差异显著,可分为较好、一般、较差、差4个等级。在今后的发展中,应针对山东半岛不同城市人居环境问题采取因时因地制宜的协调对策,创造整体最优人居环境。不仅要提高城市群的整体经济水平,提升城市群的短板建设,推动人居环境协调发展,还要符合新常态下城市发展与建设的要求,加快山东半岛城市群的区域创新体系构建,科学引领产业转型升级,优化产业结构,加强山东半岛城市规划研究与实施力度,探索"多规合一"模式。     

好氧颗粒污泥自生动态膜生物反应器处理碱减量印染废水

自生动态膜生物反应器(SFDMBR)接种颗粒污泥启动,研究溶解氧浓度和水力停留时间对该反应器处理碱减量印染废水的影响。自生动态膜生物反应器形成稳定的动态膜后,出水浊度小于10 NTU,系统对浊度的去除率在90%以上,溶解氧和水力停留时间对反应器出水浊度基本无影响。系统对废水色度的去除率随着溶解氧浓度的提高和水力停留时间的延长而增加,但是系统对色度的去除效率一般不超过40%。溶解氧浓度由0.3 mg/L逐渐增大至2.4 mg/L,COD的去除率由40%提升至80%,而当溶解氧浓度大于1.0 mg/L后,UV254的去除率达到95%。水力停留时间在8~48 h时,COD去除效率由65%逐渐上升至85%左右;水力停留时间在8~32 h,UV254去除效率为68%~93%,超过32 h后水力停留时间对UV254去除效率的影响已不明显。     

Characterization of the extracellular biodemulsifiers secreted by Bacillus cereus LH-6 and the enhancement of demulsifying efficiency by optimizing the cultivation conditions

A highly efficient demulsifying strain, LH-6, was isolated from petroleum-contaminated soil and identified as Bacillus cereus by 16S rDNA gene analysis. It achieved 95.61 and 95.40 % demulsifying ratios within 12 h for water-in-oil (W/O) and oil-in-water (O/W) model emulsions, respectively. Fourier transform infrared spectroscopy (FT-IR) and thin-layer chromatography (TLC) detections indicated that the LH-6’s extracellular biodemulsifiers were different types of lipopeptides for the W/O and O/W emulsions. Optimization of the culture medium composition was conducted to improve the biosynthesis and demulsifying efficiency of the biodemulsifier. The optimal carbon source was liquid paraffin, while waste frying oil could also be an alternative carbon source. The optimal nitrogen sources were ammonium sulfate and yeast extract. To further enhance the biodemulsifier efficiency, the optimal cultivation conditions were determined using response surface methodology (RSM) based on central composite rotation design (CCRD). Using the optimized cultivation conditions, the demulsifying ratios increased to 98.23 and 97.65 % for the W/O and O/W model emulsions, respectively.     

恩施地区生态足迹和生态承载力评价

以恩施地区2010年统计数据为依据，对其2010年的生态足迹、生态承载力、生态盈余进行计算和分析，并将生态足迹、生态承载力、生态盈余和万元GDP生态足迹分别与恩施地区贫困村分布密度进行空间耦合。研究表明：（1）恩施地区人均生态盈余为0467 hm2，人均生态承载力为0947 1 hm2，人均生态足迹为048 hm2；（2）贫困村分布密度最高的来凤县、建始县人均生态盈余很少，而贫困村分布密度最低的利川市、咸丰县、宣恩县、鹤峰县，人均生态足迹最高和最低的县分别是咸丰县、宣恩县，鹤峰县的生态承载力最高，人均生态盈余最高的是宣恩县、鹤峰县，万元GDP生态足迹最高和最低的分别是利川市，巴东县；（3）通过生态足迹的研究，提出了恩施贫困地区需放大生态比较优势，〖JP2〗因地制宜，努力将生态盈余转化为直接的经济增长，使之能够有效的帮助贫困地区脱贫致富     

Carbonyl emissions from vehicular exhausts sources in Hong Kong

Vehicular emission (VE) is one of the important anthropogenic sources for airborne carbonyls in urban area. Six types of VE-dominated samples were collected at representative locations in Hong Kong where polluted by a particular fueled type of vehicles, including (i) a gas refilling taxis station (liquefied petroleum gas [LPG] emission); (ii) a light-duty passenger car park (gasoline emission); (iii) a minibus station (diesel emission); (iv) a single-deck-bus depot (diesel emission); (v) a double-deck-bus depot (diesel emission); and (vi) a whole-food market entrance for light- and heavy-duty vehicles (diesel emission). A total of 15 carbonyls in the samples were quantified. Formaldehyde was the most abundant carbonyl among the VE-dominated samples, and its contribution to the total quantified amount on a molar basis ranged from 54.8% to 60.8%. Acetaldehyde and acetone were the next two abundant carbonyls. The carbonyls were quantified at three roadside locations in Hong Kong. The highest concentrations of formaldehyde and acetaldehyde, 22.7 +/- 8.4 and 6.0 +/- 2.8 microg/m3, respectively, were determined in the samples collected at a main transportation gate for goods between Hong Kong and Mainland China. The total quantified carbonyl concentration, 37.9 +/- 9.3 microg/m3, was the highest at an entrance of a cross-harbor tunnel in downtown area. The theoretical carbonyls compositions of the three roadside locations were estimated according to the VE-dominated sample profiles and the statistics on vehicle numbers and types during the sampling period. The measured compositions of formaldehyde were much higher than the theoretical compositions in summer, demonstrating that photochemical reactions significantly contributed to the formaldehyde production in the roadsides.     

电镀污泥的热处理特性以及对金属回收的影响

焙烧-酸浸法可有效回收电镀污泥中的有价金属,而污泥的热处理特性是决定能否采用焙烧预处理的重要因素。研究了氧化焙烧和还原焙烧对污泥成分和金属浸出性的影响,并对焙烧前后的污泥进行了金属形态分析和X射线衍射(XRD)分析。结果表明,焙烧预处理实现了污泥减量和金属富集;ES1经氧化焙烧后金属浸出率接近原泥,Cu的浸出率达99%;ES2的还原焙烧效果优于氧化焙烧,特别是Cu的浸出率超过97%,XRD分析发现,还原焙烧过程中金属Cu被还原为铁铜合金;2种焙烧均造成了ES3中目标金属Ni的浸出率的降低;金属浸出性的下降与残渣态的形成有关。     

负载壳聚糖膨润土的制备及其吸附性能的影响

以天然膨润土和壳聚糖为原料，制得一种新型水处理剂——负载壳聚糖膨润土，研究了制备条件对酸性大红印染废水处理效果的影响。实验表明，当壳聚糖的浓度为30 g/L、膨润土质量与壳聚糖溶液体积之比为0.7、浸泡时间80 min、微烘时间15 min时，壳聚糖改性膨润土对酸性大红印染废水的脱色率可达97%。对改性土进行比表面积测定、电镜扫描及X-射线衍射等结构特性分析，证明壳聚糖的引入改变了膨润土在水中的分散状态，增强了其对污染物的吸附和离子交换能力。     

电解-水生植物-软隔离带复合技术治理重污染河流的中试研究

为了探索重污染河流的治理技术，2011年3月在无锡市新区鸿山镇徐塘桥河开展生态治理示范工程，通过电解技术、种植高等水生植物和构建软隔离带复合工程技术改善河流水质。实验结果表明，通过电解技术，可以迅速降低TP、氨氮（NH4＋-N）和COD；但较难减少TN。通过软隔离带可以有效隔离外源污染，在较短时间内改善河流TN、TP、COD的平均水平，但是难以提高河流的生态系统稳定性。电解能够有效的降解大分子有机物，为水生植物提供良好的生长环境，之后再种植水生植物，能够进一步降低的TN、TP。通过电解一水生植物一软隔离带复合技术不仅能够全面改善河流水质的平均水平，而且能够修复水生生态系统，提高生态系统稳定性。     

壳聚糖复合絮凝剂处理造纸废水的实验研究

研究并考察了壳聚糖复合絮凝剂对造纸污水中COD和SS的絮凝效果，结果表明，当复合絮凝剂的配方和处理条件为：聚合硫酸铁（PFS）60 mg/L聚丙烯酰胺（PAM）2 mg/L壳聚糖（CTS）0.4 mg/L，pH为7.5时，其絮凝效果最佳，此时它对水中COD与SS的去除率分别达到57.4%和97.6%, 与传统絮凝剂PAC/PAM相比，COD与SS的去除率分别提高了10.1%和5.2%，药剂成本下降了21.1%，具有明显的经济效益与环境效益。     

Studies of potential sources that contributed to atmospheric mercury in Toronto,Canada

This study identified sources of mercury (Hg) in downtown Toronto, Canada by analyzing gaseous elemental mercury (GEM), mercury associated with particles with sizes less than 2.5 microns (PHg < 2.5), and gaseous oxidized inorganic mercury (GOIM), commonly referred to as reactive gaseous mercury (RGM), and air pollutants (CO, NO_x, O₃, PM_2.5, SO₂) concentrations between Dec 2003 and Nov 2004. The data were analyzed using Positive Matrix Factorization (PMF) model, Principal Components Analysis (PCA), ratio analysis, back trajectories, and correlation analyses. The analyses suggest industrial sources (chemical production, metal production, sewage treatment), rather than coal combustion, were the major contributors to measured Hg levels. Overlap in source profiles for the Hg sources listed in the Canadian National Pollutant Release Inventory (NPRI) and lack of source profiles for urban sources were the major limitations to positively identifying sources from the PMF and PCA factors. Correlation analyses revealed direct emissions were the sources of GOIM in spring, summer, and fall, and the occurrence of GEM oxidation by ozone in the summer. Elevated Hg events are attributed to emissions from urban sources near the sampling site, regional point sources, and photochemical processes involving ozone.