Impact of air pollution on outdoor cultural heritage objects and decoding the role of particulate matter: a critical review

Environmental Science and Pollution Research - Atmospheric gases and particulate matter (PM) in contact with the material’s surface lead to chemical and physical changes, which in most cases...     

Chemical and morphological characterization of aerosol particles at Mt. Krvavec, Slovenia, during the Eyjafjallajökull Icelandic volcanic eruption

Objective

In this work, continuous and size-segregated aerosol measurements at Mt. Krvavec, Slovenia, during the Eyjafjallajökull volcanic eruption were performed. Based on chemical and morphological characteristics of size-segregated particles, the presence of the volcanic aerosols after long-range transport to Slovenia was to be confirmed.

Results and conclusions

Continuous measurements with the aethalometer and SMPS indicated the suspected volcanic ash plume passing over the sampling site. The aerosols collected by discrete sampling showed a chemical signature similar to the known elemental signature of the Icelandic volcanic ash. Coarse particles showed a composition typical for silicates rich in metals; in many cases also S was present. Morphological analysis showed particles with features indicative of an explosive volcanic eruption, e.g., pumice and pumice shards, glass shards, minerals, evidence of steam condensation, etc. The high sulfate concentration associated with the fine particles resulted in sulfate crystallization within the cascade impactor leading to the formation of large structures resembling a “fern”. Mass size distributions for Fe, Ti, Mn, Ca, Na, and Mg showed one primary peak (for Fe, Mn, and Ti at 2.8 μm; for Ca, Na, and Mg at ca. 4 μm), which supports the fact that most of the particles in the coarse sizes were silicates rich in metals. The size distribution of the water-soluble SO ₄ ^2? showed a maximum peak at 0.75 μm, which also confirms the high sulfate concentration in the fine particles. Chemical and morphological characterization of aerosols collected at Mt. Krvavec indeed confirmed that volcanic ash plume passed over Slovenia.     

Volatile aldehydes in libraries and archives

Volatile aldehydes are produced during degradation of paper-based materials. This may result in their accumulation in archival and library repositories. However, no systematic study has been performed so far. In the frame of this study, passive sampling was carried out at ten locations in four libraries and archives. Despite the very variable sampling locations, no major differences were found, although air-filtered repositories were found to have lower concentrations while a non-ventilated newspaper repository exhibited the highest concentrations of volatile aldehydes (formaldehyde, acetaldehyde, furfural and hexanal). Five employees in one institution were also provided with personal passive samplers to investigate employees’ exposure to volatile aldehydes. All values were lower than the presently valid exposure limits.The concentration of volatile aldehydes, acetic acid, and volatile organic compounds (VOCs) in general was also compared with that of outdoor-generated pollutants. It was evident that inside the repository and particularly inside archival boxes, the concentration of VOCs and acetic acid was much higher than the concentration of outdoor-generated pollutants, which are otherwise more routinely studied in connection with heritage materials. This indicates that further work on the pro-degradative effect of VOCs on heritage materials is necessary and that monitoring of VOCs in heritage institutions should become more widespread.     

Treatment of high-ammonium anaerobic digester supernatant by aerobic granular sludge and ultrafiltration processes

Anaerobic sludge digester supernatant characterized by 569 mg TKN L^?1, high color and a COD/N ratio of 1.4 was treated in granular sequencing batch reactors (GSBRs) followed by post-denitrification (P-D) and ultrafiltration (UF) steps. The use of granular sludge allowed for the oxidation of ammonium in anaerobic digester supernatant at all investigated GSBR cycle lengths of 6, 8 and 12 h. The highest ammonium removal rate (15 mg N g^?1 VSS h^?1) with removal efficiency of 99% was noted at 8 h.Since the GSBR effluent was characterized by a high concentration of nitrites, slowly-degradable substances and biomass, additional purification steps were applied. In P-D stage, the microbial activity of granular biomass in the GSBR effluent was implemented. The P-D was supported by external carbon source addition and the most advantageous variant comprised dosing of half of the theoretical acetate dose for nitrite reduction in the 3-h intervals. The use of the system consisting of the GSBR with 8 h, an optimal P-D variant and a UF for the treatment of anaerobic digester supernatant allowed for the 99%, 71% and 97% reductions of TKN, COD and color, respectively.     

Electrochemical treatment of wastewater to remove contaminants from the production and disposal of plastics: a review

Wastewater is major source of contaminants originating from the production, usage, and disposal of plastic materials. Due to their poor biodegradability of these contaminants in municipal wastewater treatment plants, additional advanced oxidation processes such as electrochemical treatments have been developed to improve the standard biological treatment. Here we review the applications of electrochemical treatments of wastewater for the removal of the following plastic contaminants: bisphenol A, phthalic acid esters, and benzotriazoles. We present the effectiveness of treatment in terms of contaminant removal and mineralization; the identification of transformation products; toxicity assessment; and process energy requirements. In the present review, we have focused on the applications of electrochemical treatments of wastewater for the removal of three important groups of contaminants originating mainly from plastics: bisphenol A, phthalic acid esters, and benzotriazoles. The review focuses on the research of electrochemical treatments for these contaminants from the last five years. The papers are assessed from the point of i) effectiveness of treatment in terms of contaminant removal and mineralization; ii) identification of transformation products; iii) toxicity assessment; iv) processes’ energy requirements. Electrochemical treatments were confirmed to be a viable option for the removal of selected contaminants from wastewater.