强化垂直流可渗透反应墙处理渗滤液污染物

针对垃圾渗滤液污染物组分多、处理难度大、可生化性差的特点,基于可渗透反应墙(PRB)被动修复技术,通过多种填料的组合构建三重垂直流PRB强化的砂箱模型,对垃圾渗滤液进行连续动态处理研究。实验结果表明,填料的组合顺序对强化PRB系统净化能力有较大的影响,由无烟煤、沸石、钢渣依次组成的强化垂直流PRB系统(2#砂箱)对NH+4-N、NO-3-N、NO-2-N、COD、PO3-4-P的平均去除率分别为96.12%、30.36%、75.24%、39.03%和30.47%,处理效果明显好于相同条件下依次由无烟煤、钢渣、沸石组成的强化垂直流PRB系统(1#砂箱)。与常规PRB处理系统相比,强化垂直流可渗透反应墙系统可实现垃圾渗滤液中多种污染物同步有效去除,是极具发展潜力的新型技术。     

Kinetics of peanut shell pyrolysis and hydrolysis in subcritical water

Biomass is recognized as an important solution to energy and the environmental problems related to fossil fuel usage. The rational utilization of biomass waste is important not only for the prevention of environmental issues, but also for the effective utilization of natural resources. Pyrolysis and hyrolysis in subcritical water are promising processes for biomass waste conversion. This paper deals with hydrolysis and pyrolysis of peanut shells. Hydrolysis and pyrolysis kinetics of peanut shell wastes were investigated for the in-depth exploration of process mechanisms and for the control of the reactions. Hydrolysis kinetics was conducted in a temperature range of 180–240 °C. A simplified kinetic model to describe the hydrolysis of peanut shells was proposed. Hydrolysis activation energy as well as the pre-exponential factor was determined according to the model. The target products of peanut shell hydrolysis, reducing sugars, can reach up to 40.5 % (maximum yield) at 220 °C and 180 s. Pyrolysis characteristics were investigated. The results showed that three stages appeared in this thermal degradation process. Kinetic parameters in terms of apparent pyrolysis activation energy and pre-exponential factor were obtained by the Coats–Redfern method.     

The fate and risk of selected pharmaceutical and personal care products in wastewater treatment plants and a pilot-scale multistage constructed wetland system

The removal of 12 pharmaceuticals and personal care products (PPCPs) in two full-scale wastewater treatment plants (WWTPs) and a tertiary treatment system was studied. The ecological risks of effluents from both secondary and tertiary treatment systems as well as excess sludge were evaluated. Primary treatment and ultraviolet light disinfection showed limited ability to remove most selected PPCPs. The combination of an anaerobic process and triple-oxidation ditches can eliminate DEET better than the anaerobic/anoxic/oxic process. Adsorption to sludge played a key role in the removal of triclocarban. Multistage constructed wetlands as a tertiary treatment efficiently removed caffeine and ibuprofen from wastewater and could decrease the risk of partial selected PPCPs. Selected PPCPs residues in excess sludge generally produced higher risks to the ecological environment than effluents from WWTPs.     

Medium optimization for the production of anti-cyanobacterial substances by Streptomyces sp. HJC-D1 using response surface methodology

Bioremediation using isolated anti-cyanobacterial microorganism has been widely applied in harmful algal blooms (HABs) control. In order to improve the secretion of activated anti-cyanobacterial substances, and lower the cost, a sequential optimization of the culture medium based on statistical design was employed for enhancing the anti-cyanobacterial substances production and chlorophyll a (Chl a) removal by Streptomyces sp. HJC-D1 in the paper. Sucrose and KNO₃ were selected as the most suitable carbon and nitrogen sources based on the one-at-a-time strategy method, and sucrose, KNO₃ and initial pH were found as major factors that affected the anti-cyanobacterial ability of the isolated stain via the Plackett–Burman design. Based on the response surface and canonical analysis, the optimum condition of culture medium was obtained at 22.73 g l^-1 of sucrose, 0.96 g l^-1 of KNO₃, and initial pH 8.82, and the Chl a removal efficiency by strain HJC-D1 increased from 63?±?2 % to 78?±?2 % on the optimum conditions.     

Degradation of aqueous Rhodamine B by plasma generated along the water surface and its enhancement using nanocrystalline Fe-, Mn-, and Ce-doped TiO2 films

The degradation of aqueous Rhodamine B (RhB) was examined using a dual-channel spark switch module designed to regulate the steepness of pulsed high voltage with microsecond rise time. Depending on the energy per pulse, a spark along the water surface (SPWS) or streamer along the water surface (STWS) was formed. STWS was found to have a better degradation effect and energy efficiency toward RhB than SPWS at the same power; however, addition of H₂O₂ amounts resulted in increased degradation, the effect being more pronounced using SPWS. The initial concentration of RhB also appeared to influence the rate constant of the degradation reaction. Furthermore, TiO₂ films doped with Fe, Mn, and Ce were found to enhance the degradation performance of plasma. A possible reaction mechanism of plasma formation along the water surface was concluded by determination of the main inorganic products in the liquid and gas phases.     

臭氧氧化—包埋菌流化床生物处理组合工艺深度处理煤气化废水

采用臭氧氧化—包埋菌流化床生物处理组合工艺对煤气化废水进行深度处理。实验结果表明：当臭氧的质量浓度20 mg/L、臭氧进气流量1.5 L/min、臭氧通气时间30 min、包埋菌流化床水力停留时间24 h时,臭氧氧化工序的COD去除率达到30.0%~40.0%,总酚去除率达到100.0%;包埋菌流化床工序的COD去除率达到60.0%以上,氨氮的去除率大于95.0%;经组合工艺处理后,出水COD<60 mg/L,ρ（氨氮）<1.0 mg/L,ρ（总酚）未检出,色度小于50倍,达到GB8978—1996《污水综合排放标准》中的一级排放标准。     

基于改性凹凸棒土的强化混凝处理高藻低浊原水工艺

针对水厂低浊高藻水的处理难题,研究了改性凹凸棒土(改性凹土)联合聚合氯化铝(PAC)强化混凝的除藻除浊效果。设计实验原水条件为叶绿素a(chl-a)浓度为98.58~110.35μg/L,浊度(5.6±0.5)NTU。考察了PAC和改性凹土的复配投加量、混凝沉淀时间、pH、投加顺序、搅拌速率等工艺参数对Chl-a和浊度耦合去除效果的影响。结果表明,"PAC+改性凹土"对Chl-a和浊度的去除效果明显优于单投PAC的效果。当PAC投药量12 mg/L,改性凹土投药量10 mg/L,沉淀时间20 min时,对Chl-a和浊度的去除率可分别达到92.5%和89.2%,可至少减少40%的PAC投量,且形成的矾花密实,沉降速度快,去除效率高。最适pH范围为7~8。投加顺序应为先投加改性凹土,混合搅拌转数宜慢速,可控制为50 r/min。     

介质阻挡放电协同Ag/Al_2O_3对NO_x脱除的影响

为有效去除发电厂烟气中产生的NOx,利用介质阻挡放电(DBD)产生低温等离子体并结合催化剂Ag/Al2O3进行烟气脱硝实验,研究了在加入乙烯的条件下,平均负载量、催化温度和装置的布置方式对NOx脱除的影响。结果表明,随着负载的增多,NO脱除率呈现先增大后减小的趋势,5种负载量中最佳为1.76%;随着催化温度的升高,NO脱除率同样呈现先增大后减小的趋势,最佳的催化温度为150℃左右;3种不同布置方式对NO和NOx脱除有明显差别,单独催化剂在NO和NOx的脱除率都比较低;单独介质阻挡放电NO脱除率很高,但是NOx很却很低;而两者结合在NO和NOx都达到了很好的效果。     

电渗透脱水对污泥热干燥特性的影响

以污水厂机械脱水后的污泥作为研究对象,提出了采用电渗透-热干燥结合进行深度脱水的方法。通过对原泥以及电渗透脱水至不同含水率(67%、71%和76%)的污泥在热干燥过程中含水率和干燥速率的测定,分析电渗透脱水对污泥热干燥特性的改善规律。结果表明,经电渗透脱水至含水率为67%和71%的污泥在热干燥过程中的传热传质速率及干燥速率有明显提高,且干燥温度越高,电渗透后污泥的干燥速率与原泥的干燥速率差距越大。相同电压梯度及相同温度下电渗透至67%后进行热干燥耗能最少。实际应用中应结合能耗分析选择合适的电渗透程度及干燥温度,以达到最优效果。     

A novel use of anaerobically digested liquid swine manure to potentially control soybean cyst nematode

Experiments were carried out in two steps to determine the effect of anaerobically digested swine manure on soybean cyst nematode (SCN) egg control. In the first step, liquid swine manure underwent anaerobic digestion to search for the best digestion time for both volatile fatty acids (VFA) and ammonium nitrogen (NH₄ ⁺) enrichment. The results showed that about 17 and 28 days of incubation were needed, respectively, to reach the maximal levels of VFA and NH₄ ⁺ in the manure. In the second step, raw, VFA-enriched, and NH₄ ⁺-enriched manure were applied separately, at four different rates (25, 50, 100, and 200 mL/pot), to soil pots inoculated with nematode eggs in a greenhouse environment. Soil samples were collected 35 and 61 days after inoculation to determine the effect of such treated manure on SCN egg productivity. The data indicated that the SCN egg counts were inversely related to the manure application rates in a linear manner with correlation coefficients of 0.998, 0.967, and 0.900 for raw, NH₄ ⁺-enriched, and VFA-enriched manure for the 35-day samples. While no such relationships were found for the 61-day samples, implying that none of the treatments were still effective 61 days after application. At the four application rates, the VFA-enriched manure performed best in reducing SCN egg counts (by 18.1, 19.5, 34.3, and 18.6%) as compared to the raw manure treatment. In contrast, the NH₄ ⁺-enriched manure achieved mostly negative reductions. To achieve the best control of SCN egg growth, the VFA-enriched manure should be used and applied to soybean fields every 35 days.