Seasonal fluctuations in sand temperature: effects on the incubation period and mortality of loggerhead sea turtle (<Emphasis Type="Italic">Caretta</Emphasis><Emphasis Type="Italic">caretta</Emphasis>) pre-emergent hatchlings in Minabe,Japan

Incubation period, hatching success, and emergence percentage in loggerhead (Caretta caretta) nests were quantified during the 1993 and 1995 nesting seasons and following incubation seasons in Minabe, Wakayama, Japan. Sand and nest temperatures were also monitored. Over the seasons, daily mean sand temperature at nest depth fluctuated between 18.0°C and 33.3°C, with a steep increase in the second week of July and a peak in late August. Temperatures inside the nest chambers were a few degrees above those of the surrounding sand at the end of incubation. The incubation period ranged from 46 to 82 days. A significant negative correlation was found between mean sand temperature and incubation period. The relationship conformed to the day-degree concept. There was no significant seasonal trend in hatching success, but many pre-emergent hatchlings were found dead in most of the clutches during the warmest part of the season. Emergence percentage was correlated with mean sand temperature calculated for 4 days before emergence, suggesting that mortality may be due to heat. This heat-related mortality is considered to be a common phenomenon at our study site, because the peak in emergences coincides with the peak in high temperatures. These temperature effects on hatchling mortality must be taken into account in estimates of hatchling sex ratios. Because sand temperatures already exceed the optimal thermal range for incubation, this population is vulnerable to even small temperature increases resulting from global warming.     

Funipuncture for fetocide in late termination of pregnancy

The most widely used method for fetocide in late termination of pregnancy for fetal abnormalities (TOPFA) consists of injecting of potassium chloride (KCl) into the fetal heart and is likely to be painful after 22 weeks of gestation. We studied ten consecutive women undergoing TOPFA between 22 and 38 weeks. This technique for fetocide consisted of a single umbilical vein puncture under ultrasound guidance with injections of sufentanil 5 µg followed by KCl 2 g. No electrocardiographic modifications could be observed and maternal plasma potassium levels did not show any significant variation throughout the procedure. Fetal umbilical phlebotomy for fetal analgesia followed by fetocide therefore appears to be a safe procedure for the mother and allows the fetus to die without pain when late termination of pregnancy (TOP) is indicated. Copyright © 2002 John Wiley & Sons, Ltd.     

Preimplantation genetic diagnosis of the fragile X syndrome by use of linked polymorphic markers

Fragile X syndrome is the most common cause of familial mental retardation. The most common mutation is expansion of a triplet (CGG)_n repeat in the 5′ untranslated region of the FMR1 gene on Xq27.3. The expansion is refractory to PCR due to preferential amplification of the smaller allele in heterozygous cells and the high GC content of the repeat and surrounding sequences. Direct detection of the normal parental alleles in preimplantation embryos has been used for preimplantation genetic diagnosis (PGD) of this disorder. However, this approach is only suitable for approximately 63% of couples due to the heterozygosity of the repeat in the normal population. As an alternative we investigated the use of polymorphic markers flanking the mutation to track the normal and premutation carrying maternal chromosomes in preimplantation embryos. Using a panel of 11 polymorphisms, six (CA)_n repeats and five single nucleotide polymorphisms, diagnosis was developed for 90% of referred couples. Multiplex amplification of informative markers was tested in 300 single buccal cells from interested couples with efficiency and allele drop out (ADO) rates ranging from 69% to 96% and 6% to 18%, respectively. Use of this approach is accurate and applicable to a larger number of patients at risk of transmitting fragile X to their offspring. Copyright © 2001 John Wiley & Sons, Ltd.     

Development of a test method against hot alkaline chemical splashes.

High temperature alkaline chemical liquids have caused injuries and hazardous situations in Finnish pulp manufacturing mills. There are no requirements and/or test method standards concerning protection against high temperature alkaline chemical splashes. This paper describes the test method development process to test and identify materials appropriate for hot liquid chemical hazard protection. In the first phase, the liquid was spilled through a stainless steel funnel and the protection performance was evaluated using a polyvinyl chloride (PVC) film under the test material. After several tentative improvements, a graphite crucible was used for heating and spilling the chemical, and a copper-coated K-type thermometer with 4 independent measuring areas was designed to measure the temperature under the material samples. The thermometer was designed to respond quickly so that peak temperatures could be measured. The main problem was to keep the spilled amount of chemical constant, which unfortunately resulted in significant variability in data.     

Effects of bed materials on the performance of an anaerobic sequencing batch biofilm reactor treating domestic sewage

The objective of this study was to determine the best performance of an anaerobic sequencing batch biofilm reactor (AnSBBR) based on the use of four different bed materials as support for biomass immobilization. The bed materials utilized were polyurethane foam (PU), vegetal carbon (VC), synthetic pumice (SP), and recycled low-density polyethylene (PE). The AnSBBR, with a total volume of 7.2L, was operated in 8-h batch cycles over 10 months, and fed with domestic sewage with an average influent chemical oxygen demand (COD) of 358+/-110mg/L. The average effluent COD values were 121+/-31, 208+/-54, 233+/-52, and 227+/-51mg/L, for PU, VC, SP, and PE, respectively. A modified first-order kinetic model was adjusted to temporal profiles of COD during a batch cycle, and the apparent kinetic constants were 0.52+/-0.05, 0.37+/-0.05, 0.80+/-0.04, and 0.30+/-0.02h(-1) for PU, VC, SP, and PE, respectively. Specific substrate utilization rates of 1.08, 0.11, and 0.86mg COD/mgVS day were obtained for PU, VC, and PE, respectively. Although SP yielded the highest kinetic coefficient, PU was considered the best support, since SP presented loss of chemical constituents during the reactor's operational phase. In addition, findings on the microbial community were associated with the reactor's performance data. Although PE did not show a satisfactory performance, an interesting microbial diversity was found on its surface. Based on the morphology and denaturing gradient gel electrophoresis (DGGE) results, PE showed the best capacity for promoting the attachment of methanogenic organisms, and is therefore a material that merits further analysis. PU was considered the most suitable material showing the best performance in terms of efficiency of solids and COD removal.     

Molecular taxonomy of vestimentiferans of the western Pacific and their phylogenetic relationship to species of the eastern Pacific

The nucleotide sequence of part (624 bp) of a mitochondrial gene for cytochrome oxidase I was determined for 46 escarpiid vestimentiferans collected from seven sites in the western Pacific and 49 individual specimens of Arcovestia ivanovi from two sites in the Manus Basin. Phylogenetic analysis, based on the newly obtained and previously reported sequences, indicated that escarpiids in the western Pacific can be divided into two tentative species, as we proposed in a previous report. While members of the first tentative species have been collected exclusively from a seep area at a depth of 300 m off the coast of central Japan, the members of the second species inhabit some sites at depths greater than 1,100 m, namely, seep areas in Japanese and Papua-New Guinean waters as well as hydrothermal vent fields in the Okinawa Trough and the Manus Basin. We detected no genetic structure among populations of the second tentative species. The first tentative species was more closely related to a species in the eastern Pacific, Escarpia spicata, and to a species in the Gulf of Mexico, Escarpia laminata, than to the second tentative species in the western Pacific. Sequences obtained from all arcovestiids were identical with the exception of those from three individuals, each of which included a single synonymous nucleotide substitution relative to the dominant haplotype, and no genetic differences were detected between specimens from the two sites in the Manus Basin.