Dependence of mechanochemically induced decomposition of mono-chlorobiphenyl on the occurrence of radicals

Mechanochemically induced dechlorination of mono-chlorobiphenyl (BP-Cl) on the surfaces of metal oxides was compared with that on metal hydroxides, using the three metals of Mg, Al, and La as examples. The metal oxides, such as gamma-alumina (gamma-Al2O3), magnesium oxide (MgO) and lanthanum oxide (La2O3) showed an efficient ability to dechlorinate the BP-Cl; however, BP-Cl remained in the ground samples when the hydroxides were used. From the product analysis using gas chromatography/mass spectrometry (GC/MS) and electron spin resonance (ESR) measurements, it was confirmed that the charge transfer from the O2- site on the surface of the oxide additives due to the intense grinding has plays a significant role in the decomposition of the chlorinated compound. Based on the observed dependence of the dechlorination on the radical occurrence, some practical methods were proposed to improve the destruction efficiency of the chlorinated organic compounds.     

Debromination of hexabromobenzene by its co-grinding with CaO

A hexabromobenzene (HBB, C6Br6) powder was subjected to co-grinding with excess CaO powder in air using a planetary ball mill to investigate mechanochemical debromination of the HBB sample. The reaction proceeds smoothly with an increase in both grinding time and molar ratio of CaO addition. The co-grinding enables us to debrominate HBB, forming CaBr2, C and CaCO3 besides excess CaO in the product. CaBr2 in the product tends to absorb moisture from the atmosphere to form CaBr2 x nH2O. The reaction yield is quantitatively evaluated by measuring the amount of water-soluble bromide through water washing and the amount of unreacted HBB through toluene washing. It is found that almost 100% of debromination is achieved by 6 h grinding with the molar ratio kept constant at 2:1. Radicals are detected in the ground products, possibly due to rupture in the covalent bonds of C-C and C-Br in HBB.     

Thermodynamic investigation of the effect of oxygen and hydrogen chloride potential upon generation and decomposition behavior of dioxins

The thermodynamic equilibrium of the C‐H‐O‐Cl system has been calculated to elucidate the generation and decomposition behavior of dioxins, and is discussed from the viewpoint of the oxygen and hydrogen chloride potential. The dioxins behavior is greatly dependent on the oxygen potential, i.e. higher temperature and oxygen potential lead to the complete decomposition of dioxins, while low hydrogen chloride potential under insufficient oxygen condition leads to an increase of multi‐chlorine displacement of dioxins.     

Properties of a Poly(3-hydroxybutyrate) Depolymerase from Penicillium funiculosum

A poly(3-hydroxybutyrate) (PHB) depolymerase was purified from a fungus, Penicillium funiculosum (IFO6345), with phenyl-Toyopearl and its properties were compared with those of other PHB depolymerases. The molecular mass of the purified enzyme was estimated at about 33 kDa by sodium dodecyl sulfate (SDS) polyacrylamide gel electrophoresis. The pH optimum and pI were 6.5 and 6.5, respectively. The purified protein showed affinity to Con A-Sepharose, indicating that it is a glycoprotein. Diisopropylfluorophosphate and dithiothreitol inhibited the depolymerase activity completely. The N-terminal amino acid sequence of the purified enzyme was TALPAFNVNPNSVSVSGLSSGGYMAAQL, which contained a lipase box sequence. This purified enzyme is one of the extracellular PHB depolymerase which belong to serine esterase. The purified enzyme showed relatively strong hydrolytic activity against 3-hydroxybutyrate oligomers compared with its PHB-degrading activity. PHB-binding experiments showed that P. funiculosum depolymerase has the weakest affinity for PHB of all the depolymerases examined.     

Quantitative analysis of perfluorinated chemicals in media for in vitro fertilization and related samples

The actual standard in vitro fertilization (IVF) protocol recommends an overnight gamete co-incubation. All of the culture media used for human IVF are supplemented with serum or albumin. In the present study, we determined the concentrations of perfluorinated chemicals (PFCs) in IVF media (IVFM) and related samples by liquid chromatography with tandem mass spectrometry (LC/MS/MS). The results indicated that the concentrations of PFOS and PFOA in the protein source were higher than those in the IVFM samples. Compared with human plasma concentrations of PFCs, PFCs in all of the IVFM samples, such as PFBS, PFHxS and PFOA, were either not detected or present at only trace levels, even when protein source was added. LC/MS/MS could be used to determine PFCs in IVFM samples in future studies of the effects of PFC exposure on intrauterine insemination.     

Perfluorosulfonates and perfluorocarboxylates in snow and rain in Dalian,China

Samples of precipitation events (snow and rain) in Dalian, a typical coastal town in China, were analyzed for perfluorosulfonates (PFSAs) and perfluorocarboxylates (PFCAs) to investigate atmospheric contamination by these compounds. In the snow event on December 16, 2006, samples were collected from 21 different sites and in another 6 precipitation events, samples were collected from a single location. Four PFSAs (C4, C6, C8, C10) and seven PFCAs (C6–12) were analyzed. Among the homologues, perfluorooctane sulfonate (PFOS) concentrations were the highest with a geometric mean (GM) of 145 ng/L (n = 21) during the snow event on December 16, 2006, followed by perfluorooctanoate (PFOA) with a GM of 24.7 ng/L (n = 21). Concentrations of perfluorobutane sulfonate (PFBS), perfluorohexane sulfonate (PFHxS) and perfluoroheptanoate (PFHpA) were more than two orders of magnitude lower than that of PFOS. Other PFSAs and PFCAs were found to be below the limit of detection in all the samples. In other 6 precipitation events, PFSAs and PFCAs were detected approximately in the same order of magnitude in both snow and rain. The results indicate that wet deposition may be a potential transport mechanism of perfluorinated chemicals in the environment.     

Historical and geographical aspects of the increasing perfluorooctanoate and perfluorooctane sulfonate contamination in human serum in Japan

Perfluorooctane sulfonate (PFOS) and perfluorooctanoate (PFOA) have recently received attention due to their widespread contamination in the environment, as well as in wildlife and humans. We measured the PFOS and PFOA concentrations in historically recorded human serum samples at an age range between 20 and 59 years collected in Kyoto, 20 persons per each time point (n=100), and also the PFOS and PFOA concentrations in human serum samples at an age range between 20 and 59 years from 10 locations throughout Japan (n=200). The historical samples collected from 1983 to 1999 demonstrated that the PFOA concentrations in males and females from Kyoto have increased 4.4-fold and 4.3-fold at a rate of increase of 0.49 ng/ml/year and 0.42 ng/ml/year, respectively. In contrast, serum concentrations of PFOS reached a plateau in the late 1980s. There are also regional differences in both the PFOS and PFOA serum concentrations. The concentrations in serum [geometric mean (geometric standard deviation)] (ng/ml) in 2003-2004 ranged from 7.6(1.6) in the town of Matsuoka in Fukui prefecture to 27.8(1.6) in Kyoto city, and ranged from 2.3(1.5) in Matsuoka to 14.5(1.3) in Osaka city for PFOS and PFOA, respectively.     

Identification of methyl chloride-emitting plants and atmospheric measurements on a subtropical island

A survey of methyl chloride (CH3Cl)-emitting plants was performed at a subtropical island in Japan (Iriomote Island). Among the 187 species of tropical/subtropical plants investigated, 33 species from a variety of families were identified as CH3Cl-emitting plants. The strongest emitters were Osmunda banksiifolia, Cibotium balometz, Angiopteris palmiformis, Vitex rotundifolia, Vitex trifolia, and Excoecaria agalloch, each with CH3Cl emission rates exceeding 1microg (gdrywt)(-1)h(-1). The first three species are ferns, and the last three are halophilous plants. Based on our results, the character of CH3Cl emission is likely to be shared at the genus level but not always at the family level. The atmospheric CH3Cl distribution measured on Iriomote Island showed significant enhancement in forested sites (up to 2750 ppt) and a higher concentration on the downwind shore than on the upwind shore. As previously reported, our findings provide strong evidence for the high emission of CH3Cl from tropical/subtropical forests.     

Separation, synthesis and estrogenic activity of 4-nonylphenols: two sets of new diastereomeric isomers in a commercial mixture

Two sets of new diastereomeric 4-nonylphenol (NP) isomers [4-(3,4-dimethylheptan-4-yl)phenol (344NP, NP-J, L) and 4-(3,4-dimethylheptan-3-yl)phenol (343NP, NP-K, P)] were separated from a commercial NP mixture. The mixture of these diastereomers was synthesized at the same time by a single Friedel-Crafts reaction of 3,4-dimethyl-4-heptanol and phenol, and the mixture was separated into individual NPs by HPLC equipped with Hypercarb column. For the first time, in this study the stereostructure-estrogenic activity relationship of NP diastereomers was investigated. The NP isomers (NP-L and NP-P) having the beta-methyl group over the benzene ring were found to be 2-4 times more estrogenic than their diastereomers (NP-J and NP-K). In the case of the other set of diastereomer [4-(3,5-dimethylheptan-3-yl)phenol, (353NP, NP-E, G)] containing gamma-methyl group in the molecule, the gamma-methyl proton signal (delta 0.49) in the more estrogenic isomer (NP-G) also appeared in a higher field than the corresponding methyl signal (delta 0.76) of the less estrogenic isomer (NP-E).     

Simultaneous treatment of PVC and oyster-shell wastes by mechanochemical means

This work presents a new process for dechlorinating poly-vinyl chloride (PVC) by the use of oyster-shell waste. The process consists of milling of PVC waste with oyster-shell waste, followed by washing the milled sample with water. The milling of PVC and oyster-shell mixture results in size reduction and rupture in bonds, leading to mechanically induced reactions between the two to form CaCl2 and hydrocarbon with C=C bonds. Washing the milled mixtures with water at room temperature allows complete removal of chlorine from the milled sample. More than 95% of chlorine in PVC was removed when 2h grinding is conducted for the mixture. The present process could offer a potential route to the handling and disposal of oyster-shell and PVC wastes.