Saguenay河溶解有机质光化学生成溶解无机碳的研究

溶解有机质作为水生生态系统中一种重要的活跃的有机组分,对生态系统中的碳循环起到重要的作用.利用模拟太阳光对Saguenay河溶解有机质的光氧化过程模拟,研究了溶解氧浓度、模拟太阳光波长范围和铁浓度对溶解无机碳产量的影响.研究表明,基于空气饱和样品前72 h的溶解无机碳产量1.39 μmol·L-1·h-1,氧气饱和条件下照射的溶解无机碳产量增加了52.5%,而氮气饱和条件下的照射则只有空气饱和样品的10%.实验以Mylar-D、有机玻璃UF-3和有机玻璃UF-4为滤光片研究了波长范围对溶解无机碳产量的影响,近似计算的结果表明UV-B、UV-A和可见光部分分别占无机碳产量的16.5%,55.4%和28.0%,表明溶解无机碳的生成可发生在紫外光无法到达的水体较深区域.铁在光化学催化氧化过程中起重要作用,当总铁浓度达到10 μmol·L-1时,有效的增加了溶解无机碳的生成速率,其生成速率约为初始样品的1.68倍(初始样品中总铁含量为3.2 μmol·L-1).     

水化氧化处理垃圾渗滤液生物处理后的尾水

经生物处理后垃圾渗滤液尾水的CODCr约在500~800 mg/L,此类CODCr除部分为有机物外,还含有大量还原性无机类物质,因此不适合采用常规的生物处理方法进行深度处理。本研究在投药量较低的情况下,采用水泥、NaAlO2和Ca(ClO)2等物质联合作用,取得较好的尾水CODCr去除效果(达到国家二级排放标准)。机理研究表明:渗滤液尾水CODCr的去除主要通过两种途径:一方面为常规的氧化作用,另一方面通过特殊的水化作用,可去除部分还原性无机类物质。     

Photochemical alteration of the molecular weight of dissolved organic matter

Molecular weight (MW) is a key control on the physical, chemical, and biological characteristics of dissolved organic mater (DOM). This study investigated the effect of photooxidation on the average MW of DOM by exposing DOM of diverse origins to simulated solar radiation at varying levels of dissolved oxygen and under different incident light wavelength regimes. During irradiation, high-molecular-weight fractions were destroyed and low-molecular-weight constituents were formed. The average MW decreased with irradiation time in all treatments in a manner that can be described by a quasi-exponential function, which suggests that solar radiation is incapable of completely mineralizing DOM even after prolonged exposure. Increasing the oxygen concentration accelerated the MW reduction while the removal of oxygen strongly suppressed this process. The fractional contributions from UV-B, UV-A, and visible radiations to full-spectrum photoinduced MW reduction varied considerably among the DOM samples examined, ranging from 19% to 60%, 17% to 36%, and 15% to 46%, respectively. The MW changes in time-series irradiations were inversely correlated with the ratio of the absorbance at 250 nm to that at 365 nm (i.e., the E₂/E₃ quotient). Photoinduced MW reduction was accompanied by a decrease of polydispersity, which is indicative of a reduced DOM heterogeneity.     

Effects of photodegradation of dissolved organic matter on the binding of benzo(a)pyrene

Dissolved organic matter (DOM) in natural waters can bind various organic pollutants, and the affinity of this binding is strongly influenced by the chemical characteristics of the DOM and water pH. This study examined the effects of photochemically induced alteration of the DOM's chemical properties and water pH on the binding of benzo(a)pyrene (BaP). Time- and pH-series of solar-simulated irradiations were performed on a natural water sample and aqueous DOM solutions prepared from aquatic and soil humic substances. The binding affinity of BaP, expressed as a partition coefficient of a compound to DOM, decreased substantially after the DOM samples were irradiated over environmentally relevant radiation doses and pH ranges. The lowering of the pH due to the photoproduction of acidic products often partly offsets the reduction of the binding affinity caused by direct photoalteration of the DOM's chemical structure. The decrease of the binding affinity, after correction for the photoinduced pH change, was positively correlated with the decrease in the molecular weight and the aromaticity of the DOM in the course of irradiation. Increasing O(2) abundance accelerated the decrease of the binding affinity as a result of enhanced DOM photodegradation. Visible light played a more important role in reducing the molecular weight and aromaticity of the DOM than in reducing the content of dissolved organic carbon (DOC) via photoremineralization while the reverse was true for UV radiation, indicating that photochemical reduction of the binding affinity may occur in natural waters at depths greater than UV radiation can reach. A decrease of the affinity of DOM for binding BaP will increase the free dissolved fraction of BaP and thus its availability and toxicity to aquatic organisms. The results from this study may have similar implications for organic pollutants other than BaP.     

Peak exposures in aluminium potrooms: instrument development and field calibration

Aluminium smelter potrooms are unique in that workplace exposures to hydrogen fluoride (HF), sulfur dioxide (SO2), and particulate matter occur simultaneously for some tasks. The peak exposures to these contaminants are of increasing interest in discovering the etiology of respiratory health effects. While a variety of direct-reading instruments are available for sulfur dioxide and particulate matter, only a few exist for hydrogen fluoride. The sensors in these HF instruments have a cross-sensitivity to sulfur dioxide making it difficult to monitor HF in an environment that also contains SO2. To overcome this problem, we assessed the simultaneous use of two electrochemical instruments: one with a SO2 sensor that does not respond to HF and the second with a hydrogen fluoride sensor that responds to both HF and SO2 in a 1 : 1 ratio, termed 'total acid gas'. The difference in the response between the two instruments should indicate the HF concentration: [HF + SO2] minus SO2 equals HF. The performance characteristics of this sampling train were evaluated in the laboratory through the generation of both HF and SO2 with permeation tubes. The response and recovery times for the SO2 only instrument were acceptable (6 and 15 s, respectively), but the "total acid gas" instrument exhibited both slow response and slow recovery approaching three and six min. The association between the traditional integrated filter sampling method and the direct-reading instrument for SO2 is 0.80 (Spearman's rho). The use of the digital filter strengthens the association between the HF direct-reading instrument and the integrated samples from 0.41 to 0.68.     

Is urban development an urban river killer? A case study of Yongding Diversion Channel in Beijing, China

The high population and concrete environment alter urban areas by changing temperature, rainfall runoff, and water resource utilization activities. This study was conducted to investigate the water quality features of the Yongding Diversion Channel in Beijing, China, and its relationship with rainfall and urban development. Monthly water quality data were obtained from April to October of 2004 at monitoring sites of Sanjiadian, Gaojing, Luodaozhuang, and Yuyuangtan. The monthly water quality grades from 2007 to 2011 were also investigated and compared with those of other rivers. Dissolved oxygen and pH showed greater decreases after one or two moderate rainfall events than several light rainfall events. The potassium permanganate index （CODMn）, ammonia nitrogen （NH3-N） and total phosphorus （TP） increased more after several light rainfall events than after one or two moderate or heavy rainfall events. Pollutant concentrations （CODMn, NH3-N, TP） in downstream regions showed greater changes than those in upstream areas after heavy rainfall events. Intense human activities around the channel greatly influenced the water quality of the channel in rainy season because of runoff pollution; however, heavy rainfall had a strong dilution effect on the pollutant concentrations in rivers. Overall, urban development has obviously deteriorated the water quality of the Yongding Diversion Channel as indicated by an increase in the water quality index from 3.22 in 2008 to 4.55 in 2010. The Pearson correlation between monthly rainfall and water quality indices from 2007 to 2011 ranged from 0.1286 to 0.6968, generally becoming weaker as rainfall and rainfall runoff became more random and extreme.     

功能区噪声自动监测变化特征实验分析研究

为了能够更全面、真实地反映城市功能区声环境的质量状况,我们分别选择了四个类别的标准适用区四个监测点位,进行了连续的自动监测试验,获取了大量监测数据,对上面获得的监测数据进行整理分析,通过功能区噪声变化的统计特征,可以很好地了解城市功能区噪声变化特征。     

溢油模型理论及研究综述

油在水中的行为和归宿是一个复杂的过程,包括在重力、表面张力、惯性力和粘性力作用下的物理扩展,挥发、乳化、溶解、光氧化和生物降解等风化过程引起的化学变化,流场、风场等动力因素作用下的漂移运动以及随机部分。通过总结国内外的研究现状,概括了各个模型的理论依据、基本假设、应用范围,并对今后发展方向提出了几点展望。     

功能区噪声自动监测有效时间的确定

噪声自动监测在中国才刚刚起步,其各项规范还没有随之确立,这就需要进行一系列的噪声自动监测实验,以获得各项规范确立的指标。通过在四个类别的标准适用区进行的噪声监测试验,利用获得的试验数据进行统计分析,找出噪声Leq小时值的统计特征,对四个类别的标准适用区各日标准方差进行计算,获得标准方差最大与最小对应的日期,分别对其进行小时噪声等效声级进行抽样,以确定功能区噪声自动监测有效时间。经计算对任一类别的适用区日均值的获得至少需要连续监测,也就是功能区噪声自动监测有效时间是18个小时以上。