Structural and electrochemical properties of annealed La1-xYxNi3.55Mno.4Alo.3Coo.75 hydrogen storage alloys

The effects of the annealing and partial substitution of Y for La on the structural and electrochemical properties of La_1-xY_xNi_3.55Mn_o.4Al_o.3Cr_o.75 (x = 0, 0.1 and 0.2) alloys were reported in the present work. The single-phased CaCu₅-type structure was retained after La was partially substituted by Y. However, the increase of Y content leads to decrease of the lattice parameters and the unit-cell volume. The annealed La_o.9Y_o.1Ni_3.55Mn_o.4Al_o.3Co_o.75 alloys shows typical isometric microstructure, indicating that the composition segregation is improved by annealing. Y substitution for La in the alloys is effective to improve the electrochemical properties at both room temperature and high temperature. A critical substitution content of Y is found at x = 0.1.     

Cadmium removal from wastewater by sponge iron sphere prepared by hydrogen reduction

A new type of sponge iron sphere (NSIS) with 1-5 mm diameter, made of concentrated iron powder and possessed high activity and intension, was prepared by mini-pellet sintering integrated with H₂ direct reduction. Static state experiment has been carried on to investigate the Cd²⁺ removal efficiency from wastewater by the NSIS and to explore the Cd²⁺ removal reaction kinetics. It was suggested that initial pH value and Cd²⁺ original concentration had significant influence on Cd²⁺ removal percentage. Cd²⁺ removal percentage decreased significantly with the increasing of Cd²⁺original concentration whether the original pH value be adjusted to 3.0 or without adjustment. The results showed that the Cd²⁺ removal process followed the first order reaction because the reaction order was from 0.803 to 0.996. The apparent reaction rate constant between Cd²⁺ and NSIS was from 0.0025 to 0.1000 (mg·L^?1)^1-n·min^?1. Compared with SIS reduced by charcoal reduction, NSIS deoxided by hydrogen possessed higher activity, and could remove the same quantity of Cd²⁺ within a shorter period of time.     

基于REOF方法的辽宁气候舒适度区域特征分析

基于辽宁省50个气象站1964-2008年的气象资料,采用适应东北地区的人体舒适度计算公式及分级标准,得出辽宁省近45年历年人体各舒适度级别日数,使用旋转经验正交分解法(REOF),对辽宁省气候舒适度进行区域划分,并分析了各区域气候舒适度的空间分布特征和变化趋势.结果表明:(1)根据前4个旋转倚载向量场高载荷区分布,将...     

吹扫捕集-气相色谱法测定水中的乙醛和丙烯醛

建立了吹扫捕集-气相色谱法测定水样中乙醛和丙烯醛的方法,并对吹扫捕集测试条件进行优化,考察了吹扫温度和吹扫时间对吹扫捕集效率和方法检出限的影响。在50℃下,吹扫时间为20 min时,该方法乙醛和丙烯醛的检出限分别为0.001 2 mg/L、0.000 6 mg/L,相对标准偏差分别为3.5%～6.9%、2.9%～5.8%,加标回收率分别为91.6%～108%、92.0%～105%。与GB3838-2002推荐使用的分析方法相比较,该方法具有操作简便、灵敏度高、重复性好、基本上不消耗有机溶剂等特点,可满足地表水和废水中乙醛和丙烯醛的测定要求。     

低温等离子体-催化协同降解挥发性有机废气

低温等离子体-催化协同技术适合于各类挥发性有机物的治理,特别是大气量低浓度的有机废气的处理.高效催化剂的加入可 以显著提高等离子体反应中有机废气的降解效率,减少有害副产物的生成以及提高反应器的能量利用率.从反应器、催化剂以及背景气体等方面探讨了该技术实现产业化需要解决的问题,结合低温等离子体与催化剂的相互作用、等离子体...     

废弃阻燃塑料热失重行为与分解规律的研究

文章主要是研究废弃电子产品阻燃材料的热解回收方法;主要研究废弃阻燃塑料的热失重规律和热分解产物,以印刷线路板为原料利用差热热重分析仪和热裂解色谱和质谱进行了实验室规模热解实验.结果表明:热失重反应的平均活化能为182.294 kJ/mol,指前因子为3.07×1011s-1,反应的温度区间为580K～600K;随着升温...     

不同进水条件对SBR工艺脱氮除磷效能的影响

采用人工配水,研究进水在不同pH值,碳源类型,碳氮比条件下,厌氧/好氧/缺氧(A/O/A)sBR工艺对生物法脱氮除磷效能的影响.结果表明:不同的进水条件对反应器的影响较大,当pH值为7.5,乙酸钠为碳源,碳氮比为1.4时,反应器运行效果最佳,系统对PO43--P,NH4+-N的去除率分别达到97.28%,99.5%.N...     

臭氧对枯草芽孢杆菌孢子的灭活研究

隐孢子虫灭活困难,给饮用水安全带来了挑战。实验以枯草芽孢杆菌孢子(ATCC6633)作为隐孢子虫的指示菌,研究了臭氧浓度、浊度、有机物、温度等因素对臭氧灭活枯草芽孢杆菌孢子的影响。研究表明,臭氧对枯草芽孢杆菌孢子的灭活与CT值相关,臭氧浓度对消毒效果影响较小;降低浊度、有机物含量,能提高臭氧对枯草芽孢杆菌孢子的灭活效率;温度降低,为保证一定的消毒效率,所需的CT值越大。研究结果为水厂合理控制运行参数提供了借鉴。     

化学沉淀法处理线路板厂络合铜废水实验研究

为解决某线路板厂络合铜废水达标排放的问题,模拟该厂络合铜废水处理的工艺条件,采用硫酸亚铁和硫化钠相结合的化学沉淀法进行小试,通过正交实验确定最佳药剂投加量.结果表明,影响络合铜废水处理效果的各因素的重要性顺序依次为pH、PAM、FeSO4·7H2O、LIME、Na2S;处理500mL络合铜废水的最佳的操作条件是废水初始...     

利用泰乐菌素菌渣生产复合酶制剂及效果研究

发酵法生产抗生素过程中会产生大量废弃菌渣,这些菌渣因有机质含量高,堆放极易发生霉变,给当地环境造成危害.文章采用固体发酵法,以微生物降解处理后的泰乐菌素菌渣为主要原料,生产复合酶制剂,并对其在肉鸡上的使用效果进行研究.结果表明:在水含量50％～60％、干物质中麸皮含量不低于40％的泰乐菌素菌渣培养基中,接入5％～10％...