A comparative study of pre-aeration effects on hydraulic jump air–water flow properties at high Froude numbers

Environmental Fluid Mechanics - A hydraulic jump forming in the stilling basin at the base of a high-head dam spillway is often characterized by high Froude number and inflow pre-aeration...     

Optimization of micro-aeration intensity in acidogenic reactor of a two-phase anaerobic digester treating food waste

Micro-aeration is known to promote the activities of hydrolytic exo-enzymes and used as a strategy to improve the hydrolysis of particulate substrate. The effect of different micro-aeration rates, 0, 129, 258, and 387 L-air/kg TS/d (denoted as LBR-AN, LBR-6h, LBR-3h and LBR-2h, respectively) on the solubilization of food waste was evaluated at 35 °C in four leach bed reactors (LBR) coupled with methanogenic upflow anaerobic sludge blanket (UASB) reactor. Results indicate that the intensity of micro-aeration influenced the hydrolysis and methane yield. Adequate micro-aeration intensity in LBR-3h and LBR-2h significantly enhanced the carbohydrate and protein hydrolysis by 21–27% and 38–64% respectively. Due to the accelerated acidogenesis, more than 3-fold of acetic acid and butyric acid were produced in LBR-3h as compared to the anaerobic treatment LBR-AN resulting in the maximum methane yield of 0.27 L CH₄/g VS_added in the UASB. The performance of LBR-6h with inadequate aeration was similar to that of LBR-AN with a comparable hydrolysis degree. Nevertheless, higher aeration intensity in LBR-2h was also unfavorable for methane yield due to significant biomass generation and CO₂ respiration of up to 18.5% and 32.8% of the total soluble hydrolysate, respectively. To conclude, appropriate micro-aeration rate can promote the hydrolysis of solid organic waste and methane yield without undesirable carbon loss and an aeration intensity of 258 L-air/kg TS/d is recommended for acidogenic LBR treating food waste.     

南京北郊秋冬季相对湿度及气溶胶理化特性对大气能见度的影响

为了解南京北郊秋冬季相对湿度与气溶胶理化特性对大气能见度的影响,利用2012年秋冬季气象要素资料、颗粒物浓度及其主要成分和气溶胶粒子谱分布等观测数据,分析了南京北郊大气能见度与气象要素、颗粒物污染之间的关系.结果表明,南京北郊秋冬季节平均大气能见度仅为4.76 km.颗粒物浓度与能见度存在一定的负相关关系,尤其细粒子对能见度的影响更为显著.随细粒子质量浓度和相对湿度(RH)的增大,低能见度出现的频率呈现上升趋势.能见度从5~10 km衰减到5km时,PM10和PM2.1质量浓度分别增加了7.56%和37.64%;其中SO2-4和NO-3质量浓度均有显著增加.气溶胶粒子数浓度对能见度的影响与相对湿度有关,粒径0.5~2μm的气溶胶数浓度随RH增加增长缓慢,而2~10μm范围内的粒子数浓度随RH增加而减小;结合气溶胶表面积浓度与能见度进行相关性分析,表明0.5~2μm的细粒子及相对湿度是导致南京北郊秋冬季大气能见度下降的主要因素.     

模拟气候升温对湿地土壤微生物群落及磷素形态的影响

通过构建微宇宙湿地柱模拟气候升温的方法,采用高通量测序和核磁共振技术,分别研究了湿地土壤微生物群落和磷素形态对暖化作用的响应特征.结果表明,暖化作用导致了Firmicutes、Clostridia、Clostridiales、Clostridiaceae和Clostridium的相对丰度分别显著下降65%~98%、69%~87%、67%~87%、73%~97%和74%~93%,这表明暖化作用对不同分类水平上的物种Firmicutes到Clostridium具有显著的抑制效应.通过主坐标分析和聚类分析,不同湿地柱采样点的暖化组与对照组样本表现出显著的分离特征,揭示了暖化作用能够诱导微生物群落组成发生显著性变化.磷酸单酯和正磷酸盐是各湿地柱土壤主导的磷素形态,同时暖化作用导致了XX湿地柱采样点的磷酸单酯和正磷酸盐相对丰度分别显著升高275%和下降20%,JH湿地柱采样点的磷酸单酯和多聚磷酸盐相对丰度分别显著升高85%和下降49%,这表明不同磷素形态对暖化作用的响应具有土壤异质性特征.通过典型对应分析,揭示了暖化条件下微生物群落组成的显著变化对磷素形态具有显著的影响效应.     

西安市重污染与清洁天PM2.5组分及其活性氧物质对比

针对重霾污染,在西安市冬季重污染日(2015-11-30~2015-12-09)和清洁日(2016-01-13~2016-01-22)各进行了为期10d的PM_(2.5)采集,测量其中的有机碳、元素碳,及NH_4~+、NO_3~-、SO_4~(2-)等无机水溶性离子,探讨两种污染条件下的组分特征及其成因.结果表明:观测期,重霾日和清洁日PM_(2.5)质量浓度分别为(170±47.5)μg·m~(-3)和(48.6±17.9)μg·m~(-3),且重霾日伴随低能见度、高湿静风等多种不利气象条件;重霾日二次无机离子(NH_4~+、NO_3~-、SO_4~(2-))组分占PM_(2.5)质量浓度的49.8%±13.1%,而清洁日为19.4%±5.95%,并且重霾日硫氧化速率(sulfur oxidation ratio,SOR)和氮氧化速率(nitrogen oxidation ratio,NOR)分别为0.282±0.157和0.269±0.124,远高于清洁日(SOR和NOR分别为0.189±0.057和0.077±0.046),重霾日二次有机组分浓度[(6.22±3.87)μg·m~(-3)]是清洁日[(1.44±1.63)μg·m~(-3)]的5倍,表明二次污染及不利气象条件是造成重霾期间相关组分浓度升高的重要原因.最后,通过二氯荧光黄双乙酸盐(2',7'-DCFH)化学荧光分析法测定了其中活性氧物质(reactive oxygen species,ROS)的浓度,探讨其对于二次无机组分形成的影响,结果表明观测期ROS平均浓度(以H_2O_2计)分别为(4.99±1.54)nmol·m~(-3)(重霾期),(0.492±0.356)nmol·m~(-3)(清洁期),二次反应及积累效应可能是西安重霾条件下ROS浓度升高的主要原因.NO_3~-、SO_4~(2-)与ROS均呈现正相关(P0.05),表明ROS可能通过二次氧化过程参与到二次无机组分形成过程中.     

碳素纤维在近岸海洋污染物磷酸盐、硅酸盐处理中的应用

对碳素纤维进行氧化改性,利用改性后的碳素纤维处理近岸污染海水,重点研究了改性碳素纤维对海水中活性磷酸盐和活性硅酸盐的吸附作用。考察了碳素纤维液相改性时间、碳素纤维投加量、活性磷酸盐初始浓度、活性硅酸盐初始浓度、吸附时间、海况、pH值等单因素对近岸海洋污染物磷酸盐、硅酸盐吸附效果的影响。研究结果表明:改性碳素纤维对硅酸盐的吸附效果较好,去除率可达70%,对活性磷酸盐的去除率为31%左右。通过正交实验确定改性碳素纤维材料修复模拟近岸海水的优化条件为:碳素纤维改性时间为1.5 h,投加量为0.01 g,硅酸盐初始浓度为3mg/L,磷酸盐初始浓度为20 mg/L,海况为3级,pH值为8,吸附时间为3 h。在此条件下,碳素纤维对磷酸盐的去除率可达31.06%,硅酸盐去除率可达70.88%。     

我国大气中挥发性有机物的分布特征

大气中挥发性有机物(VOCs)是臭氧和二次有机气溶胶形成的关键前体物之一,研究表明烷烃、烯烃、芳香烃是我国大气VOCs的重要组分。在不同区域,城市地区烷烃含量最高,而偏远地区芳香烃为含量最丰富的VOCs。VOCs浓度日间变化多呈双峰分布趋势,峰值多出现在早晨与傍晚的上下班高峰期。目前对我国臭氧污染事件的研究均表明芳香烃和烯烃是对臭氧生成贡献最大的化合物。VOCs源解析中广泛运用的模型包括CMB、PMF和PCA/APCS,各模型均存在优点和局限性。比较各地VOCs源解析结果,发现交通排放源和工业排放源为我国VOCs的主要人为来源。VOCs的跨区域传输决定与周边地区的合作将是未来空气治理中的发展方向。     

基于臭氧溶胞的活性污泥减量化技术

目前常见的活性污泥减量技术主要包括解偶联技术、微生物的捕食作用以及隐性生长三种方法。基于臭氧氧化溶胞作用从而强化细菌隐性生长的污泥减量技术具有较好的处理效果及良好的应用前景。着重探讨了臭氧溶胞作用的机理及溶胞过程的影响因素。考虑到污泥减量技术在实际污水处理系统中的应用,探讨了臭氧溶胞对污水生物处理系统的影响。     

An online monitoring system for atmospheric nitrous acid (HONO) based on stripping coil and ion chromatography

A new instrument for measuring atmospheric nitrous acid(HONO) was developed,consisting of a double-wall glass stripping coil sampler coupled with ion chromatography(SC-IC).SC-IC is featured by small size(50 × 35 × 25 cm) and modular construction,including three independent parts:the sampling unit,the transfer and supporting unit,and the detection unit.High collection efficiency(> 99%) was achieved with 25 μmol/L Na2CO3 as absorption solution even in the presence of highly acidic compounds.This instrument has a detection limit of 8 pptv at 15 min time resolution,with a measurement uncertainty of 7%.Potential interferences from NOx,NO2+SO2,NO2+VOCs,HONO+O3,HNO3,peroxyacetyl nitrite(PAN) and particle nitrite were quantified in laboratory studies and were found to be insignificant under typical atmospheric conditions.Within the framework of the 3C-STAR project,inter-comparison between the SC-IC and LOPAP(long path liquid absorption photometer) was conducted at a rural site in the Pearl River Delta.Good agreement was achieved between the two instruments over three weeks.Both instruments determined a clear diurnal profile of ambient HONO concentrations from 0.1 to 2.5 ppbv.However,deviations were found for low ambient HONO concentrations(i.e.< 0.3 ppbv),which cannot be explained by previous investigated interference species.To accurately determine the HONO budget under illuminated conditions,more intercomparison of HONO measurement techniques is still needed in future studies,especially at low HONO concentrations.     

Insertable thin film thermocouples for in situ transient temperature monitoring in ultrasonic metal welding of battery tabs

Real-time monitoring and control of temperature in ultrasonic joining of battery tabs and coupons are important for the quality improvement and cost reduction of battery assembly. However, there have always been difficulties in accurate and real-time measurement of temperature by conventional sensors for practical implementation. In this study, an innovative method is developed to provide an enabling technology for the in situ transient temperature monitoring, which could provide reliable feedback signals for potential control of ultrasonic joining processes. Micro thin film thermocouples (TFTCs) were fabricated on thin silicon substrates, which were then inserted in the welding anvil as a permanent feature so that the sensors were always located about 100 μm directly under the welding spot during joining of multilayer Ni-coated Cu thin sheets for battery assembly. Good repeatability was demonstrated while a temperature rise of up to 650 °C was obtained due to the closeness of the sensors to the welding spot. The inserts with thin film sensors remained functional after welding experiments. This method has a great potential for in situ transient temperature monitoring, and thus the control of ultrasonic joining processes to realize a practical smart joining system.