Effects of different treatments on soil-borne DDT and HCH dynamics and plant uptake

Pot experiments were conducted to examine the effects of various fertilizers, as well as soil dilution treatments on the dynamics of soil-borne DDTs [sum of dichlorodiphenyltrichloroethane (DDT), chlorodiphenyldichloroethylene (DDE) and di- chlorodiphenyldichloroethane (DDD)] and hexachlorocyclohexanes (HCHs, sum of α-HCH, β-HCH, γ-HCH and δ-HCH) and their subsequent impacts on the uptake of DDTs and HCHs by a test plant. The results show that the soil residual DDTs and HCHs concentrations in the iron-rich fertilizer-treated soil were significantly lower than those in other fertilizer-treated soils. There was a close relationship between the soil residual DDTs and the plant tissue DDTs. This suggests that the uptake rate of DDTs by the plant was dependent on the concentration of soil-borne DDTs. A less close relationship between soil residual HCHs and plant tissue HCHs was also observed. Dilution of pesticide-contaminated soil with the non-contaminated soil not only physically reduced the concentration of pesticides in the soil but also enhanced the loss of soil-borne pesticides, possibly through the improvement of soil conditions for microbial degradation. Soil dilution had a better effect on promoting the loss of soil-borne HCHs, relative to soil-borne-DDTs. The research findings obtained from this study have implications for management of heavily contaminated soils with DDTs and HCHs. Remediation of DDTs and HCHs-contaminated soils in a cost-effective way can be achieved by incorporating treatment techniques into conventional agricultural practices. Applications of iron-rich fertilizer and soil dilution treatments could cost-effectively reduce soil-borne DDTs and HCHs, and subsequently the uptake of these organochlorine pesticides by vegetables.     

Microwave-induced nanoscale zero-valent iron degradation of perchloroethylene and pentachlorophenol

Microwave (MW) is applied to enhance perchloroethylene (PCE) or pentachlorophenol (PCP) removal using zero-valent iron (ZVI; Fe⁰) as the dielectric medium. ZVI has a much higher dielectric loss factor (39.5) than other media; it is capable of absorbing MW radiation rapidly to speed up the release of electrons, leading to rises of the ZVI particle surface temperature. If the MW power is continued, excessive electricity will accumulated inside ZVI particles, resulting in sparks. The results show that during the initial 5 sec (700 W), the linear aliphatic PCE has a faster decomposing rate than the ringed PCP (82.0% vs. 4.8%) because less energy is required for decomposing the linear-chlorine bond (90 kcal mol^?1) than ring-chlorine bonds (95 kcal mol^?1). Later, the removal rate for either PCE or PCP remains the same when the exposure time is between 5 and 60 sec. Without MW irradiation, linear PCE molecules have larger surface area to contact ZVI, and hence they have better removal efficiencies than PCP molecules. Using Fe⁰ as a microwave dielectric medium to treat PCE or PCP is a new and worthwhile treatment technology; it is environmentally friendly, and its use will eliminate the secondary pollution.

Implications Nanoscale iron particles are characterized by high surface-area-to-volume ratios, high specific surface area, and high surface reactivity. With a much higher dielectric loss factor, it is capable of absorbing MW radiation rapidly to speed up the release of electrons, leading to rise in temperature. The time needed to achieve a satisfactory treatment is also reduced, leading to significant saving of energy consumption to make this method cost-effective and also environmentally friendly for the industry to pursuit sustainable development.     

The Adsorptive Capacity of Vapor-Phase Mercury Chloride onto Powdered Activated Carbon Derived from Waste Tires

Abstract

Injection of powdered activated carbon (PAC) upstream of particulate removal devices (such as electrostatic precipitator and baghouses) has been used effectively to remove hazardous air pollutants, particularly mercury-containing pollutants, emitted from combustors and incinerators. Compared with commercial PACs (CPACs), an alternative PAC derived from waste tires (WPAC) was prepared for this study. The equilibrium adsorptive capacity of mercury chloride (HgCl₂) vapor onto the WPAC was further evaluated with a self-designed bench-scale adsorption column system. The adsorption temperatures investigated in the adsorption column were controlled at 25 and 150 °C. The superficial velocity and residence time of the flow were 0.01 m/sec and 4 sec, respectively. The adsorption column tests were run under nitrogen gas flow. Experimental results showed that WPAC with higher Brunauer–Emmett–Teller (BET) surface area could adsorb more HgCl₂ at room temperature. The equilibrium adsorptive capacity of HgCl₂ for WPAC measured in this study was 1.49 × 10^?1 mg HgCl₂/g PAC at 25 °C with an initial HgCl₂ concentration of 25 μg/m³. With the increase of adsorption temperature ≤150 °C, the equilibrium adsorptive capacity of HgCl₂ for WPAC was decreased to 1.×34 10^?1 mg HgCl₂/g PA≤C. Furthermore,WPAC with higher sulfur contents could adsorb even more HgCl₂ because of the reactions between sulfur and Hg²⁺ at 150 °C. It was demonstrated that the mechanisms for adsorbing HgCl₂ onto WPAC were physical adsorption and chemisorption at 25 and 150 °C, respectively. Experimental results also indicated that the apparent overall driving force model appeared to have the good correlation with correlation coefficients (r) >0.998 for HgCl₂ adsorption at 25 and 150 °C. Moreover, the equilibrium adsorptive capacity of HgCl₂ for virgin WPAC was similar to that for CPAC at 25 °C, whereas it was slightly higher for sulfurized WPAC than for CPAC at 150 °C.     

微电解预处理靛蓝牛仔布印染废水

靛蓝牛仔布印染废水组分复杂,浓度高、水量大,属于难处理的工业废水,为了有效降低后续生物处理单元的负荷,采用铁炭微电解工艺对该废水进行预处理;通过正交实验考察pH、反应时间及铁炭比处理效果的影响规律及COD去除反应动力学,并对各因素作了单因素影响实验,确定了最佳工艺条件.结果表明,铁炭微电解法是预处理靛蓝牛仔布印染废水的一种有效方法,在Fe/C为2:1、pH为3的条件下反应90 min,铁炭微电解出水COD的去除率在49.2％,色度去除率达到80％,该印染废水经微电解处理后,BOD5/COD比值可从原来的0.248上升至0.436,可生化性明显提高.此外,微电解预处理靛蓝牛仔布印染废水中COD的去除反应符合二级反应动力学规律.     

油田水反硝化技术抑制硫酸还原菌

利用反硝化技术对江苏油田5个联合站的采出水,进行了添加不同抑制剂的浓度、种类、不同配比和接种DNB菌对SRB、DNB的菌落数量、硫化氢的产生量和氧化还原电位的影响的静态实验。研究结果表明:投加一定浓度的硝酸盐、亚硝酸盐和钼酸盐,对油田采出水SRB的生长都有不同程度的抑制作用,而同等浓度的抑制效果表现为亚硝酸盐>硝酸盐>钼酸盐,同时投加DNB和0.3～0.5 g/L(比例为1∶1)的亚硝酸盐/硝酸盐可较好地抑制油田采出水中的SRB和硫化氢的产生,其中0.5 g/L抑制效果最明显,可抑制硫化氢的产生10 d以上,SRB和硫化氢抑制率分别可达87%和98%。以不同药剂的常压静态腐蚀实验结果表明,抑制剂的腐蚀速率比杀菌剂和缓蚀剂略高,但低于石油天然气行业中标准规定的0.0076 mm/a,也远低于对照样的0.152 mm/a。     

高气速间歇式生物过滤去除高负荷H2S

采用生物过滤法,以鸡粪堆肥和PE混合物为填料,在高气速条件下间歇式处理高负荷H2S废气。空床停留时间为20、15、10、6.7和5 s时,入口浓度3 000 mg/m3下的平均去除率分别为100%、100%、96.5%、89.2%和90.5%。高气速EBRT为5 s时,高入口负荷2 147 g/(m3.h)时的去除负荷为2 023 g/(m3.h),去除率达94%。采用Michaelis-Ment-en模型进行生物降解宏观动力学研究,其中Ks为550 mg/m3,Vm为6.8×104g/(m3.d)。结果表明,在实验温度17～24℃,湿度30%～50%下,生物过滤法间歇式处理高气速高负荷H2S的去除性能好。     

两相分配式生物反应器处理高盐废水中的苯酚

采用新型两相分配式生物反应器(TPPB)和前期研究得到的高效苯酚降解菌对高盐废水中苯酚的降解进行研究,研究中确定煤油为反应系统的最佳有机溶剂,并考察了废水苯酚含量、废水盐度以及搅拌器搅拌速度对苯酚降解的影响。结果表明,反应系统能正常降解苯酚含量为1 000～2 500 mg/L的高盐苯酚废水;反应系统在含盐量为100 g NaCl/L、搅拌速度为50 r/min的运行工况条件下,降解时间缩短为52 h,总酚去除率为20.58 mg/(L.h)。     

高速公路路面沉积物的污染特性

对湖南省长潭西高速公路不同采样点的路面沉积物进行取样分析,并检测了样品的颗粒级配、COD、重金属(Cu、Zn、Pb和Cd)和有机质。结果表明,路面沉积物主要以粒径<0.15 mm的颗粒为主;较小颗粒物中的COD含量高于较大颗粒中的COD含量;粒径在0.15 mm以下的颗粒物所含重金属Cu、Zn、Pb和Cd的浓度普遍高于所选的土壤标准值,降雨一旦形成径流将会产生严重的污染危害;沉积物中的有机质含量对重金属的吸附有一定的影响,有机质含量越高,沉积物中重金属含量相对也高。     

城市污水条件下ASBR厌氧氨氧化的启动与脱氮性能

采用ASBR在城市污水条件下进行厌氧氨氧化的启动与脱氮性能研究。实验接种好氧硝化污泥,在温度为(35±1)℃、HRT为24 h、pH为7.3～8.5的条件下经过130 d的培养,成功启动了厌氧氨氧化反应。实验结果表明,厌氧氨氧化反应稳定运行时,TN容积负荷平均为0.179 kg/(m3.d),NH4+-N、NO2--N和TN去除率分别达到了95.30%、91.30%和76.28%。启动期和稳定运行期NH4+-N、NO2--N去除量和NO3--N生成量的比值分别达到1∶1.54∶0.25和1∶1.27∶0.27;稳定运行期进出水pH差值由启动时的0.85下降到0.24。启动期反硝化和厌氧氨氧化反应同时存在而在稳定运行期厌氧氨氧化发展成为主导反应。MLSS和MLVSS/MLSS先减少后增加,反映了启动过程中硝化细菌、反硝化细菌的衰亡和厌氧氨氧化菌逐渐富集的过程,这与反应器的宏观运行效果相一致。