厌氧-好氧一体化反应器处理高浓度有机废水的运行特性研究

本实验采用新型厌氧—好氧一体化反应器处理高浓度有机废水,主要研究了系统的启动与运行性能,并对系统的NH3 N去除效果作了初步考察。实验结果表明:在16℃～24℃的自然温度下,采用递增负荷、厌氧和好氧分期启动的方式,系统可在38天内达到较好的启动效果;在系统负荷运行期内,当系统总进水COD浓度平均值为3601 8mg/L,总出水COD浓度平均值为384 0mg/L,系统容积负荷平均值为2 54kgCOD/(m3·d),系统总HRT平均值为35 1h时,系统总COD去除率平均值达90 6%。实验还发现:当进水NH3 N浓度为280 3～350 7mg/L,整个系统的NH3 N去除率在68 5%～91 7%,平均为81 0%。由此说明,本反应器具有很好的COD去除性能和NH3 N去除效果,适合于处理COD浓度高且含有中等NH3 N浓度的有机废水。     

溶出伏安法中电极的操作技术

电极性能的优劣是完成溶出伏安分析的关键,本文就三电极体系中电极的选择、处理、安装、使用、维护方法等方面作了较详细的说明和探讨,提高了方法的精密度和准确度,使溶出伏安法在海水分析中得到更好的应用.     

官方媒体参与下不同风险感知群体竞争模型及其演化规律

为识别公众风险感知的演化规律和官方媒体参与的作用机制，首先，根据公众的行为表现划分不同风险感知群体，并分析群体间的相互竞争和官方媒体的扰动作用；然后，通过扩展Lotka Volterra模型建立群体间的相互竞争模型；在此基础上，通过推导模型平衡点及其稳定性分析模型演化规律；最后，运用数值仿真考查了官方媒体的参与对模型演化的影响。研究结果表明:模型演化具有3种结果情景，官方媒体参与能够显著改变模型演化的速度和结果。     

基于自动水位补偿的含水煤层瓦斯压力测定方法研究

通过研究含水煤层瓦斯压力测定方法现状,确定主要影响测定结果的因素为水压干扰、煤泥水干扰。针对以上问题提出了测定新方法,运用自动水位补偿方法剔除水压对测定结果的干扰,通过设计装有复合材质倾斜滤网的煤泥沉淀池,完成对煤泥的过滤和导流,实现对煤泥水的净化。此方法直接测定瓦斯压力,避免反推计算,从而减小了环境因素对测定结果的干扰。依据理论设计了含水煤层瓦斯压力测定装置,并进行了井下对比试验,现场试验结果表明:运用新设计装置测定结果比普通方法更接近理论值,数据利用价值高。该装置操作简单、自动化程度高、测定结果准确,可为含水煤层瓦斯治理提供数据支持,确保生产安全。     

受限空间内惰性气体对CH4爆炸抑制特性研究

N2和CO2是常用的惰性抑爆气体,为研究两种气体的抑爆特性,采用20L球形爆炸试验装置,分析了不同浓度配比条件下N2/CH4/空气以及CO2/CH4/空气混合气体的爆炸压力,同时采集爆炸后的气体样品,对比分析爆炸后残留气体的主要成分。结果显示:随CH4浓度从5%增加至12.5%时,完全抑制CH4爆炸需要的惰性气体最小量先增大后降低,CH4浓度在6.5%~7.5%之间时,抑爆需要的惰性气体的量最大;在同一CH4浓度条件下,抑爆需要N2的量大于CO2,并且CH4浓度在5%~6.5%时,抑爆需要两种惰性气体的量值差别最大;当CH4浓度一定时,随着加入惰性气体量的增大,爆炸最大超压逐渐降低,惰性气体浓度和爆炸超压之间基本呈线性关系;在同样条件下,相对于N2,CO2为抑爆气体时,爆炸后腔体内残留的CH4浓度较高。研究成果为惰性气体抑爆技术提供技术支撑,同时为揭示惰性气体抑爆机理有一定作用。     

湿法串联氧化脱硝机理研究

采用鼓泡法测试一定质量分数的H_2O_2和NaClO_2溶液在不同的温度和质量分数条件下氧化吸收剂对脱硝效率的影响,得出各自最优脱硝条件,最后与一定质量分数的KMnO_4溶液两两串联得出最优脱硝条件。结果表明:(1)NaClO_2的脱硝效率高于H_2O_2的脱硝效率。(2)在一定质量分数范围内,H_2O_2和NaClO_2的脱硝效率随质量分数的增加而增加,但超过临界质量分数后,脱硝效率降低。(3)NaClO_2与KMnO_4溶液串联,得到的脱硝效率最高。     

含阶梯结构的高层楼梯井内烟气湍流及输运特征量的全局敏感性分析

高层建筑竖井火灾中影响因素众多,并且各因素对高层楼梯井火灾中重要现象、关键数值等的影响大小不一,使得此类火灾中的实验或理论研究成本较高。通过建立全局敏感性分析平台,定量考察了高层楼梯井结构所涉及因素的影响大小,并能够方便地筛选掉对所考察量影响较小的因素,以降低实验或计算成本。使用数值模拟方法,通过CFD软件对包含阶梯几何框架的高层楼梯井结构火灾进行了共计60次工况计算。并且根据计算结果,使用全局参数敏感性分析方法,得出建筑尺寸、热释放速率、环境参数对高层楼梯井内烟气湍流特性及输运特性的敏感性排序。结果表明,火源热释放速率对各输出参数的影响均占38%以上。     

Determination of trace metal concentrations in soil profiles of municipal waste dumps in Nigeria

The concentrations of trace metals (Cd, Pb, Cu, Cr, Fe, Ni, Zn and Co) were studied in soil profiles of eight municipal waste dump sites in Warri metropolis. The results indicate that concentrations of trace metals varied widely among the different dumpsites and decreased with depths in a studied soil profile. The accumulation pattern for the heavy metals in the soil profiles follows the order: Fe > Pb > Mn > Co > Cr > Zn > Ni > Cu > Cd. The concentrations of metals found in these sites was below the Canadian remediation criteria for land for agricultural, residential and commercial/industrial purposes except for the cadmium levels in some sites that exceeded criterion values for agricultural and residential. In such sites, remedial actions are required before any form of chosen development can take place. The levels of heavy metals found in these dump sites were higher than that of the control site. The examined metals showed no significant correlation with soil physicochemical properties at the surface horizon, which is suggestive evidence that these metals arise from anthropogenic input.     

Critical Review of Norms and Standards for Biodegradable Agricultural Plastics Part II: Composting

The critical review of norms and standards and corresponding tests to determine the compostability of biodegradable plastics, possibly applicable also to biodegradable agricultural plastics, shows that many norms concerning testing and labelling of compostable plastics have been established at the international level. Some of them are about plastic materials, some others are about products like packaging. The media and conditions of testing cover mainly the conditions designed for industrial composting facilities, and only a few concern home composting conditions. Considering that the end of life management of biodegradable agricultural plastic products will be done at the farm to reduce the management of the waste and also its cost, only a few of these norms are considered to be suitable for adaptation to cover also biodegradable agricultural plastic products. The biodegradability validation criteria under composting conditions, such as the threshold percentage of biodegradation and disintegration, the time and temperature, and the ecotoxicity, are presented for the main norms and standard testing methods. Based on these different norms and their content, a list of specs and technical requirements that could be adapted to meet farm composting conditions for agricultural compostable plastics is proposed. These requirements may be used as criteria for the establishment of a new integrative norm for agricultural compostable plastics.     

耶郸市产业结构与环境质量相关性研究

文章在2007年对邯郸市产业结构与环境质量现状相关性调查的基础上,分析了邯郸市产业结构与环境质量现状的关系,提出了改善当地环境质量的办法.