Preparation of sulfurized powdered activated carbon from waste tires using an innovative compositive impregnation process

The objective of this study is to develop an innovative compositive impregnation process for preparing sulfurized powdered activated carbon (PAC) from waste tires. An experimental apparatus, including a pyrolysis and activation system and a sulfur (S) impregnation system, was designed and applied to produce sulfurized PAC with a high specific surface area. Experimental tests involved the pyrolysis, activation, and sulfurization of waste tires. Waste-tire-derived PAC (WPAC) was initially produced in the pyrolysis and activation system. Experimental results indicated that the Brunauer-Emmett-Teller (BET) surface area of WPAC increased, and the average pore radius of WPAC decreased, as water feed rate and activation time increased. In this study, a conventional direct impregnation process was used to prepare the sulfurized PAC by impregnating WPAC with sodium sulfide (Na2S) solution. Furthermore, an innovative compositive impregnation process was developed and then compared with the conventional direct impregnation process. Experimental results showed that the compositive impregnation process produced the sulfurized WPAC with high BET surface area and a high S content. A maximum BET surface area of 886 m2/g and the S content of 2.61% by mass were obtained at 900 degrees C and at the S feed ratio of 2160 mg Na2S/g C. However, the direct impregnation process led to a BET surface area of sulfurized WPAC that decreased significantly as the S content increased.     

Determination of growth rate and yield of nitrifying bacteria by measuring carbon dioxide uptake rate.

Nitrifier growth parameters--the maximum growth rate (microAmax) and yield (YA)--were estimated by measuring the rate of carbon dioxide uptake and additional rates of oxygen uptake and ammonia (or nitrite) use. Batch tests in a combined titrimetric and offgas analyzer with enriched Nitrobacter and Nitrosomonas cultures and an activated sludge sample were performed. The measured microAmax values for the Nitrobacter and Nitrosomonas cultures were 0.67 +/- 0.03 day(-1) and 0.54 +/- 0.09 day(-1), while the YA values were 0.072 +/- 0.01 g volatile suspended solids (VSS) x g nitrogen (N)(-1) and 0.14 +/- 0.02 gVSS x gN(-1), respectively. For the activated sludge sample, microAmax was observed to increase with pH (microAmax = 0.72 x 3.3(pH-7.1)) over the range 6.8 to 7.1. All microAmax and YA values determined by this method were similar to those previously reported. Compared with other microAmax and YA estimation methods, this method allows for unique microAmax and YA estimations for given conditions from a single experiment.     

豆制品废水一级厌氧法的处理工程

在豆制品生产过程中产生的高浓度有机废水，采用4000m^3一级厌氧（UASB）法处理杭州某豆制品厂1500m^3／d的豆制品废水，原水COD浓度为4000—6000mg／L，出水浓度降至300—400mg／L，COD去除率达到95％以上，满足三级排放标准的要求。沼气产量2700—3000m^3／d，用于燃烧加热原水。     

等离子体与光催化复合技术净化污水处理泵站臭气

用一种等离子体-光催化复合技术净化污水处理泵站臭气，研究表明该复合技术具有较显著的协同促进效应，通过改变等离子体发生单元与光催化单元的距离以及在两者之间放置去静电网，可消除等离子体单元产生的负电荷对光催化单元的不利影响，进一步提高其复合效应。同时还对这一复合技术产生协同效应的机理进行了分析，并在污水处理泵站实地考查了这种复合技术对臭气的净化效果。该技术对臭气中NH3的降解率可达46．1％，对H2S的降解率可达67．3％。     

The impacts of different kinds of dust events on PM10 pollution in northern China

In this study the frequencies of PM₁₀ (as key urban pollutant) in 14 key environmental protection cities in northern China were analyzed. It follows that the PM₁₀ concentration in the high-frequency period is higher with an extent 0.009–0.066 mg m⁻³ than in the low-frequency period of 2001–2002. Further the impacts of three kinds of dust events on the PM₁₀ concentration in four cities (Beijing, Hohhot, Xi’an and Lanzhou) were explored. The results showed that different kinds of dust events have different influences on variation of PM₁₀ concentration in these four cities. In Lanzhou and Hohhot, which are near the source areas of dust events, the contribution degree of these three dust events to the PM₁₀ is: floating dust>dust storm>blowing dust. Whereas, in Beijing and Xi’an situated in dust event passing areas, the mean value of PM₁₀ concentration is higher in blowing dust than in floating dust (no dust storm). In addition, the influences of dust events on PM₁₀ concentration are different in the cities on different dust event paths. In Beijing and Hohhot (on the northern path), the high PM₁₀ concentration is usually caused by blowing dust. But in both Lanzhou and Xi’an (on the western/northwestern path) the high PM₁₀ pollution concentration is usually caused by floating dust.     

Effects of aerosol species on atmospheric visibility in Kaohsiung City, Taiwan

Visibility data collected from Kaohsiung City, Taiwan, for the past two decades indicated that the air pollutants have significantly degraded visibility in recent years. During our study period, the seasonal mean visibilities in spring, summer, fall, and winter were only 5.4, 9.1, 8.2, and 3.4 km, respectively. To ascertain how urban aerosols influence the visibility, we conducted concurrent visibility monitoring and aerosol sampling in 1999 to identify the principal causes of visibility impairments in the region. In this study, ambient aerosols were sampled and analyzed for 11 constituents, including water-soluble ions and carbon materials, to investigate the chemical composition of Kaohsiung aerosols. Stepwise regression method was used to correlate the impact of aerosol species on visibility impairments. Both seasonal and diurnal variation patterns were found from the monitoring of visibility. Our results showed that light scattering was attributed primarily to aerosols with sizes that range from 0.26 to 0.90 pm, corresponding with the wavelength region of visible light, which accounted for approximately 72% of the light scattering coefficient. Sulfate was a dominant component that affected both the light scattering coefficient and the visibility in the region. On average, (NH4)2SO4, NH4NO3, total carbon, and fine particulate matter (PM2.5)-remainder contributed 53%, 17%, 16%, and 14% to total light scattering, respectively. An empirical regression model of visibility based on sulfate, elemental carbon, and humidity was developed, and the comparison indicated that visibility in an urban area could be properly simulated by the equation derived herein.     

大气汞形态测定中吸附剂的选择及性能

本文选择了上试-402树脂作为常温高效选择性吸附氯化甲基汞的吸附剂,改进了Cbromosorb W-SE30-HCl吸附剂管的制备方法,并同时组装了一套由微孔纤维滤膜与Chromosorb W-SE30-HCl、402树脂、螺旋银丝、镀金细砂等四种吸附管串联组成的采样系统,由小型采样机抽气采样,于常温下同时依次富集颗粒汞、氯化汞、氯化甲基汞、单质汞及二甲基汞,系统小型轻便,适于野外采样。采样后,四种吸附剂分别采用高低两种温度脱汞。上述五种形态汞均由装有高温石英原子化器的AAs定量测定。     

活性矸对硫、氟、铬阴离子吸附的研究

本文对活性矸-硫、活性矸-氟、活性矸-铬(Ⅵ)三种吸附系统进行了研究.结果表明:活性矸静态等温吸附符合Freundlich吸附等温式;静态吸附动力学可用Bangharm吸附速率方程描述;利用Body公式可确定活性析矸-氟吸附系统的液相有效扩散系数.     

热带人工林生物物理参数及生物量对RADARSAT SAR信号响应研究

合成孔径侧视雷达穿透冠层而获得树干信息的特点使得其具有在南方NDVI易饱和地区的生物量估测方面优于光学遥感。文章利用地面实测调查数据,首次系统地研究了热带人工林生物物理参数及生物量对RADARSAT-SAR信号响应。结果表明:RADARSAT-SAR后向散射系数与森林生物量、树高、胸径可以用对数模型模拟。对于本实验区人工速生林来说,在森林生物量小于40 t.hm-2时RADARSAT-SAR后向散射系数与森林生物量具有较强相关性。桉树树高与后向散射系数的相关系数大于桉树胸径与后向散射系数关系。松树胸径与后向散射系数相关系数高于树高与后向散射系数的相关系数。研究结果为SAR在热带森林研究中的应用提供了一定的理论基础。     

受体功能区结构与环境内分泌干扰效应生物差异的关系

环境中存在的多种内分泌干扰物能够与生物体内的天然激素受体选择性结合并产生多种生物效应,由于受体功能区三维结构的不同,其内分泌干扰活性存在着种间、种内、组织间等的种种差异,限制了不同物种间毒性效应的外推研究,增加了环境内分泌干扰物筛选和风险评价的难度.论文综述了基于受体介导的环境内分泌干扰物生物活性与相应受体选择性及受体功能区结构关系的研究进展,并利用分子模拟方法分析探讨了雌激素受体与部分化合物结合作用模式,讨论了目前存在的问题,对以后有关方面的研究提出了建议.