Evaluation of existing equations for temporal scour depth around circular bridge piers

Scour is defined as the processes of removal of sediment particles from water stream bed by the erosive action of activated water, and also carries sediment away from the hydraulic structures. Scour is the main cause of pier failure. Numerous equations are available for estimating temporal and equilibrium scour depth. The present study describes the phenomenon of temporal scour depth variation at bridge piers and deals with the methods for its estimation. The accuracy of six temporal scour depth equations are also checked in this study. After graphical and statistical analysis, it was found that the relationship proposed by Oliveto and Hager (J Hydraul Eng (ASCE) 128(9):811–520, 2002) predicts temporal scour depth better than other equations. Three equations of equilibrium time of scour are also used for computing equilibrium time. Equilibrium time equation proposed by Choi and Choi (Water Environ J 30(1–2):14–21, 2016) gives better agreements with observed values.     

Modeling of Cr contamination in the agricultural lands of three villages near the leather industry in Kasur,Pakistan, using statistical and GIS techniques

Kasur is one of the hubs of leather industry in the Punjab, Pakistan, where chrome tanning method of leather processing is extensively being used. Chromium (Cr) accumulation levels in the irrigation water, soil, and seasonal vegetables were studied in three villages located in the vicinity of wastewater treatment plant and solid waste dumping site operated by the Kasur Tanneries Waste Management Agency (KTWMA). The data was interpreted using analysis of variance (ANOVA), clustering analysis (CA), and principal component analysis (PCA). Interpolated surface maps for Cr were generated using the actual data obtained for the 30 sampling sites in each of the three villages for irrigation water, soil, and seasonal vegetables. The level of contamination in the three villages was directly proportional to their distance from KTWMA wastewater treatment plant and the direction of water runoff. The highest level of Cr contamination in soil (mg kg^?1) was observed at Faqeeria Wala (37.67), intermediate at Dollay Wala (30.33), and the least in Maan (25.16). A gradational variation in Cr accumulation was observed in the three villages from contaminated wastewater having the least contamination level (2.02–4.40 mg L^?1), to soil (25.16–37.67 mg kg^?1), and ultimately in the seasonal vegetable crops (156.67–248.33 mg kg^?1) cultivated in the region, having the highest level of Cr contamination above the permissible limit. The model used not only predicted the current situation of Cr contamination in the three villages but also indicated the trend of magnification of Cr contamination from irrigation water to soil and to the base of the food chain. Among the multiple causes of Cr contamination of vegetables, soil irrigation with contaminated groundwater was observed to be the dominant one.     

Ecological footprint: an indicator of environmental sustainability of a surface coal mine

Ecological footprint of mining can be used as an indicator to monitor and regulate mining operations and ensure long-term environmental sustainability. It can be viewed as a mining footprint, which is surrogate of the environmental impacts of mining. In this paper, a methodological framework is developed to demonstrate how ecological footprint can be used as an indicator of environmental degradation. Nine air quality and 26 soil quality samples are collected from the adjoining area of a mechanized coal mine, located in Raniganj coal mining belt of Burdwan district, West Bengal. Geographical information system is used for data interpolation and preparation of air and soil quality maps. The weights of different air and soil quality parameters are calculated by running principal component analysis. These derived weights are used for preparation of final composite air and soil quality maps. The composite maps show the mining footprints, expressed as land equivalent, around the active mine sites. The impact zones reveal the extent of degradation of the soil and air qualities in the areas near a mine. It is found that the impact zones, with respect to air and soil qualities, extend over areas which are 7.7 and 7.8 times the actual mining areas, that is, the area covered under mining operations, respectively. The results show the extent of degradation of air and soil qualities of the area. At different stages of mining, these footprints can be used as indicators to reveal the areas where soil and air qualities are adversely impacted.     

Sustainable cooking energy options for rural poor people in India: an empirical study

Currently, energy consumption for cooking in rural households of India is mostly based on fuelwood used in traditional stoves. This paper presents results of a study carried out in a forest fringe area of India on cooking energy use. The concept of calculating levelized cost as cost per unit of useful energy is applied on source–device combinations of cooking and validated in Bargaon Community Development Block of Sundergarh District in Odisha, India. About 92 % of the households in the study area use fuelwood as the only energy source for cooking; the total use of fuelwood for only cooking, in the Block is nearly 1.8 times the total sustainable wood supply showing an urgent need for promoting alternative cooking energy options. This paper also presents an assessment of different cooking options in terms of cost per unit of useful cooking energy. LPG, biogas and gasifier stoves are found to be far too expensive for the local people. Briquette-fired improved stoves appear to be a promising cooking energy option in the study area. Government support and intervention are recommended for promoting this option.     

Locating Spatial Variation in the Association Between Wildland Fire Risk and Social Vulnerability Across Six Southern States

Wildland fire in the South commands considerable attention, given the expanding wildland urban interface (WUI) across the region. Much of this growth is propelled by higher income retirees and others desiring natural amenity residential settings. However, population growth in the WUI increases the likelihood of wildfire fire ignition caused by people, as humans account for 93% of all wildfires fires in the South. Coexisting with newly arrived, affluent WUI populations are working class, poor or otherwise socially vulnerable populations. The latter groups typically experience greater losses from environmental disasters such as wildfire because lower income residents are less likely to have established mitigation programs in place to help absorb loss. We use geographically weighted regression to examine spatial variation in the association between social vulnerability (SOVUL) and wildfire risk. In doing so, we identify “hot spots” or geographical clusters where SOVUL varies positively with wildfire risk across six Southern states—Alabama, Arkansas, Florida, Georgia, Mississippi, and South Carolina. These clusters may or may not be located in the WUI. These hot spots are most prevalent in South Carolina and Florida. Identification of these population clusters can aid wildfire managers in deciding which communities to prioritize for mitigation programming.     

Multispecies remote sensing measurements of vehicle emissions on Sherman Way in Van Nuys,California

As part of the 2010 Van Nuys tunnel study, researchers from the University of Denver measured on-road fuel-specific light-duty vehicle emissions from nearly 13,000 vehicles on Sherman Way (0.4 miles west of the tunnel) in Van Nuys, California, with its multispecies Fuel Efficiency Automobile Test (FEAT) remote sensor a week ahead of the tunnel measurements. The remote sensing mean gram per kilogram carbon monoxide (CO), hydrocarbon (HC), and oxide of nitrogen (NO_x) measurements are 8.9% lower, 41% higher, and 24% higher than the tunnel measurements, respectively. The remote sensing CO/NO_x and HC/NO_x mass ratios are 28% lower and 20% higher than the comparable tunnel ratios. Comparisons with the historical tunnel measurements show large reductions in CO, HC, and NO_x over the past 23 yr, but little change in the HC/NO_x mass ratio since 1995. The fleet CO and HC emissions are increasingly dominated by a few gross emitters, with more than a third of the total emissions being contributed by less than 1% of the fleet. An example of this is a 1995 vehicle measured three times with an average HC emission of 419 g/kg fuel (two-stroke snowmobiles average 475 g/kg fuel), responsible for 4% of the total HC emissions. The 2008 economic downturn dramatically reduced the number of new vehicles entering the fleet, leading to an age increase (>1 model year) of the Sherman Way fleet that has increased the fleet's ammonia (NH₃) emissions. The mean NH₃ levels appear little changed from previous measurements collected in the Van Nuys tunnel in 1993. Comparisons between weekday and weekend data show few fleet differences, although the fraction of light-duty diesel vehicles decreased from the weekday (1.7%) to Saturday (1.2%) and Sunday (0.6%).

Implications: On-road remote sensing emission measurements of light-duty vehicles on Sherman Way in Van Nuys, California, show large historical emission reductions for CO and HC emissions despite an older fleet arising from the 2008 economic downturn. Fleet CO and HC emissions are increasingly dominated by a few gross emitters, with a single 1995 vehicle measured being responsible for 4% of the entire fleet's HC emissions. Finding and repairing and/or scrapping as little as 2% of the fleet would reduce on-road tailpipe emissions by as much as 50%. Ammonia emissions have locally increased with the increasing fleet age.     

Impact of PAH on biological health parameters of soils of an Indian refinery and adjoining agricultural area—a case study

The present study is aimed at analysing and comparing different soil enzymes in soil samples of native contaminated sites of a Mathura refinery and adjoining agricultural land. Enzyme activities are considered as indicators of soil quality and changes in biogeochemical function due to management or perturbations. Soil samples were collected from the premises and nearby area of Mathura refinery, India. Biological health parameters (dehydrogenase, aryl esterase, aryl sulphatase, \upbeta \upbeta -glucosidase, alkaline phosphatase, acid phosphatase, lipase, laccase and catalase activity) were estimated in the soil samples. Among all the samples, sewage sludge soil showed maximum activity of enzymes, microbial biomass carbon and most probable number of polycyclic aromatic hydrocarbon (PAH) degraders in soils spiked with three- to four-ring PAHs at 50 ppm. Available phosphorus, potassium and nitrogen was also exceptionally high in this sample, indicating maximum microbial bioconversion due to presence of nutrients stimulating potent PAH-degrading microorganisms.     

The 1999 Fresno Particulate Matter Exposure Studies: Comparison of Community,Outdoor, and Residential PM Mass Measurements

ABSTRACT

Two collaborative studies have been conducted by the U.S. Environmental Protection Agency (EPA) National Exposure Research Laboratory (NERL) and National Health and Environmental Effects Research Laboratory to determine personal exposures and physiological responses to par-ticulate matter (PM) of elderly persons living in a retirement facility in Fresno, CA. Measurements of PM and other criteria air pollutants were made inside selected individual residences within the retirement facility and at a central outdoor site on the premises. In addition, personal PM exposure monitoring was conducted for a subset of the participants, and ambient PM monitoring data were available for comparison from the NERL PM research monitoring platform in central Fresno. Both a winter (February 1-28, 1999) and a spring (April 19-May 16, 1999) study were completed so that seasonal effects could be     

Using constant head step tests to determine hydraulic apertures in fractured rock

The initial step in the analysis of contaminant transport in fractured rock requires the consideration of groundwater velocity. Practical methods for estimating the average linear groundwater velocity (vˉ) in fractured rock require determination of hydraulic apertures which are commonly calculated by applying the cubic law using transmissivity (T) values and the number of hydraulically active fractures in the test interval. High-resolution, constant-head step injection testing of cored boreholes in a 100 m thick fractured dolostone aquifer was conducted using inflatable packers to isolate specific test intervals from the rest of the borehole. The steps in each test interval were gradually increased from very low to much higher injection rates. At smaller injection rates, the flow rate vs. applied pressure graph projects through the origin and indicates Darcian flow; non Darcian flow is evident at higher injection rates. Non-Darcian flow results in significantly lower calculated T values, which translates to smaller hydraulic aperture values. Further error in the calculated hydraulic aperture stems from uncertainty in the number of hydraulically active fractures in each test interval. This estimate can be inferred from borehole image and core logs, however, all of the fractures identified are not necessarily hydraulically active. This study proposes a method based on Reynolds number calculations aimed at improving confidence in the selection of the number of active fractures in each test interval.     

The Effect of CTBN Concentrations on the Kinetic Parameters of Decomposition of Blends of Epoxy Resins Modified with Carboxyl-Terminated Liquid Copolymer

Diglycidyl ether of bisphenol—A (DGEBA)—based epoxy resin was blended in the ratio of 3:1 (weight basis) with cycloaliphatic epoxy (CAE) resin. The prepared blend sample was further blended with different weight percentages of carboxyl-terminated butadiene acrylonitrile copolymer (CTBN) ranging between 0 and 25 wt% with an interval of 5 wt% and cured with stiochiometric amounts of 4, 4’- diamino diphenyl sulphone (DDS) cure agent. Structural changes during blending were studied by Fourier-transform infra-red (FTIR) spectroscopic analysis. The kinetic parameters, viz., order of decomposition reaction (n), activation energy (E), pre-exponential factor (Z) and rate decomposition constant (k), for the decomposition of the samples were calculated by applying Coats-Redfern equation over thermogravimetric (TG) data. The degradation of each sample followed second-order degradation kinetics, which was calculated by Coats-Redfern equation using best-fit analysis. This was further confirmed by linear regression analysis. The validity of data was checked by t-test statistical analysis. Further, the blend sample had higher initial degradation temperature and activation energy than its respective pure epoxy resin indicating that the CTBN acted as thermal stabilizer for epoxy resin which improved the thermal stability.