Prompting safety-belt use in the context of a belt-use law: the flash-for life revisited

PROBLEM: Safety-belt use reduces motor vehicle crash-related morbidity and mortality, yet an estimated 18% of drivers do not consistently buckle up (NHTSA, 2005). In 1985, Geller and colleagues developed an interpersonal Flash-for-Life prompt that increased belt use among 22% of 1,087 unbuckled drivers (Geller, Bruff, & Nimmer, 1985). METHOD: The Flash-for-Life intervention was re-introduced at a large university with high safety-belt use (i.e., 80%). College students stood at parking-lot entrance/exits and "flashed" signs with the message, "Please Buckle Up, I Care" to unbuckled drivers. RESULTS: Of 427 unbuckled drivers observed, 30% of these complied with the prompt. Male drivers were significantly more likely to comply with prompts delivered by females. DISCUSSION: Compliance was higher than in the 1985 study, indicating a high baseline rate of safety-belt use does not negate potential beneficial influence of a prompting intervention. This intervention is particularly effective with college-aged males, a sub-group of the driving population least likely to buckle-up. IMPACT ON INDUSTRY: A simple behavioral prompt could be used at most industrial complexes to increase safety-belt use among vehicle occupants who are not buckled-up.     

Effects of Groundwater-Flow Paths On Nitrate Concentrations Across Two Riparian Forest Corridors1

Speiran, Gary K., 2010. Effects of Groundwater-Flow Paths on Nitrate Concentrations Across Two Riparian Forest Corridors. Journal of the American Water Resources Association (JAWRA) 46(2):246-260. DOI: 10.1111/j.1752-1688.2010.00427.x Abstract: Groundwater levels, apparent age, and chemistry from field sites and groundwater-flow modeling of hypothetical aquifers collectively indicate that groundwater-flow paths contribute to differences in nitrate concentrations across riparian corridors. At sites in Virginia (one coastal and one Piedmont), lowland forested wetlands separate upland fields from nearby surface waters (an estuary and a stream). At the coastal site, nitrate concentrations near the water table decreased from more than 10 mg/l beneath fields to 2 mg/l beneath a riparian forest buffer because recharge through the buffer forced water with concentrations greater than 5 mg/l to flow deeper beneath the buffer. Diurnal changes in groundwater levels up to 0.25 meters at the coastal site reflect flow from the water table into unsaturated soil where roots remove water and nitrate dissolved in it. Decreases in aquifer thickness caused by declines in the water table and decreases in horizontal hydraulic gradients from the uplands to the wetlands indicate that more than 95% of the groundwater discharged to the wetlands. Such discharge through organic soil can reduce nitrate concentrations by denitrification. Model simulations are consistent with field results, showing downward flow approaching toe slopes and surface waters to which groundwater discharges. These effects show the importance of buffer placement over use of fixed-width, streamside buffers to control nitrate concentrations.     

Where to take a study break on the college campus: An attention restoration theory perspective

College students spend much of their time on campus engaged in activities that require sustained directed attention, which may lead to attention fatigue. They would benefit from campus settings that provide effective restoration breaks and allow them to return to their work cognitively refreshed. Studies have found direct exposure to nature, viewing nature through windows, and viewing images of nature are restorative. In the present study, college students, instructed to imagine themselves cognitively fatigued, rated the perceived restorativeness of indoor campus settings that varied by view of nature: some had no views of nature, some had window views of nature with built structures present, and some had views of simulated nature depicted as large nature murals. Students rated settings with views of dramatic nature murals, especially those with water, more restorative than settings with window views of real, but mundane nature with built structures present. Students rated settings that lacked views of real or simulated nature least restorative. The findings suggest that large nature murals in indoor settings used for study breaks may provide attentionally fatigued students with opportunities for restoration when views of nature are unavailable or limited in restorative potential.     

Don’t Fight the Site: Three Geomorphic Considerations in Catchment-Scale River Rehabilitation Planning

Three geomorphic considerations that underpin the design and implementation of realistic and strategic river conservation and rehabilitation programs that work with the nature are outlined. First, the importance of appreciating the inherent diversity of river forms and processes is discussed. Second, river dynamics are appraised, framing the contemporary behavioral regime of a reach in relation to system evolution to explain changes to river character and behavior over time. Third, the trajectory of a reach is framed in relation to downstream patterns of river types, analyzing landscape connectivity at the catchment scale to interpret geomorphic river recovery potential. The application of these principles is demonstrated using extensive catchment-scale analyses of geomorphic river responses to human disturbance in the Bega and Upper Hunter catchments in southeastern Australia. Differing implications for reach- and catchment-scale rehabilitation planning prompt the imperative that management practices work with nature rather than strive to ‘fight the site.’     

Limestone Dissolution in Flue Gas Scrubbing: Effect of Sulfite

Batch limestone dissolution experiments were carried out in a pH stat apparatus at 55°C with CO2 sparging and dissolved sulfite. Particle size distribution, utilization, sulfite in solution, limestone type, and the approach to calcite equilibrium were all found to contribute to the limestone reactivity. In the absence of sulfite, limestone dissolution was controlled solely by mass transfer. For a given stone under mass transfer control, film thickness was found to be independent of pH. The dissolution rate in the presence of sulfite was controlled by a combined surface kinetics/mass transfer regime. SEM micrographs supported this conclusion. A surface rate correlation was developed which accounted for observed inhibition by an inverse dependence on calcium sulfite concentration at the limestone surface. While the form of the rate expression was applicable to all stones, the surface rate constant was stone dependent. A computer code which accounted for mass transfer with surface kinetics was tested against experimental observations of four limestone types. Changes in pH and the concentrations of calcium, carbonate, sulfite, sulfate, and adipic acid were accurately modeled.     

Froude scaling limitations in modeling of turbidity currents

The scaling problem associated with the modeling of turbidity currents has been recognized but is yet to be explored systematically. This paper presents an analysis of the dimensionless governing equations of turbidity currents to investigate the scale effect. Three types of flow conditions are considered: (i) conservative density current; (ii) purely depositional turbidity current; and (iii) mixed erosional/depositional turbidity current. Two controlling dimensionless numbers, the Froude number and the Reynolds number, appear in the non-dimensional governing equations. When densimetric Froude similarity is satisfied, the analysis shows that the results would be scale-invariant for conservative density current under the rough turbulent condition. In the case of purely depositional flows, truly scale-invariant results cannot be obtained, as the Reynolds-mediated scale effects appear in the bottom boundary conditions of the flow velocity and sediment fall velocity. However, the scale effect would be relatively modest. The Reynolds effect becomes more significant for erosional or mixed erosional/depositional turbidity currents as Reynolds-mediated scale effects also appear in the sediment entrainment relation. Numerical simulations have been conducted at three different scales by considering densimetric Froude scaling alone as well as combined densimetric Froude and Reynolds similarity. Simulation results confirm that although the scaling of densimetric Froude number alone can produce scale-invariable results for conservative density currents, variations occur in the case of turbidity currents. The results become scale invariant when densimetric Froude and Reynolds similarities are satisfied simultaneously.     

Analytical Solutions to the Linearized Boussinesq Equation for Assessing the Effects of Recharge on Aquifer Discharge1

Boggs, Kevin G., Robert W. Van Kirk, Gary S. Johnson, Jerry P. Fairley, and P. Steve Porter, 2010. Analytical Solutions to the Linearized Boussinesq Equation for Assessing the Effects of Recharge on Aquifer Discharge. Journal of the American Water Resources Association (JAWRA) 46(6):1116–1132. DOI: 10.1111/j.1752-1688.2010.00479.x Abstract: There is a need to develop a general understanding of how variations in aquifer recharge are reflected in discharge. Analytical solutions to the linearized Boussinesq equation governing flow in an unconfined aquifer provide a unified mathematical framework to quantify relationships among lag time, attenuation and distance between aquifer recharge and discharge and the effect of an up-gradient no-flow boundary. We applied this framework to three types of recharge: (1) instantaneous, (2) periodic, and (3) constant rate for a finite duration. When the temporal scale of recharge exceeds the diffusive aquifer time scale, recharge will be reflected in discharge quickly and with little attenuation. When aquifer time scale is large, most recharge events are shorter in scale than that of the aquifer, resulting in large attenuation. Attenuation is more sensitive to boundary effects than lag time, and boundary effects increase as recharge time scale increases. Boundary effects can often be ignored when the recharge source is farther than 1/3 of the domain length away from the no-flow boundary. We illustrate analytical results with application to the economically critical Eastern Snake River Plain Aquifer in Idaho. In this aquifer, detectable annual and decadal cycles in discharge can result from recharge no farther than 20 and 60 km away from the discharge point, respectively. The effects of more distant, long-term recharge can be detected only after a time lag of several decades.     

Hazardous Waste Minimization: Part IV Waste Reduction in the Metal Finishing Industry

The metal finishing industry uses over 40 production processes to produce a wide range of metal products. Waste streams generated include wastewater, waste oils, spent solvents, and spent process solutions. Currently a wide variety of techniques which minimize waste are available. Cost-effective methods to reduce electroplating wastewater contamination include water conservation and drag-out reduction, recovery and management. Ways to cost-effectively reduce the generation of spent metal-working fluids include establishing a fluid management program and installing a fluid recovery system. However, before any techniques are selected, a waste reduction survey should first be conducted.     

The effects of appraisal instrument,feedback and goal-setting on worker satisfaction and commitment

Twenty managers and 125 subordinates participated in a field experiment performed in the Israel Airport Authority. The managers received intensive training in giving performance feedback and setting specific goals when conducting appraisals of their subordinates. Following training, the managers were assigned randomly to one of four conditions: feedback and goals using BOS-based appraisal; feedback using BOS-based appraisal with no goals; feedback and goals using GRS-based appraisal; feedback alone using GRS-based appraisal. Work satisfaction and organizational commitment were measured before and after the performance appraisals were conducted. A two-way analysis of variance followed by univariate analyses by means of a studentized range test revealed that (1) the use of BOS-based appraisal increased work satisfaction significantly more than the use of GRS-based appraisal, (2) feedback followed by goal-setting resulted in significantly higher work satisfaction and organizational commitment than feedback alone, regardless of the appraisal scale that was used, and (3) the combination of BOS-based appraisal, feedback and goal-setting led to significantly higher work satisfaction than was the case in the other experimental conditions.