Measuring marginal willingness to pay using conjoint analysis and developing benefit transfer functions in various Asian cities

We need a consistent methodology to measure the co-benefits of climate change mitigation across Asian countries. This study chose a strategy of modifying the Japan-specific life-cycle impact assessment method based on endpoint modeling (LIME) for wider application across countries. LIME has two dimensions. First, it is an environmental science that links the cause-and-effect chain. Second, it is an environmental valuation that weighs four endpoint damages in monetary terms through a conjoint analysis that is derived from an Internet-based questionnaire survey. This article describes the modification of the methodology for application of the conjoint analysis to weigh environmental impacts. We approached the investigation as follows. First, we conducted Internet surveys to measure marginal willingness-to-pay (MWTP). We used a sample of 112 respondents in their 20 s to 40 s, divided equally between men and women, in 11 cities across China, India, and Southeast Asia. The results obtained showed clear statistical significance and were comparable across the cities. Second, we attempted to develop functions (called benefit transfer functions) to simplify the measured MWTP in order to apply it across different Asian countries. The functions were derived through a stepwise meta-analytic method, a type of multiple regression analysis whose independent variable was MWTP and dependent variables were attributes of both respondents and surveyed cities. The functions showed that coal consumption and percentage of nature reserve were dependent variables. Then, the MWTPs estimated from the functions were compared with the measured MWTP for transfer error, which is calculated by the absolute value of the difference between the estimated value and the measured value divided by the latter. The transfer error was below 50% in about 90% of the 44 results (a combination of four endpoints and 11 cities), implying that the developed functions were statistically significant.     

Biological removal of selenate in saline wastewater by activated sludge under alternating anoxic/oxic conditions

Removal of selenate in saline wastewater by activated sludge was examined. Sequencing batch reactor was operated under alternating anoxic/oxic conditions. Above 97% removal of soluble selenium (Se) was achieved continuously. Major Se removal mechanism varied depending on the length of aeration period. Various Se-reducing bacteria likely contributed to coordinately to Se removal. Selenium (Se)-containing industrial wastewater is often coupled with notable salinity. However, limited studies have examined biological treatment of Se-containing wastewater under high salinity conditions. In this study, a sequencing batch reactor (SBR) inoculated with activated sludge was applied to treat selenate in synthetic saline wastewater (3% w/v NaCl) supplemented with lactate as the carbon source. Start-up of the SBR was performed with addition of 1–5 mM of selenate under oxygen-limiting conditions, which succeeded in removing more than 99% of the soluble Se. Then, the treatment of 1 mM Se with cycle duration of 3 days was carried out under alternating anoxic/oxic conditions by adding aeration period after oxygen-limiting period. Although the SBR maintained soluble Se removal of above 97%, considerable amount of solid Se remained in the effluent as suspended solids and total Se removal fluctuated between about 40 and 80%. Surprisingly, the mass balance calculation found a considerable decrease of Se accumulated in the SBR when the aeration period was prolonged to 7 h, indicating very efficient Se biovolatilization. Furthermore, microbial community analysis suggested that various Se-reducing bacteria coordinately contributed to the removal of Se in the SBR and main contributors varied depending on the operational conditions. This study will offer implications for practical biological treatment of selenium in saline wastewater.     

Workers select mates for queens: a possible mechanism of gene flow restriction between supercolonies of the invasive Argentine ant

Some invasive ants form large networks of mutually non-aggressive nests, i.e., supercolonies. The Argentine ant Linepithema humile forms much larger supercolonies in introduced ranges than in its native range. In both cases, it has been shown that little gene flow occurs between supercolonies of this species, though the mechanism of gene flow restriction is unknown. In this species, queens do not undertake nuptial flight, and males have to travel to foreign nests and cope with workers before gaining access to alien queens. In this study, we hypothesized that male Argentine ants receive interference from workers of alien supercolonies. To test this hypothesis, we conducted behavioral and chemical experiments using ants from two supercolonies in Japan. Workers attacked males from alien supercolonies but not those from their own supercolonies. The level of aggression against alien males was similar to that against alien workers. The frequency of severe aggression against alien males increased as the number of recipient workers increased. Cuticular hydrocarbon profiles, which serve as cues for nestmate recognition, of workers and males from the same supercolony were very similar. Workers are likely to distinguish alien males from males of their own supercolony using the profiles. It is predicted that males are subject to considerable aggression from workers when they intrude into the nests of alien supercolonies. This may be a mechanism underlying the restricted gene flow between supercolonies of Argentine ants. The Argentine ant may possess a distinctive reproductive system, where workers participate in selecting mates for their queens. We argue that the aggression of workers against alien males is a novel form of reproductive interference.     

Performance tests of newly developed adsorption/plasma combined system for decomposition of volatile organic compounds under continuous flow condition

The adsorption/plasma decomposition with the combination of adsorption honeycomb-sheets and a plasma element is a new technology for small-sized apparatuses to decompose volatile organic compounds (VOCs) at concentrations lower than about 100 ppm. The feasibility of the prototype adsorption/plasma decomposition apparatus was evaluated with the simulated exhausts containing one VOC component and with real exhausts from a painting booth and an adhesion factory. The apparatus decomposed VOCs e ectively at the painting booth exhaust but not always satisfactorily at the adhesion factory exhaust. The performance test results with real exhausts were discussed with respect to the concentration and discharge pattern of the exhausts and the basic properties of the system such as cooperation of adsorption and plasma reaction and the concentration dependence of the performance.     

Japanese Papilio butterflies puddle using Na+ detected by contact chemosensilla in the proboscis

Many butterflies acquire nutrients from non-nectar sources such as puddles. To better understand how male Papilio butterflies identify suitable sites for puddling, we used behavioral and electrophysiological methods to examine the responses of Japanese Papilio butterflies to Na⁺, K⁺, Ca²⁺, and Mg²⁺. Based on behavioral analyses, these butterflies preferred a 10-mM Na⁺ solution to K⁺, Ca²⁺, and Mg²⁺ solutions of the same concentration and among a tested range of 1?mM to 1?M NaCl. We also measured the ion concentrations of solutions sampled from puddling sites in the field. Na⁺ concentrations of the samples were up to 6?mM, slightly lower than that preferred by butterflies in the behavioral experiments. Butterflies that sipped the 10?mM Na⁺ solution from the experimental trays did not continue to puddle on the ground. Additionally, butterflies puddled at sites where the concentrations of K⁺, Ca²⁺, and/or Mg²⁺ were higher than that of Na⁺. This suggests that K⁺, Ca²⁺, and Mg²⁺ do not interfere with the detection of Na⁺ by the Papilio butterfly. Using an electrophysiological method, tip recordings, receptor neurons in contact chemosensilla inside the proboscis evoked regularly firing impulses to 1, 10, and 100?mM NaCl solutions but not to CaCl₂ or MgCl₂. The dose?Cresponse patterns to the NaCl solutions were different among the neurons, which were classified into three types. These results showed that Japanese Papilio butterflies puddle using Na⁺ detected by the contact chemosensilla in the proboscis, which measure its concentration.     

Sorption kinetics of atrazine and diuron in soils from southern Brazil

Sorption kinetics of atrazine and diuron was evaluated in soil samples from a typical landscape in Paraná. Samples were collected (0-20 cm) in a no-tillage area from Mamborê, PR, which has been cultivated under a crop rotation for the last six years. Six sampling points of the slope were selected to represent a wide range of soil chemical and physical properties found in this area. Radiolabeled tracers (14C-atrazine and 14C-diuron) were used and the radioactivity was detected by liquid scintillation counting (LSC). Sorption was accomplished for increasing equilibration periods (0.5, 1.5, 3, 6, 12, 24, and 48 h). Kinetics data fitted adequately well to Elovich equation, providing evidences that soil reaction occurs in two distinct stages: a fast, initial one followed by a slower one. During the fast phase, 34-42 and 71-79% of total atrazine and diuron applied were sorbed to soil samples. No important differences were found among combinations of soil and herbicide sorption during the slow phase. The unrealistic conditions under batch experiments should be overestimating sorption in the fast phase and underestimating diffusion in the slow phase. Sorption of both herbicides was positively correlated to organic carbon and clay contents of soils, but atrazine was much less sorbed than diuron, showing its higher potential to contaminate groundwater, specially in sandy, low organic carbon soils.     

Chlordane compounds residues in Weddell seals (Leptonychotesweddelli) from the Antarctic

Weddell seal samples taken from the Antarctic have been found to be contaminated with chlordane compounds. ΣChlordane ($\text{cis}\text{-chlordane}\text{+}\text{cis}\text{-nonachlor}\text{+}\text{trans}\text{-nonachlor}\text{+}\text{oxychlordane}$) was present in blubber of seals at the range of 12 - 62 ng/g fresh weight. The order of chlordane compound concentrations was $\text{trans}\text{-nonachlor}\text{>}\text{oxychlordane}\text{>}\text{cis}\text{-nonachlor}\text{>}\text{cis}\text{-chlordane}$. Relative aboundance of $\text{cis}$-chlordane in Σchlordane is higher than that in humans. A probable explanation for their occurrence in the Antarctic is an airborne transport.     

Global pollution monitoring of butyltin compounds using skipjack tuna as a bioindicator

Butyltin compounds (BTs) including mono- (MBT), di- (DBT), tri-butyltin (TBT) and total tin (sigmaSn), were determined in the liver of skipjack tuna (Katsuwonus pelamis) collected from Asian offshore waters (off-Japan, the Japan Sea, off-Taiwan, the East China Sea, the South China Sea, off-Philippines, off-Indonesia, the Bay of Bengal), off-Seychelles, off-Brazil and open seas (the North Pacific). BTs were detected in all the skipjack tuna collected, suggesting widespread contamination of BTs even in offshore waters and open seas on a global scale. Considering specific accumulation, Sex-, body length- differences and migration of skipjack tuna did not seem to affect BT concentrations, indicating rapid reflection of the pollution levels in seawater where and when they were collected. Skipjack tuna is a suitable bioindicator for monitoring the global distribution of BTs in offshore waters and open seas. High concentrations of BTs were observed in skipjack tuna from offshore waters around Japan, a highly developed and industrialized region (up to 400 ng/g wet weight). Moreover skipjack tuna collected from offshore waters around Asian developing countries also revealed the levels comparable to those in Japan (up to 270 ng/g wet weight) which may be due to the recent improvement in economic status in Asian developing countries. High percentages (almost 90%) of BTs in total tin (sigmaSn: sum of inorganic tin+organic tin) were found in the liver of skipjack tuna from offshore waters around Asian developing countries. This finding suggests that the anthropogenic BTs represent the major source of Sn accumulation in skipjack tuna from these regions.     

Studies on transitory laxative effects of sorbitol and maltitol: II: Differences in laxative effects among various foods containing the sweetening agents

We studied the laxative effect of sweetening agents, hydrogenated glucose syrup (HGS) containing 88–92% maltitol, and sorbitol contained in various foods. The subjects were 89 volunteers (64 males and 25 females). Foods used in the study were tablets, bevarages, chewing gum, jelly, adzuki-bean jelly, chocolate and candies which contained one of the two sweetening agents.The doses of the sweetening agents were 0.4 g/kg for sweets in tablet form and 20 g for the other foods. Approximately 10% of the subjects exhibited diarrhea after taking tablets as a control; approximately 20% did so after taking HGS except for adzuki-bean jelly; and approximately 30% did so after taking sorbitol. There was no significant difference between HGS and the control substance. The incidence of diarrhea tended to be higher with the two sweetening agents only when contained in adzuki-bean jelly. The length of time between the ingestion of test substances and the first onset of diarrheal stool varied widely from less than one hour to 23 hours among individuals. However, adzuki-bean jelly diarrhea was induced within 5 hours in all subjects. Soft stool accounted for 60 – 90% of the macroscopic findings of diarrheal stool. Chief complaints of abdominal symptoms were gurgling, flatus and lower abdominal pain.     

The influence of lower extremity postures on kinematics and injuries of cyclists in vehicle side collisions

Objective: A cyclist assumes various cyclic postures of the lower extremities while pushing the pedals in a rotary motion while pedaling. In order to protect cyclists in collisions, it is necessary to understand what influence these postures have on the global kinematics and injuries of the cyclist.

Method: Finite element (FE) analyses using models of a cyclist, bicycle, and car were conducted. In the simulations, the Total Human Model of Safety (THUMS) occupant model was employed as a cyclist, and the simulation was set up such that the cyclist was hit from its side by a car. Three representative postures of the lower extremities of the cyclist were examined, and the kinematics and injury risk of the cyclist were compared to those obtained by a pedestrian FE model. The risk of a lower extremity injury was assessed based on the knee shear displacement and the tibia bending moment.

Results: When the knee position of the cyclist was higher than the hood leading edge, the hood leading edge contacted the leg of the cyclist, and the pelvis slid over the hood top and the wrap-around distance (WAD) of the cyclist's head was large. The knee was shear loaded by the hood leading edge, and the anterior cruciate ligament (ACL) ruptured. The tibia bending moment was less than the injury threshold. When the cyclist's knee position was lower than the hood leading edge, the hood leading edge contacted the thigh of the cyclist, and the cyclist rotated with the femur as the pivot point about the hood leading edge. In this case, the head impact location of the cyclist against the car was comparable to that of the pedestrian collision. The knee shear displacement and the tibia bending moment were less than the injury thresholds.

Conclusion: The knee height of the cyclist relative to the hood leading edge affected the global kinematics and the head impact location against the car. The loading mode of the lower extremities was also dependent on the initial positions of the lower extremities relative to the car structures. In the foot up and front posture, the knee was loaded in a lateral shear direction by the hood leading edge and as a result the ACL ruptured. The bicycle frame and the struck-side lower extremity interacted and could influence the loadings on lower extremities.