天然浑浊水中共存无机阳离子的电动化学特征

引入流动电流这一重要电动化学参量，研究了在天然浑浊水中ＳＣ的基本模式，撮了ＳＣ与水中悬浮胶体颗凿表面电荷量及无机阳离子之间的理论关系，探讨了离子的浓度，性质，存在环境等对体系电动特性的影响，并对水中常见８种阳离子共存条件下的电动化学特性进行了实验分析，从而建立了无机阳离子对胶体的聚沉能力与电动响应特性之间的实际联系。     

离子色谱法测定饮用水和面包中的溴酸根

选用ＡＳ９－ＨＣ高容量阴离子交换色谱柱,不需处理除去干扰离子,可直接进样。测定了两种水样,其中一种检出溴酸根,方法检出根０．００５ｍｇ．１＾－１水样加标回收率９１．３－９３．４％。采用全新的自动化样品处理技术－加速溶剂萃取萃取面包中的溴酸根。经ＡＳ９－ＳＣ阴离子交换色谱柱分离,选择最佳淋洗条件。电导检测,方法检 ０．０７ｍｇ．１＾－１,对十二种市售包进行测定,均未检出溴酸根,样品加标回收率７９．９     

三唑酮在油菜-土壤生态系统中的降解与建模

为评价三唑酮可湿性粉剂在土壤-油菜生态系统中使用后的残留行为和环境安全性,进行了2 a大田试验,并比较了指数模型、GM(1,1)灰色模型、阻滞动力学模型对三唑酮降解规律的描述。结果表明:3种模型的拟合结果均达到统计学意义上显著相关;对三唑酮在土壤和油菜中降解行为模拟结果最好的分别为GM(1,1)模型和阻滞动力学模型;三唑酮在土壤中2 a的半衰期分别为3.48和4.38 d,油菜植株中分别为1.98和3.78 d,其降解受温度影响较大。     

Phytoplankton photosynthetic adaptation to high frequency light fluctuations simulating those induced by sea surface waves

In order to test the ability of phytoplankton to adapt to the high frequency light fluctuations induced by sea surface waves, the green alga Dunaliella tertiolecta was grown under both steady and fluctuating (0.1, 1.0 and 10 Hz) illuminations. The latter conditions reproduced those fluctuations experienced by phytoplankton in the upper photic layer. For each culture, photosynthesis versus irradiance were measured under four incubation frequencies (steady, 0.1, 1.0 and 10 Hz fluctuating illuminations). Results indicated that growth rates were similar for algae grown under steady light and 10 Hz fluctuating light (0.26–0.33 d^–1). Cells grown at 0.1 and 1.0 Hz showed lower growth rates (0.17–0.26 d^–1). Chlorophyll a and b were significantly higher under 0.1 and 10 Hz frequencies than under steady illumination; at 1.0 Hz, there were no significant differences with steady light. No changes in carotenoids were evidenced at any frequency tested. Photosynthetic measurements showed that algae grown under steady illumination had higher photosynthetic efficiency and capacity when incubated under steady and 0.1 Hz fluctuating light. Photosynthetic characteristics of algae grown under 0.1 Hz illumination did not show any clear responses to fluctuating light. Algae grown under 1.0 or 10 Hz had higher photosynthetic efficiency and capacity than those grown under steady illumination, when incubated under 1.0 and 10 Hz light. This suggests that microalgae grown under high frequency illumination (1.0 and 10 Hz) can adapt their photosynthetic characteristics to the rapidly fluctuating light regime experienced during growth, and that algae grown under steady conditions respond better to steady or slowly fluctuating (0.1 Hz) light. Such an adaptation provides a means of probing the photosynthetic responses of phytoplankton to vertical mixing.Contribution to the program of GIROQ (Groupe interuniversitaire de recherches océanographiques du Québec)     

海洋酸化与重金属、有机污染物和人工纳米颗粒的联合毒性效应研究进展

由于大量人类活动的影响,大气CO_2浓度持续增加,其中约1/3被海洋吸收,导致表层海水pH值降低和碳酸盐平衡体系波动,即"海洋酸化"现象。污染物的海洋环境效应一直是全球环境科学领域研究的热点。在实际环境中,海洋酸化往往与污染物共同存在并作用于海洋生态系统,且海洋酸化极有可能改变污染物的海洋环境行为从而影响其毒性效应。但现有研究大多针对海洋酸化或者污染物单独作用下的毒性效应展开,对海洋酸化与污染物的联合毒性效应的研究不足、亟待加强。为此,综述了近年来海洋酸化与典型污染物(重金属、有机污染物)及新型污染物(人工纳米颗粒)的相关文献,重点阐述了海洋酸化对污染物环境行为的影响和海洋酸化与污染物对海洋生物的联合毒性效应,指出当前的研究不足,并对未来的研究方向进行了展望。     

炉渣用于深层过滤的试验研究

将炉渣用作深层过滤的床层过滤,在油田水处理中具有良好的应用前景。通过对炉渣滤料的物性测定,对流体力学性能、过滤性能及反洗性能的研究,获得了有关炉渣滤料的粒径分布、床层孔隙率、密度、吸水率等物性参数,以及清洁滤料床层阻力与速度的关系曲线和流化曲线,过滤条件下床层阻力随时间的变化关系和悬浮物脱除率随时间的变化曲线,炉渣床层的反洗曲线。结果表明：炉渣表面粗糙,有棱角,吸附表面积大,孔隙率大,过滤效果好;炉渣滤料密度小,反洗效果较好,反洗用水量只是过滤水量的５％左右;同时,炉渣作为滤料用于深层过滤,不仅来源广泛,而且属废物利用。     

臭氧氧化降解苊的中间产物分析

苊属于EPA优先污染物名单上的物质,其在染料、化工等行业有着广泛的应用.它具有水溶性低、易蓄积、难生物降解的特点.臭氧氧化法可以对其有效的降解,但是过量的臭氧也难以实现对苊的矿化,在苊浓度下降的同时将生成中间产物.中间产物包括多种含一个苯环的酯和直链的酸、醇、酯等.     

城市生活垃圾渗透系数测试研究

采用常水头测渗实验，对不同压实密度和水力梯度下的新鲜垃圾与陈垃圾的渗透系数进行测试，根据达西定律求得渗透系数值。由于垃圾的不均匀性、小颗粒的运动和大孔隙沟道流的形成和改变，实验初始阶段渗透系数值先增大至峰值，然后缓慢降低直至趋于稳定。实验稳定后，新鲜垃圾压实密度为0．75—0．95t／m^3时，渗透系数值约为1．26E-03～1．43E-03cm／s。陈垃圾在压实密度分别为1．2和1．4t／m^3时，渗透系数为8．29E-04和1．35E-04cm／s。     

Optimum conditions for Al13 polymer formation in PACl preparation by electrolysis process

This paper introduces a new and effective method for preparation of PACl-electrolysis process. A series of PACl with high content of Al13 polymer was successfully prepared by electrolysis process. The amount of Al13 polymer formed in electrolysis process was found to be highly influenced by current density (di), the distance between the electrodes, electrolysis time and the stirring rate of the electrolyte. For the AlT (total aluminum concentration) of 2.0 M PACl obtained by electrolysis process, the optimal di and distance between the electrodes were 1.1 Adm(-2) and 10 mm respectively. The optimum circulating rate was 5.5 l h(-1). Because of the inhomogeneous pH between the surface of cathode and the bulk solution, the electrolysis process has the advantage to form more Al(OH)4- as precursor of Al13 polymer. At the optimum condition, Al13 polymer accounted for above 70% of AlT (PACl of AlT=2.0 M and B=2.0), which was much higher than that of PACl prepared by other method.     

Removal of alachlor from water by catalyzed ozonation in the presence of Fe2+, Mn2+, and humic substances

The effects of Fe(II), Mn(III) and humic substances on the catalyzed ozonation of alachlor, an endocrine disruptor were investigated. Results revealed that small amounts of Fe(II), Mn(II), and humic substances could enhance the ozonation of alachlor, but larger amounts of them would retard the oxidation. These results were successfully identified by an electron paramagnetic resonance (EPR) spectroscopy spin-trapping method that could quantify hydroxyl radicals. The production of hydroxyl radicals was obviously increased with the increasing of Fe(II) concentration, which contributed to enhance ozonation at low concentrations. But the excess Fe(II) consumed some of the radicals when it was added at a higher concentration (1.5 mg/L). However, no obvious radicals were observed when a different amount of Mn(II) was used, and the catalytic ozonation of alachlor by Mn(II) mainly followed the mechanism of "active sites created on the surface of MnO2." The radical pathway was followed when alachlor was ozonated with different concentrations of humic substances because of its radical initiating, promoting, and inhibiting effects.