An innovative sustainability assessment for urban wastewater infrastructure and its application in Chengdu, China

Sustainability assessments are an increasingly common tool for measuring progress towards sustainable development. Despite their popularity, sustainability assessments and the indicators that compose them are said to have had little impact on the policy arena. In this paper we discuss four attributes that we contend will improve the use of sustainability assessments to guide decision making: non-compartmentalization, site specificity, built-in guidance for target setting, and ability to measure active sustainability. We present a novel assessment tool for wastewater treatment infrastructure that illustrates these attributes. The assessment is composed of two-dimensional indicators we call “burden to capacity” ratios, that reveal and quantify the local value of resources embodied in wastewater and treatment byproducts, and the tradeoffs between designing systems for disposal versus reuse. We apply the sustainability assessment framework to an existing treatment plant in Chengdu, China and discuss the results.     

Mobility of dimethoate residues from spring broccoli field

Dimethoate [O, O-dimethyl-S-(N-methylcarbamoyl-methyl) phosphorodithioate] is a broad-spectrum systemic insecticide currently used worldwide and on many vegetables in Kentucky. Dimethoate is a hydrophilic compound (log K_OW = 0.7) and has the potential of offsite movement from the application site into runoff and infiltration water. The dissipation patterns of dimethoate residues were studied on spring broccoli leaves and heads under field conditions. Following foliar application of Dimethoate 4E on broccoli foliage at the rate of 0.47 L acre^?1, dimethoate residues were monitored in soil, runoff water collected down the land slope, and in infiltration water collected from the vadose zone. The study was conducted on a Lowell silty loam soil (pH 6.9) planted with broccoli under three soil management practices: (i) soil mixed with municipal sewage sludge, (ii) soil mixed with yard waste compost, and (iii) no-mulch rototilled bare soil. The main objective of this investigation was to study the effect of mixing native soil with municipal sewage sludge or yard waste compost, having considerable amounts of organic matter, on off-site movement of dimethoate residues into runoff and infiltration water following spring rainfall. The initial deposits of dimethoate were 6.2 and 21.4 μ g g^?1 on broccoli heads and leaves, respectively. These residues dissipated rapidly and fell below the maximum residue limit of 2 μ g g^?1 on the heads and leaves after 10 and 14 d, respectively, with half-lives of 5.7 d on broccoli heads and 3.9 d on the leaves. Dimethoate residues detected in top 15 cm of soil (due to droplet drift and wash off residues from broccoli foliage) one day (d) following spraying, were 30.5 ng g^?1 dry soil in the sewage sludge treatment, and 46.1 and 134.5 ng g^?1 dry soil in the yard waste and no mulch treatments, respectively. Water infiltration was greater from yard waste compost treatment than from no mulch treatment, however concentrations of dimethoate in the vadose zone of the three soil treatments did not differ.     

Effects of roof and rainwater characteristics on copper concentrations in roof runoff

Copper sheeting is a common roofing material used in many parts of the world. However, copper dissolved from roof sheeting represents a source of copper ions to watersheds. Researchers have studied and recently developed a simple and efficient model to predict copper runoff rates. Important input parameters include precipitation amount, rain pH, and roof angle. We hypothesized that the length of a roof also positively correlates with copper concentration (thus, runoff rates) on the basis that runoff concentrations should positively correlate with contact time between acidic rain and the copper sheet. In this study, a novel system was designed to test and model the effects of roof length (length of roof from crown to the drip edge) on runoff copper concentrations relative to rain pH and roof angle. The system consisted of a flat-bottom copper trough mounted on an apparatus that allowed run length and slope to be varied. Water of known chemistry was trickled down the trough at a constant rate and sampled at the bottom. Consistent with other studies, as pH of the synthetic rainwater decreased, runoff copper concentrations increased. At all pH values tested, these results indicated that run length was more important in explaining variability in copper concentrations than was the roof slope. The regression equation with log-transformed data (R ² = 0.873) accounted for slightly more variability than the equation with untransformed data (R ² = 0.834). In log-transformed data, roof angle was not significant in predicting copper concentrations.     

Prenatal exclusion of duchenne muscular dystrophy by fetal muscle biopsy

A fetal thigh muscle biopsy was performed at 18 weeks and 6 days' gestation using an automatic 18-gauge biopsy needle. A positive immunoreaction with antisera to the amino- and carboxy-terminals of dystrophin excluded Duchenne muscular dystrophy from this at-risk male.     

Nitrate pollution of wells: pollution prevention policy options

Irrigated agriculture is a major sector of agricultural economy where high value crops are grown with substantial input of fertilizers and pesticides. High concentrations of nitrate and pesticides have been observed in ground water beneath irrigated areas in humid regions, where irrigation is practiced on sandy soils that have low water-holding capacity. Data from these areas indicate that irrigation wells are typically screened in the bottom part of the aquifer (which contain coarser deposits) whereas the domestic wells are screened just below the water table. Monitoring results from several irrigated areas have shown the stratification of dissolved inorganic and organic chemicals in the aquifer. Nitrate in such systems is typically highest near the surface. This has serious health implications for the rural population that relies upon shallow ground water for drinking. Current environmental policy towards pollution reduction focuses on improved management practices to reduce the loading of the chemicals to ground water. However, an engineering issue, dealing with the design of the irrigation and domestic wells has not been addressed. A design modification for the irrigation and domestic wells can reduce the risk of high nitrate ground water being pumped by domestic wells. A proposal to convert a deep vertical irrigation well to a series of small-capacity shallow vertical wells or a large-capacity horizontal well and slight deepening of the domestic wells was examined through simulations. This can reduce the nitrate concentration of ground water in domestic wells dramatically and use the high nitrate water for crop irrigation.     

Nitrate pollution of wells: pollution prevention policy options

Irrigated agriculture is a major sector of agricultural economy where high value crops are grown with substantial input of fertilizers and pesticides. High concentrations of nitrate and pesticides have been observed in ground water beneath irrigated areas in humid regions, where irrigation is practiced on sandy soils that have low water-holding capacity. Data from these areas indicate that irrigation wells are typically screened in the bottom part of the aquifer (which contain coarser deposits) whereas the domestic wells are screened just below the water table. Monitoring results from several irrigated areas have shown the stratification of dissolved inorganic and organic chemicals in the aquifer. Nitrate in such systems is typically highest near the surface. This has serious health implications for the rural population that relies upon shallow ground water for drinking. Current environmental policy towards pollution reduction focuses on improved management practices to reduce the loading of the chemicals to ground water. However, an engineering issue, dealing with the design of the irrigation and domestic wells has not been addressed. A design modification for the irrigation and domestic wells can reduce the risk of high nitrate ground water being pumped by domestic wells. A proposal to convert a deep vertical irrigation well to a series of small-capacity shallow vertical wells or a large-capacity horizontal well and slight deepening of the domestic wells was examined through simulations. This can reduce the nitrate concentration of ground water in domestic wells dramatically and use the high nitrate water for crop irrigation.     

Prenatal diagnosis of autosomal dominant microcephaly and postnatal evaluation with magnetic resonance imaging

A case of fetal autosomal dominant microcephaly was prenatally diagnosed with ultrasonography in a woman with previously undiagnosed microcephaly. At the time of initial ultrasonographic assessment, the mother was identified to have a markedly small cranium, consistent with maternal microcephaly. The ultrasonographic examination showed the fetal head size to be four standard deviations below the mean for gestational age. Gesta-tional dating from the other biometric parameters and from the last menstrual period was consistent with 31 weeks' gestation. Neurosonographic evaluation of the fetus revealed no obvious structural abnormalities. Serial ultrasonographic examinations at 35 and 38 weeks' gestation showed no changes in the fetal head size. A 2·64 kg male fetus was delivered at term. Neonatal assessment showed the fetal head circumference to be less than the second percentile for gestational age. Neurologic assessment of the neonate with magnetic resonance imaging showed abnormal development of the brain, with small cerebellar and cerebral hemispheres, and pachygyria. These images are compared with the magnetic resonance images of the mother. Our findings of maternal and fetal microcephaly are consistent with autosomal dominant microcephaly. To our knowledge, this is the first report of the prenatal diagnosis of autosomal dominant microcephaly.     

Metallothione in-like protein in lobsters ( )

A metallothionein-like protein (MLP) was isolated from naturally cadmium-contaminated lobster hepatopancreas, gills, and green glands. Between 76–99% of the total cadmium was associated with this protein (molecular weight 9,500 daltons) while the remainder was associated with both high (68,000 daltons) and low (<6,000 daltons) molecular weight proteins. MLP was not present in uncontaminated lobster hepatopancreas and only 1% of the total cadmium was associated with the gel filtration fraction corresponding to the protein.