Triterpenoid and caffeic acid derivatives in the leaves of ragweed, <Emphasis Type="Italic">Ambrosia artemisiifolia</Emphasis> L. (Asterales: Asteraceae), as feeding stimulants of <Emphasis Type="Italic">Ophraella communa</Emphasis> LeSage (Coleoptera: Chrysomelidae)

Summary. The leaf beetle Ophraella communa infests almost exclusively Ambrosia artemisiifolia in the fields of Japan, even though it normally feeds on several Asteraceous plants. A filter paper bioassay showed that the feeding of O. communa is strongly stimulated by methanolic extracts of A. artemisiifolia. The feeding stimulants for O. communa have been isolated from methanolic extracts of A. artemisiifolia. -Amyrin acetate, -amyrin acetate, 5-caffeoylquinic acid (chlorogenic acid) and 3,5-dicaffeoylquinic acid from A. artemisiifolia have been identified as feeding stimulants for O. communa. Triterpenoid derivatives (-amyrin acetate or -amyrin acetate) and caffeic acid derivatives (3, 5-dicaffoylquinic acid or 5-caffeoylquinic acid) showed feeding stimulant activity when mixed together.     

Systematic biases in measured PM10 values with U.S. Environmental Protection Agency-approved samplers at Owens Lake, California

From 1993 through 1998, Wedding or Graseby high-volume PM10 samplers were collocated with tapered element oscillating microbalance (TEOM) samplers at three sites at Owens Lake, CA. The study area is heavily impacted by windblown dust from the dry Owens Lake bed, which was exposed as a result of water diversions to the city of Los Angeles. A dichotomous (dichot) sampler and three collocated Partisol samplers were added in 1995 and 1999, respectively. U.S. Environmental Protection Agency (EPA) operating procedures were followed for all samplers, except for a Wedding sampler that was not cleaned for the purpose of this study. On average, the TEOM and Partisol samplers agreed to within 6%, and the dichot, Graseby, and Wedding samplers measured lower PM10 concentrations by about 10, 25, and 35%, respectively. Surprisingly, the "clean" Wedding sampler consistently measured the same concentration as the "dirty" Wedding sampler through 85 runs without cleaning. The finding that the Graseby and Wedding high-volume PM10 samplers read consistently lower than the TEOM, Partisol, and dichot samplers at Owens Lake is consistent with PM10 sampler comparisons done in other fugitive dust areas, and with wind tunnel tests showing that sampler cut points can be significantly lower than 10 microns under certain conditions. However, these results are opposite of the bias found for TEOM samplers in areas that have significant amounts of volatile particles, where the TEOM reads low due to the vaporization of particles on the TEOM's heated filter. Coarse particles like fugitive dust are relatively unaffected by the filter temperature. This study shows that in the absence of volatile particles and in the presence of fugitive dust, a different systematic bias of up to 35% exists between samplers using dichot inlets and high-volume samplers, which may cause the Graseby and Wedding PM10 samplers to undermeasure PM10 by up to 35% when the PM10 is predominantly from coarse particulate sources.     

Arsenic bioaccessibility in a gold mining area: a health risk assessment for children

High concentrations of total arsenic (As) have been measured in soils of gold mining areas of Brazil. However, bioaccessibility tests have not yet been conducted on those materials, which is essential for better health risk estimates. This study aimed at?evaluating As bioaccessibility in samples from a gold mining area located in Brazil and assessing children's exposure to As-contaminated materials. Samples were collected from different materials (a control and four As-contaminated soils/sediments) found in a gold mine area located in Paracatu (MG), Brazil. Total and bioaccessible As concentrations were determined for all samples. The control soil presented the lowest As concentrations, while all other materials contained high total As concentrations (up to 2,666?mg?kg(-1)) and low bioaccessible As percentage (<4.2%), indicating a low risk from exposure of resident children next to this area. The calculated dose of exposure indicated that, except for the pond tailings, in all other areas, the exposure route considering soil ingestion contributed at most to 9.7% of the maximum As allowed ingestion per day (0.3?μg?kg(-1) BW day(-1)).     

Sesquiterpene Hydrocarbons: Kairomones with a releaser effect in the sexual communication of the white-spotted longicorn beetle, <Emphasis Type="Italic">Anoplophora malasiaca</Emphasis> (Thomson) (Coleoptera: Cerambycidae)

Summary.  We conducted a series of experiments with the white-spotted longicorn beetle Anoplophora malasiaca (Thomson), and its host plant, Citrus unshiu, to examine the origin of the sesquiterpene hydrocarbons (SHCs; including β-elemene, β-caryophyllene, α-humulene, α-farnesene, and several unidentified compounds) that are contained in the elytra of the beetles and act as an attractant. In the laboratory, mechanically wounded citrus branches, as well as those fed upon by A. malasiaca, attracted males more frequently than intact branches. Solid phase microextraction (SPME) and subsequent analyses by gas chromatography (GC) analyses detected measurable SHCs from the air around both mechanically wounded and beetle-infested branches, as well as trace amounts from intact branches. The SHCs were also detected for a certain time from beetles that had fed on the citrus branches, but the amounts decreased rapidly after they were removed from the host. This decrease generally corresponded with a reduction of attractiveness of the beetles in a behavioural assay. Isolated females acquired the SHCs after exposure to, but not upon contact with, other females that had fed on C. unshiu branches. We hypothesize that the citrus SHCs are adsorbed in, retained on, and released from the wax layer of the beetle elytra. Since these compounds are released from branches when beetles feed, they may indirectly signal the presence of beetles to others in the field. The high response rate to SHCs by males is likely representing mate searching behavior. The SHCs act as kairomones with a releaser effect in the communication system of A. malasiaca. Hiroe Yasui, Toshiharu Akino, Midori Fukaya: These authors contributed equally to this article.     

Application of a combined measurement and modeling method to quantify windblown dust emissions from the exposed playa at Mono Lake, California

Particulate matter < or =10 microm (PM10) emissions due to wind erosion can vary dramatically with changing surface conditions. Crust formation, mechanical disturbance, soil texture, moisture, and chemical content of the soil can affect the amount of dust emitted during a wind event. A refined method of quantifying windblown dust emissions was applied at Mono Lake, CA, to account for changing surface conditions. This method used a combination of real-time sand flux monitoring, ambient PM10 monitoring, and dispersion modeling to estimate dust emissions and their downwind impact. The method identified periods with high emissions and periods when the surface was stable (no sand flux), even though winds may have been high. A network of 25 Cox sand catchers (CSCs) was used to measure the mass of saltating particles to estimate sand flux rates across a 2-km2 area. Two electronic sensors (Sensits) were used to time-resolve the CSC sand mass to estimate hourly sand flux rates, and a perimeter tapered element oscillating microbalance (TEOM) monitor measured hourly PM10 concentrations. Hourly sand flux rates were related by dispersion modeling to hourly PM10 concentrations to back-calculate the ratio of vertical PM10 flux to horizontal sand flux (K-factors). Geometric mean K-factor values (K(f)) were found to change seasonally, ranging from 1.3 x 10(-5) to 5.1 x 10(-5) for sand flux measured at 15 cm above the surface (q15). Hourly PM10 emissions, F, were calculated by applying seasonal K-factors to sand flux measurements (F = K(f) x q15). The maximum hourly PM10 emission rate from the study area was 76 g/m2 x hr (10-m wind speed = 23.5 m/sec). Maximum daily PM10 emissions were estimated at 450 g/m2 x day, and annual emissions at 1095 g/m2 x yr. Hourly PM10 emissions were used by the U.S. Environmental Protection Agency (EPA) guideline AERMOD dispersion model to estimate downwind ambient impacts. Model predictions compared well with monitor concentrations, with hourly PM10 ranging from 16 to over 60,000 microg/m3 (slope = 0.89, R2 = 0.77).     

Roadside Rhododendron pulchrum leaves as bioindicators of heavy metal pollution in traffic areas of Okayama, Japan

The leaves of roadside Rhododendron pulchrum Sweet were examined as a bioindicator of traffic-related heavy metal pollution in Okayama. Total contents of heavy metals in roadside soil and the R. pulchrum leaves were determined. Results of correlation analyses showed significant correlations among Pb, Ni, and Zn contents of roadside soil and leaf samples. These results suggest that R. pulchrum is a useful bioindicator of heavy metal pollution in traffic areas. To identify traffic-related heavy metal pollution sources, traffic-related materials such as tires, asphalt pavement, and road paint were collected and analyzed. The results of analyses of our data show that Zn is emitted mainly from the abrasion of tires; Cr is emitted mainly from wear of the asphalt pavement. Furthermore, the respective lead isotope ratios in R. pulchrum leaves, soil, roadside dust, and traffic-related materials were measured using inductively coupled plasma mass spectrometry. The isotopic compositions of lead in R. pulchrum leaves were 207Pb/206Pb = 0.861-0.871 and 208Pb/206Pb = 2.093-2.127, which agrees well with ratios in automobile wheel balance weights, suggesting that lead-containing products associated with automobiles, such as wheel balance weights, contribute to traffic-related lead pollution.     

Effects of tributyltin on the energy metabolism of pen shell (Atrina pectinata japonica)

We examined the effects of tributyltin (TBT) on aerobic and anaerobic energy metabolism of pen shell (Atrina pectinata japonica). We exposed pen shells to TBT at nominal concentrations of 0 (control) and 1.0microg/l for 72h under aerobic condition. At the end of the exposure, half of the pen shells in each treatment were wrapped in plastic wrap to simulate exposure to hypoxia and held at 25 degrees C for another 12h. The concentrations of the products of energy metabolism, namely lactate, pyruvate, fumarate and succinate, in adductor muscle were measured. The exposure to TBT under aerobic condition significantly elevated lactate, pyruvate and fumarate concentrations (p<0.001). After subsequent exposure to anaerobic condition, the mean concentration of succinate in the TBT treatment group was 64% of that in the control group, but there were no significant differences. Our results suggest that the energy metabolism of pen shell is disrupted by exposure to TBT.     

Occurrence of phenols in leachates from municipal solid waste landfill sites in Japan

The concentrations of 41 phenols in leachates from 38 municipal solid waste (MSW) landfill sites in Japan were measured. The main phenols detected in leachates were phenol, three cresols, 4-tert-butylphenol, 4-tertoctylphenol, 4-nonylphenol, bisphenol A, and some chlorophenols. The concentration levels of phenols were affected by the pH values of the leachates and the different types of landfill waste. The origins of phenol and p-cresol were considered to be incineration residues, and the major origin of 4-tert-butylphenol, bisphenol A, and 2,4,6-trichlorophenol was considered to be solidified fly ash. In contrast, the major origins of 4-tert-octylphenol and 4-nonylphenol were considered to be incombustibles. The discharge of leachates to the environment around MSW landfill sites without water treatment facilities can cause environmental pollution by phenols. In particular, the disposal of incineration residues including solidified fly ash and the codisposal of solidified fly ash and incombustibles might raise the possibility of environmental pollution. Moreover, the discharge of leachates at pH values of 9.8 or more could pollute the water environment with phenol. However, phenol, 4-nonylphenol, and bisphenol A can be removed to below the con centration levels that impact the environment around landfill sites by a series of conventional water treatment processes.     

Investigation of 1,4-dioxane originating from incineration residues produced by incineration of municipal solid waste

As a groundwater contaminant, 1,4-dioxane is of considerable concern because of its toxicity, refractory nature to degradation, and rapid migration within an aquifer. Although landfill leachate has been reported to contain significant levels of 1,4-dioxane, the origin of 1,4-dioxane in leachate has not been clarified until now. In this study, the origins of 1,4-dioxane in landfill leachate were investigated at 38 landfill sites and three incineration plants in Japan. Extremely high levels of 1,4-dioxane 89 and 340 microg l(-1), were detected in leachate from two of the landfill sites sampled. Assessments of leachate and measurement of 1,4-dioxane in incineration residues revealed the most likely source of 1,4-dioxane in the leachate to be the fly ash produced by municipal solid waste incinerators. Effective removal of 1,4-dioxane in leachate from fly ash was achieved using heating dechlorination systems. Rapid leaching of 1,4-dioxane observed from fly ash in a sequential batch extraction indicated that the incorporation of a waste washing process could also be effective for the removal of 1,4-dioxane in fly ash.     

Leaching characteristics of stabilized/solidified fly ash generated from ash-melting plant

This study was designed to elucidate the leaching characteristics of stabilized/solidified (S/S) fly ash generated by ash-melting. For this study, pH-dependent leaching tests, sequential extraction procedures, and column leaching tests were carried out. The pH-dependent leaching test results for Pb, Cu, and Zn showed that the heavy metal concentrations in the high-pH range were lower than the predicted values for hydroxide and carbonate. During sequential extraction, Cu and Pb were principally distributed in the S/S ashes' organic matter fraction in the chelating agent, suggesting that metals bind to the chelating agent. The percentage of the water-soluble fraction for Pb and Cu was low (<0.2 %). The fly ashes treated with a chelating agent and cement had low leachability potential for metals in the high-pH range. Column tests for S/S fly ashes showed that two leaching stages were distinguishable: one for short time, corresponding to faster metal leaching, and another for the leaching rate. Kinetic speciation was then applied to data obtained from column leaching tests. The first-order reaction/diffusion model showed a better fit for Ca, Pb, and Cu, suggesting that the initial dissolution of soluble compounds, such as metal chloride, was controlled by the first-order reaction (surface wash off). Subsequently, insoluble compounds such as hydroxide or carbonate might penetrate into the porous matrix by diffusion.