Human viral pathogens are pervasive in wastewater treatment center aerosols

Wastewater treatment center(WTC) workers may be vulnerable to diseases caused by viruses, such as the common cold, influenza and gastro-intestinal infections. Although there is a substantial body of literature characterizing the microbial community found in wastewater, only a few studies have characterized the viral component of WTC aerosols,despite the fact that most diseases affecting WTC workers are of viral origin and that some of these viruses are transmitted through the air. In this study, we evaluated in four WTCs the presence of 11 viral pathogens of particular concern in this milieu and used a metagenomic approach to characterize the total viral community in the air of one of those WTCs. The presence of viruses in aerosols in different locations of individual WTCs was evaluated and the results obtained with four commonly used air samplers were compared.We detected four of the eleven viruses tested, including human adenovirus(h Ad V),rotavirus, hepatitis A virus(HAV) and Herpes Simplex virus type 1(HSV1). The results of the metagenomic assay uncovered very few viral RNA sequences in WTC aerosols, however sequences from human DNA viruses were in much greater relative abundance.     

Natural disasters: a framework for research and teaching

Natural disasters are defined in this paper by relating the impact of extreme geophysical events to patterns of human vulnerability. Hazard perception is shown to be a factor that limits the mitigation of risk. The historical development of disaster studies is traced and five different schools of thought are identified. The current International Decade for Natural Disaster Reduction (IDNDR) is evaluated critically with regard to its potential for unifying the disparate strands of knowledge and its scope as a vehicle for education.
A pedagogical framework for disaster studies is presented. Time and space provide valuable unifying factors, while the subject matter can be differentiated according to the continua and dichotomies that it presents. In disaster studies as in other branches of higher education, an ecocentric approach is preferable to a technocentric one, as many of the poorer nations of the world, which are most afflicted by natural catastrophe, will have to rely for mitigation on maintaining their ecological sustainability, instead of depending on sophisticated technology. Valuable insights into the impact of environmental extremes on mankind are gained from the study of disasters as human ecology.     

Digestive mechanics and gluttonous feeding in the feather starOligometra serripinna (Echinodermata: Crinoidea)

The movement and digestion of food in the gut ofOligometra serripinna (Carpenter) were studied at Lizard Island (14°3842S; 145°2710E) in the austral winter of 1986. Feather stars in the laboratory were fed a brief, small meal of brine shrimp nauplii and killed at increasing time intervals thereafter. Histological reconstructions showed that the ingested nauplii progressed along the digestive tract surprisingly quickly. Some nauplii were found in the mid and hind intestine in only 30 min, and all of the nauplii had reached the hind intestine and rectum in 1 h. Digestion of the nauplii had started at 1 h, and only a few fragments of naupliar exoskeleton remained in the hind intestine and rectum 5 h after the start of feeding. Videotape analysis showed that no fecal pellets were released during this experiment. In the natural environment ofO. serripinna, ingested particles may similarly be transported quickly to the hind part of the gut and digested there — when feather stars were fixed in the field, most of the gut contents were found in the hind intestine and rectum.O. serripinna, which efficiently rejects inert particles before they are ingested, usually defecates infrequently (probably not more than once over a span of many hours) and differs from some other feather stars that ingest numerous inert particles and defecate much more frequently. When specimens ofO. serripinna were fed continuously on brine shrimp nauplii,Artemia sp. (San Francisco strain), in the laboratory, the feather stars fed gluttonously, packing their guts with several hundred nauplii in 1 to 2 h. Thereafter, superfluous feeding began (i.e., further ingestions appeared to force undigested nauplii, some of them still living, out of the anus). These observations suggest thatO. serripinna usually feeds at relatively modest rates in its natural habitat, but can feed gluttonously to take advantage of infrequent patches of highly concentrated, nutritious particles (e.g. copepod swarms, migrating demersal zooplankton, and invertebrate gametes from mass spawnings). It is likely that such patches of nutritious particles are usually small enough to drift out of reach of the feather stars before gluttonous feeding proceeds to superfluous feeding. Opportunities for superfluous feeding in nature are probably very infrequent (e.g. ingestion of coral gametes and embryos after a mass spawning), and the feather stars evidently have no behavior that stops further ingestions after the gut becomes filled to capacity.     

The effect of chronic toxicity of copper on the activity of Balbiani rings and nucleolar organizing region in the salivary gland chromosomes of Chironomus ninevah larvae

The effect of copper on the activity of Balbiani rings (BR1 and BR2) and nucleolar organizing region (NOR) in chromosome IV of the salivary gland of the 4th instar larvae of Chironomus ninevah has been investigated. Sublethal concentrations, i.e. 0.02, 0.1, 0.15 and 0.2 mg litre(-1) suppress the activity of BR1, and are statistically significant. The same concentrations reduced the activity of BR2 and NOR, but without significant differences, except 0.1 mg litre(-1) which was significant. The purpose of this work was to evaluate the effect of chronic toxicity of Cu(2+) on the expression of gene activity of midge salivary gland chromosomes Although there may be many more aquatic organisms that are more sensitive to copper, this midge was selected as a biological indicator species because of its association with benthic sediments.     

Effect of methyl mercuric chloride treatment on haematological characteristics and erythrocyte morphology of Swiss mice

Effects of methyl mercuric chloride (MMC) on the blood parameters of Swiss mice (Mus musculus) were studied. The mice received an initial dose of MMC (24 mg kg(-1) body wt) as intraperitoneal injection followed by a second similar dose on the 14th day of the first dose administration. Significant (p < or = 0.001) decreases in haemoglobin content, red blood cell (RBC) count and haematocrit value were observed in the MMC injected mice when compared to the control mice. The effect of the second dose was severe, after which no significant recovery in the values of these parameters was observed. The result also showed a high degree of mercury accumulation in the blood of the MMC exposed mice. Interesting features were marked in the erythrocyte morphology of the exposed mice. An initial shrinkage followed by swelling of the cells was observed after each injection. The outline of the exposed cells was irregular with beak like or small finger like projections. Rupturing and disintegration of the erythrocyte membrane, leading to erythrolysis, were also noticed.     

The influence of pH on cadmium toxicity to the green alga Stichococcus bacillaris and on the cadmium forms present in the culture medium

Cadmium toxicity to the green alga Stichococcus bacillaris was investigated in media of pH 3-9. A significant decrease of cadmium toxicity occurred in both the acidic and alkaline ranges of pH. In media of pH 3 and 9, cadmium did not affect the dry mass content substantially. Maximum toxicity of cadmium was noticed at pH 6-7. Voltametric investigations showed a significant effect of pH on electrochemically measured cadmium content in the culture media. Hydrolysis of the medium components and formation of cadmium complexes with OH(-) ions caused a considerable decrease in amounts of electrochemically measured cadmium in the alkaline range of pH.     

Reduction and avoidance of lubricant mist demands an integrated assessment approach

A case study to identify major factors for lubricant mist exposure covered 15 metal machining sites. The investigation included milling, turning, drilling and grinding applications. Systematic analysis considered all relevant data concerning the machine tool, the lubricant and the suction plant. The efficiency of the implemented maintenance program at the installed filter systems was checked by concentration measurements immediately before and after service. All performed measurements of lubricant aerosol and vapor loads upstream and downstream of the installed filter systems were carried out according to VDI 2066 and BIA 3110, respectively. The selection criteria for the sites to be investigated, the systematic nature of the data acquisition and the procedure of the analysis are demonstrated in detail by performing comparisons between selected applications using emulsions and those employing straight oil for lubrication. The results of the study identify recirculation of ventilated air as the major source of workplace exposure to airborne lubricant emissions. More than 60% of the demisters investigated emit air at total lubricant loads (aerosols and vapor) above the limit of 20 mg m-3 at any time of operation; which also means immediately after service. A common reason for exceeded aerosol loads in recirculated air is e.g. the fact that the type of filter system applied is often not suitable for the separation problem. Loads of lubricant vapor are usually higher at the processes which use water emulsions as lubricant. In a quarter of the cases the limits were exceeded solely due to high vapor loads even immediately after service. The exposure can be reduced by replacing the lubricant, installation of a vapor separation plant or avoiding air recirculation. Maintenance time of the demisting system and aerosol separation efficiency of state-of-the-art demisting systems can be expanded by implementation of enhanced preliminary filter stages. This study confirms that appropriate service measures lower both aerosol emissions and lubricant vapor concentrations due to the reduction of exposed oil-wetted surfaces. The performed measurements show no significant relationship between loads of airborne lubricants and the type of machining process. Therefore, investigations at a much more detailed level have to be performed. However, the individual assessment of any workplace due to the complex situation remains essential.     

Soil sampling and analysis for volatile organic compounds

Concerns over data quality have raised many questions related to sampling soils for volatile organic compounds (VOCs). This paper was prepared in response to some of these questions and concerns expressed by Remedial Project Managers (RPMs) and On-Scene Coordinators (OSCs). The following questions are frequently asked:

1. Is there a specific device suggested for sampling soils for VOCs?
2. Are there significant losses of VOCs when transferring a soil sample from a sampling device (e.g., split spoon) into the sample container?
3. What is the best method for getting the sample from the split spoon (or other device) into the sample container?
4. Are there smaller devices such as subcore samplers available for collecting aliquots from the larger core and efficiently transferring the sample into the sample container?
5. Are certain containers better than others for shipping and storing soil samples for VOC analysis?
6. Are there any reliable preservation procedures for reducing VOC losses from soil samples and for extending holding times?

Guidance is provided for selecting the most effective sampling device for collecting samples from soil matrices. The techniques for sample collection, sample handling, containerizing, shipment, and storage described in this paper reduce VOC losses and generally provide more representative samples for volatile organic analyses (VOA) than techniques in current use. For a discussion on the proper use of sampling equipment the reader should refer to other sources (Acker, 1974; U.S. EPA, 1983; U.S. EPA, 1986a). Soil, as referred to in this report, encompasses the mass (surface and subsurface) of unconsolidated mantle of weathered rock and loose material lying above solid rock. Further, a distinction must be made as to what fraction of the unconsolidated material is soil and what fraction is not. The soil component here is defined as all mineral and naturally occurring organic material that is 2 mm or less in size. This is the size normally used to differentiate between soils (consisting of sands, silts, and clays) and gravels. Although numerous sampling situations may be encountered, this paper focuses on three broad categories of sites that might be sampled for VOCs:

1. Open test pit or trench.
2. Surface soils (<5 ft in depth).
3. Subsurface soils (>5 ft in depth).