Contaminant transport in a municipal drinking water supply: a steady-state approach to estimate rate and uncertainty

Contaminant transport is generally considered to be a key factor when assessing and classifying the environmental risk of polluted areas. In the study presented here, a steady-state approach was applied to obtain estimates of the transit time and concentration of the pesticide metabolite BAM (2,6-dichlorobenzoamide) at a site where it is contaminating a municipal drinking water supply. A Monte Carlo simulation technique was used to quantify the uncertainty of the results and to evaluate the sensitivity of the used parameters. The adopted approach yielded an estimated median transit time of 10 y for the BAM transport from the polluted site to the water supply. Soil organic carbon content in the unsaturated zone and the hydraulic conductivity in the saturated zone explained 44% and 23% of the uncertainty in the transit time estimate, respectively. The sensitivity analysis showed that the dilution factor due to regional groundwater flow and the soil organic carbon content at the polluted site explained 53% and 31% of the uncertainty of concentration estimates, respectively. In conclusion, the adopted steady-state approach can be used to obtain reliable first estimates of transit time and concentration, but to improve concentration predictions of degrading contaminants, a dynamic model is probably required.     

Zur Kritik des Hooker-Forbes-Tests (HFT)

The Science of Nature -     

Quecksilbergasfeinreinigung mittels metall- und salzpartikelbelegter Trägermaterialien (G/S-Reaktor) Ökotoxizität von Quecksilber und seiner Verbindungen

Waste and process gases from thermal power and metallurgical plants or such products from alkali-chloride industries contain metallic, inorganic and organic mercury. Widespread processes applied to remove the greatest amount of mercury are absorption and adsorption. Caused by the lowering of the emission limit from 200 to 50 μg/m³ [STP] by national and European legislators, considerable efforts have been made to enhance the efficiency of the main separation units of flue gas cleaning plants by applying the appropriate technological measures. This article is focused on the removal of mercury from waste gases. The state of engineering is described, especially with regard to enhancing the efficiency of separation in the raw gas, in wet, dry and quasi-dry processes as well as in tail-end process units. Specially impregnated ceramic carriers can be used for the selective separation of metallic, inorganic and organic mercury. Amalgamation has been investigated as a possible separation mechanism both experimentally and in theory. Using the ceramic reactor, removal rates for gaseous mercury and its compounds can be achieved which are even lower than 50 μg/m³ [STP]. The technology, the separation mechanisms and the ecological advantages through the use of ceramic reactors are presented in the article as well.     

Factors influencing formation of trihalomethanes in drinking water with special reference to Swedish conditions

The trihalomethane (THM) concentrations in drinking water are greatly affected by the disinfection methods as well as the organic content of the water. The THM formation was shown to increase considerable during 24 hours. This indicates a higher concentration of THM at the consumers' tap compared to the levels in the outgoing water from the water work. The dosage ratio between chlorine and ammonium sulphate can be used to regulate the THM concentrations. Disinfection with a relatively high dosage of chlorine dramatically increase the THM level while the equal amount of chlorine dioxide produces trace concentrations of THM only. The relatively low THM concentrations in Swedish drinking water as compared to levels found in water from for example the USA may probably depend on the low chlorine dosage practiced in Sweden.