PCBs污染土壤的CaO诱导低温热处理脱氯研究

研究了低温热处理脱氯技术对废弃电容器封存点附近污染土壤中多氯联苯脱氯的效果,考察反应温度、反应时间及CaO添加比例对PCBs去除率、脱氯率的影响以及反应前后土壤中污染物的组分变化。实验土样中PCBs浓度为107.7 mg/g,属于罕见高浓度PCBs污染土壤。当反应温度为400℃、停留时间4h、CaO添加比例为10%,PCBs的去除率为87.7%,脱氯率为85.3%。土壤样品中五氯联苯和四氯联苯反应后含量降低或未检出,部分反应后样品检出一氯联苯和联苯,说明在CaO诱导PCBs低温热处理脱氯反应中存在逐步脱氯/加氢反应途径。     

罐底含油泥热解动力学参数计算方法的优选

在化学反应设计中反应动力学是较重要的因素。为得到更合理的污泥热解动力学参数计算方法,利用热重分析仪,在氮气气氛下对罐底含油污泥的热解特性进行研究。根据热重实验数据,分别采用Coats-Redfern法、Kissinger法、FWO法和Popescu法计算污泥热解动力学参数,并获取罐底泥热解制油的主要阶段(第2阶段)的反应活化能E、频率因子A并分析各种方法反应机理。通过对比不同计算方法得到动力学参数及拟合曲线与实验曲线的相关性,确定了最佳罐底含油污泥热解动力学参数计算方法。研究表明,Popescu法得到罐底泥的热解过程符合Jander方程,活化能E为101.43 kJ/mol,与FWO法得到的91.20 kJ/mol相近,且预测曲线与实验曲线有较好的相关性(0.9816),说明Popescu法计算罐底泥热解动力学参数更合适。     

基于改性凹凸棒土的强化混凝处理高藻低浊原水工艺

针对水厂低浊高藻水的处理难题,研究了改性凹凸棒土(改性凹土)联合聚合氯化铝(PAC)强化混凝的除藻除浊效果。设计实验原水条件为叶绿素a(chl-a)浓度为98.58~110.35μg/L,浊度(5.6±0.5)NTU。考察了PAC和改性凹土的复配投加量、混凝沉淀时间、pH、投加顺序、搅拌速率等工艺参数对Chl-a和浊度耦合去除效果的影响。结果表明,"PAC+改性凹土"对Chl-a和浊度的去除效果明显优于单投PAC的效果。当PAC投药量12 mg/L,改性凹土投药量10 mg/L,沉淀时间20 min时,对Chl-a和浊度的去除率可分别达到92.5%和89.2%,可至少减少40%的PAC投量,且形成的矾花密实,沉降速度快,去除效率高。最适pH范围为7~8。投加顺序应为先投加改性凹土,混合搅拌转数宜慢速,可控制为50 r/min。     

镍渣的重金属浸出特性

在分析镍渣的矿物相组成和重金属元素含量的基础上,鉴定了镍渣样品的浸出毒性,并考察了pH、液固比和浸出时间等条件对镍渣样中铬、铅、铜和锌等重金属浸出特性的影响。结果表明,镍渣中的重金属总量约为渣样的0.9%,且铬、铜和锌的含量较高,需进行安全管理。实验所用镍渣样品为第Ⅰ类一般工业固体废物。在强酸条件下镍渣中重金属浸出浓度较大,pH3后浸出浓度显著降低;液固比40 L/kg时,镍渣中重金属不断溶出,液固比40 L/kg后,浸出达到饱和,浸出浓度趋于平衡;随着浸出时间的增加,重金属离子的浸出浓度先增加后减少,但由于各重金属性质不同,各重金属达到最大浸出浓度的时间不同。     

Distribution,sources, and ecological risk assessment of SVOCs in surface sediments from Guan River Estuary,China

The contamination of semi-volatile organic compounds (SVOCs) in the surface sediments of the Guan River Estuary, China was fully investigated. Total concentrations of 56 species of SVOCs ranged from 132 to 274 ng/g with an average of 186 ng/g (dry weight). Polycyclic aromatic hydrocarbon (PAH) concentrations were positively correlated with clay content and negatively correlated with sediment grain size. Source identification indicated that PAHs originated mainly from pyrolytic sources. However, intense ship traffic in the estuary may provide sources of petrogenic PAHs. Organochlorine pesticides (OCPs) mainly originated from direct input of dichlorodiphenyltrichloroethanes (DDTs) during some industrial processes. The SVOC concentrations were also compared with International Sediments Quality Guidelines and Sediments Quality Criteria, and the results indicated that negative biological impacts may originate from high concentrations of FLO, p,p′-DDE, and total DDTs.     

Improve Compliance with Limited Resources by a Three-Group Inspection Regime

Frequent monitoring and relatively high fines are usually necessary to bring about improvements in environmental quality, but more challenging for many countries with limited human, material, and financial resources is to put them into practice. This paper developed a three-group model of a state-dependent enforcement in a repeated game to improve the policy implementation under limited inspection capacities. A certain number of firms are grouped (group 1, group 2, group 3) for different supervision intensity (e.g., the order of inspection probability corresponding to each group is p ₁?<?p ₂?<?p ₃) based on their environmental performance. The optimal policy parameters, such as inspection probability of each group and the probability that a firm found in compliance is moved to a better reputation group, were obtained as the basis for regulator’s policy making. Numerical simulations indicated that the three-group inspection regime can significantly increase compliance rate as compared with static enforcement with the same monitoring probability. Among the number of firms in each group under steady state conditions, group 2 had the most, group 1 was the second, and group 3 had the smallest. Analysis and prediction of a three-group reputation example provided a good experiment for the model. The results give a practical reference for the policy makers with inspection capacity constraints to achieve higher compliance rate.     

Spatial simulation and LCA evaluation on the plastic waste recycling system in Tianjin

With the rapid economic development in China, the amount of plastic waste (PW) generated has greatly increased and much of the waste is currently not treated. To reduce greenhouse gas (GHG) emissions from recycling of PW, we estimated the PW flow and considered methods to improve the household PW recycling system in Tianjin by adjusting processes during transportation and establishing a PW recycling factory in Zi’ya Industrial Park. The goal of the study was to identify reasonable improvements for the recycling system and clarify the environmental load. Geographic information system (GIS) technology was used to simulate transport processes for comparing GHG emissions from the transport processes between the present case and an improved case. Life cycle assessment (LCA) was used to compare GHG emissions between a projected scenario and a baseline scenario. Estimated GHG emissions during transport processes in the improved case were reduced by about 12,197 t CO₂ eq per year compared to the present case, equivalent to about 65.9 % of the total emissions in the present case. GHG emissions in the projected scenario were about 101,738 t CO₂ eq less per year than the baseline scenario, equivalent to about 75.5 % of the total emissions in the baseline scenario.     

Field crops (Ipomoea aquatica Forsk. and Brassica chinensis L.) for phytoremediation of cadmium and nitrate co-contaminated soils via rotation with Sedum alfredii Hance

Environmental Science and Pollution Research - Phytoremediation coupled with crop rotation (PCC) is a feasible strategy for remediation of contaminated soil without interrupting crop production....     

Research status,challenges and future prospects of renewable synthetic fuel catalysts for CO2 photocatalytic reduction conversion

Environmental Science and Pollution Research - In recent years, with global climate change, the utilization of carbon dioxide as a resource has become an important goal of human society to achieve...     

邻苯二甲酸酯类雌激素活性联合作用模型分析

环境雌激素对生命健康影响受到广泛关注,现行污染物环境标准制订和风险评价只针对单一化合物而非混合物效应,不足以保护生命安全与人类健康。为探讨环境雌激素的混合物效应,选择对雌激素敏感的人乳腺癌MCF-7细胞增殖实验,检测雌二醇(E2)、邻苯二甲酸酯类化合物(DBP和DEHP)的单一及其联合雌激素活性;基于单一化合物的浓度-反应曲线,运用浓度相加(CA)和独立作用(IA)模型对混合物的毒性进行预测,并将模型预测结果与混合物实验数据进行比较分析。结果表明,E2、DBP、DEHP对MCF-7细胞的单一作用数据可通过Weibull方程拟合,由拟合方程得到的半数效应浓度(EC50)及95%置信区间分别为3.450×10-6(2.373×10-6~1.675×10-5)、5.138(1.489~1.082×10)、1.186(4.478×10-1~2.24)μmol·L-1;3种化合物的混合物数据亦可通过Weibull、Logistic和Exp Gro1方程进行有效拟合,混合物效应与化合物单独作用产生的效应具有显著性差异;3种化合物表现非相似联合作用,利用独立作用(IA)模型预测混合物效应较为可靠,外源性环境雌激素与内源性雌激素联合作用产生的混合效应显著。环境雌激素混合物毒性可以通过相加作用模型预测,为环境复合污染的风险评价和管理提供基础数据。