Dissipation pattern and risk quotients assessment of amisulbrom in Korean melon cultivated in plastic house conditions

Amisulbrom formulated as suspension concentrate was applied at the rate recommended for Korean melon to determine the dissipation pattern (at two different sites), the pre-harvest residue limit (PHRL), and risk assessments. Samples collected over 10 days were extracted using liquid-liquid extraction (LLE) and cleaned up with solid-phase extraction (SPE) Florisil cartridge. Residual concentrations were determined using liquid chromatography-ultraviolet detector (LC-UVD) and confirmed by liquid chromatography-tandem mass spectrometry (LC-MS/MS). The standard showed good instrument response linearity with a correlation coefficient (R ²) = 0.9999, and the recovery ranged from 87.5 to 93.7%. The dissipation half-life calculated from two different sites were found to be 7.0 and 8.8 days for sites 1 and 2, respectively. A PHRL graph constructed from the data indicated that if the residue levels were less than 0.55–0.59 mg/kg 3 days before harvest or less than 0.61–0.74 mg/kg 7 days before harvest, then they would be lower than the maximum residue limits (MRLs) at harvest. Risk assessments showed that the risk quotient (RQ) was 4.39–3.47% at 0 day, declined to 1.53–1.63% at 10 days. Therefore, the current data indicate that the amisulbrom can be applied safely to Korean melon; hence, it is unlikely to induce adverse health effects in consumers.     

Effects of glyphosate on the non-target leaf beetle Cerotoma arcuata (Coleoptera: Chrysomelidae) in field and laboratory conditions

This study aimed to assess the glyphosate application effects on the Cerotoma arcuata Oliver (Coleoptera: Chrysomelidae) population in glyphosate-resistant soybean crops. Field studies were conducted with glyphosate and the insecticide endosulfan to observe the effects of these pesticides on C. arcuata, on its damages in the crop and on the populations of natural enemies in glyphosate-resistant soybean crops. Moreover, the lethal and behavioral sublethal response of C. arcuata to glyphosate and endosulfan was conducted in the laboratory. The results of the field and laboratory experiments showed that glyphosate caused moderate toxicity and high irritability in C. arcuata and that endosulfan caused high toxicity and irritability. Therefore, the direct effect of glyphosate on C. arcuata was negative and does not explain the population increases of this pest in glyphosate-resistant soybean. However, the glyphosate also decreased the density of predators. Thus, the negative effect of glyphosate on the predators may be related to population increases of C. arcuata in glyphosate-resistant soybean crops, however, more studies are needed to better evidence this relationship. This study suggests that glyphosate can impact other non-target organisms, such as herbivorous insects and natural enemies and that the use of this herbicide will need to be carefully stewarded to prevent potential disturbances in beneficial insect communities in agricultural systems.     

Phthalides as promising insecticides against Tuta absoluta (Lepidoptera: Gelechiidae)

In this study, the insecticide potential of eight phthalides derived from furan-2(5H)-one was evaluated against Tuta absoluta (Meyrick) (Lepidoptera: Gelechiidae) larvae. The potency of the most active phthalides and the susceptibility of six different T. absoluta populations to these compounds were determined. The toxicity of these molecules to two non-target species (Solenopsis saevissima Smith and Tetragonisca angustula Latreille) was also evaluated. Two phthalides (3 and 4) presented insecticide potential against T. absoluta. Phthalide 4 was as toxic as piperine (positive control) and both phthalides exhibited rapid action (LT₅₀ < 2 hours). The variation in the susceptibility of T. absoluta populations to the phthalides 3 and 4 was low. Neither phthalide presented physiological selectivity for non-target species.

Therefore, the phthalides 3 and 4 are promising molecules, or at least, a starting point for a chemical optimization program leading to formulations for the management of the tomato leafminer. The application of such products should be conducted according to the principles of ecological selectivity.     

Modeling the dynamics of DDT in a remote tropical floodplain: indications of post-ban use?

Significant knowledge gaps exist regarding the fate and transport of persistent organic pollutants like dichlorodiphenyltrichloroethane (DDT) in tropical environments. In Brazil, indoor residual spraying with DDT to combat malaria and leishmaniasis began in the 1950s and was banned in 1998. Nonetheless, high concentrations of DDT and its metabolites were recently detected in human breast milk in the community of Lake Puruzinho in the Brazilian Amazon. In this work, we couple analysis of soils and sediments from 2005 to 2014 at Puruzinho with a novel dynamic floodplain model to investigate the movement and distribution of DDT and its transformation products (dichlorodiphenyldichloroethylene (DDE) and dichlorodiphenyldichloroethane (DDD)) and implications for human exposure. The model results are in good agreement with the accumulation pattern observed in the measurements, in which DDT, DDE, and DDD (collectively, DDX) accumulate primarily in upland soils and sediments. However, a significant increase was observed in DDX concentrations in soil samples from 2005 to 2014, coupled with a decrease of DDT/DDE ratios, which do not agree with model results assuming a post-ban regime. These observations strongly suggest recent use. We used the model to investigate possible re-emissions after the ban through two scenarios: one assuming DDT use for IRS and the other assuming use against termites and leishmaniasis. Median DDX concentrations and p,p′-DDT/p,p′-DDE ratios from both of these scenarios agreed with measurements in soils, suggesting that the soil parameterization in our model was appropriate. Measured DDX concentrations in sediments were between the two re-emission scenarios. Therefore, both soil and sediment comparisons suggest re-emissions indeed occurred between 2005 and 2014, but additional measurements would be needed to better understand the actual re-emission patterns. Monte Carlo analysis revealed model predictions for sediments were very sensitive to highly uncertain parameters associated with DDT degradation and partitioning. With this model as a tool for understanding inter-media cycling, additional research to refine these parameters would improve our understanding of DDX fate and transport in tropical sediments.     

Potential for CSO treatment with horizontal flow constructed wetlands: influence of hydraulic load,plant presence and loading frequency

This study aimed at analysing the performance of horizontal subsurface flow constructed wetlands (CWs) to treat combined sewer overflow (CSO). Four horizontal subsurface flow CWs, organized in two groups (A and B) each with a planted (Phragmites australis) and a non-planted bed, were loaded with simulated CSO, with group B receiving twice the hydraulic load of group A. Beds were monitored for pH, dissolved oxygen, conductivity, redox potential, chemical oxygen demand (COD), total suspended solids (TSS) and enterococci. Porosity variations were also estimated. Monitoring was conducted during spring and wintertime, with regular and irregular loading frequencies. Results showed an average treatment efficiency of 90–100 % for TSS, 60–90 % for COD and 2–6 log for enterococci. Removal rates were especially relevant in the first 24 h for COD and TSS. TSS and enterococci removal did not exhibit the influence of macrophytes or the applied hydraulic load while COD’s removal efficiency was lower in the higher load group and in planted beds.

     

Determination of three cresol isomers in sewage sludge by solid-liquid extraction with low temperature purification and gas chromatography-mass spectrometry

Abstract

Cresols are chemical contaminants derivative from phenol which can be found in sewage sludge. However, little attention has been given to monitoring these compounds in environmental matrices in the literature. Thus, the objective of this study was to develop a simple method based on solid-liquid extraction with low temperature purification for determining three cresol isomers in sludge. The quantification of these compounds was performed by gas chromatography coupled to mass spectrometry with a previous derivatization step. After a detailed study, the cresol recovery was higher than 91%, with relative standard deviation lower than 12% and a limit of quantification of 20?μg kg^?1. Linearity was achieved between 10 and 90?μg L^?1 (R² > 0.98) with the standard solutions prepared in matrix extracts due to the trouble caused by the matrix effect. The proposed method was applied with success for monitoring cresols in sewage sludge samples coming from six different wastewater treatment plants. All samples showed contamination by cresols, mainly p-cresol with values between 32.3 and 516.9?μg kg^?1. The majority of the analyzed samples showed a total sum of the isomers higher than the maximum residue limit established by Brazilian legislation (160?μg kg^?1).     

Chemical and plant tests to assess the viability of amendments to reduce metal availability in mine soils and tailings

The goal of this research was to assess the potential of several industrial wastes to immobilise metals in two polluted soils deriving from an old Pb/Zn mine. Two different approaches were used to assess the performance of different amendments: a chemical one, using extraction by ethylenediaminetetraacetic acid (EDTA), and a biological one, using Lupinus albus as a bio-indicator. Four amendments were used: inorganic sugar production waste (named ‘sugar foam’, SF), sludge from a drinking water treatment sludge (DWS), organic waste from olive mill waste (OMW) and paper mill sludge (PMS). Amendment to soil ratios ranged from 0.1 to 0.3 (w/w). All the amendments were capable of significantly decreasing (p?<?0.05) EDTA-extractable Pb, Zn and Cu concentrations in the two soils used, with decreases in ranges 21–100, 25–100 and 2–100 % for Pb, Zn and Cu, respectively. The amendments tested were also effective in reducing the bioavailability of Pb and Zn for L. albus, which gave rise to a decrease in shoot metal accumulation by the lupine plants compared to that found in the control soil. That decrease reached up to 5.6 and 2.8 times for Pb and Zn, respectively, being statistically significant in most cases. Moreover, application of the OMW, DWS and SF amendments led to higher average values of plant biomass (up to 71 %) than those obtained in the control soil. The results obtained showed the technology put forward to be a viable means of remediating mine soils as it led to a decrease in the availability and toxicity of metals and, thus, facilitated the growth of a vegetation layer.     

Energy rating methodology for light-duty vehicles: geographical impact

The aim of this paper was to describe a new energy dependency score methodology and its consequent application to cars sold in twelve regions: Europe (EU-28) and eleven specific countries worldwide (Australia, Brazil, China, India, Japan, Norway, Portugal, Russia, Saudi Arabia, South Africa and USA). This methodology was developed as a potential tool to inform consumers of their choice impact on the country’s economy. This methodology is based on primary energy assessments and origins for each energy pathway associated with a gasoline-, diesel-, natural gas (used for H₂ production)- or electricity (balanced with country electricity mix)-powered vehicle. An energy dependency index was attributed to the best-case (100 % endogenous production) and worst-case (0 % endogenous production) scenarios and consequently weighted with vehicle fuel consumption. This enabled obtaining an energy dependency index (10–0). This index could be assigned to an environmental and social index to provide a sustainability index and therefore complement a road vehicle environmental rating system, providing a combined index rating. Internal combustion engine vehicles and hybrid vehicles (that have oil products as energy source) rate the lowest for almost all locations, with the exception of regions that are energy independent (Norway, Saudi Arabia or Russia). Electric vehicles rank higher when comparing to the other technologies analyzed for all locations in this study. The plug-in hybrid electric vehicle shows generally a rank in an intermediate place, except for Japan where it scores lower than all other technologies.