Leaching characteristics of stabilized/solidified fly ash generated from ash-melting plant

This study was designed to elucidate the leaching characteristics of stabilized/solidified (S/S) fly ash generated by ash-melting. For this study, pH-dependent leaching tests, sequential extraction procedures, and column leaching tests were carried out. The pH-dependent leaching test results for Pb, Cu, and Zn showed that the heavy metal concentrations in the high-pH range were lower than the predicted values for hydroxide and carbonate. During sequential extraction, Cu and Pb were principally distributed in the S/S ashes' organic matter fraction in the chelating agent, suggesting that metals bind to the chelating agent. The percentage of the water-soluble fraction for Pb and Cu was low (<0.2 %). The fly ashes treated with a chelating agent and cement had low leachability potential for metals in the high-pH range. Column tests for S/S fly ashes showed that two leaching stages were distinguishable: one for short time, corresponding to faster metal leaching, and another for the leaching rate. Kinetic speciation was then applied to data obtained from column leaching tests. The first-order reaction/diffusion model showed a better fit for Ca, Pb, and Cu, suggesting that the initial dissolution of soluble compounds, such as metal chloride, was controlled by the first-order reaction (surface wash off). Subsequently, insoluble compounds such as hydroxide or carbonate might penetrate into the porous matrix by diffusion.     

Plutonium isotopes concentration in seawater and bottom sediment off the Pacific coast of Aomori sea area during 1991-2005

A radioactivity survey was launched in 1991 to determine the background levels of ^239+240Pu in the marine environment off a commercial spent nuclear fuel reprocessing plant before full operation of the facility. Particular attention was focused on the ²⁴⁰Pu/²³⁹Pu atom ratio in seawater and bottom sediment to identify the origins of Pu isotopes. The concentration of ^239+240Pu was almost uniform in surface water, decreasing slowly over time. Conversely, the ^239+240Pu concentration varied markedly in the bottom water and was dependent upon the sampling point, with higher concentrations of ^239+240Pu observed in the bottom water sample at sampling points having greater depth. The ²⁴⁰Pu/²³⁹Pu atom ratio in the seawater and sediment samples was higher than that of global fallout Pu, and comparable with the data in the other sea area around Japan which has likely been affected by close-in fallout Pu originating from the Pacific Proving Grounds. The ²⁴⁰Pu/²³⁹Pu atom ratio in bottom sediment samples decreased with sea depth. The land-originated Pu is not considered as the reason of the increasing ^239+240Pu concentration and also decreasing the ²⁴⁰Pu/²³⁹Pu atom ratio with sea depth, and further study is required to clarify it.     

Male mate choice and male–male competition in the hermit crab Pagurus nigrofascia: importance of female quality

Male mate choice has recently been reported in some animals with male–male competition. In the laboratory, we examined whether males choose their mates based on female quality that was indicated by body size and/or days to prenuptial molt, and the effects of female quality on male–male competition in the hermit crab Pagurus nigrofascia. We collected samples from April to May 2009 at an intertidal shore in Hokkaido, Japan (41°N, 140°E). When a male simultaneously encountered two receptive females in the mate choice experiment, males chose females which require less time to molt. When a male guarding a female with less time to molt was challenged by an intruder, the guarding male defended the female for a longer period and was more likely to win the contest. These results indicate that male P. nigrofascia use time to molt to discriminate between females.     

Effect of density-driven flow on the through-diffusion experiment

Diffusion is one of the main mechanisms of solute transport in pore water of geologic media. The effective diffusion coefficient of a solute in a rock is usually measured by the through-diffusion experiment. However, in this experiment, the effect of advection, induced by density difference between dense aqueous solution and pure water, has not been considered. To evaluate the effect of density-driven flow, a through-diffusion experiment using Fontainebleau sandstone was conducted for KCl and KI aqueous solutions with various densities. The measured effective diffusion coefficients were positively correlated with the density difference; the effective diffusion coefficient of a 1 M KI solution (density difference, 0.119 g/cm³) was one order of magnitude larger than that of a 0.1 M KCl solution (density difference, 0.005 g/cm³). The result is explained by a theoretical model using a diffusion–advection equation including Darcy's law. Based on the theory, a diagram to evaluate the condition at which the measured effective diffusion coefficient does not include the effect of advection is presented.     

Improvement of an efficient separation method for chemicals in diesel exhaust particles: analysis for nitrophenols

GOAL, SCOPE, AND BACKGROUND: Diesel exhaust is believed to consist of thousands of organic constituents and is a major cause of urban pollution. We recently reported that a systematic separation procedure involving successive solvent extractions, followed by repeated column chromatography, resulted in the isolation of vasodilatory active nitrophenols. These findings indicated that the estimation of the amount of nitrophenols in the environment is important to evaluate their effect on human health. The isolation procedure, however, involved successive solvent extractions followed by tedious, repeated chromatography, resulting in poor fractionation and in a significant loss of accuracy and reliability. Therefore, it was crucial to develop an alternative, efficient, and reliable analytical method. Here, we describe a facile and efficient acid-base extraction procedure for the analysis of nitrophenols. MATERIALS AND METHODS: Diesel exhaust particles (DEP) were collected from the exhaust of a 4JB1-type engine (ISUZU Automobile Co., Tokyo, Japan). Gas chromatography-mass spectrometry (GC-MS) analysis was performed with a GCMS-QP2010 instrument (Shimadzu, Kyoto, Japan). RESULTS: A solution of DEP in 1-butanol was extracted with aqueous NaOH to afford a nitrophenol-rich oily extract. The resulting oil was methylated with trimethylsilyldiazomethane and subsequently subjected to GC-MS analysis, revealing that 4-nitrophenol, 3-methyl-4-nitrophenol, 2-methyl-4-nitrophenol, and 4-nitro-3-phenylphenol were present in significantly higher concentrations than those reported previously. DISCUSSION: Simple acid-base extraction followed by the direct analysis of the resulting extract by GC-MS gave only broad peaks of nitrophenols with a poor detection limit, while the GC-MS analysis of the sample pretreated with (trimethylsilyl)diazomethane gave satisfactorily clear chromatograms with sharp peaks and with a significantly lowered detection limit (0.5 ng/ml, approximately 100 times). CONCLUSION: The present method involving an acid-base extraction, in situ derivatization, and GC-MS analysis has shown to be a simple, efficient, and reliable method for the isolation and identification of the chemical substances in DEP.     

Anthropogenic radionuclides in sediment in the Japan Sea: distribution and transport processes of particulate radionuclides

Distributions of anthropogenic radionuclides ((90)Sr, (137)Cs and (239+240)Pu) in seabed sediment in the Japan Sea were collected during the period 1998-2002. Concentration of (90)Sr, (137)Cs and (239+240)Pu in seabed sediment was 0.07-1.6 Bq kg(-1), 0.4-9.1 Bq kg(-1) and 0.002-1.9 Bq kg(-1), respectively. In the northern basin of the sea (Japan Basin), (239+240)Pu/(137)Cs ratios in seabed sediment were higher and their variation was smaller compared to that in the southeastern regions of the sea. The higher (239+240)Pu/(137)Cs ratios throughout the Japan Basin were considered to reflect production of Pu-enriched particles in the surface layer and substantial sinking of particulate materials in this region. In the southern regions of the Japan Sea (<38 degrees N), both inventories and (239+240)Pu/(137)Cs ratios in sediment were larger than those in the other regions. In the southern Japan Sea, observations suggested that supply of particulate radionuclides by the Tsushima Warm Current mainly enhanced accumulation of the radionuclides in this region.     

Distribution of Poly(β-propiolactone) Aerobic Degrading Microorganisms in Different Environments

The distribution of degading microorganisms of high molecular weight poly(-propiolactone) (PPL), whose individual structural units are similar to those of poly(-hydroxybutyrate) (PHB) and poly(€-caprolactone) (PCL), was examined. Despite the fact that PPL is a chemosynthetic polymer, many kinds of PPL-degrading microorganisms were found to be distributed as resident populations widely in natural environments. A total of 77 strains of PPL-degrading microorganisms was isolated. From standard physiological and biochemical tests, at least 41 strains were referred to as Bacillus species. Microbial degradation of fibrous PPL proceeded rapidly in some enrichment cultures but was not as complete as that of PHB. Most of the isolated PPL-degrading microorganisms were determined to be PCL degraders and/or PHB degraders. Therefore, it can be assumed that mostly PPL is recognized by the microorganisms as PHB or another natural substrate of the same type as which PCL is regarded. Microbial degradation of PPL was confirmed by some Bacillus strains from type culture collections. The similarity of microbial degradation between PPL and PCL was found to be very close.     

De novo formation characteristics of dioxins in the dry zone of an iron ore sintering bed

The objectives of this work are to understand the details of the mechanism of dioxin formation in the part of a sintering bed termed the dry zone, and to obtain ideas on how to prevent their formation. Sinter mixtures of various composition types were heated in a packed bed reactor, and dioxins in the outlet gas and in the sinter mixture residue were measured. The dioxin formation potential of a simple sinter mixture composed of iron ore, coke and limestone was markedly lower than that of fly ash from a municipal solid waste incinerator (MSWI). In consideration of this result, a series of experiments were conducted using a sinter mixture impregnated with CuCl2. Experimental results showed that dioxin formation was temperature-dependent in the range of 300-550 degrees C, with the maximum observed at around 300 degrees C, which was quite similar to that of fly ash from the MSWI. The homologue distribution of PCDD/Fs in gas and solid reflected the possible difference in carbonaceous materials in coke and activated coke. Gaseous hydrogen chloride acted as a chlorinating reagent for dioxin formation.