碳量子点掺杂氮化碳提高的光电化学阴极保护性能研究

目的研究g-C_3N_4/C-Dots-M复合材料的光电化学阴极保护性能。方法采用X射线衍射(XRD)、扫描电子显微镜(SEM)和紫外可见漫反射光谱技术对样品的晶体结构、微观形貌和光吸收性能进行表征。通过电化学测试可见光照射下g-C_3N_4/C-Dots-M复合材料光电极偶联316L不锈钢后的光电化学阴极保护电流密度和电位变化曲线,研究材料的光电化学阴极保护性能。结果可见光照射下,该偶联体系的光致混合电位下降至-0.43 V(vs. Ag/AgCl),光电化学阴极保护电流密度达到4.3μA/cm。结论得益于碳量子点优异的电子传导特性,g-C_3N_4/C-Dots-550复合材料的光电化学阴极保护性能比纯g-C_3N_4的明显增强。该复合材料在光电化学阴极保护方面展现了较大的应用潜力。     

DZ125合金HY3包覆型涂层退除研究

目的 研究化学法退除DZ125合金HY3包覆型涂层。方法 采用真空电弧镀技术（AIP）在定向凝固镍基高温合金DZ125上制备包覆型涂层HY3,利用化学方法完全退除基体上的涂层,通过失重法研究对比1#和2#退除溶液退除HY3涂层和DZ125合金的退除速率,采用扫描电镜（SEM）对退除后的HY3涂层和DZ125基体的微观组织进行观察。结果 经过100 min,2#溶液可以将20 ?m左右的HY3涂层完全退除,采用1#溶液需要超过100 min才能完全退除涂层。两种对DZ125合金的腐蚀性很小,对于同一种合金而言,1#溶液和2#溶液对合金的腐蚀速率比值为1︰13。在1#溶液中,合金与涂层腐蚀速率的比值为1︰87.65;在2#退除溶液中,合金与涂层腐蚀速率的比值为1︰6.81。结论 1#溶液更加适合退除DZ125合金上的HY3涂层。     

爆炸螺栓分离对热防护系统冲击响应分析

目的考察在爆炸螺栓分离过程中,作用在TPS(热防护系统)上的冲击响应是否会导致其破坏,从而影响航天器飞行安全,对过程进行数值仿真分析。方法提出四阶段仿真方案,基于MSC.Dytran软件,采用流固耦合方法对爆炸螺栓分离过程进行动力学仿真;根据单个爆炸螺栓地面分离试验的结构进行建模和分析,获取结构响应曲线;再根据实测的冲击响应数据,对爆炸过程中炸药及JWL方程的参数等设置进行调整,获取准确爆炸螺栓的分析模型;最后应用于对真实结构中TPS(热防护系统)在分离过程里受爆炸螺栓冲击响应的动力学分析与评估。结果通过参数调整,获得的仿真模型与爆炸螺栓地面分离试验实测结果一致,证明了仿真模型的有效性和四阶段仿真方案的可行性。结论提取的真实结构爆炸螺栓分离过程中作用在TPS(热防护结构)上的最大加速度响应曲线,可用于指导TPS(热防护系统)的设计。     

小型水利工程项目对环境的影响分析与研究

水利工程是农业项目发展的重要组成部分之一,小型水利工程项目的建设对环境的影响不容忽视。因此,以环境影响因素为基础对水利工程项目进行详细的设计是保障工程有序进行的重要前提。环境影响评价工作直接影响水利工程建设方案的价值,是判断工程设计方案可行性的重要依据。通过对小型水利工程项目对环境的影响进行调查和分析以及对水利工程对周围环境带来的影响进行评析,分析和介绍了环境影响评价的原则和思想,进而分析了水利工程建设与环境之间的关系,希望为建设水利项目提供借鉴作用。     

西安市文教区表层土壤中PAHs来源及风险分析

文教区土壤环境质量直接影响学生以及职工的身体健康。本研究应用高效液相色谱仪对采集的西安市文教区表层土壤样品中的16种优控多环芳烃(PAHs)进行含量检测,分析其组分特征、来源及健康风险。结果表明,西安市文教区表层土壤中∑PAHs含量为0.290~4.147μg/g,平均值为1.515μg/g,7种致癌多环芳烃的含量为0.079~2.093μg/g,均值为0.593μg/g,土壤PAHs污染较为严重。其中4环的高环PAHs为土壤PAHs污染的主要物质,平均占∑PAHs含量的40.72%。源解析结果表明西安市文教区表层土壤中PAHs主要来源于石油燃烧、煤及生物质等的不完全燃烧。终生癌症风险评价表明西安市文教区表层土壤中PAHs污染对其生活在周围的人群产生的终生致癌风险性较小,但71.4%的样点达到严重污染水平,产生的间接影响应引起足够重视。     

环保型民用建筑墙体节能工程施工质量监督策略研究

环保型民用建筑墙体节能工程施工的材料、设备、工艺复杂,需要进行建筑施工优化管理和质量监督,从而确保施工进度和工程质量,对环保型民用建筑墙体节能工程施工实施全过程质量控制,加强墙体施工的质量监督和管理。对建筑项目做好工程施工质量的风险预估,结合材料和设备、环境等方面的影响因素进行工程质量技术指导和风险控制。在施工过程中进行质量监督的动态过程控制,按照标准和规范,进行环保型节能建筑墙体施工质量的量化管理,使得建筑施工质量符合规范标准要求。     

Air Pollution in Singapore: Its Multielemental Aspect as Measured by Nuclear Analytical Techniques

Aerosol samples were collected in 1994 in Singapore on two occasions: once in June during the normal meteorological conditions and later in October during a long haze period caused by the heavy forest fire in Indonesia. Filtration and impaction collection methods were used simultaneously so that detailed elemental analysis of bulk as well as of different size fractions could be performed. Accelerator based nuclear analytical techniques such as Particle Induced X-Ray Emission (PIXE), Rutherford Backscattering (RBS) and Nuclear Microscopy (NM) were used for analysis. These techniques are fast, truly multielemental and perfectly suited for routine analysis of a large number of aerosol samples. Typically all samples were analysed for the following 24 elements: Na, Mg, Al, Si, P, S, Cl, K, Ca, Ti, V, Mn, Cr, Fe, Co, Ni, Cu, Zn, Ga, As, Br, Rb, Sr and Pb. Detection limits for bulk analysis were generally below ng/m3 and for single particle analysis absolute detectable mass was approximately 10-17 g. Additionally, trace elements such as Cd, Sn, Sb and Ba whose characteristic X-ray lines were normally "obscured" by the lines of other more abundant elements, were detected when analysing by nuclear microscope in single particle mode.Judging by the average concentrations of lead and sulphur which are good indicators of industrial component of air pollution the situation in Singapore is satisfactory. Pb was typically found in concentrations of 5 to 50 ng/m3 and sulphur in concentrations of 1 to 2 µg/m3. These concentrations are well below limits set by the World Health Organisation (1500 ng/m3 and 40 µg/m3, respectively). On the other hand during the haze period the average concentrations of elements like S, K, Ti, V, Mn, Ni, As and Pb were found to be 3 to 6 times higher than usual. Results are presented and discussed.     

Application of cryofocusing hydride generation and atomic fluorescence detection for dissolved mercury species determination in natural water samples

The concentration levels of mercury (Hg) species in natural water samples are usually low. Consequently, accurate analysis with low detection limits is still a major problem. In this work, a method was applied for the simultaneous direct determination of dissolved mercury species in water samples by on-line hydride generation (HG), cryogenic trapping (CT), gas chromatography (GC) and detection by atomic fluorescence spectrometry (AFS). The suitability of the method for real samples with different organic matter and chloride contents was evaluated by recovery experiments in synthetic and natural spiked water samples. The HG method was compared with other current available methods for mercury analysis with respect to the different fraction of mercury analysed, i.e. 'reactive', 'reducible' or total. HG derivatization and SnCl2 reduction (with and without previous oxidation with BrCl) were applied to synthetic and natural (spiked and non-spiked) water samples. The influence of chloride and dissolved organic matter concentrations was studied. The results suggest that the HG procedure is suitable for the simultaneous determination of Hg2+ and MeHg+ in surface water samples. Inorganic mercury analysed by HG (i.e. reducible) is close to the total inorganic mercury.     

湖南未耕种土壤中~(234、238)U、~(226)Ra、~(210)Po和~(210)Pb的分布和移动规律的研究

本文采集了湖南省十三个地区未耕种的０８０ｃｍ不同类型土壤样品，分别测定了０１０ｃｍ、２０３０ｃｍ、４０５０ｃｍ、７０８０ｃｍ样品中的２３４、２３８Ｕ、２２６Ｒａ、２１０Ｐｂ、２１０Ｐｏ含量，研究了土壤中铀系放射性核素分布影响和移动规律     

Speciation of arsenic using solid phase extraction cartridges

Various solid phase extraction (SPE) cartridges were investigated for speciation of arsenite [As(III)], arsenate [As(v)], monomethylarsonic acid (MMA) and dimethylarsinic acid (DMA). Cartridges containing different types of sorbent materials were tested for arsenic retention and elution characteristics. Alumina cartridges were found to completely retain all the four target arsenic species, and are suitable for removal and preconcentration purposes. For speciation analysis, different arsenic species were separated on the basis of their selective retention on and elution from specific cartridges. DMA was retained on a resin-based strong cation exchange cartridge and eluted with 1.0 M HCl. MMA and As(v) were both retained on a silica-based strong anion exchange cartridge and sequentially eluted with 60 mM acetic acid (for MMA) and 1.0 M HCl [for As(v)]. As(III) was not retained on either cartridge and remained in solution. Arsenic species in solution and those eluted from the cartridges were subsequently quantified by using flow injection with hydride generation atomic fluorescence spectrometry (FI-HGAFS) and hydride generation atomic absorption spectrometry (FI-HGAAS). A detection limit of 0.05 microg L(-1) arsenic in water sample was achieved using HGAFS. An application of the method was demonstrated at a drinking water treatment facility. As(III) and As(v) species were determined in water at various stages of treatment. The method is suitable for routine determination of trace levels of arsenic in drinking water to comply with more stringent environmental regulations.