Histoenzymological study on the toxicity of copper sulphate in the digestive glands of Lymnaea luteola

During 24 and 48 hr of exposure, the digestive glands of Lymnaea treated with a lethal concentration of 0.038 mgl(-1) CuSO4 revealed intense activity of acid phosphatase in perilobular margin. On the other hand, same area of the gland showed moderate activity of ATPase during 24 and 48 hr of exposure. However, alkaline phosphatase showed average activity in perialveolar region and perilobular margin during 24 and 48, and 72 hr of exposure respectively The changes in the activity of these enzymes were nonsignificant in alveolar margin and perialveolar region of the gland. It is interesting to note moderate activity of acid phosphatase in perialveolar region during 24 hr of exposure.     

A comparative hydrobiological study of a few ponds of Barak Valley, Assam and their role as sustainable water resources

A hydrobiological study conducted in nine different ponds of a rural area of Barak Valley, Assam, showed that the concentrations of chemical parameters like dissolved oxygen, free carbon dioxide, pH, conductivity alkalinity nitrate, phosphate, calcium, magnesium, copper and zinc are within the permissible levels of drinking water quality standard of WHO and ISI. However iron content was higher in most of the ponds. A clear indirect relationship between iron concentration and euglenoids has been observed. Major phytoplankton taxa present in the ponds are Chlorophyceae, Cyanophyceae, Bacillariophyceae and Euglenophyceae. The study reveals that rural ponds can be a very good source of water for drinking, domestic use and fishery and should be conserved at any cost.     

Characterisation of PM10, PM2.5 and Benzene Soluble Organic Fraction of Particulate Matter in an Urban Area of Kolkata, India

In this study, the relationship between inhalable particulate (PM₁₀), fine particulate (PM_2.5), coarse particles (PM_{2.5 – 10}) and meteorological parameters such as temperature, relative humidity, solar radiation, wind speed were statistically analyzed and modelled for urban area of Kolkata during winter months of 2003–2004. Ambient air quality was monitored with a sampling frequency of twenty-four hours at three monitoring sites located near traffic intersections and in an industrial area. The monitoring sites were located 3–5 m above ground near highly trafficked and congested areas. The 24 h average PM₁₀ and PM_2.5 samples were collected using Thermo-Andersen high volume samplers and exposed filter papers were extracted and analysed for benzene soluble organic fraction. The ratios between PM_2.5 and PM₁₀ were found to be in the range of 0.6 to 0.92 and the highest ratio was found in the most polluted urban site. Statistical analysis has shown a strong positive correlation between PM₁₀ and PM_2.5 and inverse correlation was observed between particulate matter (PM₁₀ and PM_2.5) and wind speed. Statistical analysis of air quality data shows that PM₁₀ and PM_2.5 are showing poor correlation with temperature, relative humidity and solar radiation. Regression equations for PM₁₀ and PM_2.5 and meteorological parameters were developed. The organic fraction of particulate matter soluble in benzene is an indication of poly aromatic hydrocarbon (PAH) concentration present in particulate matter. The relationship between the benzene soluble organic fraction (BSOF) of inhalable particulate (PM₁₀) and fine particulate (PM_2.5) were analysed for urban area of Kolkata. Significant positive correlation was observed between benzene soluble organic fraction of PM₁₀ (BSM10) and benzene soluble organic fraction of PM_2.5 (BSM2.5). Regression equations for BSM10 and BSM2.5 were developed.     

Characterization and Identification of the Sources of Chromium, Zinc, Lead, Cadmium, Nickel, Manganese and Iron in Pm10 Particulates at the Two Sites of Kolkata, India

Monitoring of ambient PM₁₀ (particulate matter which passes through a size selective impactor inlet with a 50% efficiency cut-off at 10 μm aerodynamic diameter) has been done at residential (Kasba) and industrial (Cossipore) sites of an urban region of Kolkata during November 2003 to November 2004. These sites were selected depending on the dominant anthropogenic activities. Metal constituents of atmospheric PM₁₀ deposited on glass fibre filter paper were estimated using Inductively Coupled Plasma Atomic Emission Spectrometer (ICP-AES). Chromium (Cr), zinc (Zn), lead (Pb), cadmium (Cd), nickel (Ni), manganese (Mn) and iron (Fe) are the seven toxic trace metals quantified from the measured PM₁₀ concentrations. The 24 h average concentrations of Cr, Zn, Pb, Cd, Ni, Mn and Fe from ninety PM₁₀ particulate samples of Kolkata were found to be 6.9, 506.1, 79.1, 3.3, 7.4, 2.4 and 103.6 ng/m³, respectively. The 24 h average PM₁₀ concentration exceeded national ambient air quality standard (NAAQS) as specified by central pollution control board, India at both residential (Kasba) and industrial (Cossipore) areas with mean concentration of 140.1 and 196.6 μg/m³, respectively. A simultaneous meteorology study was performed to assess the influence of air masses by wind speed, wind direction, rainfall, relative humidity and temperature. The measured toxic trace metals generally showed inverse relationship with wind speed, relative humidity and temperature. Factor analysis, a receptor modeling technique has been used for identification of the possible sources contributing to the PM₁₀. Varimax rotated factor analysis identified four possible sources of measured trace metals comprising solid waste dumping, vehicular traffic with the influence of road dust, road dust and soil dust at residential site (Kasba), while vehicular traffic with the influence of soil dust, road dust, galvanizing and electroplating industry, and tanning industry at industrial site (Cossipore).     

Biofilm mediated degradation of commercially available LDPE films by bacterial strains isolated from partially degraded plastic

Biodegradation is an attractive approach for the elimination of synthetic polymers, pervasively accumulated in natural environments and generating ecological problems. The present work investigated the degradation of low‐density polyethylene (PE) by three Bacillus sp., that is, ISJ36, ISJ38, and ISJ40. The degree of biodegradation was assessed by measuring hydrophobicity, viability, and total protein content of bacterial biofilm attached to the PE surface. Although all three bacterial strains were able to establish an active biofilm community on the PE surface, ISJ40 showed better affinity toward PE degradation than the other two. Bacterial colonization and physical changes on the PE surface were visualized by scanning electron microscopy. Fourier transform infrared spectroscopy analysis revealed alteration in the intensities of functional groups along with an increase in the carbonyl bond indexes. The study results suggest that the Bacillus strain ISJ40 can be used as a potential degrader for the eco‐friendly treatment of PE waste.     

Removal and recovery of toxic nanosized Cerium Oxide using eco-friendly Iron Oxide Nanoparticles

• Eco-friendly IONPs were synthesized through solvothermal method. • IONPs show very high removal efficiency for CeO₂ NPs i.e. 688 mg/g. • Removal was >90% in all synthetic and real water samples. • >80% recovery of CeO₂ NPs through sonication confirms reusability of IONPs. Increasing applications of metal oxide nanoparticles and their release in the natural environment is a serious concern due to their toxic nature. Therefore, it is essential to have eco-friendly solutions for the remediation of toxic metal oxides in an aqueous environment. In the present study, eco-friendly Iron Oxide Nanoparticles (IONPs) are synthesized using solvothermal technique and successfully characterized using scanning and transmission electron microscopy (SEM and TEM respectively) and powder X-Ray diffraction (PXRD). These IONPs were further utilized for the remediation of toxic metal oxide nanoparticle, i.e., CeO₂. Sorption experiments were also performed in complex aqueous solutions and real water samples to check its applicability in the natural environment. Reusability study was performed to show cost-effectiveness. Results show that these 200 nm-sized spherical IONPs, as revealed by SEM and TEM analysis, were magnetite (Fe₃O₄) and contained short-range crystallinity as confirmed from XRD spectra. Sorption experiments show that the composite follows the pseudo-second-order kinetic model. Further R²>0.99 for Langmuir sorption isotherm suggests chemisorption as probable removal mechanism with monolayer sorption of CeO₂ NPs on IONP. More than 80% recovery of adsorbed CeO₂ NPs through ultrasonication and magnetic separation of reaction precipitate confirms reusability of IONPs. Obtained removal % of CeO₂ in various synthetic and real water samples was>90% signifying that IONPs are candidate adsorbent for the removal and recovery of toxic metal oxide nanoparticles from contaminated environmental water samples.     

Clinical effects and cholinesterase activity changes in workers exposed to Phorate (Thimet)

Phorate (Thimet), an aliphatic derivative of phosphorus is a highly toxic insecticide. In order to implement the safety measures, the clinical manifestations and cholinesterase (ChE) activity were evaluated before and after 2 weeks of exposure to this insecticide in 40 male formulators. The 2 week's exposure reveal signs and symptoms of toxicity in 60% of the formulators. Gastrointestinal symptoms and lowering of heart rate (bradycardia) were more prominent as compared to the neurological symptoms. A significant depression in plasma ChE activity was observed at the end of 1st week (55%) and 2nd week (71%) as compared to the respective pre-exposure values. A recovery up to 79% of the pre-exposure activity of this enzyme was noticed 10 days after cessation of the above exposure.     

Evaluation and standardisation of a simple HG-AAS method for rapid speciation of As(III) and As(V) in some contaminated groundwater samples of West Bengal, India

A simple HG-AAS technique has been evaluated and standardised for rapid speciation of As(III) and As(V) in a number of contaminated groundwater samples of West Bengal, India. Citric acid has been used for selective hydride formation of As(III). The sensitivity of the evaluated HG-AAS method is 7.91 mg(-1)l, standard deviation, 0.001 and detection limit, 0.4 microg l(-1). As(III) sensitivity remains constant in the sample pH range of 2.3-10.6. Concomitant mineral matrix of the water samples did not interfere with arsenic determination. Eight out of ten groundwater samples analysed for As(IlI)and As(V) contain more As(III), which lies in the range of 54-350 ppb. As(III) estimation in drinking water along with total arsenic should be invoked as a policy for a realistic risk assessment of the contaminated water.     

Effect of concentration,moisture and soil type on the dissipation of flufenacet from soil

Effect of concentration, moisture and soil type on dissipation of flufenacet from soil has been studied under laboratory condition. The treated soil samples (1 and 10 microg/g levels) were incubated at 25+/-1 degrees C. The effect of moisture was studied by maintaining the treated soil samples (10 microg/g level) at field capacity and submerged condition. In general, flufenacet persisted for 60-90 days at lower and beyond 90 days at high rate. The dissipation of flufenacet from soil followed first order kinetics with half-life (DT50) values ranging from 10 to 31 days. The dissipation of flufenacet was faster at low rate than high rate of application. The slow dissipation at high rate could be attributed to inhibition of microbial activity at high rate. There was little overall difference in rate of dissipation in Ranchi and Nagpur soil maintained at field capacity and submerged condition moisture regimes. In Delhi soil net dissipation was faster under field capacity moisture than submerged condition. Soil types greatly influenced the dissipation of flufenacet. Dissipation was fastest in Delhi soil (DT50 10.1-22.3 days) followed by Ranchi soil (DT50 10.5-24.1 days) and least in Nagpur soil (DT50 29.2-31.0 days). The difference in dissipation could be attributed to the magnitude of adsorption and desorption of flufenacet in these soils.